The standard mathematical formalism of cavity QED leads us to consider photons as excitations of a quantum harmonic oscillator. Although it is one of the most familiar problems of quantum mechanics, some aspects of the quantum harmonic oscillator remain difficult to visualize, particularly in the rather abstract context of an electromagnetic field. Recently, modern microfabrication and refrigeration techniques have begun to allow the creation of nanoscale mechanical oscillators which can be cooled close to the quantum regime. Despite the extreme physical differences between an electromagnetic cavity and a nanomechanical resonator, both systems may be approximated by the same quantum harmonic oscillator model. However, the conceptual consequences of quantum behavior, and the challenges to physical intuition, are quite different in the two cases. Taking a mechanical point of view therefore allows fresh insight into the quantum harmonic oscillator problem. To illustrate the connection and how it may aid our understanding of light, the mathematical parallelism between an electromagnetic cavity and a mechanical resonator is demonstrated. Current nanomechanics experiments are discussed, and some possible quantum measurements are introduced. Finally, the discrepancies between the predictions of quantum mechanics and our experience of classical vibrating beams are considered, with an emphasis on how nanomechanics may be able to offer a new perspective on the nature of photons.
The standard mathematical formalism of cavity QED leads us to consider photons as excitations of a quantum harmonic oscillator. Although it is one of the most familiar problems of quantum mechanics, some aspects of the quantum harmonic oscillator remain difficult to visualize, particularly in the rather abstract context of an electromagnetic field. Recently, modern microfabrication and refrigeration techniques have begun to allow the creation of nanoscale mechanical oscillators which can be cooled close to the quantum regime. Despite the extreme physical differences between an electromagnetic cavity and a nanomechanical resonator, both systems may be approximated by the same quantum harmonic oscillator model. However, the conceptual consequences of quantum behavior, and the challenges to physical intuition, are quite different in the two cases. Taking a mechanical point of view therefore allows fresh insight into the quantum harmonic oscillator problem. To illustrate the connection and how it may aid our understanding of light, the mathematical parallelism between an electromagnetic cavity and a mechanical resonator is demonstrated. Current nanomechanics experiments are discussed, and some possible quantum measurements are introduced. Finally, the discrepancies between the predictions of quantum mechanics and our experience of classical vibrating beams are considered, with an emphasis on how nanomechanics may be able to offer a new perspective on the nature of photons.
The coupling of nanomechanical resonators to controllable quantum systems represents a growing and promising area of research. Recent advances in this field have brought to astonishing results, such as the initialization of a mechanical resonator into its quantum ground state and even the preparation of non-classical coherent states of motion. These achievements open up appealing scenarios to quantum information technologies and to the exploration of the quantum-classical boundary. From an application perspective, such quantum-mechanical hybrid systems provide a versatile and attractive tool for a variety of precision measurements, like ultra-sensitive detection of force, mass, and displacement. \n \nQuantum control over a mechanical resonator, or, conversely, the prospect of using resonator's motion for probing quantum states, both involve some tight requirements. First of all, the interaction between the mechanics and its quantum partner has to be large on the scale of the decoherence rates of the coupled systems. In most cases, the coupling mechanism has to be activated by engineering the resonator with electrodes, magnets, or mirrors, or by using tailored laser fields. For this reason, the search for a strong coupling typically competes with the requirement of overcoming decoherence effects. In addition, for quantum effects to be observable, strong coupling has to be accompanied by the preparation of zero entropy initial states, for instance by cooling the resonator into its ground state of motion. \n \nThe motivation pursued by this thesis is to contribute to the inspiring field of hybrid systems by walking through each of the aforementioned directions. We in fact demonstrate a promising system in which optically active quantum dots, embedded in fully self-assembled core-shell nanowires, are coupled to the nanowire motion. Mechanical vibrations of the nanowire modulate the quantum dot emission energy over a broad range exceeding 14 meV, by means of deformation potential coupling. In our system, therefore, both the coupling mechanism and the quantum states themselves are intrinsic to the resonator's structure. Besides revealing unusually strong, such a built-in opto-mechanical interaction produces a hybrid system whose inherent coherence is unspoiled by any functionalization or external field and whose fabrication is simpler than top-down techniques. \n \nWe further demonstrate the use of a quantum point contact as a displacement transducer to measure and control the low-temperature thermal motion of a nearby micromechanical cantilever. We show that by including the QPC in a suitable feedback loop, we are able to cool the cantilever's fundamental mechanical mode down to the level of the measurement noise, achieving a squashing of the QPC noise at high gain. Due to its off-board design, our system is particularly versatile and suitable to force-sensing applications. Since the QPC transducer is sensitive to local modifications of the nearby electric field, our approach is in principle compatible with any nanoscale resonator, without requiring any functionalization to activate the coupling. By improving the performance of the QPC as a one-dimensional conductor and the cantilever-QPC capacitive coupling, our system has the potential to achieve quantum-limited displacement resolution and ground state cooling. We then report on some ongoing attempts to overcome the current limitations of our system and couple mechanical motion to different mesoscopic transport devices. \n \nWe remark that our demonstration of an as-grown quantum-dot-in-nanowire hybrid system opens up bright prospects on future experiments, as also testified by the very recent ferment of the scientific community around this topic. We find that the opto-mechanical coupling rate is not far from the nanowire mechanical frequency. This fact makes our system particularly promising for the quantum non-demolition readout of a quantum dot state through a measurement of the nanowire position. On the other hand, we show that the coupling can be further optimized, and the nanowire mechanical heating rate reduced, thus disclosing the captivating perspective of using quantum dots to probe and control the mechanical state of a nanowire. In this context, it would be important to investigate a possible spin-oscillator coupling in our system, given the long coherence time offered by a spin state in a quantum dot. The wide range of control over the quantum dots emission energy and the ability to tune two neighboring dots into resonance pave the way to mechanically induced emitter-emitter coupling. In addition, our monolithic opto-mechanical system constitutes a good candidate for recent proposals of a tripartite hybrid system, which would integrate an optical cavity, a quantum two-level system and a mechanical resonator. The intrinsically strong coupling between the quantum dots and the nanowire motion would enhance the interaction between the mechanics and the cavity field, leading for instance to efficient cooling of the resonator to the ground state. Finally, the quantum dot sensitivity to the nanowire resonant vibration could also support the use of our system as an integrated force probe or as a nanomechanical mass sensor. In other words, the results reported in this dissertation constitute not only a relevant proof-of-principle, moreover they open up intriguing challenges for future research.
