Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Nanowire single-photon detector with an integrated optical cavity and anti-reflection coating

Kristine M. Rosfjord, Joel K. W. Yang, Eric A. Dauler, Andrew J. Kerman, Vikas Anant, Boris M. Voronov, Gregory N Gol'tsman, Karl K. Berggren

Published Jan 1, 2006• 403 citations
Publisher

Abstract

We have fabricated and tested superconducting single-photon detectors and demonstrated detection efficiencies of 57% at 1550-nm wavelength and 67% at 1064 nm. In addition to the peak detection efficiency, a median detection efficiency of 47.7% was measured over 132 devices at 1550 nm. These measurements were made at 1.8K, with each device biased to 97.5% of its critical current. The high detection efficiencies resulted from the addition of an optical cavity and anti-reflection coating to a nanowire photodetector, creating an integrated nanoelectrophotonic device with enhanced performance relative to the original device. Here, the testing apparatus and the fabrication process are presented. The detection efficiency of devices before and after the addition of optical elements is also reported.

DOI
10.1364/opex.14.000527

Related papers

Increased detection efficiencies of nanowire single-photon detectors by integration of an optical cavity and anti-reflection coating

Kristine M. Rosfjord, Joel K. W. Yang, Eric A. Dauler +5 more

We fabricate and test superconducting NbN-nanowire single-photon detectors with an integrated optical cavity and anti-reflection coating. We design the cavity and coating such as to maximize absorption in the NbN film of the detector.

Conference on Lasers and Electro-Optics•Jan 1, 2006•1 citation

Improving detection efficiency of superconducting nanowire single-photon detector using multilayer antireflection coating

Hao Li, Xiaoyan Yang, Lixing You +5 more

Optical cavity with backside optical coupling is one of the prevalent optical structures for superconducting nanowire single photon detector. A single layer anti-reflection coating (ARC) on the backside of the substrate is often adopted to enhance the transmittance to the substrate. We here apply a multilayer ARC to further increase the transmittance from 94.5% to 99.5%. An NbTiN SNSPD made on such a substrate with cavity structure presents a system detection efficiency of 90.1% at a dark count rate (DCR) of 100 Hz, which is the best value reported for backside optical coupled SNSPD at 1550 nm. It shows a timing jitter of ∼40.7 ps and the recovery time constant of ∼22.9 ns.

AIP Advances•Nov 1, 2018•18 citations

Enhancing Detection Efficiency by Applying an Optical Cavity Structure in a Superconducting Nanowire Single-Photon Detector

Shigehito Miki, Taro Yamashita, Mikio Fujiwara +2 more

We report on the enhancement of system detection efficiency in a superconducting nanowire single-photon detector (SNSPD) by applying the optical cavity structure. The nanowire was made using 4-nm-thick NbN thin films and covered with an SiO cavity and Au mirror designed for 1300-1600nm wavelengths. The device is mounted into fiber-coupled packages, and installed in a practical multichannel system based on GM cryocoolers. System detection efficiency depends on the absorptance of cavity structure, and reached 28% and 40% at 1550nm and 1310nm wavelengths, respectively. These values were considerably higher than an SNSPD without optical cavity.

IEICE Transactions on Electronics•Jan 1, 2011•3 citations

Superconducting single photon detectors for quantum information processing

Robert A. Kirkwood

Single photon detectors are a vital part of many emerging technologies which harness the quantum properties of light to benefit the fields of communication, computation and sensing. Superconducting nanowire single photon detectors (SNSPDs) offer high detection efficiency, low dark count rates, low timing jitter, and infrared sensitivity that are required by the most demanding single photon counting applications. This thesis presents SNSPDs fabricated and tested at the University of Glasgow that are integrated with optical structures which enable enhanced detection efficiency and integration with waveguide circuit technology. The monolithic integration of waveguide circuit components presents a route towards realisation of an optical quantum information processor that has the stability and scalability to perform the demanding tasks of quantum computation. A novel process is introduced for incorporating superconducting detectors with single mode gallium arsenide waveguides and quantum dot single photon sources. Together these elements would enable the generation of quantum states of light which could be manipulated and detected on a single chip. Detectors are patterned in NbTiN thin superconducting films on to suspended nanobeam waveguides with better than 50 nm alignment accuracy. Low temperature electrical and optical testing confirms the detectors’ single photon sensitivity under direct illumination as well as to waveguide coupled light. Measured detectors were found to have internal registering efficiencies of 6.8 ± 2.4%. Enhancing absorption of photons into thin superconducting films is vital to the creation of high efficiency superconducting single photon detectors. Fabricating an SNSPD on a dielectric mirror creates a partial cavity that can be tailored to enhance detection of light at specific wavelengths. Devices have been fabricated and tested in this thesis with enhanced detection efficiency at infrared and visible wavelengths for quantum cryptography, remote sensing and life science applications. Detectors fabricated in NbTiN on GaAs/AlGaAs Bragg mirrors exhibited a system detection efficiency of 1.5% at 1500 nm wavelength for the best device measured. SNSPDs were also fabricated in NbN on aperiodic dielectric mirrors with a range of different bandwidths. A peak system detection efficiency of 82.7% at 808 nm wavelength was recorded.

•Jan 1, 2017•1 citation

Performances of NbTiN superconducting nanowire single photon detector

Shigehito Miki, Taro Yamashita, Hirotaka Terai +1 more

We present high performance fiber-coupled niobium titanium nitride superconducting nanowire single photon detectors fabricated on thermally oxidized silicon substrates. By applying a double sided cavity structure, simulated absorptance in the nanowire meander reached 97% at 1550 nm wavelength. The fabricated device showed a system detection efficiency (DE) of 74% at 1550 nm, dark count rate of 100 c/s, and a full width at half maximum timing jitter of 68 ps under a bias current of 18.0 μA with a practical Gifford-McMahon cryocooler system.

