We considered an application of a feedback loop to enhance the self-organization of atoms in a cavity. In contrast to the original setup, we assumed the light leaking from the cavity was photo-detected and the signal was used to appropriately adjust the atomic potential. It was shown that no additional feedback-induced quantum noise was introduced into the system. Numerical simulations performed in classical approximation showed that the application of feedback weakened the requirement for the atom-field coupling needed to observe the self-organization.
We considered an application of a feedback loop to enhance the self-organization of atoms in a cavity. In contrast to the original setup, we assumed the light leaking from the cavity was photo-detected and the signal was used to appropriately adjust the atomic potential. It was shown that no additional feedback-induced quantum noise was introduced into the system. Numerical simulations performed in classical approximation showed that the application of feedback weakened the requirement for the atom-field coupling needed to observe the self-organization.
Many interesting nonlinear effects are based on the strong interaction of motional degrees of freedom of atoms with an optical cavity field. Among them is the spatial self-organization of atoms in a pattern where the atoms group in either odd or even sites of the cavity-induced optical potential. An experimental observation of this effect can be simplified by using, along with the original cavity-induced feedback, an additional electronic feedback based on the detection of light leaking the cavity and the control of the optical potential for the atoms. Following our previous study, we show that this approach is more efficient from the laser power perspective than the original scheme without the electronic feedback.
It is well known that in the presence of a ring cavity the light scattering from a uniform atomic ensemble can become unstable resulting in the collective atomic recoil lasing. This is the result of a positive feedback due to the cavity. We propose to add an additional electronic feedback loop based on the photodetection of the scattered light. The advantage is a great flexibility in choosing the feedback algorithm, since manipulations with electric signals are very well developed. In this paper we address the application of such a feedback to atoms in the Bose-Einstein condensed state and explore the quantum noise due to the incoherent feedback action. We show that although the feedback based on the photodetection does not change the local stability of the initial uniform distribution with respect to small disturbances, it reduces the region of attraction of the uniform equilibrium. The feedback-induced nonlinearity enables quantum fluctuations to bring the system out of the stability region and cause an exponential growth even if the uniform state is globally stable without the feedback. Using numerical solution of the feedback master equation we show that there is no feedback-induced noise in the quadratures of the excited atomic and light modes. The feedback loop, however, introduces additional noise into the number of quanta of these modes. Importantly, the feedback opens an opportunity to position the modulated BEC inside a cavity as well as tune the phase of scattered light. This can find applications in precision measurements and quantum simulations.
Feedback is a general idea of modifying system behavior depending on the measurement outcomes. It spreads from natural sciences, engineering, and artificial intelligence to contemporary classical and rock music. Recently, feedback has been suggested as a tool to induce phase transitions beyond the dissipative ones and tune their universality class. Here, we propose and theoretically investigate a system possessing such a feedback-induced phase transition. The system contains a Bose-Einstein condensate placed in an optical potential with the depth that is feedback-controlled according to the intensity of the Bragg-reflected probe light. We show that there is a critical value of the feedback gain where the uniform gas distribution loses its stability and the ordered periodic density distribution emerges. Due to the external feedback, the presence of a cavity is not necessary for this type of atomic self-organization. We analyze the dynamics after a sudden change of the feedback control parameter. The feedback time constant is shown to determine the relaxation above the critical point. We show as well that the control algorithm with the derivative of the measured signal dramatically decreases the transient time.
We propose and numerically analyze a new method of cooling for generic polarizable particles. It combines the ideas of cavity self-organization and feedback cooling. In particular, we propose to control the periodic potential for the atoms using the Bragg back-reflection of the probe light. The feedback loop is designed to maximize the reflection, which corresponds to tight localization of the atoms in the potential wells. The model, with realistic parameters, has been numerically simulated and found to demonstrate pronounced cooling and spatial localization effects. On the basis of the same numerical simulations, the time scale of the cooling process was shown to be comparable to the trapping time in conventional dipole traps.
This thesis considers two types of applications of quantum feedback control; feedback creation of nonclassical states of light, and controlling nonclassical properties of an ensemble of atoms. An electro-optical feedback loop will create an in-loop field with nonclassical photon statistics similar to squeezed light, resulting in fluorescence line-narrowing of a two-level atom coupled to such light. We extend this theory to study a three-level atom coupled to broadband squashed light, and confirm the two-level atom line-narrowing using a more realistic non-Markovian description of the feedback loop. The second type of application utilizes continuous QND measurement of atomic ensembles. If we measure the collective spin, then the system experiences conditional spin squeezing dependent on the measurement results. We show that feedback based on these results can continuously drive the system into the same conditioned state, resulting in deterministically reproducible spin squeezing. If we measure the atom number fluctuations of a BEC, then, due to the nonlinearity of atomic self interactions, this is also information about phase fluctuations. We show that feedback based on this information can greatly reduce the collisional broadening of the linewidth of an atom laser out-coupled from the condensate.
The interaction of light with matter is at the heart of quantum optics, which itself enables insight into the fundamental aspects of quantum mechanics. First experimental access to this research field has been realized by coupling atoms to light. Here, the transition between discrete energy states of the atom is associated with the absorption and emission of a photon, a single quantum of the electromagnetic field. As a central aspect of quantum optics, the light-emitter interaction can be significantly enhanced by placing the emitter in optical cavity that is on resonance with the emitter. In recent years, this has led to a rapidly evolving research field known as cavity quantum electrodynamics (CQED). In CQED two different regimes are distinguished: the strong and the weak coupling regimes. In the strong coupling regime, the emitted photon is reflected from the cavity mirrors and eventually reabsorbed by the emitter. In contrast, the weak coupling regime describes the irreversible emission, where the photon leaks out of the cavity before it can be reabsorbed. Both the weak and strong coupling regimes enabled fundamental experiments for a better understanding of quantum optical phenomena. \n \n \n \nCQED grants access to the quantum world and hence offers potentially revolutionizing applications, particularly in the field of quantum information processing. A central aspect for the successful implementation of quantum applications is the system's scalability. Unfortunately, placing atoms deterministically inside a cavity remains technologically elaborate and hence minimizes the prospect of scaling a atom-CQED system. \n \nA possibility to address this issue is to implement CQED in the solid state, where sophisticated fabrication strategies allow miniaturization and scalability of the system. Particularly the development of self-assembled quantum dots (QD) in semiconductors represent a promising route. QDs can be considered as artificial atoms that mimic the atomic two-level system. These structures interact strongly with light and therefore have the potential for replacing atoms in CQED. As a central advantage, QDs are naturally trapped, which greatly simplifies the deterministic incorporation into the cavity. \n \nIn recent years, many efforts have been made to couple self-assembled QDs to microcavities. Generally, the successful implementation of CQED requires a cavity with a high quality factor Q and a low mode volume. In a majority of the approaches, the high Q/small mode volume cavities were monolithically defined around the QD, embedding the QD at a fixed position inside the cavity. Both the weak and strong coupling regimes have been reached with these systems. However, for future applications they suffer from several disadvantages. The fixed position of the QD inside the cavity minimizes the prospects for spectral tunability and spatial positioning the QD inside the cavity. Furthermore, prospects for further increasing of the cavity Q-factor and minimization of the mode volume remain limited in these systems. \n \nIn this thesis the mentioned disadvantages are addressed by developing a fully tunable miniaturized Fabry-Pérot microcavity with low mode volume. The design enables both spatial positioning of the emitter inside the cavity and spectral tunability. Successful coupling of a single QD to the microcavity is demonstrated including the strong coupling regime. Further a new approach to decrease the cavity mode volume is presented, where we demonstrate weak coupling is achieved