Why are classical theories often sufficient to describe the physics of our world even though everything around us is entirely composed of microscopic quantum systems? The boundary between these two fundamentally dissimilar theories remains an unsolved problem in modern physics. Position measurements of small objects allow us to probe the area where the classical approximation breaks down. In quantum mechanics, Heisenbergâ s uncertainty principle dictates that any measurement of the position must be accompanied by measurement induced back-action---in this case manifested as an uncertainty in the momentum. In recent years, cavity optomechanics has become a powerful tool to perform precise position measurements and investigate their fundamental limitations. The utilization of optical micro-cavities greatly enhances the interaction between light and state-of-the-art nanomechanical oscillators. Therefore, quantum mechanical phenomena have been successfully observed in systems far beyond the microscopic world. In such a cavity optomechanical system, the fluctuations in the position of the oscillator are transduced onto the phase of the light, while fluctuations in the amplitude of the light disturb the momentum of the oscillator during the measurement. As a consequence, correlations are established between the amplitude and phase quadrature of the probe light. However, so far, observation of quantum effects has been limited exclusively to cryogenic experiments, and access to the quantum regime at room temperature has remained an elusive goal because the overwhelming amount of thermal motion masks the weak quantum effects. This thesis describes the engineering of a high-performance cavity optomechanical device and presents experimental results showing, for the first time, the broadband effects of quantum back-action at room temperature. The device strongly couples mechanical and optical modes of exceptionally high quality factors to provide a measurement sensitivity ∼104 times below the requirement to resolve the zero-point fluctuations of the mechanical oscillator. The quantum back-action is then observed through the correlations created between the probe light and the motion of the nanomechanical oscillator. A so-called â variational measurementâ , which detects the transmitted light in a homodyne detector tuned close to the amplitude quadrature, resolves the quantum noise due to these correlations at the level of 10\% of the thermal noise over more than an octave of Fourier frequencies around mechanical resonance. Moreover, building on this result, an additional experiment demonstrates the ability to achieve quantum enhanced metrology. In this case, the generated quantum correlations are used to cancel quantum noise in the measurement record, which then leads to an improved relative signal-to-noise ratio in measurements of an external force. In conclusion, the successful observation of broadband quantum behavior on a macroscopic object at room temperature is an important milestone in the field of cavity optomechanics. Specifically, this result heralds the rise of optomechanical systems as a platform for quantum physics at room temperature and shows promise for generation of ponderomotive squeezing in room-temperature interferometers.
Experiments over the past years have demonstrated that it is possible to bring nanomechanical resonators and superconducting qubits close to the quantum regime and to measure their properties with an accuracy close to the Heisenberg uncertainty limit. Therefore, it is just a question of time before we will routinely see true quantum effects in nanomechanical systems. One of the hallmarks of quantum mechanics is the existence of entangled states. We propose a realistic scenario making it possible to detect entanglement of a mechanical resonator and a qubit in a nanoelectromechanical setup. The detection scheme involves only standard current and noise measurements of an atomic point contact coupled to an oscillator and a qubit. This setup could allow for the first observation of entanglement between a continuous and a discrete quantum system in the solid state.
