Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Japanese Journal of Applied Physics

Composite Josephson Device

Masakazu Nakanishi, Ko Hara

Published May 1, 1984• 3 citations
Publisher

Abstract

A superconductive loop circuit including more than four Josephson junctions (JJ), which is called a Composite Josephson Device (CJD), can support a fluxoid stably without inductance and has multiple stable states depending on the number of fluxoids. One of the simplest cases of CJD with a three-terminal six JJ loop device is analyzed numerically. The result shows that it has five stable areas and is able to operate as a current amplifier within a certain parameter range.

DOI
10.1143/jjap.23.l321

Related papers

Experimental Test of the Composite Josephson Device

Masakazu Nakanishi, Ko Hara

A circuit composed of superconductive loops of 4 Josephson junctions (abbreviated as JJ) or more with infinitesimal loop area is named as a Composite Josephson device (abbreviated as CJD). Its numerical analysis has been reported before. One of the CJD, a 3 terminal 6 JJ loop device, is fabricated by the microbridge utilizing step edge technology and its experimental tests are reported in this paper. Its numerical analysis is proved by the experimental tests.

Japanese Journal of Applied Physics•Nov 1, 1985•1 citation

Variable superconducting quantum-interference device: Theory

H. J. Fink, V. Grünfeld, S. M. Roberts

A dc superconducting quantum interference device (SQUID) consisting of a symmetric ring circuit with four Josephson junctions and two independent external currents ${I}_{1}$ and ${I}_{2}$, which enter the circuit at different points, has a phase boundary between the fully superconducting and the normal states that is different from that of a conventional SQUID. The control current ${I}_{2}$ modifies the magnetic flux (\ensuremath{\varphi}) periodicity and the value of the maximum measuring current ${I}_{1m}$(\ensuremath{\varphi}). For values of ${I}_{2}$>${I}_{c}$ (critical current of Josephson junction) the fully resistive state exists over flux intervals centered around (n+(1/2)${\ensuremath{\varphi}}_{0}$, where n is an integer and ${\ensuremath{\varphi}}_{0}$ is the fluxoid quantum. A superconducting circuit without Josephson junctions is suggested which should have a phase boundary similar to that found here. Minimization procedures which are usually employed in analyzing SQUID's are discussed.

Physical review. B, Condensed matter•Jul 1, 1987•5 citations

Dynamic properties of a superconducting quantum interference device containing arrays of Josephson junctions

Marian Darula, P. Seidel, F. H. Busse +1 more

The dynamic properties of a superconducting quantum interference device (SQUID) containing arrays of Josephson junctions in a superconducting loop, and in particular the case of a four-junction SQUID, is analyzed theoretically via computer simulations. It is shown that phase locking of Josephson junctions determines the dynamic behavior of the SQUID. In the case of a stable phase-lock state hysteretic I-V curves as well as unusual voltage-flux dependencies appear. The influence of a small spread in the Josephson junction parameters upon the stability of the phase-lock state is investigated in parameter space.

Journal of Applied Physics•Aug 15, 1993•21 citations

Flux qubit with a large loop size and tunable Josephson junctions

邓辉, 于海峰, 薛光明 +6 more

We present the design of a superconducting flux qubit with a large loop inductance. The large loop inductance is desirable for coupling between qubits. The loop is configured into a gradiometer form that could reduce the interference from environmental magnetic noise. A combined Josephson junction, i.e., a DC-SQUID is used to replace the small Josephson junction in the usual 3-JJ (Josephaon junction) flux qubit, leading to a tunable energy gap by using an independent external flux line. We perform numerical calculations to investigate the dependence of the energy gap on qubit parameters such as junction capacitance, critical current, loop inductance, and the ratio of junction energy between small and large junctions in the flux qubit. We suggest a range of values for the parameters.

中国物理B：英文版•Jan 1, 2012•0 citations

Flux qubit with a large loop size and tunable Josephson junctions

Hui Deng, Haifeng Yu, Guangming Xue +6 more

We present the design of a superconducting flux qubit with a large loop inductance. The large loop inductance is desirable for coupling between qubits. The loop is configured into a gradiometer form that could reduce the interference from environmental magnetic noise. A combined Josephson junction, i.e., a DC-SQUID is used to replace the small Josephson junction in the usual 3-JJ (Josephaon junction) flux qubit, leading to a tunable energy gap by using an independent external flux line. We perform numerical calculations to investigate the dependence of the energy gap on qubit parameters such as junction capacitance, critical current, loop inductance, and the ratio of junction energy between small and large junctions in the flux qubit. We suggest a range of values for the parameters.

Chinese Physics B•Apr 1, 2012•2 citations

Analysis of strong inductive coupling on SQUID systems

Claudia D. Tesche

A technique for the analysis of complex superconducting circuits containing one or more current biased inductively coupled Josephson junction interferometers is described. The equations of motion for the system are shown to separate into a set of non-linear junction equations relating the voltage drops across the junctions to the currents passing through the junctions, and a set of linear equations expressing the quantization of the fluxoid around the superconducting loops and the corresponding linear circuit equations for the normal loops. In many cases, the linear equations can be integrated, resulting in an effective elimination of the normal circuit loops from the problem. The circuit is thus reduced to that of an equivalent set of coupled SQUIDs whose device parameters are a function of the original circuit parameters and the inductive coupling strengths. The dc SQUID tuned linear amplifier is analyzed to display the method. As a result of this analysis, the optimal noise temperature of a tuned SQUID amplifier is derived as a function of the current and voltage noise spectral densities, Svand Sj, and forward transfer function, Vφ. The results obtained demonstrate that the behavior of the SQUID cannot be isolated from that of the rest of the circuit in the manner assumed in previous analyses. The existence of a quantum noise limit on the noise temperature of any phase preserving linear amplifier is used to infer that the noise figures must satisfy the constraint[(S_{v}/2LV_{\phi}^{2})(LS_{j}/2)-S_{vj}^{2}]^{1/2}>\hbarThe behavior of several simple circuits containing a pair of inductively coupled current biased interferometers is discussed to display the extension of the method to circuits containing more than one interferometer.

