Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE International New Circuits and Systems Conference (NEWCAS)

Parallel architecture for bandpass ΔΣ ADC in superconducting technology

Héla Gassara, Patricia Desgreys, Patrick Loumeau

Published Jun 1, 2011• 0 citations
Publisher

Abstract

Basing on a bandpass ΔΣ modulator model in superconducting technology, we propose to design and implement a time-interleaved parallel architecture for this type of ADC. The interest of such architecture consists in combining oversampling and time-interleaved techniques in order to obtain a high speed and large band superconducting ΔΣ ADC.

DOI
10.1109/newcas.2011.5981281

Related papers

Superconducting modulators for high dynamic range delta-sigma analog-to-digital converters

A. Hodge Worsham, Donald L. Miller, Paul D. Dresselhaus +2 more

Superconducting digital circuits are capable of producing high dynamic range analog-to-digital converters (ADCs). We present sigma-delta architectures using large (>100) oversampling ratios to give signal-to-noise ratios of greater than 100 dB in simulation. Three distinct designs, using two distinct mechanisms for feedback, are presented. All of the designs use only shunted junctions, and are therefore compatible with HTS SNS junctions. Simulations are presented for a modulator which creates feedback pulses by SQUID lobe-crossings, a modulator which uses the transresistance of a SQUID for feedback, and a modulator which uses threshold crossings in both the first and second loops for feedback.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•26 citations

Design of an I/Q Mixer for a Bandpass ΔΣ ADC in Superconducting Technology

Héla Gassara, Patricia Desgreys, Patrick Loumeau +1 more

•Sep 20, 2009•0 citations

Superconducting modulators for analog-to-digital converters

Peter Magnusson

The main topic of this thesis is the evaluation of performance of super-conducting rst- and second-order low-pass sigma-delta modulators. Superconducting electronics comprise characteristics such as very high switching speed, natural quantization, high sensitivity and low noise, proper-ties that are all essential for modulators used in high performance analog-to-digital converters (ADC). Sigma-delta modulators trade speed for improved resolution using feedback mechanisms making superconducting electronics an interesting alternative technology for the implementation. With linear models and device-level simulations the performance of these modulators have been evaluated. The linear model of the rst-order sigma-delta modulator shows that the performance, for a given oversampling ratio, only depends on the cut-o frequency of the RL-lter used. This is veried by device-level simulations and the results from the two methods are in good agreement. Device-level simulations of the second-order sigma-delta modu-

•Jan 1, 2005•1 citation

Superconductor analog-to-digital converters and their applications

Deepnarayan Gupta, Amol Inamdar, Dmitri E. Kirichenko +2 more

A wide variety of applications, ranging from radio-frequency (RF) receivers for broadband communications and signal detection, on earth and in space, would benefit from high-performance superconductor analog-to-digital converters (ADCs), based on magnetic flux quantization and fast switching Josephson junctions. Superconductor ADCs are capable of very high sample rates (100 GHz or more), very high linearity, and high sensitivity. Nyquist-rate ADCs use the high sample rate to digitize a wide instantaneous bandwidth (tens of GHz) and are useful for wideband spectrum monitoring as well as high-end scientific instrumentation. Delta and delta-sigma oversampling ADCs use the high linearity to achieve programmable trade-off between dynamic range and instantaneous bandwidth. These lowpass and bandpass ADCs have been used for direct digitization of narrower (tens to hundreds of MHz) RF bands in the 1-20 GHz range for a variety of communications, intelligence, electronic warfare, and radar applications. Another application area of these cryogenic ADCs is for outputs of cryogenic sensor arrays and terahertz mixers. Recent advances in various classes of ADCs for different applications are described.

IEEE MTT-S International Microwave Symposium digest•Jun 1, 2011•21 citations

Flux quantum sigma-delta analog-to-digital converters for rf signals

Donald L. Miller, John X. Przybysz, A. Hodge Worsham +1 more

The sigma-delta architecture is the method of choice for analog-to-digital converters (ADCs) for high dynamic range applications. This architecture uses oversampling and precise feedback to generate a shaped spectral distribution of the quantization noise. Subsequent digital filtering suppresses out-of-band quantization noise, yielding a large signal to in-band noise ratio. A unique advantage of superconducting electronics is the availability of the flux quantum to provide quantum mechanically accurate feedback at GHz rates. Josephson digital technology extends sigma-delta ADCs from MHz sampling rates to GHz sampling rates, from kHz signal bandwidths to MHz signal bandwidths, with comparable or better dynamic range when compared to semiconductor implementations. This paper presents circuits for Josephson sigma-delta ADCs, including single-loop and double-loop modulators operating at sampling rates up to 2 GHz, and circuits for quantized feedback. The first demonstration of double-loop noise shaping is also presented.

