Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

Microwave-Induced Vortex Motion in Long Josephson Junctions

Katsuyoshi Hamasaki, Keiji Yoshida, Fujio Irie, Keiji Enpuku, Masaaki Inoue

Published Jan 1, 1980• 7 citations
Publisher

Abstract

Experimental and theoretical studies are made of the effect of a microwave on dc current-voltage characteristics of long Josephson junctions. In the case of zero external dc current, dc voltages were observed when the microwave was applied to the junctions. By comparing the observed magnetic-field and microwave-power dependences with theoretical results, it is concluded that these dc voltages resulted from vortex motion which was induced by the applied microwave. When the junctions were in a flux-flow state caused by the external current, a good agreement between theory and experiment concerning the microwave-power and magnetic-field dependences of Shapiro steps demonstrates that an almost ideal traveling-wave type coupling between the applied microwave and a moving vortex array took place in the long Josephson junctions.

DOI
10.1143/jjap.19.191

Related papers

Capacitance measurement of Josephson tunnel junctions with microwave-induced dc quasiparticle tunneling currents

K. Hamasaki, Keiji Yoshida, F. Irie +1 more

The microwave response of the dc quasiparticle tunneling current in Josephson tunnel junctions, where the Josephson current is suppressed by an external magnetic field, has been studied quantitatively in order to clarify its characteristics as a probe for the measurement of the junction capacitance. Extensive experiments for both small and long junctions are carried out for distinguishing between microwave behaviors of lumped and distributed constant junctions. It is shown that the observed voltage dependence of the dc quasiparticle tunneling current modified by an applied rf field is in good agreement with a theoretical result which takes into account the influence of the microwave circuit connected to the junction. The comparison between theory and experiment gives the magnitude of the internal rf field in the junction. Together with the applied rf field, this internal rf field leads to the junction rf impedance which is dominated by the junction capacitance in our experimental condition. In the case of lumped junctions, this experimental rf impedance is in reasonable agreement with the theoretical one with the junction capacitance estimated from the Fiske step of the distributed junction fabricated on the same substrate; the obtained ratio of the experimental impedance to the theoretical one is approximately 0.6–1.7. In the case of distributed junctions, however, experimental values of their characteristic impedances are approximately 0.2–0.3 of theoretical values calculated by assuming the one-dimensional junction model and taking account of the standing-wave effect in the junction.

Journal of Applied Physics•May 1, 1982•3 citations

Microwave oscillator using arrays of long Josephson junctions

S. Pagano, R. Monaco, G. Costabile

The authors report on measurements performed on integrated superconducting devices based on arrays of long Josephson tunnel junctions operating in the resonant fluxon oscillation regime (i.e. biased on the zero field steps). The electromagnetic coupling among the junctions causes a mutual phase-locking of the fluxon oscillations with a corresponding increase of the emitted power and a decrease of the signal linewidth. This phase-locked state can be controlled by means of an external DC bias current and magnetic field. The effect of the generated microwave signal has been observed on a small Josephson tunnel junction coupled to the array via a microstrip transmission line. The feasibility of the reported devices as local oscillators in an integrated microwave Josephson receiver is discussed.>

IEEE Transactions on Magnetics•Mar 1, 1989•46 citations

Microwave response of long intrinsic Josephson junctions fabricated on Bi-2212 single crystals

Takashi Tachiki, Takashi Uchida

The microwave response properties of Bi 2 Sr 2 CaCu 2 O 8+x long intrinsic Josephson junctions have been experimentally and theoretically investigated. We fabricated a mesa structure consisting of 14 junctions, 50 μm long and 4 μm wide, and observed the microwave-induced steps in the I-V characteristics under irradiation with microwaves in the range 5–8 GHz. The step voltages were proportional to the square root of the microwave power, implying that the steps were produced by the motion of fluxons created by the microwaves. The Josephson frequency corresponding to the maximum step voltage was estimated to be 570 GHz. The step voltage decreased with increasing temperature, which can be explained by the decrease of the Swihart velocity. We performed a numerical simulation using coupled sine-Gordon equations and obtained a power dependence of the step voltage similar to the experimental result, and demonstrated standing waves of electric fields with in-phase plasma oscillation in all the junctions. These facts suggest that the steps observed in the experiment were produced by plasma resonance excited by the external microwaves.

