Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Instrumentation and Measurement

Development of 10-v josephson series arrays

Se Il Park, Hyun Kwon Hong

Published Apr 1, 2003• 3 citations
Publisher

Abstract

Developed a new fabrication process for 10-V Josephson junction series arrays (JJAs). A plasma nitridation process is employed for reducing the microwave attenuation in the Josephson microstripline. Improvements of microwave attenuation are about 2 dB for test arrays of 2000, 3000, and 4000 Josephson junctions in a single stripline. We obtained stable quantized voltage steps up to 12 V at 76.4 and 86.8 GHz with step amplitudes of more than 5 /spl mu/A and stability times of more than 5 min. The circuits used 14 648 junctions arranged in 8 parallel paths.

DOI
10.1109/tim.2003.809913

Related papers

Reduction of microwave attenuation in superconducting microstripline using plasma nitridation

S.I. Park, Jinhee Kim, Hyun Kwon Hong +1 more

We have been developed a new fabrication process of Josephson junction series array (JJA) by using reactive ion etching (RIE) and a self-aligning technique. A plasma nitridation process is also employed in improving the microwave transmission characteristics by blocking the O/sub 2/ from diffusing into the Nb ground-plane by depositing SiO/sub 2/ dielectric layer using plasma enhanced chemical vapor deposition (PECVD) at substrate temperature of 300/spl deg/C.

Conference on Precision Electromagnetic Measurements•Jun 25, 2003•0 citations

Optimized 1 V and 10 V Josephson series arrays

F. Muller, R. Pöpel, J. Kohlmann +6 more

By means of a new fabrication method and detailed design investigations we have been able to optimize the array circuits for the Josephson voltage standard. Even in very long arrays (4800 junctions in one stripline) a yield of 1 mV per junction could be achieved. The microwave power at 70 GHz required for the stable operation of 1 V and 10 V circuits could be reduced down to 1 mW and 10 mW (antenna input), respectively.

Conference on Precision Electromagnetic Measurements•Dec 23, 2002•2 citations

Development and investigation of Nb-Al-oxide-Nb Josephson junction arrays [voltage standard application]

A.F. Bochanov, V.D. Gelikonova, Alexander M. Klushin +2 more

An array of 3072 Josephson junctions Nb-AlO/sub x/-Nb is developed at IEM "KVARZ". Some preliminary results of an investigation of I-V curves under microwave irradiation in the 70 GHz frequency band are given. Zero current quantized voltage steps are displayed up to 450 mV with an amplitude >100 /spl mu/A. An improvement of the fabrication process, which is in progress, will enable to increase quantized voltage steps region up to 1 V.>

Conference on Precision Electromagnetic Measurements•Dec 17, 2002•0 citations

Hybrid integration of microwave oscillators with Josephson series arrays for the use as voltage standards

Franz X. Hebrank, P. Gutmann, F. Muller +2 more

We have designed and fabricated a new type of Josephson device to be hybrid integrated with microstripline oscillators. For optimum matching of the Josephson series array to the oscillator the samples make use of a new stripline design. The first circuits were fabricated in a simplified Nb/Al/sub 2/O/sub 3//Nb technology and exhibit excellent dc characteristics and good microwave coupling to the junctions of the array. At 70 GHz constant voltage steps up to 350 mV could be observed. By hybrid integrating different samples with a new 10-GHz oscillator, constant voltage steps were created. For this experiment the Josephson current density had to be low enough to reduce the plasma frequency of the junctions to well below the driving frequency.>

IEEE Transactions on Applied Superconductivity•Jun 1, 1995•5 citations

Development and investigation of Nb-Al-oxide-Nb Josephson Junction arrays

A.F. Bochanov, V.D. Gelikonova, Alexander M. Klushin

An array of 3072 Josephson junctions Nb - AlO{sub x} - Nb is developed at IEM {open_quotes}KVARZ{close_quotes}. Some preliminary results of an investigation of IV curves under microwave irradiation in the 70 GHz frequency band are given. Zero current quantized voltage steps are displayed up to 450 mV with an amplitude > 100 {mu}A. An improvement of the fabrication process, which is in progress, will enable to increase quantized voltage steps region up to IV.

