Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)
Experimental state estimation for spatial qubits
Piotr Leszek Kolenderski, Kelsey D. Johnsen, Carmelo Scarcella, Deny R. Hamel, Krister Shalm, Simone Tisa, Alberto Tosi, Kevin J. Resch, Thomas D. Jennewein
We experimentally demonstrate a quantum state estimation and tomography for qubits encoded in a single photon's spatial degree of freedom. The experimental setup depicted in Fig. 1 consists of: 1) polarization entangled photon pairs source; 2) spatial encoder allowing to map a polarization state into spatial state; 3) polarization analyzer and 4) spatial state analyzer. The 28 element spatial quantum state measurement set was implemented using imaging optics and a linear array of 28 single photon avalanche diodes (SPAD). The timing information from all the detectors was acquired using custom made FPGA electronics.
We experimentally demonstrate a quantum state estimation and tomography for qubits encoded in a single photon's spatial degree of freedom. The experimental setup depicted in Fig. 1 consists of: 1) polarization entangled photon pairs source; 2) spatial encoder allowing to map a polarization state into spatial state; 3) polarization analyzer and 4) spatial state analyzer. The 28 element spatial quantum state measurement set was implemented using imaging optics and a linear array of 28 single photon avalanche diodes (SPAD). The timing information from all the detectors was acquired using custom made FPGA electronics.
A single photon has many physical degrees of freedom (DOF) that can carry the state of a high-dimensional quantum system. Nevertheless, only a single DOF is usually used in any specific demonstration. Furthermore, when more DOF are being used, they are analyzed and measured one at a time. We introduce a two-qubit information system, realized by two degrees of freedom of a single photon: polarization and time. The photon arrival time is divided into two time bins representing a qubit, while its polarization state represents a second qubit. The time difference between the two time bins is created without an interferometer at the picosecond scale, which is much smaller than the detector's response time. The two physically different DOF are analyzed simultaneously by photon bunching between the analyzed photon and an ancilla photon. Full two-qubit states encoded in single photons were reconstructed using quantum state tomography, both when the two DOF were entangled and when they were not, with fidelities higher than 96%.
While measuring the orbital angular momentum state of bright light beams can be performed using imaging techniques, a full characterization at the single-photon level is challenging. For applications to quantum optics and quantum information science, such characterization is an essential capability. Here, we present a setup to perform the quantum state tomography of photonic qubits encoded in this degree of freedom. The method is based on a projective technique using spatial mode projection via fork holograms and single-mode fibers inserted into an interferometer. The alignment and calibration of the device is detailed as well as the measurement sequence to reconstruct the associated density matrix. Possible extensions to higher-dimensional spaces are discussed.
Photonic quantum technologies utilize various degrees of freedom (DOFs) of light, such as polarization, frequency, and spatial modes, to encode quantum information. In the effort of further improving channel capacity of quantum communication, and for increasing the complexity of available quantum operations, high-dimensional and hyperentangled states are now gaining interest. However, efficiently measuring these high dimensional states is challenging due to the large number of measurements required for reconstructing the full density matrix via quantum state tomography (QST), and the fact that each measurement requires some modification in the experimental setup. Here, we propose a framework for reconstructing the density matrix of a single-photon hyperentangled across multiple DOFs using a single intensity-measurement obtainable from traditional cameras, and discuss extensions for multiphoton hyperentangled states. Our method hinges on the spatial DOF of the photon and uses it to encode the quantum information from the other DOFs. We numerically demonstrate this method for single-photon OAM-spin and OAM-frequency entangled states using an ideal coupler and a multimode fiber, to perform the information mixing and transfer the encoding to spatial information, where it is detected using a simple camera. This technique simplifies the experimental setup and reduces acquisition time compared to traditional QST-based methods. Moreover, it allows the recovery of DOFs that conventional cameras cannot detect, such as polarization, thus eliminating the need for projection measurements.
In this thesis, I present experimental and theoretical work which assesses and develops a range of tools that are required for performing quantum information processing, particularly in photonic systems. I investigate the three degrees of freedom of a single photon—its polarisation, spatialmomentum and time-frequency distributions. For polarisation, I show that using wave plates to implement arbitrary, single-qubit rotations is more complicated than is commonly appreciated. In the spatial-momentum and time-frequency domains, I develop ways to perform tomographic analysis of quantum states, and I report the first demonstrations of these techniques. In the time-frequency domain, the tomography technique utilises entanglement in the photon polarisation as a resource to store and provide access to the time-frequency information. In my first two experiments, I use spontaneous parametric down-conversion to produce entanglement between pairs of single photons in all three degrees of freedom. I demonstrate the first characterisation of entanglement in spatial modes and the time-frequency domain, the first quantitative measurement of entangled qutrit states, and the highest quality entangled states yet measured in both polarisation and spatial modes. I also report the first realisation of complete hyperentanglement, and a full, black-box tomography of a 36-dimensional two-photon state—the largest system to be characterised in this way to date. In my final experiment, I model and implement a new architecture for a controlled-Z gate which is much simpler to align than previous implementations. This gate requires only one non-classical interference condition, the visibility of which is the main limitation to its performance. I show that the gate operates effectively as a means of both creating entanglement and discriminating between the four elements in a basis of maximally entangled, Bell-type states. Indeed, its observed performance as a Bell analyser would be sufficient to build a quantum state teleporter which would guarantee that the recipient would be left with a better copy of an unknown input state than any eavesdropper. In a series of numerical simulations, I investigate some of the practicalities that arise when using tomographic reconstruction techniques, including how to estimate errors, which measurements to make and what is actually the optimal reconstruction. In particular, I show that tomographies perform better when based on the results from over-complete sets of measurements. Finally, I discuss the important issue of how to compare two processes, particularly when trying to assess the quality of a measured process by comparing it to some expected ideal. Judging possible candidate measures against a set of experimentally and theoretically motivated
Tomography allows one to estimate the density matrix describing the state an ensemble of quantum systems are prepared in (for example, polarization tomography determines the polarization state of a beam of identically prepared photons). In general, it is not possible to uniquely decompose the density matrix into its pure state components. Agarwal et al. proposed a protocol which, for a mixture composed of any two pure states of a qubit (with arbitrary probabilities), allows an observer to infer not only the density matrix but the identity of those specific pure states and their weights - the additional requirement being that the qubits arrive in pairs, where both qubits in each pair are in the same state. We experimentally demonstrate this learning-from-pairs concept using photons in the polarization degree of freedom. We use tomography to measure a sequence of single photons and make use of their time-of-arrival information to 'pair up' the photons after the measurement. From here we are able to infer the photons' polarization states and their respective probabilities, and we demonstrate this for various different choices of polarization states and ratios. Finally, we investigate our ability to discriminate between two equal mixtures of distinct pairs of orthogonal polarization states. We find that on the order of approx. 10e4 photons is typically enough to achieve tomography fidelities of approximately 0.9999. This is sufficient to discriminate between two different preparations of the same mixed state, differing by angles of less than 5 degrees between the pure states used in the two preparations.
We present an experimental proof-of-principle for the generation and detection of pure two-qubit states that have been encoded in degrees of freedom that are common to both classical-light beams and single photons. Our protocol requires performing polarization tomography on a single qubit from a qubit pair. The degree of entanglement in the qubit pair is measured by concurrence, which can be directly extracted from intensity measurements-or photon counting-entering single-qubit polarization tomography.