Decoherence is an essential mechanism that defines the boundary between classical and quantum behaviours, while imposing technological bounds for quantum devices. Little is known about quantum coherence of mechanical systems, as opposed to electromagnetic degrees of freedom. But decoherence can also be thought of in a purely classical context, as the loss of phase coherence in the classical phase space. Indeed the bridge between quantum and classical physics is under intense investigation, using, in particular, classical nanomechanical analogues of quantum phenomena. In the present work, by separating pure dephasing from dissipation, we quantitatively model the classical decoherence of a mechanical resonator: through the experimental control of frequency fluctuations, we engineer artificial dephasing. Building on the fruitful analogy introduced between spins/quantum bits and nanomechanical modes, we report on the methods available to define pure dephasing in these systems, while demonstrating the intrinsic almost-ideal properties of silicon nitride beams. These experimental and theoretical results, at the boundary between classical nanomechanics and quantum information fields, are prerequisite in the understanding of decoherence processes in mechanical devices, both classical and quantum. Introduction and background. Frequency noise in nano-mechanical systems (NEMS) is a topic intensely studied these last years, for both fundamental and practical reasons (references [ 13 – 23 ] of the paper): the frequency fluctuations can have an intrinsic origin linked to essential material properties, but they also limit the resolution of actual devices used as sensors. Recently, the Delft group proposed to analyze the effects of this noise on the dynamics of NEMS within a framework analogous to one of Nuclear Magnetic Resonance (NMR), or quantum bits (2014 Nat. Commun. 5 5819 ). Main results. Building on the analogy, in this paper we engineer frequency noise to study its impact on nano-resonators. We present a model experiment, with the full theory enabling the fit of data without free parameters. The effect of frequency noise is analogous to 'pure dephasing' in quantum bits, even though the device is a classical harmonic oscillator. As such, the analogy is very informative and interrogates the crossover between classical and quantum physics; it enters the class of 'classical analogues of quantum phenomena' studied in recent model nano-mechanical experiments (e.g. reference [ 10 ]). Wider implications. This is a broad topic that is of interest to many areas of science, far beyond NEMS and NMR. For the focused audience, we present the methods to quantitatively describe this 'classical pure dephasing' of NEMS, which can be used e.g. with carbon-based systems. As a conclusion, our results are a new tool for the understanding of classical decoherence in nano-resonators, and a pre-requisite for future experiments on quantum NEMS.
In this chapter we introduce the basic concept of a quantum harmonic oscillator, and how such oscillators couple to their environment. Our purpose is not to exhaustively cover all aspects of such systems, but rather to provide the foundation material required to treat the quantum mechanics of mechanical resonators and optical cavities – and their interactions – in later chapters. The quantum fluctuation-dissipation theorem is derived relating the power spectral density of environmental forcing of an oscillator to the rate of energy decay from the oscillator into the environment. This is in direct analogy to the familiar fluctuation-dissipation theorem in classical physics. However, in contrast to the classical case, the noncommutation of position and momentum introduces an asymmetry between the positive and negative frequency components of the power spectrum. This provides a natural definition for the effective temperature of the oscillator. The quantum Langevin approach is introduced as a method to model the open dynamics of quantum systems, both with and without recourse to the rotating wave approximation.
Harmonic oscillators might be one of the most fundamental entities described by physics. Yet they stay relevant in recent research. The topological properties associated with exceptional points that can occur when two modes interact have generated much interest in recent years. Harmonic oscillators are also at the heart of new quantum technological applications: the long lifetime of high-Q resonators make them advantageous as quantum memories, and they are employed for narrowband processing of quantum signals, as in Josephson parametric amplifiers. The goal of this thesis is to explore different fundamental regimes of two coupled harmonic oscillators using cavity optomechanics as the experimen- tal platform. With consistent progress in attaining ever increasing Q factors, mechanical and electromagnetic resonators realize near-ideal harmonic oscillators. By parametrically modulating the nonlinear optomechanical interaction between them, an effective linear coupling is achieved, which is tunable in strength and in the relative frequencies of the two modes. Thus cavity optomechanics provides a framework with excellent control over system parameters for the study of two coupled harmonic modes. The specific optomechanical implementation employed are superconducting circuits with the vibrating top plate of a capacitor as the mechanical element. Multimode optomechanical circuits are realized, with two microwave modes interacting with one or two mechanical oscillators. The supplementary modes serve either as intermediaries in the relation of the two modes of interest, or as auxiliaries used to control a parameter of the system. Three main experimental results are achieved. First, an auxiliary microwave mode allows the engineering of the effective dissipation rate of a mechanical oscillator. The latter then acts as a reservoir for the main microwave mode with which it interacts. The microwave mode susceptibility can be tuned, resulting in an instability akin to that of a maser and in resonant amplification of incoming microwave signals with an added noise close to the quantum minimum. Second, we study the conditions for a nonreciprocal interaction between two microwave modes, when the information flows in one direction but not in the other. The two modes interact through two mechanical oscillators, leading to frequency conversion between the two cavities. Dissipation in the mechanical modes is essential to the scheme in two ways: it provides a reciprocal phase necessary for the interference and eliminates the unwanted signals. Third, level attraction between a microwave and a mechanical mode is demonstrated, where the eigenfrequencies of the system are drawn closer as the result of interaction, rather distancing themselves as in the more usual case of level repulsion. The phenomenon is theoretically connected to exceptional points, and a general classification of the possible regimes of interaction between two harmonic modes is exposed, including level repulsion and attraction as special cases.