Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE

Design issues in continuously programmed coherent transient processors

K.D. Merkel, Jianyu Zhao, Kevin S. Repasky, William Randall Babbitt

Published Nov 22, 1999• 1 citation
Publisher

Abstract

The design issues for the technique of continuously programming a coherent transient spatial-spectral optical signal processor are discussed. The repeated application of two spatially distinct optical programming pulses to a non- persistent hole-burning material writes an accumulated, spatial-spectral population grating with low intensity optical pulses as compared to single shot programing. An optical data stream is introduced on a third beam, resulting in a processor output signal spatially distinct from all the input pulses. Programming and processing take place simultaneously, asynchronously and continuously. For accumulated gratings, the frequency stability of the optical source is an important consideration. Assuming a sufficiently stable optical source, simulations show that an accumulated (and maintained) grating in steady state, for both storage of a true-time delay and/or pattern waveform, can be highly efficient using currently available materials, on the order of that predicted for a perfect photon-gated device. An experimental demonstration of the continuous programming concept for true time delays programmed with chirped pulses is presented, showing the accumulation of the grating with low area pulses over time until it reaches steady state, for times longer than the persistence of the material.

DOI
10.1117/12.370239

Related papers

Optical coherent transient continuously programmed continuous processor

K.D. Merkel, William Randall Babbitt

A novel technique for continuously programming an optical coherent transient spatial-spectral signal processor is proposed. The repeated application of two spatially distinct optical programming pulses to a nonpersistent hole-burning material writes an accumulated spatial-spectral population grating. An optical data stream is introduced on a third beam, resulting in a processor output signal that is spatially distinct from all the input pulses. Programming and processing take place simultaneously, asynchronously, and continuously. In the case of true-time delays, the efficiency that is achievable with currently available materials is of the order of that predicted for a perfect photon-gated device.

Optics Letters•Feb 1, 1999•15 citations

Accumulated programming of a complex spectral grating

K.D. Merkel, R. D. Peters, Peter B. Sellin +2 more

A complex spectral grating is accumulated by repeated application of a pair of low-power optical programming pulses to a short-term persistent inhomogeneously broadened transition in Tm:YAG at 4.5 K and then probed to investigate the buildup dynamics. The necessary frequency stability is obtained by locking a cw Ti:sapphire laser to a regenerating transient spectral hole in the same transition. Grating accumulation is demonstrated for both a periodic spectral grating, representing a true-time delay, and a complex spectral grating, permitting correlation-based pattern recognition. This work is a step toward demonstrating an optical coherent transient continuously programmed continuous processor.

Optics Letters•Nov 15, 2000•20 citations

Steady-state accumulated complex spectral gratings for correlation signal processing

Nathan L. Seldomridge, R.K. Mohan, William Randall Babbitt +1 more

Summary form only given. Complex spectral gratings, accumulated to nearly steady-state in a short-term persistent inhomogeneously broadened optical transition, have been demonstrated by repeated application of a pair of frequency stabilized and low power-optical pulses (i.e. continuous programming). Provided the grating is not saturated, it can perform continuous correlation of an amplitude and/or phase modulated optical waveform at multi-gigahertz rates with large time-bandwidth products. The present work demonstrates continuous programming of a complex spectral grating, representing a 30-bit pattern and 4 microsecond time delay, to and beyond steady state. Grating accumulation and maintenance is observed by applying a probe pulse (identical to the pattern) after each programming pulse pair. Each probe stimulates an optical coherent transient emitted signal that represents the correlation of the pattern and probe. The probe was non-destructive to the grating, and consequently did not interfere with programming. The frequency reference was a transient, regenerating spectral hole created by the optical carrier in the same inhomogeneously broadened transition.

Conference on Lasers and Electro-Optics•Jan 1, 2001•0 citations

Variable-time-delay optical coherent transient signal processing

K.D. Merkel, William Randall Babbitt, Ken E. Anderson +1 more

A technique is proposed and experimentally demonstrated that achieves simultaneous optical pattern waveform storage and programmable time delay for continuous real-time signal processing by use of optical coherent transient technology. We achieve variable-time-delay and broadband signal processing by frequency shifting of two chirped programming pulses, the chirp rate of one being twice that of the other, without using brief reference pulses and without changing the timing of the programming sequence. We demonstrate the technique experimentally in Tm(3+): YAG at 5 K for 40-MHz chirps by performing temporal signal convolution with true-time delays that vary over a 250-ns range.

Optics Letters•Oct 15, 1999•10 citations

Coherent transient continuous optical processor

William Randall Babbitt, John A Bell

After the absorption profile of an inhomogeneously broadened solid is programmed by two temporally modulated pulses (at least one encoded with a pattern), it can be gated to fix the ground-state spectral population distribution permanently. The subsequent illumination of the solid by an uninterrupted, temporally modulated optical beam results in a coherent transient output signal that represents the correlation of the signal with the stored pattern. Multiple patterns can be stored at different locations on the sample and accessed randomly, enabling fast reprogramming of the processor. A performance analysis of this optical signal processor predicts that real-time continuous processing is possible with a processor bandwidth that exceeds 5 GHz, a time-bandwidth product that exceeds 10(4), and a pattern storage density that exceeds 10(5) patterns per square centimeter.

