Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Transactions on Microwave Theory and Techniques

Spectral-domain analysis of harmonic effects in superconducting quasiparticle mixers

S. Withington, E. Kollberg

Published Jan 1, 1989• 33 citations
Publisher

Abstract

An algorithm was developed for calculating the harmonic performance of superconducting quasiparticle millimeter-wave mixers. The scheme uses harmonic balance to determine the steady-state waveform of the large-amplitude voltage which is induced across the tunnel junction by the local oscillator source. A key feature of the algorithm is that the large-signal tunneling-current calculations are done in the frequency domain rather than in the time domain, and this approach leads to numerically efficient computer simulations. The superiority of the spectral-domain method is particularly pronounced when modeling mixers that incorporate high-quality tunnel junctions with very sharp DC nonlinearities. A simplified mixer simulation was performed to determine the range of omega CR products for which harmonic effects are likely to be important.>

DOI
10.1109/22.20043

Related papers

Simulation of the superconducting quasiparticle mixer using a five-port model

Edward Tong, R. Blundell

A harmonic Newton technique has successfully been used in the simulation of superconducting quasiparticle mixers in a five-port model. The steady-state large-signal waveform impressed across the tunnel junction by the incident local oscillator (LO) power is computed in the frequency domain. The three-frequency approximation provides the initial trial solution, which, together with the superlinear convergence property of Newton's method, ensures rapid convergence. A wide range of simulations based on the response function of a real superconductor-insulator-superconductor (SIS) junction is presented. The case of an SIS harmonic mixer (n=2) is also studied. Using a five-port model, the simulation explicitly takes the effect of the first harmonic into account. The algorithm and the principal results obtained for a hypothetical mixer incorporating the measured current-voltage characteristics of a real (SIS) junction are presented. The first results indicate that harmonic quasiparticle mixing may be very attractive in the submillimeter-wave band.>

IEEE Transactions on Microwave Theory and Techniques•Jan 1, 1990•15 citations

Simulating the Behavior of a 230-GHz SIS Mixer Using Multitone Spectral Domain Analysis

John Garrett, Boon-Kok Tan, Faouzi M. Boussaha +2 more

We present a new software package, called QMix, for simulating the behavior of superconductor/insulator/ superconductor (SIS) mixers. The software uses a harmonic balance procedure to calculate the ac voltage across the SIS junction and multitone spectral domain analysis to calculate the quasiparticle tunneling currents. This approach has two major advantages over other simulation techniques: 1) it can include an arbitrary number of higher order harmonics, and 2) it can simulate the effect of multiple strong nonharmonic frequencies. This allows the QMix software to simulate a wide range of SIS mixer operation, including the effects of harmonics in the local-oscillator (LO) signal and gain saturation with respect to the RF signal power. In this article, we compare the simulated results from QMix to the measured performance of a 230-GHz SIS device, both to validate the software and to investigate the experimental data. To begin, we simulated the conversion gain of the mixer and we found excellent agreement with the experimental results. We were also able to recreate the broken photon step effect by adding higher and lower order harmonics to the LO signal. We then simulated a range of incident RF signal powers in order to calculate the gain saturation point. This is an important metric for SIS mixers because we require linear gain for reliable measurements and calibration. In the simulated results, we found both gain compression and gain expansion, which is consistent with other studies. Overall, these examples demonstrate that QMix is a powerful software package that will allow researchers to simulate the performance of SIS mixers, investigate experimental results, and optimize mixer operation. We have made all of the QMix software open-source and we invite others to contribute to the project.

IEEE Transactions on Terahertz Science and Technology•Sep 2, 2019•2 citations

CAD of Superconducting Nonlinear Circuits

S. Withington, P. R. Ke

The paper summarises preliminary work on the development of a general-purpose superconducting nonlinear-circuit simulator. After contrasting, from a CAD perspective, time and frequency domain descriptions of the macroscopic quantum behaviour of superconducting tunnel junctions, it is reported that the large-signal steady-state dynamics of a tunnel-junction circuit can be conmpletely decomposed by using the method of harmonic balance, and that the resulting system of coupled nonlinear algebraic equations can be solved through harmonic Newton. The principle is illustrated by briefly mentioning an analysis of inadvertent harmonic pumping in quasiparticle mixers.

