© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

Measurement of the Energy Relaxation Time in rf SQUID Flux Qubits

Wei Qiu

Published Dec 17, 2007• 0 citations

Abstract

It is well known that that superconducting qubits based on Josephson junctions have the advantages of scalability and the qubit states are easy to prepare and control. In addition, demonstration of Rabi oscillations in various superconducting circuits shows that superconducting qubits are promising for scalable quantum information processing. However, despite flexibility of design and fabrication, easier to scale up, and fast gate speed, superconducting qubits usually have much shorter decoherence time than trapped ions, NMR etc. due to the relatively strong interactions between qubits and environment. Recent experiments show that low frequency flux noise is the dominant mechanism of decoherence in superconducting flux qubits. However, despite extensive effort the origin of flux noise is still not well understood. The goal of this work is to identify the source and characterize the property of flux noisein rf SQUID flux qubit through various spectroscopy and time-resolved measurements. Our result show that one can determine all circuit parameters needed for reconstructing qubit Hamiltonian with high accuracy via measurement of macroscopic resonant tunneling (MRT) and photon assisted tunneling (PAT) and that the amount of flux noise in rf SQUID qubits scales linearly with self inductance of the qubits. In addition, we have investigated the dynamics of a three-level flux qubit in incoherent regime. The result demonstrates that treating a multi-level physical qubit, such as the superconducting flux qubit, as an ideal two-level quantum system may be inadequate under certain circumstances.

Related papers

Studies of Quantum Transitions of Magnetic Flux in a RF Squid Qubit

Luigi Longobardi

At low temperature and low damping, the magnetic flux of a rf Superconducting QUantum Interference Device (SQUID) acts as a macroscopic quantum variable whose dynamic is described by a double well potential. A rf SQUID consists of a superconducting loop interrupted by a thin insulating barrier, known as a Josephson junction. The modified rf SQUID design discussed in this thesis has independent, in situ, controls that allow varying the barrier height between the potential wells and their relative tilt. This high level of control of the potential together with the capability to implement an experimental setup optimized to reduce coupling to external sources of noise, made this system ideal not only for tests of quantum transition at a macroscopic level, but also as a scalable solid state device for quantum computation. A variety of measurements of quantum phenomena are reported in this thesis, including microwave level spectroscopy, coherent oscillations, and macroscopic resonant tunneling (MRT). These measurements are compared with theoretical models to study the possible sources of decoherence in a rf SQUID qubit. The analysis confirmed that the main source of decoherence is not due to coupling to the external environment, but it can be linked to intrinsic low frequency flux noise. Work from many groups over the last several years has shown that the performance of a superconductive qubit is limited by coupling to spurious defects in the materials used for the device fabrication. In this work we analyze the possibility of using the MRT as a tool for future studies of effects of materials and fabrication process in the realization of improved qubits, and we also explore the feasibility for measurements of quantum phenomena that involve fast pulsing of the potential barrier height.

•Oct 22, 2010•0 citations

Measurement of Integrated Low Frequency Flux Noise in Superconducting Flux∕Phase Qubits

Bo Mao, Wei Qiu, Siyuan Han +2 more

We measured the integrated low frequency flux noise (∼1 mΦ0) of an rf SQUID as a flux qubit by fitting the resonant peaks from photon assistant tunneling (PAT). The energy relaxation time Tl between the ground and first excited states in the same potential well, measured directly in time domain, is 3 ns. From these results we identified low frequency flux noise as the dominant source of decoherence. In addition, we found that the measured values of integrated flux noise in three qubits of various sizes differ more than an order of magnitude.

AIP conference proceedings•Jan 1, 2008•0 citations

Experimental demonstration of a robust and scalable flux qubit

R. Harris, J. Johansson, A. J. Berkley +16 more

A rf--superconducting quantum interference device (SQUID) flux qubit that is robust against fabrication variations in Josephson-junction critical currents and device inductance has been implemented. Measurements of the persistent current and of the tunneling energy between the two lowest-lying states, both in the coherent and incoherent regimes, are presented. These experimental results are shown to be in agreement with predictions of a quantum-mechanical Hamiltonian whose parameters were independently calibrated, thus justifying the identification of this device as a flux qubit. In addition, measurements of the flux and critical current noise spectral densities are presented that indicate that these devices with Nb wiring are comparable to the best Al wiring rf SQUIDs reported in the literature thus far, with a $1/f$ flux noise spectral density at 1 Hz of ${1.3}_{\ensuremath{-}0.5}^{+0.7}\text{ }\ensuremath{\mu}{\ensuremath{\Phi}}_{0}/\sqrt{\text{Hz}}$. An explicit formula for converting the observed flux noise spectral density into a free-induction-decay time for a flux qubit biased to its optimal point and operated in the energy eigenbasis is presented.

