The method to produce spin-polarized xenon-129 gas was based on the method of spin-exchange optical pumping (SEOP). The magnetizations produced by the hyperpolarized (HP) xenon-129 gas were analyzed from the perspective of theoretical and experimental research. The theoretical simulation was based on the conventional Bloch equation. The experimental research was based on measurements made by using an all-optical atomic magnetometer. The experimental results agreed with the theoretical simulated results, which proved that an all-optical atomic magnetometer had the ability to measure the magnetic field produced by xenon-129 nuclei in a low external magnetic field. Because the frequency of the nuclear spin precession could be detected precisely, the results showed that the mean measurement error of the gyromagnetic ratio was 1.1 × 10 -4 Hz/nT.
The method to produce spin-polarized xenon-129 gas was based on the method of spin-exchange optical pumping (SEOP). The magnetizations produced by the hyperpolarized (HP) xenon-129 gas were analyzed from the perspective of theoretical and experimental research. The theoretical simulation was based on the conventional Bloch equation. The experimental research was based on measurements made by using an all-optical atomic magnetometer. The experimental results agreed with the theoretical simulated results, which proved that an all-optical atomic magnetometer had the ability to measure the magnetic field produced by xenon-129 nuclei in a low external magnetic field. Because the frequency of the nuclear spin precession could be detected precisely, the results showed that the mean measurement error of the gyromagnetic ratio was 1.1 × 10 -4 Hz/nT.
We present a design for a spin-exchange optical pumping system to produce large quantities of highly polarized 129Xe and 131Xe. Low xenon concentrations in the flowing gas mixture which allow the laser to maintain high Cs polarization. The large spin-exchange rate between Cs and Xe through the long-lived van der Waals molecules at low pressure, combined with a high flow rate, results in large production rates of hyperpolarized xenon. The fast rates make it possible to obtain large nuclear polarizations after several minutes of optical pumping with a laser.At high Xe pressures. According to the theory, the longitudinal spin-elaxation rate 1T1 of Xe in a high-pressure sample containing only Xe and Cs vapor has the simple form is the velocity averaged binary spin-exchange cross section, It is the relaxation rate due to wall collisions and perhaps magnetic field inhomogeneities. Our results complement earlier studies performed at 129Xe pressures of about 20 Torr and 131Xe pressures of about 20 Torr and N2 pressures of 600 Torr . This work is useful for predicting spin-exchange rates between polarized Cs atoms and Xe nuclei.
Analytical model for polarization transfer during gas-phase collision events in spin-exchange optical pumping: Spin-21129Xe versus spin-23131Xe
Spin-exchange optical pumping (SEOP) is a method for producing spin-hyperpolarized noble gas nuclei, such as 129Xe and 131Xe, which are used in various magnetic resonance applications from fundamental physics to quantum sensing and medical imaging. In SEOP, optically polarized alkali-metal atoms transfer their spin polarization to the noble gas nuclei in gas-phase collision events via the hyperfine coupling (HFC) between the alkali valence electron and the noble gas nucleus. While the polarization transfer physics of spin I=1/2 nuclei, such as 129Xe, is relatively well understood, that of spin I>1/2 nuclei, such as 131Xe (I=3/2), has been far less studied, and no rigorous theoretical model has been presented to date. To this end, we derive a simple analytical model for the upper limit, neglecting relaxation, of the SEOP polarization transfer, applicable to noble gases with arbitrary nuclear spin. Analytical evaluation of the Baker-Campbell-Hausdorff expansion for the time evolution of the spin density operator ρ^(t) reveals that only even-order terms in the HFC contribute to the polarization transfer, with the leading-order quadratic term being the most significant. We obtain a result similar to that derived for the spin-exchange cross section by Herman [Phys. Rev. 137, A 1062 (1965)], but in a more general framework for the time evolution of ρ^(t) that is also more familiar to magnetic resonance researchers. The model is applied to understand the difference in the polarization transfer efficiency between 129Xe and 131Xe, yielding results in agreement with previous experiments. We also validate the model by comparison to detailed numerical multiscale simulations of the SEOP process, where full quantum-chemically computed spin Hamiltonians sampled from molecular dynamics simulations of the gas-phase collision events are used to propagate the spin dynamics.
We analyze the transverse nuclear magnetizations of 129Xe and 131Xe in a vapor cell containing natural Xe, 87Rb, and buffer gases. The Xe atoms are polarized through spin-exchange optical pumping (SEOP) with Rb atoms under low-magnetic-field conditions. From the free-induction-decay (FID) signal, we measure the nuclear magnetization of the Xe atoms in the Xe-Rb vapor cell. Furthermore, we measure the dependence of the gyromagnetic ratio on the magnetization of 129Xe and 131Xe by examining the amplitude of the FID signal of each isotope, and we evaluate the relationship between the magnetic field gradient and transverse relaxation rate for both of the 129Xe and 131Xe isotopes.
