Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Chinese Physics B

Controlled decoherence of three-level rf-SQUID qubit with asymmetric potential

Yinghua Ji, Lai Hui-Fang, Shihua Cai, Wang Zisheng

Published Mar 1, 2010• 11 citations
Publisher

Abstract

A scheme is proposed to controll the decoherence of three-level rf-SQUID qubit with asymmetric potential by designing an external electric circuit for superconductive flux qubit. The results show that it may not only raise the gate speed but also extend decoherence time for a three-level structure.
DOI
10.1088/1674-1056/19/3/030310

Related papers

Design of an RSFQ control circuit to observe MQC on an rf-SQUID

Roberto Rey-de-Castro, Mark F. Bocko, Andrea M. Herr +2 more

We believe that the best chance to observe macroscopic quantum coherence (MQC) in an rf-SQUID qubit is to use on-chip RSFQ digital circuits for preparing, evolving and reading out the qubit's quantum state. This approach allows experiments to be conducted on a very short time scale (sub-nanosecond) without the use of large bandwidth control lines that would couple environmental degrees of freedom to the qubit, thus contributing to its decoherence. In this paper we present our design of an RSFQ digital control circuit for demonstrating MQC in an rf-SQUID. We assess some of the key practical issues in the circuit design including the achievement of the necessary flux bias stability. We present an "active" isolation structure to be used to increase coherence times. The structure decouples the SQUID from external degrees of freedom, and then couples it to the output measurement circuitry when required, all under the active control of RSFQ circuits.

arXiv:quant-ph/0102089•IEEE Transactions on Applied Superconductivity•Mar 1, 2001•24 citations

One-step implementing three-qubit phase gate via manipulating rf SQUID qubits in the decoherence-free subspace with respect to cavity decay

Shao Xiao-Qiang, Chen Li, Zhang Shou +1 more

We present a scheme for implementing a three-qubit phase gate via manipulating rf superconducting quantum interference device (SQUID) qubits in the decoherence-free subspace with respect to cavity decay. Through appropriate changes of the coupling constants between rf SQUIDs and cavity, the scheme can be realized only in one step. A high fidelity is obtained even in the presence of decoherence.

Chinese Physics B•Dec 1, 2009•4 citations

INVESTIGATION COMPARISON ON THE GATE SPEED OF THREE-LEVEL AND TWO-LEVEL QUANTUM NOT GATES WITH ASYMMETRIC POTENTIAL OF rf-SQUID

Yinghua Ji, Juju Hu, Shihua Cai

We investigate the relation between the speed of quantum NOT gate and the asymmetry or detuning of the potential in system of the interaction of a two-level rf-SQUID qubit with a classical microwave pulse. The rf-SQUID is characterized by an asymmetric double well potential that gives rise to diagonal matrix elements. Then in resonance, we compare the gate speeds for three-level and two-level quantum NOT gates. We show that in general, a three-level gate is much faster than the conventional two-level gate.

Modern Physics Letters B•Aug 20, 2007•3 citations

Measurement of the Energy Relaxation Time in rf SQUID Flux Qubits

Wei Qiu

It is well known that that superconducting qubits based on Josephson junctions have the advantages of scalability and the qubit states are easy to prepare and control. In addition, demonstration of Rabi oscillations in various superconducting circuits shows that superconducting qubits are promising for scalable quantum information processing. However, despite flexibility of design and fabrication, easier to scale up, and fast gate speed, superconducting qubits usually have much shorter decoherence time than trapped ions, NMR etc. due to the relatively strong interactions between qubits and environment. Recent experiments show that low frequency flux noise is the dominant mechanism of decoherence in superconducting flux qubits. However, despite extensive effort the origin of flux noise is still not well understood. The goal of this work is to identify the source and characterize the property of flux noisein rf SQUID flux qubit through various spectroscopy and time-resolved measurements. Our result show that one can determine all circuit parameters needed for reconstructing qubit Hamiltonian with high accuracy via measurement of macroscopic resonant tunneling (MRT) and photon assisted tunneling (PAT) and that the amount of flux noise in rf SQUID qubits scales linearly with self inductance of the qubits. In addition, we have investigated the dynamics of a three-level flux qubit in incoherent regime. The result demonstrates that treating a multi-level physical qubit, such as the superconducting flux qubit, as an ideal two-level quantum system may be inadequate under certain circumstances.

•Dec 17, 2007•0 citations

Measurement of Dissipation of a Three-Level rf SQUID Qubit

Shaoxiong Li, Wei Qiu, Zhongyuan Zhou +4 more

The dissipation-induced relaxation (T_1) time of a macroscopic quantum system - a \{lambda}-type three-level rf SQUID flux qubit weakly coupled to control and readout circuitry (CRC) - is investigated via time-domain measurement. The measured interwell relaxation time of the qubit's first excited state, T_1=3.45+/-0.06 \{mu}s, corresponds to an effective damping resistance of the flux qubit R=1.6+/-0.1 M\{omega} which is much lower than the intrinsic quasiparticle resistance of the Josephson tunnel junction. An analysis of the system shows that although the CRC is very weakly coupled to the qubit it is the primary source of damping. This type of damping can be significantly reduced by the use of more sophisticated circuit design to allow coherent manipulation of qubit states.