•Dec 31, 1994•0 citations

Microwave Design and Performance of PTB 10 V Circuits for the Programmable Josephson Voltage Standard

Franz Müller, Thomas Scheller, Jinni Lee +4 more

At Physikalisch-Technische Bundesanstalt (PTB), superconducting 10 V circuits for the programmable Josephson voltage standard (PJVS) are routinely manufactured on the basis of NbxSi1-x barrier junctions. This paper describes in detail the basic design principles for an operating frequency of 70 GHz. It starts with single junctions, discusses their insertion into microstriplines and closes with the whole microwave circuit containing 69,632 NbxSi1-x barrier junctions arranged over 128 microstriplines connected in parallel. The microwave attenuation of this junction type is a key parameter for the 10 V design and we report its experimental determination. Special attention has been devoted to subarrays with just a few Josephson junctions in one of the outermost striplines. The arrangement of these subarrays determines the optimum performance of the complete 10 V series array. The high performance of programmable 10 V circuits fabricated at PTB is characterized by measured operating margins in all subarrays of more than 1 mA centered at the same dc bias current. The observed modulation of the current margins, when changing the frequency around 70 GHz, is explained by microwave reflections caused by the rf waveguide inside the cryoprobe. We determine the current margins in dependence of the output power of a microwave synthesizer and show that 60 mW is sufficient to achieve current margins larger than 1 mA.

World Journal of Condensed Matter Physics•Jan 1, 2014•20 citations
Developed a new fabrication process for 10-V Josephson junction series arrays (JJAs). A plasma nitridation process is employed for reducing the microwave attenuation in the Josephson microstripline. Improvements of microwave attenuation are about 2 dB for test arrays of 2000, 3000, and 4000 Josephson junctions in a single stripline. We obtained stable quantized voltage steps up to 12 V at 76.4 and 86.8 GHz with step amplitudes of more than 5 /spl mu/A and stability times of more than 5 min. The circuits used 14 648 junctions arranged in 8 parallel paths.
We have designed and fabricated a new type of Josephson device to be hybrid integrated with microstripline oscillators. For optimum matching of the Josephson series array to the oscillator the samples make use of a new stripline design. The first circuits were fabricated in a simplified Nb/Al/sub 2/O/sub 3//Nb technology and exhibit excellent dc characteristics and good microwave coupling to the junctions of the array. At 70 GHz constant voltage steps up to 350 mV could be observed. By hybrid integrating different samples with a new 10-GHz oscillator, constant voltage steps were created. For this experiment the Josephson current density had to be low enough to reduce the plasma frequency of the junctions to well below the driving frequency.>
At Physikalisch-Technische Bundesanstalt (PTB), superconducting 10 V circuits for the programmable Josephson voltage standard (PJVS) are routinely manufactured on the basis of NbxSi1-x barrier junctions. This paper describes in detail the basic design principles for an operating frequency of 70 GHz. It starts with single junctions, discusses their insertion into microstriplines and closes with the whole microwave circuit containing 69,632 NbxSi1-x barrier junctions arranged over 128 microstriplines connected in parallel. The microwave attenuation of this junction type is a key parameter for the 10 V design and we report its experimental determination. Special attention has been devoted to subarrays with just a few Josephson junctions in one of the outermost striplines. The arrangement of these subarrays determines the optimum performance of the complete 10 V series array. The high performance of programmable 10 V circuits fabricated at PTB is characterized by measured operating margins in all subarrays of more than 1 mA centered at the same dc bias current. The observed modulation of the current margins, when changing the frequency around 70 GHz, is explained by microwave reflections caused by the rf waveguide inside the cryoprobe. We determine the current margins in dependence of the output power of a microwave synthesizer and show that 60 mW is sufficient to achieve current margins larger than 1 mA.