We report a rubidium atomic magnetometer based on pump-probe nonlinear magneto-optical rotation. The rubidium vapor cell is placed in a five-layer magnetic shield with inner coils that can generate uniform magnetic fields along the direction of pump beam, and the cell is also placed in the center of a Helmholtz coil that can generate an oscillating magnetic field perpendicular to the direction of pump beam. The atoms are optically pumped by circularly polarized pump beam along a constant magnetic field in a period of time, then the pump beam is turned off and a /2 pulse of oscillating magnetic field for 87Rb atoms is applied. After the above process, the individual atomic magnetic moments become phase coherent, resulting in a transverse magnetization vector precessing at the Larmor frequency in the magnetic field. The linearly polarized probing beam is perpendicular to the direction of magnetic field, and can be seen as a superposition of the left and right circularly polarized light. Because of the different absorptions and dispersions of the left and right circularly polarized light by rubidium atoms, the polarization direction of probing beam rotates when probing beam passes through rubidium vapor cell. The rotation of the polarization is subsequently converted into an electric signal through a polarizing beam splitter. Finally, the decay signal related to the transverse magnetization vector is measured. The Larmor frequency proportional to magnetic field is obtained by the Fourier transform of the decay signal. The value of magnetic field is calculated from the formula:B=(2/) f, where and f are the gyromagnetic ratio and Larmor frequency, respectively. In order to measure the magnetic field in a wide range, the tracking lock mode is proposed and tested. The atomic magnetometer can track the magnetic field jump of 1000 nT or 10000 nT, indicating that the atomic magnetometer has strong locking ability and can be easily locked after start-up. The main performances in different magnetic fields are tested. The results show that the measurement range of the atomic magnetometer is from 100 nT to 100000 nT, the extreme sensitivity is 0.2 pT/Hz1/2, and the magnetic field resolution is 0.1 pT. The transverse relaxation times of the transverse magnetization vector in different magnetic fields are obtained, and the relaxation time decreases with the increase of the magnetic field. When the measurement range is from 5000 nT to 100000 nT, the magnetic field sampling rate of the atomic magnetometer can be adjusted in a range from 1 Hz to 1000 Hz. The atomic magnetometer in high sampling rate can measure weak alternating magnetic field at low frequency. This paper provides an important reference for developing the atomic magnetometer with large measurement range, high sensitivity and high sampling rate.
Ultrasensitive atomic comagnetometers (ACMs) are invaluable tools for both inertial measurement and fundamental physics research. However, the misalignment between the pump light and the main magnetic field affects the polarization characteristics of nuclear spins of the noble gas atoms, making it a significant source of noise. In this article, an atomic magnetometer response model with the optical-magnetic misalignment error is established, and the mechanism of the influence of optical-magnetic misalignment on nuclear spin polarization is analyzed. An in situ evaluation method and a suppression method of optical-magnetic misalignment error are proposed, and their effectiveness is verified through experiments with varying pump light incidence directions. The experimental results indicate that after optical-magnetic alignment using the proposed method, the spin polarization of the coupled atomic ensemble is enhanced by 20.7%, and the longitudinal relaxation rate of the nuclear spin is reduced by 6.9%. Additionally, the amplitude-frequency response (AFR) of the x-axis magnetic field is reduced by 33.2% at 1 Hz and by 53.1% at frequencies below 0.002 Hz. This indicates an improvement in the transverse magnetic field error suppression capability of the ACMs.
An all-optical atomic spin magnetometer using a hybrid cell of K and Rb atoms is demonstrated in this paper. Via deriving and solving the Bloch equations, we established the models for the polarization rate of Rb and the magnetometer’s output signal, respectively. In order to achieve the maximum sensitivity, we carried out research on the influence of the pump power on the polarization rate and magnetometer’s output signal. The magnetometer’s sensitivity was found to be proportional to the polarization rate of Rb, which was confined by the pump power. In a certain context, theoretical predictions indicated that the larger the pump power was, the higher magnetometer’s sensitivity that could be realized. However, the theoretical estimate deviated from the experimental results. An analysis of the errors between the actual value and the theoretical value showed that the different molar ratio between the two species of alkali-metal atoms was the primary reason causing the deviation. By comparing the experimental measurement result with simulation result, we found the difference in the molar ratio to be approximate 4 times. After various parameters had been optimized, a sensitivity of 18 fT/Hz 1/2 was achieved by analyzing the signal-to-noise ratio.