IEEE Transactions on Magnetics•May 1, 1983•12 citations
A superconductive loop circuit including more than four Josephson junctions (JJ), which is called a Composite Josephson Device (CJD), can support a fluxoid stably without inductance and has multiple stable states depending on the number of fluxoids. One of the simplest cases of CJD with a three-terminal six JJ loop device is analyzed numerically. The result shows that it has five stable areas and is able to operate as a current amplifier within a certain parameter range.
A dc superconducting quantum interference device (SQUID) consisting of a symmetric ring circuit with four Josephson junctions and two independent external currents I1{I}_{1}I1​ and I2{I}_{2}I2​, which enter the circuit at different points, has a phase boundary between the fully superconducting and the normal states that is different from that of a conventional SQUID. The control current I2{I}_{2}I2​ modifies the magnetic flux (\ensuremath{\varphi}) periodicity and the value of the maximum measuring current I1m{I}_{1m}I1m​(\ensuremath{\varphi}). For values of I2{I}_{2}I2​>Ic{I}_{c}Ic​ (critical current of Josephson junction) the fully resistive state exists over flux intervals centered around (n+(1/2)${\ensuremath{\varphi}}_{0}$, where n is an integer and ${\ensuremath{\varphi}}_{0}$ is the fluxoid quantum. A superconducting circuit without Josephson junctions is suggested which should have a phase boundary similar to that found here. Minimization procedures which are usually employed in analyzing SQUID's are discussed.
The dynamic properties of a superconducting quantum interference device (SQUID) containing arrays of Josephson junctions in a superconducting loop, and in particular the case of a four-junction SQUID, is analyzed theoretically via computer simulations. It is shown that phase locking of Josephson junctions determines the dynamic behavior of the SQUID. In the case of a stable phase-lock state hysteretic I-V curves as well as unusual voltage-flux dependencies appear. The influence of a small spread in the Josephson junction parameters upon the stability of the phase-lock state is investigated in parameter space.
We present the design of a superconducting flux qubit with a large loop inductance. The large loop inductance is desirable for coupling between qubits. The loop is configured into a gradiometer form that could reduce the interference from environmental magnetic noise. A combined Josephson junction, i.e., a DC-SQUID is used to replace the small Josephson junction in the usual 3-JJ (Josephaon junction) flux qubit, leading to a tunable energy gap by using an independent external flux line. We perform numerical calculations to investigate the dependence of the energy gap on qubit parameters such as junction capacitance, critical current, loop inductance, and the ratio of junction energy between small and large junctions in the flux qubit. We suggest a range of values for the parameters.
We present the design of a superconducting flux qubit with a large loop inductance. The large loop inductance is desirable for coupling between qubits. The loop is configured into a gradiometer form that could reduce the interference from environmental magnetic noise. A combined Josephson junction, i.e., a DC-SQUID is used to replace the small Josephson junction in the usual 3-JJ (Josephaon junction) flux qubit, leading to a tunable energy gap by using an independent external flux line. We perform numerical calculations to investigate the dependence of the energy gap on qubit parameters such as junction capacitance, critical current, loop inductance, and the ratio of junction energy between small and large junctions in the flux qubit. We suggest a range of values for the parameters.
A technique for the analysis of complex superconducting circuits containing one or more current biased inductively coupled Josephson junction interferometers is described. The equations of motion for the system are shown to separate into a set of non-linear junction equations relating the voltage drops across the junctions to the currents passing through the junctions, and a set of linear equations expressing the quantization of the fluxoid around the superconducting loops and the corresponding linear circuit equations for the normal loops. In many cases, the linear equations can be integrated, resulting in an effective elimination of the normal circuit loops from the problem. The circuit is thus reduced to that of an equivalent set of coupled SQUIDs whose device parameters are a function of the original circuit parameters and the inductive coupling strengths. The dc SQUID tuned linear amplifier is analyzed to display the method. As a result of this analysis, the optimal noise temperature of a tuned SQUID amplifier is derived as a function of the current and voltage noise spectral densities, Svand Sj, and forward transfer function, Vφ. The results obtained demonstrate that the behavior of the SQUID cannot be isolated from that of the rest of the circuit in the manner assumed in previous analyses. The existence of a quantum noise limit on the noise temperature of any phase preserving linear amplifier is used to infer that the noise figures must satisfy the constraint[(S_{v}/2LV_{\phi}^{2})(LS_{j}/2)-S_{vj}^{2}]^{1/2}>\hbarThe behavior of several simple circuits containing a pair of inductively coupled current biased interferometers is discussed to display the extension of the method to circuits containing more than one interferometer.