European Microwave Conference (EuMC)•Oct 1, 1990•0 citations

Fast Harmonic Balance of SIS Mixers with Multiple Junctions and Superconducting Circuits

F. Rice, John S. Ward, Jonas Stasys Zmuidzinas +1 more

We have extended the spectral domain harmonic balance method of Withington and Kollberg [1] to handle quasiparticle mixer circuits of arbitrary complexity containing any number of superconducting tunnel junctions. Our algorithm uses a multidimensional Newton-Raphson technique to achieve rapid convergence, even when many harmonics are included in the analysis. Another improvement is to perform all linear circuit calculations using the scattering matrix representation typical of modern circuit modeling techniques. This algorithm has been implemented as part of an extensive C++ class library for modeling the signal and noise performance of superconducting heterodyne receivers (SuperMix). Using the common, free C++ compiler "g++" (Free Software Foundation), impressive results can be achieved on modern workstations of moderate capability. Such speeds will make complex nonlinear optimization calculations a routine part of SIS receiver design.

•Mar 1, 1999•12 citations

Harmonic mixing in a superconducting tunnel junction

Edward Tong, Lawrence M. Chernin, R. Blundell

A theoretical analysis of harmonic mixing in a quasiparticle tunnel junction at Vbias=0 shows that harmonic mixing for submillimeter frequencies is a viable alternative to fundamental mixing. It is also shown that the signal gain from the first harmonic above the pump frequency to the intermediate frequency is independent of the embedding admittance at the pump frequency. In fact, we show that the five-port model reduces to the three-port model as a result of the inversion symmetry of the I-V curve and, moreover, no large-signal analysis is necessary. Full simulations of harmonic mixing using a five-port model confirm these results. The simulations have been done for the case of a superconductor-insulator-normal junction in which there is no pair current interference. For this type of harmonic mixer we show that the local oscillator (LO) power requirement can be less than a fundamental mixer operating at the same signal frequency, which is particularly useful in circumventing the problems of high-frequency LO power generation.

Journal of Applied Physics•Oct 15, 1990•8 citations

A general numerical analysis of the superconducting quasiparticle mixer

R.G. Hicks, M. J. Feldman, Anthony R. Kerr

Virtually all analyses of the superconductor-insulator-superconductor (SIS) quasiparticle mixer have employed the quantum theory of mixing in its three-frequency approximate form. This approximation is valid only in the limit of very large junction capacitance. For finite capacitance, these analyses may be seriously in error. To remedy this, a computer program has been developed which uses the quantum theory of mixing in its most general form, treating the large-signal properties of the mixer in the time domain. The terminating impedances at the harmonics of the local oscillator frequency and their sidebands can be arbitrary. Using this analysis, the effect of finite junction capacitance on one SIS mixer's performance is described. This gives an insight into the range of validity of the three-frequency model.