Journal of Physics Conference Series•Feb 1, 2008•1 citation

The influence of magnetic vortices motion on the inverse ac Josephson effect in asymmetric arrays

Boris Chesca, Marat B Gaifullin, Daniel John +3 more

We report on the influence a preferential magnetic vortices motion has on the magnitude of the inverse ac Josephson effect (the appearance of dc current Shapiro steps) and the coherent operation of asymmetrical parallel arrays of YBa2Cu3O7−δ Josephson junctions (JJ) irradiated with microwave (MW) radiation in the presence of an applied magnetic field B. The preferential direction of motion of the Josephson vortices is due to the asymmetry-induced ratchet effect and has a dramatic impact: for a particular positive dc bias current I when the flux-flow is robust multiple pronounced Shapiro-steps are observed consistent with a coherent operation of the array. This suggests an efficient emission/detection of MW in related applications. In contrast, when we reverse the direction of I, the flux-flow is reduced and the Shapiro steps are strongly suppressed due to a highly incoherent operation that suggests an inefficient emission/detection of MW. Remarkably, by changing B slightly, the situation is reversed: Shapiro steps are now suppressed for a positive I while well pronounced for a reverse current −I. Our results suggest that a preferential vortex-flow has a very significant impact on the coherent MW operation of superconducting devices consisting of either multiple JJs or an asymmetrically biased single long JJ. This is particularly relevant in the case of flux-flow oscillators for sub-terahertz integrated-receivers, flux-driven Josephson (travelling-wave) parametric amplifiers, or on-chip superconducting MW generators, which usually operate at bias currents in the Shapiro step region.

arXiv:2209.08998•Applied Physics Letters•Oct 17, 2022•1 citation

Microwave radiation from long in-line Josephson tunnel junctions

Sergio Nicola Erne, A. Ferrigno, Thomas F. Finnegan +1 more

The frequency and power of the microwave radiation detected from long in-line Josephson tunnel junctions when dc biased on low order singularities or self-induced steps have been measured as a function of bias current and externally applied magnetic field. The preliminary experimental results reported here show that the magnetic tuning of the emitted radiation may be considerably greater than that obtained in similar junctions of overlap geometry.

IEEE Transactions on Magnetics•May 1, 1983•1 citation

Microwave-Induced dc Voltages in BaPb1-xBixO3 Bicrystal Josephson Junctions

Hiroyuki Fuke, Kunihiko Hayashi, Yukio Kanke +1 more

We have fabricated an artificial BaPb1- x Bi x O3 grain boundary tunnel junction on a SrTiO3 bicrystal substrate. Current-voltage characteristics exhibit supercurrent and quasi-particle tunneling which is commonly observed for superconductor-insulator-superconductor (SIS) type junctions. A Shapiro step is observed for a junction with a large area under microwave radiation. On the other hand, microwave-induced dc voltages at zero bias current are observed for a narrow junction. This dependence on the junction width indicates that generation of the microwave-induced voltages is related to normal resistance or capacitance of a junction.

