Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Conference on Precision Electromagnetic Measurements

Recent process with the SINIS turnstile

E. Mykkänen, A. Kemppinen, V. F. Maisi, M. Meschke, E. T. Mannila, Joonas T. Peltonen, Jukka P Pekola, Antti J. Manninen

Published Aug 1, 2014• 0 citations
Publisher

Abstract

We are developing the superconductor - insulator - normal metal - insulator - superconductor type turnstile (SINIS) as a candidate for the future quantum current standard of the ampere. We discuss the most notable error sources and future plans to overcome them.
DOI
10.1109/cpem.2014.6898495

Related papers

Development of the sinis turnstile for the quantum metrological triangle

A. Kemppinen, Sergey G. Kafanov, V. F. Maisi +11 more

We develop a quantum current standard based on the hybrid superconductor-insulator-normal-metal-insulator-superconductor (SINIS) structure in turnstile operation. We discuss the properties of the device and the relevant error sources. We also present a preliminary plan how to implement the device in a direct quantum metrological triangle experiment.

Conference on Precision Electromagnetic Measurements•Jun 1, 2010•5 citations

Radio-frequency transport of single electrons in superconductor-normal-metal tunnel junctions and the quantum metrological triangle

A. Kemppinen, V. F. Maisi, O.-P. Saira +17 more

We are developing a single-electron turnstile based on a nanoscale superconductor-insulator-normal-metal-insulator-superconductor (SINIS) structure. The goal is to obtain the frequency to current conversion I = ef with a relative uncertainty−8which would be sufficient for a quantum-based standard of electric current. Finally, the quantum current standard will be compared against the quantum standards of voltage and resistance via Ohm's law in the quantum metrological triangle experiment.

URSI General Assembly and Scientific Symposium•Aug 1, 2011•0 citations

Towards accurate charge transport with SINIS turnstile

V. F. Maisi, O.-P. Saira, A. Kemppinen +4 more

We discuss the current quantization obtainable in SINIS turnstiles. Various error processes, for example environmentally assisted and higher order tunneling as well as quasiparticle exitations in superconducting leads, may limit the achievable quantization. We argue that by careful design of the device, relative uncertainty of less than 10−7, required by metrological applications, is feasible. We also present a scheme for error detection of the turnstiles.

Conference on Precision Electromagnetic Measurements•Jul 1, 2012•2 citations

Hybrid single-electron turnstile - Towards a quantum standard of electric current

Jukka P Pekola, D. V. Averin, Sergey G. Kafanov +9 more

First I discuss various candidates of single-electron current pumps for quantum metrology. Then I focus on the hybrid normal-metal-superconductor turnstile in the form of a one-island single-electron transistor with one gate. The device demonstrates robust current plateaus at multiple levels of ef at frequency f. I discuss the various error mechanisms, based on our experiments and theoretical considerations. Ultimately the quantization accuracy is expected to be limited by either two-electron tunneling or by Cooper-pair-electron co-tunneling. We predict that it should be possible to achieve the metrological accuracy of 10-8, while maintaining the quantized current on the level of more than 10 pA, just by one turnstile with realistic parameters using aluminium as a superconductor. Recently we have managed to run ten turnstiles in parallel increasing the current level to above 100 pA. Work on suppressing the harmful sub-gap leakage current is in progress with encouraging experimental results.

Conference on Precision Electromagnetic Measurements•Jun 1, 2010•1 citation

SINIS junction technology for complex superconducting circuits

J. Niemeyer

Physica C Superconductivity•Aug 1, 2002•7 citations

A hybrid superconductor-normal metal electron trap as a photon detector

S. V. Lotkhov, Alexander B Zorin

A single-electron trap built with two superconductor-insulator-normal metal tunnel junctions and coupled to a readout SINIS-type single-electron transistor A (SET A) was studied in a photon detection regime. As a source of photon irradiation, we used an operating second SINIS-type SET B positioned in the vicinity of the trap. In the experiment, the average hold time of the trap was found to be critically dependent on the voltage across SET B. Starting in a certain voltage range, a photon-assisted electron escape was observed at a rate roughly proportional to the emission rate of the photons with energies exceeding the superconducting gap of S-electrodes in the trap. The discussed mechanism of photon emission and detection is of interest for low-temperature noise spectrometry, and it can be of relevance for the ampere standard based on hybrid SINIS turnstiles.

arXiv:1204.3548•Applied Physics Letters•Jun 11, 2012•9 citations
First I discuss various candidates of single-electron current pumps for quantum metrology. Then I focus on the hybrid normal-metal-superconductor turnstile in the form of a one-island single-electron transistor with one gate. The device demonstrates robust current plateaus at multiple levels of ef at frequency f. I discuss the various error mechanisms, based on our experiments and theoretical considerations. Ultimately the quantization accuracy is expected to be limited by either two-electron tunneling or by Cooper-pair-electron co-tunneling. We predict that it should be possible to achieve the metrological accuracy of 10-8, while maintaining the quantized current on the level of more than 10 pA, just by one turnstile with realistic parameters using aluminium as a superconductor. Recently we have managed to run ten turnstiles in parallel increasing the current level to above 100 pA. Work on suppressing the harmful sub-gap leakage current is in progress with encouraging experimental results.
A single-electron trap built with two superconductor-insulator-normal metal tunnel junctions and coupled to a readout SINIS-type single-electron transistor A (SET A) was studied in a photon detection regime. As a source of photon irradiation, we used an operating second SINIS-type SET B positioned in the vicinity of the trap. In the experiment, the average hold time of the trap was found to be critically dependent on the voltage across SET B. Starting in a certain voltage range, a photon-assisted electron escape was observed at a rate roughly proportional to the emission rate of the photons with energies exceeding the superconducting gap of S-electrodes in the trap. The discussed mechanism of photon emission and detection is of interest for low-temperature noise spectrometry, and it can be of relevance for the ampere standard based on hybrid SINIS turnstiles.