Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

Harmonic mixing in a superconducting tunnel junction

Edward Tong, Lawrence M. Chernin, R. Blundell

Published Oct 15, 1990• 8 citations
Publisher

Abstract

A theoretical analysis of harmonic mixing in a quasiparticle tunnel junction at Vbias=0 shows that harmonic mixing for submillimeter frequencies is a viable alternative to fundamental mixing. It is also shown that the signal gain from the first harmonic above the pump frequency to the intermediate frequency is independent of the embedding admittance at the pump frequency. In fact, we show that the five-port model reduces to the three-port model as a result of the inversion symmetry of the I-V curve and, moreover, no large-signal analysis is necessary. Full simulations of harmonic mixing using a five-port model confirm these results. The simulations have been done for the case of a superconductor-insulator-normal junction in which there is no pair current interference. For this type of harmonic mixer we show that the local oscillator (LO) power requirement can be less than a fundamental mixer operating at the same signal frequency, which is particularly useful in circumventing the problems of high-frequency LO power generation.

DOI
10.1063/1.346235

Related papers

Simulation of the superconducting quasiparticle mixer using a five-port model

Edward Tong, R. Blundell

A harmonic Newton technique has successfully been used in the simulation of superconducting quasiparticle mixers in a five-port model. The steady-state large-signal waveform impressed across the tunnel junction by the incident local oscillator (LO) power is computed in the frequency domain. The three-frequency approximation provides the initial trial solution, which, together with the superlinear convergence property of Newton's method, ensures rapid convergence. A wide range of simulations based on the response function of a real superconductor-insulator-superconductor (SIS) junction is presented. The case of an SIS harmonic mixer (n=2) is also studied. Using a five-port model, the simulation explicitly takes the effect of the first harmonic into account. The algorithm and the principal results obtained for a hypothetical mixer incorporating the measured current-voltage characteristics of a real (SIS) junction are presented. The first results indicate that harmonic quasiparticle mixing may be very attractive in the submillimeter-wave band.>

IEEE Transactions on Microwave Theory and Techniques•Jan 1, 1990•15 citations

Theoretical and numerical analysis of very high harmonic superconducting tunnel junction mixers

Phichet Kittara, S. Withington, G. Yassin

We describe a procedure for modeling the nonlinear, quantum-mechanical behavior of very high harmonic superconductor-insulator-superconductor (SIS) mixers. A typical mixer is pumped by a strong microwave source at 10–15GHz, which causes high-harmonic (20–40) currents to flow, any one of which can be used as a local oscillator to downconvert a submillimeter-wave signal to a low microwave frequency, 1–8GHz. This mode of operation is attractive for measuring the beam patterns of conventional SIS mixers, because only a single submillimeter-wave source is needed. We conducted simulations using the 20th harmonic of a 13.5GHz microwave source, downconverting a 271.4GHz signal to a 1.4GHz intermediate frequency. These simulations clearly show that linear downconversion can be achieved even for relatively high levels of rf signal power; although, care is needed when choosing the operating point. The patterns of behavior seen in the simulations are in remarkable agreement with recently published experimental results.

Journal of Applied Physics•Jan 15, 2007•14 citations

Investigation of the Harmonic Mixer and Low-Frequency Converter Regimes in a Superconducting Tunnel Junction

K. V. Kalashnikov, Anton A. Artanov, Gert J. de Lange +1 more

We experimentally investigate different mixing regi-mes in Nb/AlOx/Nb and Nb/AlN/NbN tunnel superconductor-insulator-superconductor (SIS) junctions. The SIS mixers were studied with regard to the following modes of operation: in an extremely low-frequency range (0.1-20 GHz) and as high harmonic mixers; n ≈ 20-30 at signal frequencies of about 500 GHz that requires high power of a local oscillator. The quasiparticle and Josephson mixing regimes have been compared. We demonstrate that, in some applications requiring high conversion efficiency, the Josephson regime can be more preferable than the quasiparticle regime due to a larger output signal and better signal-to-noise ratio. As an example of such an application, we consider the phase locking of a THz oscillator using a cryogenic harmonic phase detector, which only ought to realize all of its benefits under the Josephson mixing regime. In addition, we demonstrate that the presence of the Josephson effect results in considerable increase in conversion efficiency at the expense of the dynamic range decrease; it was measured for low-frequency up- and down-convertors, which are promising for cryogenic multiplexing systems.

IEEE Transactions on Applied Superconductivity•Feb 6, 2018•6 citations

Fundamental and harmonic mixing at 500 GHz using a superconductor-insulator-normal metal junction

Lawrence M. Chernin, R. Blundell, Edward Tong +1 more

We have demonstrated fundamental and harmonic mixing using a PbInAu/InOxPbOx/Ag superconductor-insulator-normal metal tunnel junction mixer designed to operate over the 450–550 GHz frequency range. Direct mixing experiments at up to 1.8 times the gap frequency of the tunnel junction have shown that the mixer works in both fundamental and second harmonic modes, with the highest conversion from the fundamental mode obtained at bias voltages near the gap voltage and the highest conversion from the harmonic mode obtained at zero bias. The measured mixer conversion curves are consistent with our five-port model simulations based on Tucker’s quantum mixer theory [IEEE J. Quantum. Electron. QE-15, 1234 (1979)].

Journal of Applied Physics•Oct 15, 1992•4 citations

Harmonic mixing in a superconductor-insulator-normal metal tunnel junction receiver

Lawrence M. Chernin, R. Blundell

We have investigated the theoretical performance of a subharmonically pumped Pb/Bi/In-oxide-Ag superconductor-insulator-normal metal mixer and found excellent receiver noise performance for signal frequencies above the gap frequency, Δ/h, if the junction is biased at zero volts. This type of mixer needs no pair current suppression and can use local oscillator power more efficiently than a fundamental mixer.