Japanese Journal of Applied Physics•Sep 1, 1995•2 citations
Experimental and theoretical studies are made of the effect of a microwave on dc current-voltage characteristics of long Josephson junctions. In the case of zero external dc current, dc voltages were observed when the microwave was applied to the junctions. By comparing the observed magnetic-field and microwave-power dependences with theoretical results, it is concluded that these dc voltages resulted from vortex motion which was induced by the applied microwave. When the junctions were in a flux-flow state caused by the external current, a good agreement between theory and experiment concerning the microwave-power and magnetic-field dependences of Shapiro steps demonstrates that an almost ideal traveling-wave type coupling between the applied microwave and a moving vortex array took place in the long Josephson junctions.
The microwave response of the dc quasiparticle tunneling current in Josephson tunnel junctions, where the Josephson current is suppressed by an external magnetic field, has been studied quantitatively in order to clarify its characteristics as a probe for the measurement of the junction capacitance. Extensive experiments for both small and long junctions are carried out for distinguishing between microwave behaviors of lumped and distributed constant junctions. It is shown that the observed voltage dependence of the dc quasiparticle tunneling current modified by an applied rf field is in good agreement with a theoretical result which takes into account the influence of the microwave circuit connected to the junction. The comparison between theory and experiment gives the magnitude of the internal rf field in the junction. Together with the applied rf field, this internal rf field leads to the junction rf impedance which is dominated by the junction capacitance in our experimental condition. In the case of lumped junctions, this experimental rf impedance is in reasonable agreement with the theoretical one with the junction capacitance estimated from the Fiske step of the distributed junction fabricated on the same substrate; the obtained ratio of the experimental impedance to the theoretical one is approximately 0.6–1.7. In the case of distributed junctions, however, experimental values of their characteristic impedances are approximately 0.2–0.3 of theoretical values calculated by assuming the one-dimensional junction model and taking account of the standing-wave effect in the junction.
The authors report on measurements performed on integrated superconducting devices based on arrays of long Josephson tunnel junctions operating in the resonant fluxon oscillation regime (i.e. biased on the zero field steps). The electromagnetic coupling among the junctions causes a mutual phase-locking of the fluxon oscillations with a corresponding increase of the emitted power and a decrease of the signal linewidth. This phase-locked state can be controlled by means of an external DC bias current and magnetic field. The effect of the generated microwave signal has been observed on a small Josephson tunnel junction coupled to the array via a microstrip transmission line. The feasibility of the reported devices as local oscillators in an integrated microwave Josephson receiver is discussed.>
The microwave response properties of Bi 2 Sr 2 CaCu 2 O 8+x long intrinsic Josephson junctions have been experimentally and theoretically investigated. We fabricated a mesa structure consisting of 14 junctions, 50 μm long and 4 μm wide, and observed the microwave-induced steps in the I-V characteristics under irradiation with microwaves in the range 5–8 GHz. The step voltages were proportional to the square root of the microwave power, implying that the steps were produced by the motion of fluxons created by the microwaves. The Josephson frequency corresponding to the maximum step voltage was estimated to be 570 GHz. The step voltage decreased with increasing temperature, which can be explained by the decrease of the Swihart velocity. We performed a numerical simulation using coupled sine-Gordon equations and obtained a power dependence of the step voltage similar to the experimental result, and demonstrated standing waves of electric fields with in-phase plasma oscillation in all the junctions. These facts suggest that the steps observed in the experiment were produced by plasma resonance excited by the external microwaves.
We report on the influence a preferential magnetic vortices motion has on the magnitude of the inverse ac Josephson effect (the appearance of dc current Shapiro steps) and the coherent operation of asymmetrical parallel arrays of YBa2Cu3O7−δ Josephson junctions (JJ) irradiated with microwave (MW) radiation in the presence of an applied magnetic field B. The preferential direction of motion of the Josephson vortices is due to the asymmetry-induced ratchet effect and has a dramatic impact: for a particular positive dc bias current I when the flux-flow is robust multiple pronounced Shapiro-steps are observed consistent with a coherent operation of the array. This suggests an efficient emission/detection of MW in related applications. In contrast, when we reverse the direction of I, the flux-flow is reduced and the Shapiro steps are strongly suppressed due to a highly incoherent operation that suggests an inefficient emission/detection of MW. Remarkably, by changing B slightly, the situation is reversed: Shapiro steps are now suppressed for a positive I while well pronounced for a reverse current −I. Our results suggest that a preferential vortex-flow has a very significant impact on the coherent MW operation of superconducting devices consisting of either multiple JJs or an asymmetrically biased single long JJ. This is particularly relevant in the case of flux-flow oscillators for sub-terahertz integrated-receivers, flux-driven Josephson (travelling-wave) parametric amplifiers, or on-chip superconducting MW generators, which usually operate at bias currents in the Shapiro step region.
We have fabricated an artificial BaPb1- x Bi x O3 grain boundary tunnel junction on a SrTiO3 bicrystal substrate. Current-voltage characteristics exhibit supercurrent and quasi-particle tunneling which is commonly observed for superconductor-insulator-superconductor (SIS) type junctions. A Shapiro step is observed for a junction with a large area under microwave radiation. On the other hand, microwave-induced dc voltages at zero bias current are observed for a narrow junction. This dependence on the junction width indicates that generation of the microwave-induced voltages is related to normal resistance or capacitance of a junction.