Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Journal of Applied Physics

A self-pumped high-temperature superconducting Josephson mixer: Modelling and measurement

Jia Du, J.C. Macfarlane, Colin M. Pegrum, Ting Zhang, Y. Cai, Y. Jay Guo

Published Mar 1, 2012• 10 citations
Publisher

Abstract

We have recently developed a high-temperature superconducting (HTS) Josephson self-pumped mixer with an on-chip heterodyne local oscillator. The device is based on HTS step-edge junction technology and a “resistive-superconducting quantum interference device” (RSQUID) configuration. The heterodyne local oscillator and mixer output are frequency-tunable from below 10 MHz to 5 GHz by a control current. The performance of the autonomous Josephson mixer–local oscillator has been experimentally evaluated in terms of the current-voltage characteristics, intermediate frequency (IF)-tunable bandwidth, operation range, linearity, bias current, and temperature dependence of the IF output (or mixer conversion efficiency). We find the results are in good overall agreement with numerical simulation.

DOI
10.1063/1.3691191

Related papers

Self-pumped HTS Josephson heterodyne tunable mixer

Jia Du, J.C. Macfarlane, Ting Zhang +2 more

Experimental evaluation of a high-temperature superconducting Josephson heterodyne mixer based on a 'resistive-SQUID' configuration is reported. The device consists of two YBa 2 Cu 3 O 7− x step-edge Josephson junctions connected via a small resistor in an otherwise superconducting loop. It has been previously shown to generate a heterodyne oscillation, which is frequency-tunable by a control current through the resistor. Under certain conditions, this device can operate as a frequency-tunable heterodyne mixer (down-converter) in the presence of an RF signal. In this paper, we describe the operation of the autonomous Josephson mixer–local oscillator device and present the experimental results on the mixer performances in terms of the junction current–voltage characteristics, the frequency tunability, linearity, and dynamic range as well as their temperature dependence for signal frequencies from 1 to 5 GHz.

Superconductor Science and Technology•Jan 10, 2012•16 citations

Frequency down-conversion in self-pumped HTS R-SQUID mixer

Jia Du, J.C. Macfarlane

A pair of high-temperature-superconducting (HTS) step-edge Josephson junctions connected in the ‘resistive-SQUID’ (R-SQUID) configuration has been previously shown to generate a heterodyne oscillation which is frequency-tunable by a control current across the resistor. A method is described which enables the R-SQUID to act both as the local oscillator (LO) and simultaneously as a radio- frequency down-converter element. For the first time the autonomous Josephson mixer–local oscillator device for signal frequencies between 1–5 GHz, over a temperature range of 20–70 K, is demonstrated.

Electronics Letters•Jun 22, 2011•16 citations

Characterizations of High-Temperature Superconducting Step-Edge Josephson Junction Mixer

Dan Dan Bai, Jia Du, Yu Sheng He

We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.

IEEE Transactions on Applied Superconductivity•Aug 15, 2014•6 citations

Simulation and Measurement of HTS Josephson Heterodyne Oscillator

J.C. Macfarlane, Jia Du, Richard Taylor +1 more

We report continuing investigations into practical applications of the AC Josephson effect as the basis for a voltage-tunable radio-frequency oscillator. We have previously demonstrated experimentally that useful power levels (10 s of nW) and linewidths of a few kHz can be achieved in the heterodyne output from a high-temperature-superconducting resistive SQUID (HTS-RSQUID) operating in the frequency range 1-50 MHz. Those results were achieved with 2-junction R-SQUIDs incorporating current-biased shunt resistors of a few micro-ohms. We have now modified the fabrication procedures, and adjusted the shunt resistors and bias current values so that higher frequencies can be achieved. The Josephson junctions are of step-edge type, rather than the bi-crystal type used in our earlier work. The step-edge technique permits much more flexibility in the geometrical lay-out and utilizes the more cost-effective single-crystal MgO substrates. In the present paper, we report numerical simulations and experimental measurements on these devices in the frequency range up to 2 GHz.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•17 citations

Simulation of HTS Josephson Mixers

Colin M. Pegrum, Ting Zhang, Jia Du +1 more

The Commonwealth Scientific and Industrial Research Organization has developed superconducting microwave monolithic integrated circuit (MMIC) mixers using step-edge Josephson junctions and on-chip filters, made from YBaCuO on MgO substrates. Integration into an MMIC results in a compact and efficiently coupled structure. These have been shown to have outstanding conversion efficiency, dynamic range, and linearity. We report here a range of simulations of this type of mixer. We have mainly used Josephson simulators and analyze the data in both the time and frequency domains. More recently, we have also used microwave simulators incorporating a novel Verilog-A Josephson junction model that we have developed. We have looked at the interactions of junction bias current, local oscillator power, and radio-frequency input power with conversion efficiency, dynamic range, and linearity. Good agreement is found overall with measurements.