arXiv:0909.4321•Physical Review B•Apr 7, 2010•180 citations

Probing flux and charge noise with macroscopic resonant tunneling

Alexander Whiticar, Anatoly Yu. Smirnov, Trevor M. Lanting +8 more

We report on measurements of flux and charge noise in an rf-SQUID (superconducting quantum interference device) flux qubit using macroscopic resonant tunneling (MRT). We measure rates of incoherent tunneling from the lowest energy state in the initial well to the ground and first excited states in the target well. The result of the measurement consists of two peaks. The first peak corresponds to tunneling to the ground state of the target well, and is dominated by flux noise. The second peak is due to tunneling to the excited state and is wider due to an intrawell relaxation process dominated by charge noise. We develop a theoretical model that allows us to extract information about flux and charge noise within one experimental setup. The model agrees very well with experimental data over a wide dynamic range and provides parameters that characterize charge and flux noise.

arXiv:2210.01714•Physical review. B./Physical review. B•Feb 10, 2023•5 citations

Measurement of Dissipation of a Three-Level rf SQUID Qubit

Shaoxiong Li, Wei Qiu, Zhongyuan Zhou +4 more

The dissipation-induced relaxation (T_1) time of a macroscopic quantum system - a \{lambda}-type three-level rf SQUID flux qubit weakly coupled to control and readout circuitry (CRC) - is investigated via time-domain measurement. The measured interwell relaxation time of the qubit's first excited state, T_1=3.45+/-0.06 \{mu}s, corresponds to an effective damping resistance of the flux qubit R=1.6+/-0.1 M\{omega} which is much lower than the intrinsic quasiparticle resistance of the Josephson tunnel junction. An analysis of the system shows that although the CRC is very weakly coupled to the qubit it is the primary source of damping. This type of damping can be significantly reduced by the use of more sophisticated circuit design to allow coherent manipulation of qubit states.

arXiv:cond-mat/0507008•Jul 1, 2005•1 citation

Probing Noise in Flux Qubits via Macroscopic Resonant Tunneling

R. Harris, Mark W. Johnson, Siyuan Han +13 more

Macroscopic resonant tunneling between the two lowest lying states of a bistable rf SQUID is used to characterize noise in a flux qubit. Measurements of the incoherent decay rate as a function of flux bias revealed a Gaussian-shaped profile that is not peaked at the resonance point but is shifted to a bias at which the initial well is higher than the target well. The rms amplitude of the noise, which is proportional to the dephasing rate 1/tauphi, was observed to be weakly dependent on temperature below 70 mK. Analysis of these results indicates that the dominant source of low energy flux noise in this device is a quantum mechanical environment in thermal equilibrium.

arXiv:0712.0838•Physical Review Letters•Sep 10, 2008•81 citations

It is well known that that superconducting qubits based on Josephson junctions have the advantages of scalability and the qubit states are easy to prepare and control. In addition, demonstration of Rabi oscillations in various superconducting circuits shows that superconducting qubits are promising for scalable quantum information processing. However, despite flexibility of design and fabrication, easier to scale up, and fast gate speed, superconducting qubits usually have much shorter decoherence time than trapped ions, NMR etc. due to the relatively strong interactions between qubits and environment. Recent experiments show that low frequency flux noise is the dominant mechanism of decoherence in superconducting flux qubits. However, despite extensive effort the origin of flux noise is still not well understood. The goal of this work is to identify the source and characterize the property of flux noisein rf SQUID flux qubit through various spectroscopy and time-resolved measurements. Our result show that one can determine all circuit parameters needed for reconstructing qubit Hamiltonian with high accuracy via measurement of macroscopic resonant tunneling (MRT) and photon assisted tunneling (PAT) and that the amount of flux noise in rf SQUID qubits scales linearly with self inductance of the qubits. In addition, we have investigated the dynamics of a three-level flux qubit in incoherent regime. The result demonstrates that treating a multi-level physical qubit, such as the superconducting flux qubit, as an ideal two-level quantum system may be inadequate under certain circumstances.

