Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Modern Physics Letters B

CONVERSION FROM ATOMIC TO MOLECULAR BOSE–EINSTEIN CONDENSATE VIA CHAINWISE ADIABATIC PASSAGE

Jian Li, Yong Liu, Shu‐Lin Cong

Published May 15, 2013• 1 citation
Publisher

Abstract

We present an approach for effectively converting atomic Bose–Einstein condensate (BEC) into molecular one. Atoms are converted into molecules through a series of intermediate vibrational states by using chainwise stimulated Raman adiabatic passage technique. We utilize a feasible pulse sequence to achieve higher conversion efficiency by solving the coupled mean-field equations. As an example, we investigate the formation of Rb 2 and calculate conversion efficiency to be 92.3%.

DOI
10.1142/s0217984913501091

Related papers

Stimulated Raman adiabatic passage from an atomic to a molecular Bose-Einstein condensate

P. D. Drummond, Karen V. Kheruntsyan

Summary form only given. Coherent conversion of an atomic to a molecular Bose-Einstein condensate (BEC) is a first step towards 'superchemistry', which is the atom optics analog of frequency conversion in nonlinear optics. A number of studies of this have shown that direct conversion via Raman photo-association appears feasible, based on stimulated free-bound and bound-bound transitions in the presence of two laser fields E/sup (1)/=E/sub 0//sup (1)/ cos(/spl omega//sup (1)/t) and E/sup (2)/=E/sub 0//sup (2)/ cos(/spl omega//sup (2)/t). Here pairs of atoms from the two-atom continuum are transferred-via an excited bound molecular state-to a bound molecular state of lower energy. Raman photo-association allows coupling to a single molecular state, which can be selected by the Raman laser frequencies /spl omega//sup (1)/ and /spl omega//sup (2)/. However, practical calculations using available lasers and transitions indicate that coherent transfer is often limited by spontaneous emission from the intermediate molecular excited electronic state. A possible route towards minimizing losses and decoherence from spontaneous emission is to use the stimulated Raman adiabatic passage (STIRAP) method (Drummond et al, Phys. Rev. Lett. vol. 81, p. 3055, 1998) in which a counter-intuitive pulse sequence is used where the first input pulse couples the molecular levels, even when there are no molecules present.

Quantum Electronics and Laser Science Conference•Nov 13, 2002•1 citation

Achieving ground-state polar molecular condensates by chainwise atom-molecule adiabatic passage

Jing Qian, Weiping Zhang, Hong Yuan Ling

We generalize the idea of chainwise stimulated Raman adiabatic passage (STIRAP) [Kuznetsova et al., Phys. Rev. A 78, 021402(R) (2008)] to a photoassociation-based chainwise atom-molecule system, with the goal of directly converting two-species atomic Bose-Einstein condensates (BEC) into a ground polar molecular BEC. We pay particular attention to the intermediate Raman laser fields, a control knob inaccessible to the usual three-level model. We find that an appropriate exploration of both the intermediate laser fields and the stability property of the atom-molecule STIRAP can greatly reduce the power demand on the photoassociation laser, a key concern for STIRAPs starting from free atoms due to the small Franck-Condon factor in the free-bound transition.

arXiv:1001.3580•Physical Review A•Jan 29, 2010•14 citations

Stimulated Raman adiabatic passage from an atomic to a molecular Bose-Einstein condensate

P. D. Drummond, Karen V. Kheruntsyan, Daniel J. Heinzen +1 more

The process of stimulated Raman adiabatic passage (STIRAP) provides a possible route for the generation of a coherent molecular Bose-Einstein condensate (BEC) from an atomic BEC. We analyze this process in a three-dimensional mean-field theory, including atom-atom interactions and nonresonant intermediate levels. We find that the process is feasible, but at larger Rabi frequencies than anticipated from a crude single-mode lossless analysis, due to two-photon dephasing caused by the atomic interactions. We then identify optimal strategies in STIRAP allowing one to maintain high conversion efficiencies with smaller Rabi frequencies and under experimentally less demanding conditions.