arXiv:cond-mat/0507008•Jul 1, 2005•6 citations

Studies of Quantum Transitions of Magnetic Flux in a RF Squid Qubit

Luigi Longobardi

At low temperature and low damping, the magnetic flux of a rf Superconducting QUantum Interference Device (SQUID) acts as a macroscopic quantum variable whose dynamic is described by a double well potential. A rf SQUID consists of a superconducting loop interrupted by a thin insulating barrier, known as a Josephson junction. The modified rf SQUID design discussed in this thesis has independent, in situ, controls that allow varying the barrier height between the potential wells and their relative tilt. This high level of control of the potential together with the capability to implement an experimental setup optimized to reduce coupling to external sources of noise, made this system ideal not only for tests of quantum transition at a macroscopic level, but also as a scalable solid state device for quantum computation. A variety of measurements of quantum phenomena are reported in this thesis, including microwave level spectroscopy, coherent oscillations, and macroscopic resonant tunneling (MRT). These measurements are compared with theoretical models to study the possible sources of decoherence in a rf SQUID qubit. The analysis confirmed that the main source of decoherence is not due to coupling to the external environment, but it can be linked to intrinsic low frequency flux noise. Work from many groups over the last several years has shown that the performance of a superconductive qubit is limited by coupling to spurious defects in the materials used for the device fabrication. In this work we analyze the possibility of using the MRT as a tool for future studies of effects of materials and fabrication process in the realization of improved qubits, and we also explore the feasibility for measurements of quantum phenomena that involve fast pulsing of the potential barrier height.

•Oct 22, 2010•0 citations
We believe that the best chance to observe macroscopic quantum coherence (MQC) in an rf-SQUID qubit is to use on-chip RSFQ digital circuits for preparing, evolving and reading out the qubit's quantum state. This approach allows experiments to be conducted on a very short time scale (sub-nanosecond) without the use of large bandwidth control lines that would couple environmental degrees of freedom to the qubit, thus contributing to its decoherence. In this paper we present our design of an RSFQ digital control circuit for demonstrating MQC in an rf-SQUID. We assess some of the key practical issues in the circuit design including the achievement of the necessary flux bias stability. We present an "active" isolation structure to be used to increase coherence times. The structure decouples the SQUID from external degrees of freedom, and then couples it to the output measurement circuitry when required, all under the active control of RSFQ circuits.
We investigate the relation between the speed of quantum NOT gate and the asymmetry or detuning of the potential in system of the interaction of a two-level rf-SQUID qubit with a classical microwave pulse. The rf-SQUID is characterized by an asymmetric double well potential that gives rise to diagonal matrix elements. Then in resonance, we compare the gate speeds for three-level and two-level quantum NOT gates. We show that in general, a three-level gate is much faster than the conventional two-level gate.
It is well known that that superconducting qubits based on Josephson junctions have the advantages of scalability and the qubit states are easy to prepare and control. In addition, demonstration of Rabi oscillations in various superconducting circuits shows that superconducting qubits are promising for scalable quantum information processing. However, despite flexibility of design and fabrication, easier to scale up, and fast gate speed, superconducting qubits usually have much shorter decoherence time than trapped ions, NMR etc. due to the relatively strong interactions between qubits and environment. Recent experiments show that low frequency flux noise is the dominant mechanism of decoherence in superconducting flux qubits. However, despite extensive effort the origin of flux noise is still not well understood. The goal of this work is to identify the source and characterize the property of flux noisein rf SQUID flux qubit through various spectroscopy and time-resolved measurements. Our result show that one can determine all circuit parameters needed for reconstructing qubit Hamiltonian with high accuracy via measurement of macroscopic resonant tunneling (MRT) and photon assisted tunneling (PAT) and that the amount of flux noise in rf SQUID qubits scales linearly with self inductance of the qubits. In addition, we have investigated the dynamics of a three-level flux qubit in incoherent regime. The result demonstrates that treating a multi-level physical qubit, such as the superconducting flux qubit, as an ideal two-level quantum system may be inadequate under certain circumstances.
The dissipation-induced relaxation (T_1) time of a macroscopic quantum system - a \{lambda}-type three-level rf SQUID flux qubit weakly coupled to control and readout circuitry (CRC) - is investigated via time-domain measurement. The measured interwell relaxation time of the qubit's first excited state, T_1=3.45+/-0.06 \{mu}s, corresponds to an effective damping resistance of the flux qubit R=1.6+/-0.1 M\{omega} which is much lower than the intrinsic quasiparticle resistance of the Josephson tunnel junction. An analysis of the system shows that although the CRC is very weakly coupled to the qubit it is the primary source of damping. This type of damping can be significantly reduced by the use of more sophisticated circuit design to allow coherent manipulation of qubit states.
At low temperature and low damping, the magnetic flux of a rf Superconducting QUantum Interference Device (SQUID) acts as a macroscopic quantum variable whose dynamic is described by a double well potential. A rf SQUID consists of a superconducting loop interrupted by a thin insulating barrier, known as a Josephson junction. The modified rf SQUID design discussed in this thesis has independent, in situ, controls that allow varying the barrier height between the potential wells and their relative tilt. This high level of control of the potential together with the capability to implement an experimental setup optimized to reduce coupling to external sources of noise, made this system ideal not only for tests of quantum transition at a macroscopic level, but also as a scalable solid state device for quantum computation. A variety of measurements of quantum phenomena are reported in this thesis, including microwave level spectroscopy, coherent oscillations, and macroscopic resonant tunneling (MRT). These measurements are compared with theoretical models to study the possible sources of decoherence in a rf SQUID qubit. The analysis confirmed that the main source of decoherence is not due to coupling to the external environment, but it can be linked to intrinsic low frequency flux noise. Work from many groups over the last several years has shown that the performance of a superconductive qubit is limited by coupling to spurious defects in the materials used for the device fabrication. In this work we analyze the possibility of using the MRT as a tool for future studies of effects of materials and fabrication process in the realization of improved qubits, and we also explore the feasibility for measurements of quantum phenomena that involve fast pulsing of the potential barrier height.