Journal of Applied Physics•Feb 15, 1991•9 citations

Harmonic Mixing with SIS Tunnel Junctions in the Millimeter and Submillimeter Regions

Masayoshi Kobayashi, Shinji Ohara, Akira Katsuno +2 more

The characteristics of SIS (Superconductor-Insulator-Superconductor) harmonic mixing were studied in the millimeter and submillimeter regions. IF (Intermediate Frequency) signals originating from the Josephson effect and the photon-assisted tunneling were observed. Each property was investigated by applying a magnetic field. Compared with mixing based on photon-assisted tunneling, mixing by the Josephson effect required low LO (Local Oscillator) power and gave rise to a smaller conversion loss, but more noise.

Japanese Journal of Applied Physics•Dec 1, 1985•3 citations
A theoretical analysis of harmonic mixing in a quasiparticle tunnel junction at Vbias=0 shows that harmonic mixing for submillimeter frequencies is a viable alternative to fundamental mixing. It is also shown that the signal gain from the first harmonic above the pump frequency to the intermediate frequency is independent of the embedding admittance at the pump frequency. In fact, we show that the five-port model reduces to the three-port model as a result of the inversion symmetry of the I-V curve and, moreover, no large-signal analysis is necessary. Full simulations of harmonic mixing using a five-port model confirm these results. The simulations have been done for the case of a superconductor-insulator-normal junction in which there is no pair current interference. For this type of harmonic mixer we show that the local oscillator (LO) power requirement can be less than a fundamental mixer operating at the same signal frequency, which is particularly useful in circumventing the problems of high-frequency LO power generation.
A harmonic Newton technique has successfully been used in the simulation of superconducting quasiparticle mixers in a five-port model. The steady-state large-signal waveform impressed across the tunnel junction by the incident local oscillator (LO) power is computed in the frequency domain. The three-frequency approximation provides the initial trial solution, which, together with the superlinear convergence property of Newton's method, ensures rapid convergence. A wide range of simulations based on the response function of a real superconductor-insulator-superconductor (SIS) junction is presented. The case of an SIS harmonic mixer (n=2) is also studied. Using a five-port model, the simulation explicitly takes the effect of the first harmonic into account. The algorithm and the principal results obtained for a hypothetical mixer incorporating the measured current-voltage characteristics of a real (SIS) junction are presented. The first results indicate that harmonic quasiparticle mixing may be very attractive in the submillimeter-wave band.>
We describe a procedure for modeling the nonlinear, quantum-mechanical behavior of very high harmonic superconductor-insulator-superconductor (SIS) mixers. A typical mixer is pumped by a strong microwave source at 10–15GHz, which causes high-harmonic (20–40) currents to flow, any one of which can be used as a local oscillator to downconvert a submillimeter-wave signal to a low microwave frequency, 1–8GHz. This mode of operation is attractive for measuring the beam patterns of conventional SIS mixers, because only a single submillimeter-wave source is needed. We conducted simulations using the 20th harmonic of a 13.5GHz microwave source, downconverting a 271.4GHz signal to a 1.4GHz intermediate frequency. These simulations clearly show that linear downconversion can be achieved even for relatively high levels of rf signal power; although, care is needed when choosing the operating point. The patterns of behavior seen in the simulations are in remarkable agreement with recently published experimental results.
We experimentally investigate different mixing regi-mes in Nb/AlOx/Nb and Nb/AlN/NbN tunnel superconductor-insulator-superconductor (SIS) junctions. The SIS mixers were studied with regard to the following modes of operation: in an extremely low-frequency range (0.1-20 GHz) and as high harmonic mixers; n ≈ 20-30 at signal frequencies of about 500 GHz that requires high power of a local oscillator. The quasiparticle and Josephson mixing regimes have been compared. We demonstrate that, in some applications requiring high conversion efficiency, the Josephson regime can be more preferable than the quasiparticle regime due to a larger output signal and better signal-to-noise ratio. As an example of such an application, we consider the phase locking of a THz oscillator using a cryogenic harmonic phase detector, which only ought to realize all of its benefits under the Josephson mixing regime. In addition, we demonstrate that the presence of the Josephson effect results in considerable increase in conversion efficiency at the expense of the dynamic range decrease; it was measured for low-frequency up- and down-convertors, which are promising for cryogenic multiplexing systems.
We have demonstrated fundamental and harmonic mixing using a PbInAu/InOxPbOx/Ag superconductor-insulator-normal metal tunnel junction mixer designed to operate over the 450–550 GHz frequency range. Direct mixing experiments at up to 1.8 times the gap frequency of the tunnel junction have shown that the mixer works in both fundamental and second harmonic modes, with the highest conversion from the fundamental mode obtained at bias voltages near the gap voltage and the highest conversion from the harmonic mode obtained at zero bias. The measured mixer conversion curves are consistent with our five-port model simulations based on Tucker’s quantum mixer theory [IEEE J. Quantum. Electron. QE-15, 1234 (1979)].
The characteristics of SIS (Superconductor-Insulator-Superconductor) harmonic mixing were studied in the millimeter and submillimeter regions. IF (Intermediate Frequency) signals originating from the Josephson effect and the photon-assisted tunneling were observed. Each property was investigated by applying a magnetic field. Compared with mixing based on photon-assisted tunneling, mixing by the Josephson effect required low LO (Local Oscillator) power and gave rise to a smaller conversion loss, but more noise.