Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Variable-time-delay optical coherent transient signal processing

K.D. Merkel, William Randall Babbitt, Ken E. Anderson, Kelvin H. Wagner

Published Oct 15, 1999• 10 citations
Publisher

Abstract

A technique is proposed and experimentally demonstrated that achieves simultaneous optical pattern waveform storage and programmable time delay for continuous real-time signal processing by use of optical coherent transient technology. We achieve variable-time-delay and broadband signal processing by frequency shifting of two chirped programming pulses, the chirp rate of one being twice that of the other, without using brief reference pulses and without changing the timing of the programming sequence. We demonstrate the technique experimentally in Tm(3+): YAG at 5 K for 40-MHz chirps by performing temporal signal convolution with true-time delays that vary over a 250-ns range.

DOI
10.1364/ol.24.001386

Related papers

Signal correlator with programmable variable time delay based on optical coherent transients

K.D. Merkel, Zachary Cole, William Randall Babbitt

We have demonstrated a technique for programming variable time delays of a pattern waveform in a spectral grating. By frequency shifting the chirped programming pulses, correlation and delays over 450 ns were achieved without changing the programming sequence timing. The demonstrated bandwidth of 40 MHz only utilized /spl sim/0.2 % of the inhomogeneously broadened absorber's bandwidth. Thus, this technique has the potential to allow versatile, all-optical reception and processing of > 10 GHz signals in broadband array antenna beamforming.

IEEE Lasers and Electro-Optics Society Annual Meeting (LEOS)•Jan 20, 2003•0 citations

Coherent transient optical signal processing without brief pulses

K.D. Merkel, William Randall Babbitt

The temporal processing operations of convolution and correlation are demonstrated through optical coherent transient techniques, in which two long, low-intensity frequency-chirped pulses replace the single, brief reference pulse of a traditional three-pulse excitation sequence (brief pulse, pattern pulse, and data pulse). Here, a four-pulse excitation sequence is used (two frequency-chirped pulses, pattern pulse, and data pulse) in which the particular order and timing of the chirped pulses with respect to the other waveforms determine the processing operation. An experiment is performed with biphase-coded pattern and data pulses to demonstrate both the correlation and the convolution operations. A new atomic rephasing process that we call delayed rephasing is demonstrated.

Applied Optics•Jan 10, 1996•7 citations

Frequency-tuned continuous true-time delay by optical coherent transient technology

K.D. Merkel, William Randall Babbitt

Summary form only given. A practical device creating a variable RF true-time delay (TTD) for signals on an optical carrier would be useful in array antennas. An optical coherent transient (OCT)-TTD device could provide high-resolution delays (/spl sim/1 ps) over a wide range (/spl sim/1 /spl mu/s), for high bandwidth signals (/spl sim/10 GHz) with currently available materials. In previously demonstrated OCT-TTD devices, two optical pulses separated in time and space program a delay in an absorbing medium as a spatial-spectral grating on an inhomogeneously broadened transition (IBT). In the paper, we experimentally demonstrate widely tunable OCT-TTD of a continuous optical data stream without changing the timing between the programming pulses.

Conference on Lasers and Electro-Optics•Jan 20, 2003•0 citations

Design issues in continuously programmed coherent transient processors

K.D. Merkel, Jianyu Zhao, Kevin S. Repasky +1 more

The design issues for the technique of continuously programming a coherent transient spatial-spectral optical signal processor are discussed. The repeated application of two spatially distinct optical programming pulses to a non- persistent hole-burning material writes an accumulated, spatial-spectral population grating with low intensity optical pulses as compared to single shot programing. An optical data stream is introduced on a third beam, resulting in a processor output signal spatially distinct from all the input pulses. Programming and processing take place simultaneously, asynchronously and continuously. For accumulated gratings, the frequency stability of the optical source is an important consideration. Assuming a sufficiently stable optical source, simulations show that an accumulated (and maintained) grating in steady state, for both storage of a true-time delay and/or pattern waveform, can be highly efficient using currently available materials, on the order of that predicted for a perfect photon-gated device. An experimental demonstration of the continuous programming concept for true time delays programmed with chirped pulses is presented, showing the accumulation of the grating with low area pulses over time until it reaches steady state, for times longer than the persistence of the material.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 22, 1999•1 citation

Broadband true time-delay with optical coherent transients

Ming Tian, Randy R. Reibel, William Randall Babbitt

Summary form only given. When phased array antenna systems operate with broadband (multiple gigahertz) signals, true time-delay devices are needed to solve the problem of beam squint. Optical coherent transient technology, also known as spatial-spectral holography, offers a unique way of using the space and frequency dimensions of inhomogeneously broadened absorbers to handle thousands of high-resolution delays in a compact volume. We demonstrated broadband true-time delay in a Tm/sup 3+/:YAG crystal, which offers delays up to a microsecond on signals having several tens of GHz bandwidth with sub-picosecond delay resolution.