arXiv:cond-mat/0110578•Physical Review A•Jun 17, 2002•133 citations

Achieving Ground Polar Molecular Condensates by a Chainwise Atom-Molecule Adiabatic Passage

Jing Qian, Weiping Zhang, Hong Yuan Ling

Phys. Rev. A 78, 021402(R) (2008)] to a photoassociation-based chainwise atom-moleculesystem, with the goal of directly convertingtwo-species atomic Bose-Einstein condensates(BEC) intoa ground polar molecular BEC. We pay particular attention to the intermediate Raman laser fields,a control knob inaccessible to the usual three-level model. We find that an appropriate explorationof both the intermediate laser fields and the stability property of the atom-molecule STIRAP cangreatly reduce the power demand on the photoassociation laser, a key concern for STIRAPs startingfrom free atoms due to the small Franck-Condon factor in the free-bound transition.

Bulletin of the American Physical Society•May 21, 2009•0 citations

Reply to “Comment on ‘Stimulated Raman adiabatic passage from an atomic to a molecular Bose-Einstein condensate’ ”

P. D. Drummond, Karen V. Kheruntsyan, Daniel J. Heinzen +1 more

In the preceding Comment, the authors suggest that the molecular conversion efficiency in atom-molecule stimulated Raman adiabatic passage can be improved by lowering the initial atomic density, which in turn requires longer pulse durations to maintain adiabaticity. Apart from the fact that the mean-field approximation becomes questionable at low densities, we point out that a low-density strategy with longer pulses has several problems. It generally requires higher pulse energies and increases radiative losses. We also show that even within the approximations used in the Comment, their example leads to no efficiency improvement compared to our high-density case. In a more careful analysis including radiative losses neglected in the Comment, the proposed strategy gives almost no conversion owing to the longer pulse durations required.

arXiv:physics/0410115•Physical Review A•Jan 20, 2005•18 citations

Observation of Bose-enhanced photoassociation products

A. Ciamei, Alex Bayerle, Benjamin Pasquiou +1 more

We produce 84 Sr 2 molecules using Bose-enhanced Raman photoassociation. We apply the stimulated Raman adiabatic passage (STIRAP) technique on a Bose-Einstein condensate (BEC) to produce more than 8 × 10 3 ultracold molecules. This chemical reaction is only made possible because of the Bose enhancement of the optical transition dipole moment between the initial atomic state and an intermediate molecular state. We study the effect of Bose enhancement by measuring the transition Rabi frequency in a BEC and by comparing it with measurements for two atoms in sites of a Mott insulator. By breaking the dimers' bond and directly observing the separated atoms, we measure the molecular inelastic collision rate parameters. We discuss the possibility of applying Bose-enhanced STIRAP to convert a BEC of atoms into a BEC of molecules, and argue that the required efficiency for STIRAP is within experimental reach.