IEEE Transactions on Applied Superconductivity•Jun 1, 1999•25 citations

Superconducting bandpass delta-sigma modulator

John F. Bulzacchelli, H.-S. Lee, James A. Misewich +1 more

Bandpass delta-sigma modulators digitize narrowband signals with high dynamic range and linearity. The required sampling rate is only a few times higher than the centre frequency of the input. This paper presents a superconducting bandpass delta-sigma modulator for direct analogue-to-digital conversion of RF signals in the GHz range. The input signal is capacitively coupled to one end of a microstrip transmission line, and a single flux quantum balanced comparator quantizes the current flowing out of the other end. Quantization noise is suppressed at the quarter-wave resonance of the transmission line (about 2 GHz in our design). Circuit performance at a 20 GHz sampling rate has been studied with several long JSIM simulations. Full-scale (FS) input sensitivity is 20 mV (rms), and in-band noise is -53 dBFS and -57 dBFS over bandwidths of 39 MHz and 19.5 MHz, respectively. In-band intermodulation distortion is better than -69 dBFS.

Superconductor Science and Technology•Nov 1, 1999•13 citations
Basing on a bandpass ΔΣ modulator model in superconducting technology, we propose to design and implement a time-interleaved parallel architecture for this type of ADC. The interest of such architecture consists in combining oversampling and time-interleaved techniques in order to obtain a high speed and large band superconducting ΔΣ ADC.
Superconducting digital circuits are capable of producing high dynamic range analog-to-digital converters (ADCs). We present sigma-delta architectures using large (>100) oversampling ratios to give signal-to-noise ratios of greater than 100 dB in simulation. Three distinct designs, using two distinct mechanisms for feedback, are presented. All of the designs use only shunted junctions, and are therefore compatible with HTS SNS junctions. Simulations are presented for a modulator which creates feedback pulses by SQUID lobe-crossings, a modulator which uses the transresistance of a SQUID for feedback, and a modulator which uses threshold crossings in both the first and second loops for feedback.
The main topic of this thesis is the evaluation of performance of super-conducting rst- and second-order low-pass sigma-delta modulators. Superconducting electronics comprise characteristics such as very high switching speed, natural quantization, high sensitivity and low noise, proper-ties that are all essential for modulators used in high performance analog-to-digital converters (ADC). Sigma-delta modulators trade speed for improved resolution using feedback mechanisms making superconducting electronics an interesting alternative technology for the implementation. With linear models and device-level simulations the performance of these modulators have been evaluated. The linear model of the rst-order sigma-delta modulator shows that the performance, for a given oversampling ratio, only depends on the cut-o frequency of the RL-lter used. This is veried by device-level simulations and the results from the two methods are in good agreement. Device-level simulations of the second-order sigma-delta modu-
A wide variety of applications, ranging from radio-frequency (RF) receivers for broadband communications and signal detection, on earth and in space, would benefit from high-performance superconductor analog-to-digital converters (ADCs), based on magnetic flux quantization and fast switching Josephson junctions. Superconductor ADCs are capable of very high sample rates (100 GHz or more), very high linearity, and high sensitivity. Nyquist-rate ADCs use the high sample rate to digitize a wide instantaneous bandwidth (tens of GHz) and are useful for wideband spectrum monitoring as well as high-end scientific instrumentation. Delta and delta-sigma oversampling ADCs use the high linearity to achieve programmable trade-off between dynamic range and instantaneous bandwidth. These lowpass and bandpass ADCs have been used for direct digitization of narrower (tens to hundreds of MHz) RF bands in the 1-20 GHz range for a variety of communications, intelligence, electronic warfare, and radar applications. Another application area of these cryogenic ADCs is for outputs of cryogenic sensor arrays and terahertz mixers. Recent advances in various classes of ADCs for different applications are described.
The sigma-delta architecture is the method of choice for analog-to-digital converters (ADCs) for high dynamic range applications. This architecture uses oversampling and precise feedback to generate a shaped spectral distribution of the quantization noise. Subsequent digital filtering suppresses out-of-band quantization noise, yielding a large signal to in-band noise ratio. A unique advantage of superconducting electronics is the availability of the flux quantum to provide quantum mechanically accurate feedback at GHz rates. Josephson digital technology extends sigma-delta ADCs from MHz sampling rates to GHz sampling rates, from kHz signal bandwidths to MHz signal bandwidths, with comparable or better dynamic range when compared to semiconductor implementations. This paper presents circuits for Josephson sigma-delta ADCs, including single-loop and double-loop modulators operating at sampling rates up to 2 GHz, and circuits for quantized feedback. The first demonstration of double-loop noise shaping is also presented.
Bandpass delta-sigma modulators digitize narrowband signals with high dynamic range and linearity. The required sampling rate is only a few times higher than the centre frequency of the input. This paper presents a superconducting bandpass delta-sigma modulator for direct analogue-to-digital conversion of RF signals in the GHz range. The input signal is capacitively coupled to one end of a microstrip transmission line, and a single flux quantum balanced comparator quantizes the current flowing out of the other end. Quantization noise is suppressed at the quarter-wave resonance of the transmission line (about 2 GHz in our design). Circuit performance at a 20 GHz sampling rate has been studied with several long JSIM simulations. Full-scale (FS) input sensitivity is 20 mV (rms), and in-band noise is -53 dBFS and -57 dBFS over bandwidths of 39 MHz and 19.5 MHz, respectively. In-band intermodulation distortion is better than -69 dBFS.