Conference on Lasers and Electro-Optics•Jan 1, 2001•0 citations

Temporal dependence of coherent transient regenerated true-time delays on intensity of applied pulses

K.D. Merkel, William Randall Babbitt

Summary form only given. Accurate true-time delays are essential to correctly steer modern phased-array antennas. Optical coherent transient technology has the ability to store a variable true-time delay as a spatial-spectral holographic population grating in an inhomogeneously broadened absorber (IBA). Typically, two optical pulses program the delay. A third optical pulse or waveform applied to the IBA generates a delayed replica of itself. The delay is typically defined by /spl tau//sub 21/=t/sub 2/-t/sub 1/, the arrival time difference of the first two pulses. However, we find that this prediction for the delay of the emitted signal only holds for input optical pulse areas much less than pi. Experimental investigation and simulations were performed to observe the variation in arrival time of the output signal.

Conference on Lasers and Electro-Optics•Jan 1, 1998•0 citations
A technique is proposed and experimentally demonstrated that achieves simultaneous optical pattern waveform storage and programmable time delay for continuous real-time signal processing by use of optical coherent transient technology. We achieve variable-time-delay and broadband signal processing by frequency shifting of two chirped programming pulses, the chirp rate of one being twice that of the other, without using brief reference pulses and without changing the timing of the programming sequence. We demonstrate the technique experimentally in Tm(3+): YAG at 5 K for 40-MHz chirps by performing temporal signal convolution with true-time delays that vary over a 250-ns range.
We have demonstrated a technique for programming variable time delays of a pattern waveform in a spectral grating. By frequency shifting the chirped programming pulses, correlation and delays over 450 ns were achieved without changing the programming sequence timing. The demonstrated bandwidth of 40 MHz only utilized /spl sim/0.2 % of the inhomogeneously broadened absorber's bandwidth. Thus, this technique has the potential to allow versatile, all-optical reception and processing of > 10 GHz signals in broadband array antenna beamforming.
The temporal processing operations of convolution and correlation are demonstrated through optical coherent transient techniques, in which two long, low-intensity frequency-chirped pulses replace the single, brief reference pulse of a traditional three-pulse excitation sequence (brief pulse, pattern pulse, and data pulse). Here, a four-pulse excitation sequence is used (two frequency-chirped pulses, pattern pulse, and data pulse) in which the particular order and timing of the chirped pulses with respect to the other waveforms determine the processing operation. An experiment is performed with biphase-coded pattern and data pulses to demonstrate both the correlation and the convolution operations. A new atomic rephasing process that we call delayed rephasing is demonstrated.
Summary form only given. A practical device creating a variable RF true-time delay (TTD) for signals on an optical carrier would be useful in array antennas. An optical coherent transient (OCT)-TTD device could provide high-resolution delays (/spl sim/1 ps) over a wide range (/spl sim/1 /spl mu/s), for high bandwidth signals (/spl sim/10 GHz) with currently available materials. In previously demonstrated OCT-TTD devices, two optical pulses separated in time and space program a delay in an absorbing medium as a spatial-spectral grating on an inhomogeneously broadened transition (IBT). In the paper, we experimentally demonstrate widely tunable OCT-TTD of a continuous optical data stream without changing the timing between the programming pulses.
The design issues for the technique of continuously programming a coherent transient spatial-spectral optical signal processor are discussed. The repeated application of two spatially distinct optical programming pulses to a non- persistent hole-burning material writes an accumulated, spatial-spectral population grating with low intensity optical pulses as compared to single shot programing. An optical data stream is introduced on a third beam, resulting in a processor output signal spatially distinct from all the input pulses. Programming and processing take place simultaneously, asynchronously and continuously. For accumulated gratings, the frequency stability of the optical source is an important consideration. Assuming a sufficiently stable optical source, simulations show that an accumulated (and maintained) grating in steady state, for both storage of a true-time delay and/or pattern waveform, can be highly efficient using currently available materials, on the order of that predicted for a perfect photon-gated device. An experimental demonstration of the continuous programming concept for true time delays programmed with chirped pulses is presented, showing the accumulation of the grating with low area pulses over time until it reaches steady state, for times longer than the persistence of the material.
Summary form only given. When phased array antenna systems operate with broadband (multiple gigahertz) signals, true time-delay devices are needed to solve the problem of beam squint. Optical coherent transient technology, also known as spatial-spectral holography, offers a unique way of using the space and frequency dimensions of inhomogeneously broadened absorbers to handle thousands of high-resolution delays in a compact volume. We demonstrated broadband true-time delay in a Tm/sup 3+/:YAG crystal, which offers delays up to a microsecond on signals having several tens of GHz bandwidth with sub-picosecond delay resolution.
Summary form only given. Accurate true-time delays are essential to correctly steer modern phased-array antennas. Optical coherent transient technology has the ability to store a variable true-time delay as a spatial-spectral holographic population grating in an inhomogeneously broadened absorber (IBA). Typically, two optical pulses program the delay. A third optical pulse or waveform applied to the IBA generates a delayed replica of itself. The delay is typically defined by /spl tau//sub 21/=t/sub 2/-t/sub 1/, the arrival time difference of the first two pulses. However, we find that this prediction for the delay of the emitted signal only holds for input optical pulse areas much less than pi. Experimental investigation and simulations were performed to observe the variation in arrival time of the output signal.