arXiv:1708.00299•Europhysics Letters (EPL)•Aug 1, 2017•9 citations
We present an approach for effectively converting atomic Bose–Einstein condensate (BEC) into molecular one. Atoms are converted into molecules through a series of intermediate vibrational states by using chainwise stimulated Raman adiabatic passage technique. We utilize a feasible pulse sequence to achieve higher conversion efficiency by solving the coupled mean-field equations. As an example, we investigate the formation of Rb 2 and calculate conversion efficiency to be 92.3%.
Summary form only given. Coherent conversion of an atomic to a molecular Bose-Einstein condensate (BEC) is a first step towards 'superchemistry', which is the atom optics analog of frequency conversion in nonlinear optics. A number of studies of this have shown that direct conversion via Raman photo-association appears feasible, based on stimulated free-bound and bound-bound transitions in the presence of two laser fields E/sup (1)/=E/sub 0//sup (1)/ cos(/spl omega//sup (1)/t) and E/sup (2)/=E/sub 0//sup (2)/ cos(/spl omega//sup (2)/t). Here pairs of atoms from the two-atom continuum are transferred-via an excited bound molecular state-to a bound molecular state of lower energy. Raman photo-association allows coupling to a single molecular state, which can be selected by the Raman laser frequencies /spl omega//sup (1)/ and /spl omega//sup (2)/. However, practical calculations using available lasers and transitions indicate that coherent transfer is often limited by spontaneous emission from the intermediate molecular excited electronic state. A possible route towards minimizing losses and decoherence from spontaneous emission is to use the stimulated Raman adiabatic passage (STIRAP) method (Drummond et al, Phys. Rev. Lett. vol. 81, p. 3055, 1998) in which a counter-intuitive pulse sequence is used where the first input pulse couples the molecular levels, even when there are no molecules present.
We generalize the idea of chainwise stimulated Raman adiabatic passage (STIRAP) [Kuznetsova et al., Phys. Rev. A 78, 021402(R) (2008)] to a photoassociation-based chainwise atom-molecule system, with the goal of directly converting two-species atomic Bose-Einstein condensates (BEC) into a ground polar molecular BEC. We pay particular attention to the intermediate Raman laser fields, a control knob inaccessible to the usual three-level model. We find that an appropriate exploration of both the intermediate laser fields and the stability property of the atom-molecule STIRAP can greatly reduce the power demand on the photoassociation laser, a key concern for STIRAPs starting from free atoms due to the small Franck-Condon factor in the free-bound transition.
The process of stimulated Raman adiabatic passage (STIRAP) provides a possible route for the generation of a coherent molecular Bose-Einstein condensate (BEC) from an atomic BEC. We analyze this process in a three-dimensional mean-field theory, including atom-atom interactions and nonresonant intermediate levels. We find that the process is feasible, but at larger Rabi frequencies than anticipated from a crude single-mode lossless analysis, due to two-photon dephasing caused by the atomic interactions. We then identify optimal strategies in STIRAP allowing one to maintain high conversion efficiencies with smaller Rabi frequencies and under experimentally less demanding conditions.
Phys. Rev. A 78, 021402(R) (2008)] to a photoassociation-based chainwise atom-moleculesystem, with the goal of directly convertingtwo-species atomic Bose-Einstein condensates(BEC) intoa ground polar molecular BEC. We pay particular attention to the intermediate Raman laser fields,a control knob inaccessible to the usual three-level model. We find that an appropriate explorationof both the intermediate laser fields and the stability property of the atom-molecule STIRAP cangreatly reduce the power demand on the photoassociation laser, a key concern for STIRAPs startingfrom free atoms due to the small Franck-Condon factor in the free-bound transition.
In the preceding Comment, the authors suggest that the molecular conversion efficiency in atom-molecule stimulated Raman adiabatic passage can be improved by lowering the initial atomic density, which in turn requires longer pulse durations to maintain adiabaticity. Apart from the fact that the mean-field approximation becomes questionable at low densities, we point out that a low-density strategy with longer pulses has several problems. It generally requires higher pulse energies and increases radiative losses. We also show that even within the approximations used in the Comment, their example leads to no efficiency improvement compared to our high-density case. In a more careful analysis including radiative losses neglected in the Comment, the proposed strategy gives almost no conversion owing to the longer pulse durations required.
We produce 84 Sr 2 molecules using Bose-enhanced Raman photoassociation. We apply the stimulated Raman adiabatic passage (STIRAP) technique on a Bose-Einstein condensate (BEC) to produce more than 8 × 10 3 ultracold molecules. This chemical reaction is only made possible because of the Bose enhancement of the optical transition dipole moment between the initial atomic state and an intermediate molecular state. We study the effect of Bose enhancement by measuring the transition Rabi frequency in a BEC and by comparing it with measurements for two atoms in sites of a Mott insulator. By breaking the dimers' bond and directly observing the separated atoms, we measure the molecular inelastic collision rate parameters. We discuss the possibility of applying Bose-enhanced STIRAP to convert a BEC of atoms into a BEC of molecules, and argue that the required efficiency for STIRAP is within experimental reach.