The manipulation of gas-phase molecules with electric and magnetic fields above a chip is an emerging field of research. Miniaturization of the electric and magnetic field structures allows for the creation of large field gradients and tight traps above the chip. Present-day microelectronics technology enables the integration of complicated tools and devices on a compact surface area. The molecules can be positioned extremely accurately and reproducibly above the chip where they can be held isolated from their environment and where there is excellent access to them. It is expected that several of the gas-phase molecular beam experiments that are currently being done in machines that are up to several meters in length can in the future be performed on a surface area of a few cm 2 and that many new experiments will become possible.
The manipulation of gas-phase molecules with electric and magnetic fields above a chip is an emerging field of research. Miniaturization of the electric and magnetic field structures allows for the creation of large field gradients and tight traps above the chip. Present-day microelectronics technology enables the integration of complicated tools and devices on a compact surface area. The molecules can be positioned extremely accurately and reproducibly above the chip where they can be held isolated from their environment and where there is excellent access to them. It is expected that several of the gas-phase molecular beam experiments that are currently being done in machines that are up to several meters in length can in the future be performed on a surface area of a few cm 2 and that many new experiments will become possible.
Magnetic trapping of atoms on chips has recently become straightforward, but analogous trapping of molecules has proved to be challenging. We demonstrated trapping of carbon monoxide molecules above a chip using direct loading from a supersonic beam. Upon arrival above the chip, the molecules are confined in tubular electric field traps approximately 20 micrometers in diameter, centered 25 micrometers above the chip, that move with the molecular beam at a velocity of several hundred meters per second. An array of these miniaturized moving traps is brought to a standstill over a distance of only a few centimeters. After a certain holding time, the molecules are accelerated off the chip again for detection. This loading and detection methodology is applicable to a wide variety of polar molecules, enabling the creation of a gas-phase molecular laboratory on a chip.
The motion of molecules that possess a permanent electric or magnetic dipole moment can be manipulated using electric or magnetic fields. Various devices have been developed over the last few decades to deflect or focus molecules, to orient them in space, and to decelerate or accelerate them. These precisely controlled molecules are ideal starting points for scattering experiments that reveal the quantum mechanical nature of molecular interactions. In this Tutorial Review, we present an overview of the various manipulation tools, discuss how they can be used to advantage in molecular beam scattering experiments, and review recent progress in this field. We describe a selection of benchmark experiments that illustrate the unique possibilities that are available nowadays to study molecular collisions under controlled conditions.
A study was conducted to demonstrate the manipulation of molecular beams with electric and magnetic fields. Seeded pulsed supersonic expansions were employed to conduct the investigations. The conservative forces exerted further downstream by the electric and magnetic fields enabled the researchers to manipulate and control the shape and the position of the distribution in the six-dimensional phase-space. All of the original experimental geometries were devised to create strong magnetic or electric field gradients to efficiently deflect particles from the beam axis. It was demonstrated that a detailed understanding of the influence of the external field on the energy level structure of the molecules was required for the manipulation of molecules with electric or magnetic fields.
The subject of this thesis’s work is research of cold molecules on a microchip. On the one hand, cold and ultracold molecules might allow high- precision measurements of molecular properties and the determination of their behavior at the quantum level. On the other hand, one could try to study highly controlled chemical reactions or to build a quantum computer with their help. In the experiments presented here, electrically neutral, polar molecules in low-field-seeking states are trapped and decelerated on a microchip with the help of electric fields. This exploits the Stark effect: the energy level shift of atoms and molecules in an electric field. After manipulation on the chip the molecules can be detected quantum-state specifically via the REMPI method. At first, CO molecules were prepared in the upper Λ-doublet component of the a3Π1, v = 0, J = 1 state, trapped on the chip and get vibrationally excited by an infrared laser in the middle of the chip to the J = 1 or J = 2 rotational state of the vibrational state v = 1. This could be shown experimentally and was analyzed theoretically for molecules which were trapped at all times. Secondly, CO molecules were detected on the chip and the structure of previously trapped molecule clouds of several of the only 120 μm spaced traps was spatially resolved. For this purpose the chip was extended with an ion lens setup, which enabled the determination of the temperature of the clouds by following the free ballistic expansion of the molecules in time; either by comparing the data to trajectory simulations (T = 11 ± 1 mK) or by applying a ballistic expansion model (T = 13 ± 3.5 mK), comparable to the method used by the ultracold atom community. The spatial imaging enabled the observation of a phasespace manipulation scheme, which adiabatically expanded the molecules in the trap and significantly reduces their temperature to approximately one third of their initial value. The third goal was to trap ground state ammonia molecules, which should extend the trapping time and would show that also other molecules could be trapped on the chip. The ammonia isotopologues 14NH3, 14ND3, and 15ND3 in the |vInv = 1, J = 1,K = 1> state of the electronic ground state X were used. No signal could be measured from trapped molecules, which is attributed to large nonadiabatic transitions to untrappable quantum states, leading to severe trap loss. At last, a new chip- based Stark decelerator is presented, which is a miniaturized version of the so-called “traveling-wave” ring decelerator. This chip-based decelerator should be able to trap more molecules compared to the chip that was used so far, and due to improved electronics it should be able to decelerate molecules from molecular beam velocities of approximately 360 m/s down to a standstill, in contrast to large-scale traveling-wave decelerators so far. The chip is still in development to achieve operation with the full specification (voltage). Performance simulations show the usefulness of this design, which needs to be tested in experiments.
Atom chips are robust and extremely powerful toolboxes for quantum optical experiments, since they make it possible to create exceedingly precise magnetic traps for neutral atoms with minimal field modulations. Accurate manipulation of trapped atoms is feasible with magnetic and electric fields created on the atom chip. Therefore atom chips with high quality surfaces and extremely well defined wires were build (roughness < 20nm). Furthermore new generations of atom chips were developed, like the multi-layer atom chip with contact-free wire crossings, the sub-micron structured atom chip and the semiconducting atom chip. Extensive characterisation measurements of atom chip wires demonstrated that the wires stand current densities of up to 10^7A/cm^2 for seconds and voltage differences of more than 500V over 10µm. From the different materials tested doped silicon with a thin silicon dioxide layer is the best qualified substrate for atom chip fabrication. The atom chips fabricated during this thesis have been used in many successful experiments, yielding numerous results. Moreover this thesis established the basics for many further experiments in atom physics and quantum optics and delivers complete instructions for the fabrication of all developed atom chips as well as an introduction to the experiments.
The merging of molecular beam methods with those of accelerator physics has yielded new tools to manipulate the motion of molecules. Over the last few years, decelerators, lenses, bunchers, traps, and storage rings for neutral molecules have been demonstrated. Molecular beams with a tunable velocity and with a tunable width of the velocity distribution can now be produced, and are expected to become a valuable tool in a variety of physical chemistry and chemical physics experiments. Here we present a compact molecular beam machine, capable of producing 3D spatially focused packets of state-selected accelerated or decelerated molecules.