At low temperature and low damping, the magnetic flux of a rf Superconducting QUantum Interference Device (SQUID) acts as a macroscopic quantum variable whose dynamic is described by a double well potential. A rf SQUID consists of a superconducting loop interrupted by a thin insulating barrier, known as a Josephson junction. The modified rf SQUID design discussed in this thesis has independent, in situ, controls that allow varying the barrier height between the potential wells and their relative tilt. This high level of control of the potential together with the capability to implement an experimental setup optimized to reduce coupling to external sources of noise, made this system ideal not only for tests of quantum transition at a macroscopic level, but also as a scalable solid state device for quantum computation. A variety of measurements of quantum phenomena are reported in this thesis, including microwave level spectroscopy, coherent oscillations, and macroscopic resonant tunneling (MRT). These measurements are compared with theoretical models to study the possible sources of decoherence in a rf SQUID qubit. The analysis confirmed that the main source of decoherence is not due to coupling to the external environment, but it can be linked to intrinsic low frequency flux noise. Work from many groups over the last several years has shown that the performance of a superconductive qubit is limited by coupling to spurious defects in the materials used for the device fabrication. In this work we analyze the possibility of using the MRT as a tool for future studies of effects of materials and fabrication process in the realization of improved qubits, and we also explore the feasibility for measurements of quantum phenomena that involve fast pulsing of the potential barrier height.

We measured the integrated low frequency flux noise (∼1 mΦ0) of an rf SQUID as a flux qubit by fitting the resonant peaks from photon assistant tunneling (PAT). The energy relaxation time Tl between the ground and first excited states in the same potential well, measured directly in time domain, is 3 ns. From these results we identified low frequency flux noise as the dominant source of decoherence. In addition, we found that the measured values of integrated flux noise in three qubits of various sizes differ more than an order of magnitude.

A rf--superconducting quantum interference device (SQUID) flux qubit that is robust against fabrication variations in Josephson-junction critical currents and device inductance has been implemented. Measurements of the persistent current and of the tunneling energy between the two lowest-lying states, both in the coherent and incoherent regimes, are presented. These experimental results are shown to be in agreement with predictions of a quantum-mechanical Hamiltonian whose parameters were independently calibrated, thus justifying the identification of this device as a flux qubit. In addition, measurements of the flux and critical current noise spectral densities are presented that indicate that these devices with Nb wiring are comparable to the best Al wiring rf SQUIDs reported in the literature thus far, with a

1/f

flux noise spectral density at 1 Hz of ${1.3}_{\ensuremath{-}0.5}^{+0.7}\text{ }\ensuremath{\mu}{\ensuremath{\Phi}}_{0}/\sqrt{\text{Hz}}$. An explicit formula for converting the observed flux noise spectral density into a free-induction-decay time for a flux qubit biased to its optimal point and operated in the energy eigenbasis is presented.

We report on measurements of flux and charge noise in an rf-SQUID (superconducting quantum interference device) flux qubit using macroscopic resonant tunneling (MRT). We measure rates of incoherent tunneling from the lowest energy state in the initial well to the ground and first excited states in the target well. The result of the measurement consists of two peaks. The first peak corresponds to tunneling to the ground state of the target well, and is dominated by flux noise. The second peak is due to tunneling to the excited state and is wider due to an intrawell relaxation process dominated by charge noise. We develop a theoretical model that allows us to extract information about flux and charge noise within one experimental setup. The model agrees very well with experimental data over a wide dynamic range and provides parameters that characterize charge and flux noise.

The dissipation-induced relaxation (T_1) time of a macroscopic quantum system - a \{lambda}-type three-level rf SQUID flux qubit weakly coupled to control and readout circuitry (CRC) - is investigated via time-domain measurement. The measured interwell relaxation time of the qubit's first excited state, T_1=3.45+/-0.06 \{mu}s, corresponds to an effective damping resistance of the flux qubit R=1.6+/-0.1 M\{omega} which is much lower than the intrinsic quasiparticle resistance of the Josephson tunnel junction. An analysis of the system shows that although the CRC is very weakly coupled to the qubit it is the primary source of damping. This type of damping can be significantly reduced by the use of more sophisticated circuit design to allow coherent manipulation of qubit states.

Macroscopic resonant tunneling between the two lowest lying states of a bistable rf SQUID is used to characterize noise in a flux qubit. Measurements of the incoherent decay rate as a function of flux bias revealed a Gaussian-shaped profile that is not peaked at the resonance point but is shifted to a bias at which the initial well is higher than the target well. The rms amplitude of the noise, which is proportional to the dephasing rate 1/tauphi, was observed to be weakly dependent on temperature below 70 mK. Analysis of these results indicates that the dominant source of low energy flux noise in this device is a quantum mechanical environment in thermal equilibrium.