Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

All-NbN digital-to-analog converters for a programmable voltage standard

Hirotake Yamamori, Mitsuru Itoh, Hajime SASAKI, Alexandre Shoji, Samuel P. Benz, Paul D. Dresselhaus

Published Nov 21, 2001• 33 citations
Publisher

Abstract

Five-bit all-NbN digital-to-analog converters (DACs) for a programmable voltage standard have been fabricated using NbN/TiN x /NbN Josephson junctions and their operation has been demonstrated. The DAC consists of six arrays of 128, 128, 256, 512, 1024 and 2048 junctions per array. We have measured the current–voltage characteristics for the junction arrays driven with a 16 GHz microwave signal at 4.2 and 10 K, resulting in constant-voltage steps with heights larger than 2 mA. The maximum output voltage for the DAC was 136 mV, indicating that all 4096 junctions in the DAC yielded a voltage corresponding to the microwave frequency through the ac Josephson effect.

DOI
10.1088/0953-2048/14/12/314

Related papers

Programmable Josephson Voltage Standard Circuits Using Arrays of NbN/TiN/NbN/TiN/NbN Double-Junction Stacks Operated at 10 K

Mayumi Ishizaki, Hirotake Yamamori, Alexandre Shoji +2 more

Programmable Josephson voltage standard (PJVS) circuits using arrays of NbN/TiN/NbN/TiN/NbN double-junction stacks were fabricated and operated at a temperature of 10 K. Four arrays each with 32 768 junctions produced expected voltage outputs when driven at (10, 15, 17, and 20) GHz with an operating current range of 0.2-1.0 mA. Another circuit showed constant-voltage steps at /spl plusmn/6 V when driven with an 11 GHz microwave bias, indicating that over 260 000 junctions were operating properly. This circuit did not show constant-voltage steps when driven with a 19 GHz microwave bias, which was the design frequency to achieve /spl plusmn/10 V output voltage.

IEEE Transactions on Instrumentation and Measurement•Mar 21, 2005•11 citations

A Programmable Josephson Voltage Standard Chip using Arrays of NbN/TiN/NbN/TiN/NbN Double-Junction Stacks Operated at 10K

Mayumi Ishizaki, H. Yamamori, Alexandre Shoji +2 more

A programmable Josephson voltage standard chip using arrays of NbN/TiN/NbN/TiN/NbN double-junction stacks was fabricated and operated at 10 K. The circuit with over 260,000 junctions showed constant voltage steps at +/- 6 V when driven at 11 GHz microwave bias. Further investigation is required to achieve 10 V operation at the desired design frequency of 19 GHz

Conference on Precision Electromagnetic Measurements•Jun 1, 2004•2 citations

Superconductor-normal-superconductor junctions for programmable voltage standards

S. P. Benz

Series arrays of Nb–PdAu–Nb Josephson junctions were fabricated with characteristics ideally suited for application in programmable voltage standards and D/A converters with fundamental accuracy. Large arrays of junctions with applied microwave power showed constant voltage steps with current amplitudes as large as 7 mA. A novel coplanar waveguide design enabled uniform microwave power coupling to a five-segment array of 8192 junctions, so each segment had constant voltage steps over the same bias range. The 8192-junction device generated 1.1 mA steps at 186 mV with 11 GHz power and a maximum constant voltage step of 260 mV at 15.34 GHz.

Applied Physics Letters•Oct 30, 1995•133 citations

Operation of a NbN-based programmable Josephson voltage standard chip with a compact refrigeration system

Alexandre Shoji, Hirotake Yamamori, Mayumi Ishizaki +2 more

A refrigeration system was designed and constructed for realizing a liquid-He-free programmable Josephson voltage standard. The system is equipped with a two-stage Gifford-McMahon cooler, a thermal-radiation shield, a magnetic-field shield and semi-rigid coaxial cables to supply microwave power to a chip. The performance of the system was examined by use of a NbN-based 8-bit digital-to-analog converter (DAC) chip designed as a 1 V programmable voltage standard. When operated at 8.5 K on the cryocooler, constant-voltage steps with amplitudes greater than 1 mA were observed for every segment of junction arrays on the chip.

IEEE Transactions on Applied Superconductivity•Jun 1, 2003•37 citations

Improved Fabrication Yield for 10-V Programmable Josephson Voltage Standard Circuit Including 524288 NbN/TiN/NbN Josephson Junctions

Hirotake Yamamori, Takahiro Yamada, Hitoshi Sasaki +1 more

A 10-V programmable Josephson voltage standard (PJVS) circuit including 524 288 vertically stacked NbN/TiN/NbN Josephson junctions was successfully fabricated without any defects. The chip was cooled with a compact cryocooler at a temperature of 9.8 K and generated an output voltage of 17.3 V with the first Shapiro step height of 1.0 mA under microwave irradiation at 16 GHz. Furthermore, the circuit design having the high output voltage increased the number of available chips for the 10-V PJVS. The fabrication yield for the chip, which generates greater than 10 V, was 36%, which is ten times greater than that for a perfect chip without any defects. This method was not effective for the chip that had serious defects, such as a disconnection across the array or short between the array and ground; thus, efforts to reduce such defects, e.g., frequent maintenance inside vacuum chambers for film preparation and etching, were found to be essential.