IEEE International Superconductive Electronics Conference (ISEC)•Jul 1, 2013•1 citation

Superconducting nanowire single-photon detector in an optical cavity for front-side illumination

Burm Baek, Jeffrey A. Stern, Sae Woo Nam

We have integrated superconducting nanowire single-photon detectors (SNSPDs) with an optical cavity design for front-side illumination. Our optical cavity design increases the coupling efficiency of light to the nanowire detector and enables straightforward proximity fiber-coupling for a multichannel detector system. Using a confocal optical scanning technique, we measured a significantly enhanced optical absorptance of 73% in comparison with 20% in a typical bare nanowire device at 1550 nm and 3 K. Our method of fabrication of these devices on a silicon wafer and the local optical absorptance measurement are important steps toward developing next-generation SNSPD technology.

Applied Physics Letters•Nov 9, 2009•38 citations
We have fabricated and tested superconducting single-photon detectors and demonstrated detection efficiencies of 57% at 1550-nm wavelength and 67% at 1064 nm. In addition to the peak detection efficiency, a median detection efficiency of 47.7% was measured over 132 devices at 1550 nm. These measurements were made at 1.8K, with each device biased to 97.5% of its critical current. The high detection efficiencies resulted from the addition of an optical cavity and anti-reflection coating to a nanowire photodetector, creating an integrated nanoelectrophotonic device with enhanced performance relative to the original device. Here, the testing apparatus and the fabrication process are presented. The detection efficiency of devices before and after the addition of optical elements is also reported.
Optical cavity with backside optical coupling is one of the prevalent optical structures for superconducting nanowire single photon detector. A single layer anti-reflection coating (ARC) on the backside of the substrate is often adopted to enhance the transmittance to the substrate. We here apply a multilayer ARC to further increase the transmittance from 94.5% to 99.5%. An NbTiN SNSPD made on such a substrate with cavity structure presents a system detection efficiency of 90.1% at a dark count rate (DCR) of 100 Hz, which is the best value reported for backside optical coupled SNSPD at 1550 nm. It shows a timing jitter of ∼40.7 ps and the recovery time constant of ∼22.9 ns.
We report on the enhancement of system detection efficiency in a superconducting nanowire single-photon detector (SNSPD) by applying the optical cavity structure. The nanowire was made using 4-nm-thick NbN thin films and covered with an SiO cavity and Au mirror designed for 1300-1600nm wavelengths. The device is mounted into fiber-coupled packages, and installed in a practical multichannel system based on GM cryocoolers. System detection efficiency depends on the absorptance of cavity structure, and reached 28% and 40% at 1550nm and 1310nm wavelengths, respectively. These values were considerably higher than an SNSPD without optical cavity.
Single photon detectors are a vital part of many emerging technologies which harness the quantum properties of light to benefit the fields of communication, computation and sensing. Superconducting nanowire single photon detectors (SNSPDs) offer high detection efficiency, low dark count rates, low timing jitter, and infrared sensitivity that are required by the most demanding single photon counting applications. This thesis presents SNSPDs fabricated and tested at the University of Glasgow that are integrated with optical structures which enable enhanced detection efficiency and integration with waveguide circuit technology. The monolithic integration of waveguide circuit components presents a route towards realisation of an optical quantum information processor that has the stability and scalability to perform the demanding tasks of quantum computation. A novel process is introduced for incorporating superconducting detectors with single mode gallium arsenide waveguides and quantum dot single photon sources. Together these elements would enable the generation of quantum states of light which could be manipulated and detected on a single chip. Detectors are patterned in NbTiN thin superconducting films on to suspended nanobeam waveguides with better than 50 nm alignment accuracy. Low temperature electrical and optical testing confirms the detectors’ single photon sensitivity under direct illumination as well as to waveguide coupled light. Measured detectors were found to have internal registering efficiencies of 6.8 ± 2.4%. Enhancing absorption of photons into thin superconducting films is vital to the creation of high efficiency superconducting single photon detectors. Fabricating an SNSPD on a dielectric mirror creates a partial cavity that can be tailored to enhance detection of light at specific wavelengths. Devices have been fabricated and tested in this thesis with enhanced detection efficiency at infrared and visible wavelengths for quantum cryptography, remote sensing and life science applications. Detectors fabricated in NbTiN on GaAs/AlGaAs Bragg mirrors exhibited a system detection efficiency of 1.5% at 1500 nm wavelength for the best device measured. SNSPDs were also fabricated in NbN on aperiodic dielectric mirrors with a range of different bandwidths. A peak system detection efficiency of 82.7% at 808 nm wavelength was recorded.
We present high performance fiber-coupled niobium titanium nitride superconducting nanowire single photon detectors fabricated on thermally oxidized silicon substrates. By applying a double sided cavity structure, simulated absorptance in the nanowire meander reached 97% at 1550 nm wavelength. The fabricated device showed a system detection efficiency (DE) of 74% at 1550 nm, dark count rate of 100 c/s, and a full width at half maximum timing jitter of 68 ps under a bias current of 18.0 μA with a practical Gifford-McMahon cryocooler system.
We have integrated superconducting nanowire single-photon detectors (SNSPDs) with an optical cavity design for front-side illumination. Our optical cavity design increases the coupling efficiency of light to the nanowire detector and enables straightforward proximity fiber-coupling for a multichannel detector system. Using a confocal optical scanning technique, we measured a significantly enhanced optical absorptance of 73% in comparison with 20% in a typical bare nanowire device at 1550 nm and 3 K. Our method of fabrication of these devices on a silicon wafer and the local optical absorptance measurement are important steps toward developing next-generation SNSPD technology.