IEEE Transactions on Magnetics•Mar 1, 1985•15 citations
An algorithm was developed for calculating the harmonic performance of superconducting quasiparticle millimeter-wave mixers. The scheme uses harmonic balance to determine the steady-state waveform of the large-amplitude voltage which is induced across the tunnel junction by the local oscillator source. A key feature of the algorithm is that the large-signal tunneling-current calculations are done in the frequency domain rather than in the time domain, and this approach leads to numerically efficient computer simulations. The superiority of the spectral-domain method is particularly pronounced when modeling mixers that incorporate high-quality tunnel junctions with very sharp DC nonlinearities. A simplified mixer simulation was performed to determine the range of omega CR products for which harmonic effects are likely to be important.>
A harmonic Newton technique has successfully been used in the simulation of superconducting quasiparticle mixers in a five-port model. The steady-state large-signal waveform impressed across the tunnel junction by the incident local oscillator (LO) power is computed in the frequency domain. The three-frequency approximation provides the initial trial solution, which, together with the superlinear convergence property of Newton's method, ensures rapid convergence. A wide range of simulations based on the response function of a real superconductor-insulator-superconductor (SIS) junction is presented. The case of an SIS harmonic mixer (n=2) is also studied. Using a five-port model, the simulation explicitly takes the effect of the first harmonic into account. The algorithm and the principal results obtained for a hypothetical mixer incorporating the measured current-voltage characteristics of a real (SIS) junction are presented. The first results indicate that harmonic quasiparticle mixing may be very attractive in the submillimeter-wave band.>
We present a new software package, called QMix, for simulating the behavior of superconductor/insulator/ superconductor (SIS) mixers. The software uses a harmonic balance procedure to calculate the ac voltage across the SIS junction and multitone spectral domain analysis to calculate the quasiparticle tunneling currents. This approach has two major advantages over other simulation techniques: 1) it can include an arbitrary number of higher order harmonics, and 2) it can simulate the effect of multiple strong nonharmonic frequencies. This allows the QMix software to simulate a wide range of SIS mixer operation, including the effects of harmonics in the local-oscillator (LO) signal and gain saturation with respect to the RF signal power. In this article, we compare the simulated results from QMix to the measured performance of a 230-GHz SIS device, both to validate the software and to investigate the experimental data. To begin, we simulated the conversion gain of the mixer and we found excellent agreement with the experimental results. We were also able to recreate the broken photon step effect by adding higher and lower order harmonics to the LO signal. We then simulated a range of incident RF signal powers in order to calculate the gain saturation point. This is an important metric for SIS mixers because we require linear gain for reliable measurements and calibration. In the simulated results, we found both gain compression and gain expansion, which is consistent with other studies. Overall, these examples demonstrate that QMix is a powerful software package that will allow researchers to simulate the performance of SIS mixers, investigate experimental results, and optimize mixer operation. We have made all of the QMix software open-source and we invite others to contribute to the project.
The paper summarises preliminary work on the development of a general-purpose superconducting nonlinear-circuit simulator. After contrasting, from a CAD perspective, time and frequency domain descriptions of the macroscopic quantum behaviour of superconducting tunnel junctions, it is reported that the large-signal steady-state dynamics of a tunnel-junction circuit can be conmpletely decomposed by using the method of harmonic balance, and that the resulting system of coupled nonlinear algebraic equations can be solved through harmonic Newton. The principle is illustrated by briefly mentioning an analysis of inadvertent harmonic pumping in quasiparticle mixers.
We have extended the spectral domain harmonic balance method of Withington and Kollberg [1] to handle quasiparticle mixer circuits of arbitrary complexity containing any number of superconducting tunnel junctions. Our algorithm uses a multidimensional Newton-Raphson technique to achieve rapid convergence, even when many harmonics are included in the analysis. Another improvement is to perform all linear circuit calculations using the scattering matrix representation typical of modern circuit modeling techniques. This algorithm has been implemented as part of an extensive C++ class library for modeling the signal and noise performance of superconducting heterodyne receivers (SuperMix). Using the common, free C++ compiler "g++" (Free Software Foundation), impressive results can be achieved on modern workstations of moderate capability. Such speeds will make complex nonlinear optimization calculations a routine part of SIS receiver design.
A theoretical analysis of harmonic mixing in a quasiparticle tunnel junction at Vbias=0 shows that harmonic mixing for submillimeter frequencies is a viable alternative to fundamental mixing. It is also shown that the signal gain from the first harmonic above the pump frequency to the intermediate frequency is independent of the embedding admittance at the pump frequency. In fact, we show that the five-port model reduces to the three-port model as a result of the inversion symmetry of the I-V curve and, moreover, no large-signal analysis is necessary. Full simulations of harmonic mixing using a five-port model confirm these results. The simulations have been done for the case of a superconductor-insulator-normal junction in which there is no pair current interference. For this type of harmonic mixer we show that the local oscillator (LO) power requirement can be less than a fundamental mixer operating at the same signal frequency, which is particularly useful in circumventing the problems of high-frequency LO power generation.
Virtually all analyses of the superconductor-insulator-superconductor (SIS) quasiparticle mixer have employed the quantum theory of mixing in its three-frequency approximate form. This approximation is valid only in the limit of very large junction capacitance. For finite capacitance, these analyses may be seriously in error. To remedy this, a computer program has been developed which uses the quantum theory of mixing in its most general form, treating the large-signal properties of the mixer in the time domain. The terminating impedances at the harmonics of the local oscillator frequency and their sidebands can be arbitrary. Using this analysis, the effect of finite junction capacitance on one SIS mixer's performance is described. This gives an insight into the range of validity of the three-frequency model.