Fine structure of VRFvs IRFdependence of the rf SQUID in the hysteretic mode is investigated experimentally at temperatures from 0.5 to 4.2 K. A suggestion is made that for high resistance point contacts of small capacitance the SQUID sensitivity may be limited by quantum processes for temperatures high enough (T\simeq4K). To explain the experimental results macroscopic quantum tunneling and zero-point fluctuations are considered as relevant mechanisms.
Fine structure of VRFvs IRFdependence of the rf SQUID in the hysteretic mode is investigated experimentally at temperatures from 0.5 to 4.2 K. A suggestion is made that for high resistance point contacts of small capacitance the SQUID sensitivity may be limited by quantum processes for temperatures high enough (T\simeq4K). To explain the experimental results macroscopic quantum tunneling and zero-point fluctuations are considered as relevant mechanisms.
The mechanisms of the decay of metastable current states in the superconducting loop of an rf SQUID in the hysteresis state are studied. Clamped point contacts are used as the Josephson weak link. The first derivative of the radio-frequency IVC dVT/dIRF, which gives the dependence of the decay probability density on the amplitude of the oscillations of the magnetic flux in the ring, was measured experimentally. Studies of the temperature dependence of the width of the probability distribution in the interval from 4.2 to 0.5 K show that for most high-resistance Nb–Nb, Nb–Ag–Nb contacts the quantum mechanisms of decay become dominant at a temperature of the order of 2 K. The experimentally measured parameters of the decay probability distribution in the quantum limit are compared with the theoretical values calculated based on the theory of macroscopic quantum tunneling in the limit of strong and weak dissipation. The experimental magnitude of the width of the probability density as well as the characteristic quantum temperature exceed the theoretical values, which can be explained by the deviation of the current-phase dependence of the contact from a sinusoidal dependence. In addition, some contacts apparently correspond to the case of an intermediate magnitude of dissipation. When the frequency of the rf oscillations changed from 30 to 6 MHz, the width of the distribution remained unchanged, which follows from the theory of quantum tunneling decay of the metastable current state in the loop in the limit of strong damping. At low temperatures (T ∼ 50 K) and for a sufficiently small damping coefficient, anomalous peaks were observed in the probability density with an amplitude of the rf oscillations significantly smaller than the critical magnitude of the magnetic flux in the loop.
We measured the amplitude–frequency characteristics of radio frequency superconducting quantum interference devices (rf SQUIDs) over a temperature range between 65 and 79 K. Using the expressions derived from the recently developed rf SQUID theory, valid also at large thermal fluctuations, we determined from these data the basic parameters of high-transition-temperature superconductor (HTS) rf SQUIDs. These parameters were: (a) the high-frequency coupling coefficient between the rf SQUID and the tank circuit resonator, k, (b) the SQUIDs hysteretic parameter, β, (c) the critical current of the Josephson junction, Ic, (d) its normal resistance, Rn, and (e) its noise parameter, Γ. We found a good agreement with the values of β(Ic) and Rn determined directly after destructively opening the SQUID loop. In accordance with the theoretical predictions, our experimental results show that at large thermal fluctuation levels (T≅77 K), rf SQUIDs with large loop inductance operate in nonhysteretic mode up to β values exceeding 3. Furthermore, we have shown that the optimal energy sensitivity is attained in the nonhysteretic mode at a value of β distinctly higher than 1. A quantitative comparison of white noise predicted by the theory with that obtained from the experiment showed a reasonable agreement. We also discussed the contribution of the phase information to the SQUID’s signal and noise at optimum operation conditions, when a mixer was used as a signal detector.
At low temperature and low damping, the magnetic flux of a rf Superconducting QUantum Interference Device (SQUID) acts as a macroscopic quantum variable whose dynamic is described by a double well potential. A rf SQUID consists of a superconducting loop interrupted by a thin insulating barrier, known as a Josephson junction. The modified rf SQUID design discussed in this thesis has independent, in situ, controls that allow varying the barrier height between the potential wells and their relative tilt. This high level of control of the potential together with the capability to implement an experimental setup optimized to reduce coupling to external sources of noise, made this system ideal not only for tests of quantum transition at a macroscopic level, but also as a scalable solid state device for quantum computation. A variety of measurements of quantum phenomena are reported in this thesis, including microwave level spectroscopy, coherent oscillations, and macroscopic resonant tunneling (MRT). These measurements are compared with theoretical models to study the possible sources of decoherence in a rf SQUID qubit. The analysis confirmed that the main source of decoherence is not due to coupling to the external environment, but it can be linked to intrinsic low frequency flux noise. Work from many groups over the last several years has shown that the performance of a superconductive qubit is limited by coupling to spurious defects in the materials used for the device fabrication. In this work we analyze the possibility of using the MRT as a tool for future studies of effects of materials and fabrication process in the realization of improved qubits, and we also explore the feasibility for measurements of quantum phenomena that involve fast pulsing of the potential barrier height.
The sensitivity limitations due to thermal, quantum and shot noise are calculated for dc and ac SQUIDs. Two approximations are used for the Josephson junctions: i. RSJ model with the equilibrium source of thermal-and-quantum fluctuations and ii. microscopic theory of the tunnel junctions with small capacitance (the latter theory takes into account the shot noise as well). The ultimate "output" sensitivity ε_{V}=/2L\Deltaf is shown to be substantially less than the Planck's constant h, for the both types of SQUIDs. This result does not contradict to the uncertainty principle, because the "total" sensitivity ε=(ε_{V}ε_{I}-εmin{IV}\max{2})^{1/2} rather than ε_{V} is an adequate figure of merit of SQUID as a linear amplifier. The total sensitivity is shown to be, in fact, limited by the quantum fluctuations, ε>h/2. These fluctuations originate in the shunting resistances of the dc SQUID, while in the ac SQUID they are due to quantum noise of the following stage of amplification. Nevertheless, even the total sensitivity ε can be made less than h/2, if the "degenerate" type of SQUID is used, being sensitive to the only one of the quadrature components of the input signal.
The spectral density of the low-frequency open-circuit intrinsic input noise of the hysteretic rf-biased SQUID is calculated. The noise level, which affects the optimized power sensitivity of the SQUID, is found to be strongly model dependent and thus also constitutes an interesting probe of device physics. The results of the calculation are significantly different from previous predictions. A direct measurement of the total input noise of a typical rf-biased SQUID system is reported. The results, which are consistent our calculation, correspond to a system noise temperature of 3.1±0.4 mK at a frequency of 1 kHz. This value is consistent with the Manley-Rowe equations and with previous experimentally determined upper limits.
Low-frequency noise in a hysteric rf superconducting quantum interference device (SQUID) originating from fluctuations of critical current of a weak link is considered. Such noise can be due to trapping-detrapping processes within the tunnel barrier or to the presence of structural defects with internal degrees of freedom in the surrounding of the weak link. The defects can switch between two (or more) metastable states due to interaction with the thermal bath. On the other hand, elastic (and electric) fields created by defects act upon the critical current of the weak link inducing its fluctuations in time. Such noise is most important for high-Tc SQUIDs at high enough temperatures when defects are effectively interacting with the thermal bath. The dependencies of the intensity and statistics of flicker noise on the SQUID’s parameters and operating regime are analyzed. It is shown that higher correlation functions of output voltage at a given driving current can provide some information on the mechanism of 1/f noise in rf SQUIDs.