IEEE Transactions on Applied Superconductivity•Feb 19, 2016•14 citations

MIXING EXPERIMENTS AT W-BAND USING HIGH-TC JOSEPHSON JUNCTIONS

Oliver Harnack, Marian Darula, S. Beuven +1 more

We report on the mixing properties of high-T, superconductor (HTS) Josephson junctions. Direct radiation and heterodyne mixing experiments in the frequency range 78 GHz-119 GHz have been performed using YBa 2Cu30 7_ x (YBCO) step-edge junctions (SEJ) and bicrystal junctions (BO) on LaA10 3 and MgO substrates. Under external radiation our junctions showed harmonic phase synchronization (Shapiro steps) up to 1.88 THz. Junctions with current voltage characteristics (PVC) dose to predictions of the resistively shunted junction model (RSJ) were mounted into a heterodyne mixing setup. Under the radiation of two monochromatic signals we obtained conversion efficiencies around -14 dB in the 11 GHz intermediate frequency (IF) band. In the fundamental mixing regime we observed response at IF at working temperatures up to 72K. We demonstrated the operation of HTS Josephson junctions in the self-mixing mode. The experimental results are in good agreement with simulations using the RSJ model.

•Jan 1, 1997•0 citations
We have recently developed a high-temperature superconducting (HTS) Josephson self-pumped mixer with an on-chip heterodyne local oscillator. The device is based on HTS step-edge junction technology and a “resistive-superconducting quantum interference device” (RSQUID) configuration. The heterodyne local oscillator and mixer output are frequency-tunable from below 10 MHz to 5 GHz by a control current. The performance of the autonomous Josephson mixer–local oscillator has been experimentally evaluated in terms of the current-voltage characteristics, intermediate frequency (IF)-tunable bandwidth, operation range, linearity, bias current, and temperature dependence of the IF output (or mixer conversion efficiency). We find the results are in good overall agreement with numerical simulation.
Experimental evaluation of a high-temperature superconducting Josephson heterodyne mixer based on a 'resistive-SQUID' configuration is reported. The device consists of two YBa 2 Cu 3 O 7− x step-edge Josephson junctions connected via a small resistor in an otherwise superconducting loop. It has been previously shown to generate a heterodyne oscillation, which is frequency-tunable by a control current through the resistor. Under certain conditions, this device can operate as a frequency-tunable heterodyne mixer (down-converter) in the presence of an RF signal. In this paper, we describe the operation of the autonomous Josephson mixer–local oscillator device and present the experimental results on the mixer performances in terms of the junction current–voltage characteristics, the frequency tunability, linearity, and dynamic range as well as their temperature dependence for signal frequencies from 1 to 5 GHz.
A pair of high-temperature-superconducting (HTS) step-edge Josephson junctions connected in the ‘resistive-SQUID’ (R-SQUID) configuration has been previously shown to generate a heterodyne oscillation which is frequency-tunable by a control current across the resistor. A method is described which enables the R-SQUID to act both as the local oscillator (LO) and simultaneously as a radio- frequency down-converter element. For the first time the autonomous Josephson mixer–local oscillator device for signal frequencies between 1–5 GHz, over a temperature range of 20–70 K, is demonstrated.
We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.
We report continuing investigations into practical applications of the AC Josephson effect as the basis for a voltage-tunable radio-frequency oscillator. We have previously demonstrated experimentally that useful power levels (10 s of nW) and linewidths of a few kHz can be achieved in the heterodyne output from a high-temperature-superconducting resistive SQUID (HTS-RSQUID) operating in the frequency range 1-50 MHz. Those results were achieved with 2-junction R-SQUIDs incorporating current-biased shunt resistors of a few micro-ohms. We have now modified the fabrication procedures, and adjusted the shunt resistors and bias current values so that higher frequencies can be achieved. The Josephson junctions are of step-edge type, rather than the bi-crystal type used in our earlier work. The step-edge technique permits much more flexibility in the geometrical lay-out and utilizes the more cost-effective single-crystal MgO substrates. In the present paper, we report numerical simulations and experimental measurements on these devices in the frequency range up to 2 GHz.
The Commonwealth Scientific and Industrial Research Organization has developed superconducting microwave monolithic integrated circuit (MMIC) mixers using step-edge Josephson junctions and on-chip filters, made from YBaCuO on MgO substrates. Integration into an MMIC results in a compact and efficiently coupled structure. These have been shown to have outstanding conversion efficiency, dynamic range, and linearity. We report here a range of simulations of this type of mixer. We have mainly used Josephson simulators and analyze the data in both the time and frequency domains. More recently, we have also used microwave simulators incorporating a novel Verilog-A Josephson junction model that we have developed. We have looked at the interactions of junction bias current, local oscillator power, and radio-frequency input power with conversion efficiency, dynamic range, and linearity. Good agreement is found overall with measurements.
We report on the mixing properties of high-T, superconductor (HTS) Josephson junctions. Direct radiation and heterodyne mixing experiments in the frequency range 78 GHz-119 GHz have been performed using YBa 2Cu30 7_ x (YBCO) step-edge junctions (SEJ) and bicrystal junctions (BO) on LaA10 3 and MgO substrates. Under external radiation our junctions showed harmonic phase synchronization (Shapiro steps) up to 1.88 THz. Junctions with current voltage characteristics (PVC) dose to predictions of the resistively shunted junction model (RSJ) were mounted into a heterodyne mixing setup. Under the radiation of two monochromatic signals we obtained conversion efficiencies around -14 dB in the 11 GHz intermediate frequency (IF) band. In the fundamental mixing regime we observed response at IF at working temperatures up to 72K. We demonstrated the operation of HTS Josephson junctions in the self-mixing mode. The experimental results are in good agreement with simulations using the RSJ model.