IEEE Transactions on Applied Superconductivity•Mar 26, 2010•15 citations

10 V programmable Josephson voltage standard circuits using NbN∕TiNx∕NbN∕TiNx∕NbN double-junction stacks

Hirotake Yamamori, Mayumi Ishizaki, Alexandre Shoji +2 more

Using NbN∕TiNx∕NbN∕TiNx∕NbN double-junction stack technology we have demonstrated a programmable Josephson voltage standard chip that operates up to 10.16V output voltage cooled with a two-stage Gifford–McMahon cryocooler. The circuit uses double-junction stacks, where two junctions are fabricated in each stack, in order to integrate 327 680 junctions into a 15.3mm×15.3mm chip. A 1-to-32 microwave distribution circuit is also integrated on the chip. The chip is divided into 22 cells, which perform as an 11-bit digital-to-analog converter. The 21 working cells include 307 200 junctions biased with 16GHz microwaves at 10.2K that generated flat voltage steps with current margins greater than 1mA, which indicates good uniformity of the stacked junctions.

Applied Physics Letters•Jan 23, 2006•91 citations
Five-bit all-NbN digital-to-analog converters (DACs) for a programmable voltage standard have been fabricated using NbN/TiN x /NbN Josephson junctions and their operation has been demonstrated. The DAC consists of six arrays of 128, 128, 256, 512, 1024 and 2048 junctions per array. We have measured the current–voltage characteristics for the junction arrays driven with a 16 GHz microwave signal at 4.2 and 10 K, resulting in constant-voltage steps with heights larger than 2 mA. The maximum output voltage for the DAC was 136 mV, indicating that all 4096 junctions in the DAC yielded a voltage corresponding to the microwave frequency through the ac Josephson effect.
Programmable Josephson voltage standard (PJVS) circuits using arrays of NbN/TiN/NbN/TiN/NbN double-junction stacks were fabricated and operated at a temperature of 10 K. Four arrays each with 32 768 junctions produced expected voltage outputs when driven at (10, 15, 17, and 20) GHz with an operating current range of 0.2-1.0 mA. Another circuit showed constant-voltage steps at /spl plusmn/6 V when driven with an 11 GHz microwave bias, indicating that over 260 000 junctions were operating properly. This circuit did not show constant-voltage steps when driven with a 19 GHz microwave bias, which was the design frequency to achieve /spl plusmn/10 V output voltage.
Series arrays of Nb–PdAu–Nb Josephson junctions were fabricated with characteristics ideally suited for application in programmable voltage standards and D/A converters with fundamental accuracy. Large arrays of junctions with applied microwave power showed constant voltage steps with current amplitudes as large as 7 mA. A novel coplanar waveguide design enabled uniform microwave power coupling to a five-segment array of 8192 junctions, so each segment had constant voltage steps over the same bias range. The 8192-junction device generated 1.1 mA steps at 186 mV with 11 GHz power and a maximum constant voltage step of 260 mV at 15.34 GHz.
A refrigeration system was designed and constructed for realizing a liquid-He-free programmable Josephson voltage standard. The system is equipped with a two-stage Gifford-McMahon cooler, a thermal-radiation shield, a magnetic-field shield and semi-rigid coaxial cables to supply microwave power to a chip. The performance of the system was examined by use of a NbN-based 8-bit digital-to-analog converter (DAC) chip designed as a 1 V programmable voltage standard. When operated at 8.5 K on the cryocooler, constant-voltage steps with amplitudes greater than 1 mA were observed for every segment of junction arrays on the chip.
A 10-V programmable Josephson voltage standard (PJVS) circuit including 524 288 vertically stacked NbN/TiN/NbN Josephson junctions was successfully fabricated without any defects. The chip was cooled with a compact cryocooler at a temperature of 9.8 K and generated an output voltage of 17.3 V with the first Shapiro step height of 1.0 mA under microwave irradiation at 16 GHz. Furthermore, the circuit design having the high output voltage increased the number of available chips for the 10-V PJVS. The fabrication yield for the chip, which generates greater than 10 V, was 36%, which is ten times greater than that for a perfect chip without any defects. This method was not effective for the chip that had serious defects, such as a disconnection across the array or short between the array and ground; thus, efforts to reduce such defects, e.g., frequent maintenance inside vacuum chambers for film preparation and etching, were found to be essential.
Using NbN∕TiNx∕NbN∕TiNx∕NbN double-junction stack technology we have demonstrated a programmable Josephson voltage standard chip that operates up to 10.16V output voltage cooled with a two-stage Gifford–McMahon cryocooler. The circuit uses double-junction stacks, where two junctions are fabricated in each stack, in order to integrate 327 680 junctions into a 15.3mm×15.3mm chip. A 1-to-32 microwave distribution circuit is also integrated on the chip. The chip is divided into 22 cells, which perform as an 11-bit digital-to-analog converter. The 21 working cells include 307 200 junctions biased with 16GHz microwaves at 10.2K that generated flat voltage steps with current margins greater than 1mA, which indicates good uniformity of the stacked junctions.