Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Advanced Photonics

Phase Locking of SBS Slow Light in a 2.2-km Single-Mode Fiber

Joseph E. Vornehm, Aaron Schweinsberg, Zhimin Shi, Robert W. Boyd

Published Jan 1, 2011• 1 citation
Publisher

Abstract

A stimulated Brillouin scattering (SBS) slow light system in a 2.2-km single-mode fiber is phase locked to a reference signal. Optical pulses of 6.5 ns duration are delayed 0.9 pulse width while maintaining lock.
DOI
10.1364/sl.2011.slma4

Related papers

Broadening-free stimulated Brillouin scattering-based slow and fast light in optical fibers

Thomas Schneider, Andrzej Wiatrek

The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.

Optical Engineering•Aug 25, 2014•0 citations

Nearly transparent SBS slow light in an optical fiber

Zhaoming Zhu, Daniel J. Gauthier

Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.

arXiv:physics/0607169•Optics Express•Jan 1, 2006•40 citations

Stimulated Brillouin scattering slow light in optical fibers [Invited]

Avi Zadok, Avishay Eyal, Moshe Tur

Stimulated Brillouin scattering (SBS) has become a favorable underlying mechanism in many demonstrations of all-optical variable delay in standard fibers, often referred to as slow and fast light. Over 100 journal papers and numerous conference sessions have been dedicated to SBS slow light since 2005. In this paper, recent research in this area is reviewed. Following a short introduction to the topic, several specific trends in contemporary work are highlighted: the optimization of the SBS pump spectrum for extended slow light delay and reduced pulse distortion; SBS slow light demonstrations in nonstandard, highly nonlinear fibers; applications of SBS slow light to the delay of analog waveforms; and the role of polarization. Finally, a brief concluding perspective is provided.

Applied Optics•Jun 30, 2011•102 citations

Improving the Delay Efficiency of SBS Slow Light by Using Highly Nonlinear Photonic Crystal Fiber

Xiufeng Yang, Zhengrong Tong, Junfa Zhao +2 more

An efficient stimulated Brillouin scattering slow light system based on a highly nonlinear photonic crystal fiber is presented. Up to 30 ns time delay could be achieved by using 70-m long fiber under the pump power 101 mW. The figure of merit (FOM) of this kind fiber is 0.0035 dB/mW/m, which is about 4.8 times larger than the single mode fiber (SMF).

•Apr 1, 2010•0 citations

Passive stabilization of slow light delays in SBS-based system using a Faraday rotator mirror

Mark Bashkansky, D. R. Walker, ARMEN M. GULIAN +2 more

Stimulated Brillouin scattering in non-polarization maintaining single mode fibers is often used for slow light. Due to polarization sensitivity in the fibers the delay may vary as a function of time. We demonstrate a technique that can be used to stabilize the delay.

Frontiers in Optics•Jan 1, 2008•0 citations

Time delay enhancement in stimulated-Brillouin-scattering-based slow-light systems

Thomas Schneider, Markus Junker, Kai-Uwe Lauterbach

We show a simple method of time delay enhancement in slow-light systems based on the effect of stimulated Brillouin scattering. The method is based on the reduction of the absolute Brillouin gain by a loss produced by an additional pump laser. With this method we achieved pulse delays of nearly 100 ns in a standard single-mode fiber. In the presented approach the delay or acceleration of optical signals is decoupled from their amplification or attenuation, which allows the adaptation of the pulse amplitudes to the given application.

Optics Letters•Jan 10, 2007•44 citations
The manipulation of the group velocity of optical signals (slow and fast light) has many possible applications in telecommunications, sensing, nonlinear optics, and so on. The exploitation of the effect of stimulated Brillouin scattering (SBS) is of special interest for the alteration of the group velocity in optical fibers, since it just requires standard telecom equipment and low-to-moderate optical power. However, each delay in one single, low-gain SBS-based slow-light system is accompanied by a pulse broadening. This is a result of the inherent Kramers–Kronig relations among the gain, the phase change, and the accompanied group velocity. For an ideal flat gain, the phase change is nonideal, and for an ideal phase change the gain curve leads to a broadening. Furthermore, if the gain bandwidth is adapted to the signal by broadening, the delay will be reduced. Thus the signal broadening can be reduced by several methods for one single low-gain slow-light system, but it cannot be zero. Here, we will show how a zero-broadening SBS-based slow light can be achieved with several methods. The basic idea is a reshaping of the original pulse in a second stage by saturation of the SBS system, or by the superposition of two gains. As will be shown, all of these systems show an almost ideal overall gain and phase function over the bandwidth of the pulses. Thus, SBS-based slow light with a delay bandwidth product of 1 bit and zero distortion is possible.
Slow-light delay via stimulated Brillouin scattering (SBS) in optical fibers is usually achieved with delay-dependent amplification that degrades system performance. To address this problem, we propose a SBS slow-light method that makes use of two widely separated anti-Stokes absorption resonances, and achieve nearly transparent slow light in an optical fiber. We demonstrate the method in a highly nonlinear optical fiber, and achieve a slow-light bandwidth of approximately 150 MHz and a relative of delay of approximately 0.3 for approximately 9-ns pulses with a signal attenuation of approximately 4.8 dB.
Stimulated Brillouin scattering (SBS) has become a favorable underlying mechanism in many demonstrations of all-optical variable delay in standard fibers, often referred to as slow and fast light. Over 100 journal papers and numerous conference sessions have been dedicated to SBS slow light since 2005. In this paper, recent research in this area is reviewed. Following a short introduction to the topic, several specific trends in contemporary work are highlighted: the optimization of the SBS pump spectrum for extended slow light delay and reduced pulse distortion; SBS slow light demonstrations in nonstandard, highly nonlinear fibers; applications of SBS slow light to the delay of analog waveforms; and the role of polarization. Finally, a brief concluding perspective is provided.
We show a simple method of time delay enhancement in slow-light systems based on the effect of stimulated Brillouin scattering. The method is based on the reduction of the absolute Brillouin gain by a loss produced by an additional pump laser. With this method we achieved pulse delays of nearly 100 ns in a standard single-mode fiber. In the presented approach the delay or acceleration of optical signals is decoupled from their amplification or attenuation, which allows the adaptation of the pulse amplitudes to the given application.