Applied Optics•Mar 10, 1994•43 citations

Temporal dependence of coherent transient regenerated true-time delays on intensity of applied pulses

K.D. Merkel, William Randall Babbitt

Summary form only given. Accurate true-time delays are essential to correctly steer modern phased-array antennas. Optical coherent transient technology has the ability to store a variable true-time delay as a spatial-spectral holographic population grating in an inhomogeneously broadened absorber (IBA). Typically, two optical pulses program the delay. A third optical pulse or waveform applied to the IBA generates a delayed replica of itself. The delay is typically defined by /spl tau//sub 21/=t/sub 2/-t/sub 1/, the arrival time difference of the first two pulses. However, we find that this prediction for the delay of the emitted signal only holds for input optical pulse areas much less than pi. Experimental investigation and simulations were performed to observe the variation in arrival time of the output signal.

Conference on Lasers and Electro-Optics•Jan 1, 1998•0 citations
The design issues for the technique of continuously programming a coherent transient spatial-spectral optical signal processor are discussed. The repeated application of two spatially distinct optical programming pulses to a non- persistent hole-burning material writes an accumulated, spatial-spectral population grating with low intensity optical pulses as compared to single shot programing. An optical data stream is introduced on a third beam, resulting in a processor output signal spatially distinct from all the input pulses. Programming and processing take place simultaneously, asynchronously and continuously. For accumulated gratings, the frequency stability of the optical source is an important consideration. Assuming a sufficiently stable optical source, simulations show that an accumulated (and maintained) grating in steady state, for both storage of a true-time delay and/or pattern waveform, can be highly efficient using currently available materials, on the order of that predicted for a perfect photon-gated device. An experimental demonstration of the continuous programming concept for true time delays programmed with chirped pulses is presented, showing the accumulation of the grating with low area pulses over time until it reaches steady state, for times longer than the persistence of the material.
A novel technique for continuously programming an optical coherent transient spatial-spectral signal processor is proposed. The repeated application of two spatially distinct optical programming pulses to a nonpersistent hole-burning material writes an accumulated spatial-spectral population grating. An optical data stream is introduced on a third beam, resulting in a processor output signal that is spatially distinct from all the input pulses. Programming and processing take place simultaneously, asynchronously, and continuously. In the case of true-time delays, the efficiency that is achievable with currently available materials is of the order of that predicted for a perfect photon-gated device.
A complex spectral grating is accumulated by repeated application of a pair of low-power optical programming pulses to a short-term persistent inhomogeneously broadened transition in Tm:YAG at 4.5 K and then probed to investigate the buildup dynamics. The necessary frequency stability is obtained by locking a cw Ti:sapphire laser to a regenerating transient spectral hole in the same transition. Grating accumulation is demonstrated for both a periodic spectral grating, representing a true-time delay, and a complex spectral grating, permitting correlation-based pattern recognition. This work is a step toward demonstrating an optical coherent transient continuously programmed continuous processor.
Summary form only given. Complex spectral gratings, accumulated to nearly steady-state in a short-term persistent inhomogeneously broadened optical transition, have been demonstrated by repeated application of a pair of frequency stabilized and low power-optical pulses (i.e. continuous programming). Provided the grating is not saturated, it can perform continuous correlation of an amplitude and/or phase modulated optical waveform at multi-gigahertz rates with large time-bandwidth products. The present work demonstrates continuous programming of a complex spectral grating, representing a 30-bit pattern and 4 microsecond time delay, to and beyond steady state. Grating accumulation and maintenance is observed by applying a probe pulse (identical to the pattern) after each programming pulse pair. Each probe stimulates an optical coherent transient emitted signal that represents the correlation of the pattern and probe. The probe was non-destructive to the grating, and consequently did not interfere with programming. The frequency reference was a transient, regenerating spectral hole created by the optical carrier in the same inhomogeneously broadened transition.
A technique is proposed and experimentally demonstrated that achieves simultaneous optical pattern waveform storage and programmable time delay for continuous real-time signal processing by use of optical coherent transient technology. We achieve variable-time-delay and broadband signal processing by frequency shifting of two chirped programming pulses, the chirp rate of one being twice that of the other, without using brief reference pulses and without changing the timing of the programming sequence. We demonstrate the technique experimentally in Tm(3+): YAG at 5 K for 40-MHz chirps by performing temporal signal convolution with true-time delays that vary over a 250-ns range.
After the absorption profile of an inhomogeneously broadened solid is programmed by two temporally modulated pulses (at least one encoded with a pattern), it can be gated to fix the ground-state spectral population distribution permanently. The subsequent illumination of the solid by an uninterrupted, temporally modulated optical beam results in a coherent transient output signal that represents the correlation of the signal with the stored pattern. Multiple patterns can be stored at different locations on the sample and accessed randomly, enabling fast reprogramming of the processor. A performance analysis of this optical signal processor predicts that real-time continuous processing is possible with a processor bandwidth that exceeds 5 GHz, a time-bandwidth product that exceeds 10(4), and a pattern storage density that exceeds 10(5) patterns per square centimeter.
Summary form only given. Accurate true-time delays are essential to correctly steer modern phased-array antennas. Optical coherent transient technology has the ability to store a variable true-time delay as a spatial-spectral holographic population grating in an inhomogeneously broadened absorber (IBA). Typically, two optical pulses program the delay. A third optical pulse or waveform applied to the IBA generates a delayed replica of itself. The delay is typically defined by /spl tau//sub 21/=t/sub 2/-t/sub 1/, the arrival time difference of the first two pulses. However, we find that this prediction for the delay of the emitted signal only holds for input optical pulse areas much less than pi. Experimental investigation and simulations were performed to observe the variation in arrival time of the output signal.