Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Letters

Storage limit of two-photon-based three-dimensional memories with parallel access

M.E. Marhic

Published Aug 15, 1991• 9 citations
Publisher

Abstract

For systems that use parallel access by simultaneous writing or reading of bits located in an entire common plane, diffraction sets a limit to the storage density that is far smaller than that for sequential operation. Comparable densities can be achieved by using a three-dimensional waveguiding structure.
DOI
10.1364/ol.16.001272

Related papers

Status of 3D memory storage materials

Gajendra D. Savant, Tomasz P. Jannson, Winston Ho

The speed of modern supercomputers is primarily limited by the relatively slow speed of memory. Research over the past years has focused on developing optical memory systems that, by nature of optics, promise to achieve high speed and high memory capacity. Three- dimensional optical memory systems are well known for their storage capacity and achievable short access time. But the early attempts to exploit 3-dimensional media were limited to photorefractive crystals such as lithium niobate, due to the unavailability of any other suitable medium (alternative media are precluded by their diffraction limited storage densities and non- erasable characteristics). Although volume phase holograms can be recorded in photorefractive crystals, these materials have many obvious flaws such as strong scattering, phase distortion, self diffraction, fast decay, and low refractive index modulation. There have also been continuous efforts to develop new 3-D media (such as photon echo, photorefractive polymers, bacteriorhodusphin, memory access cache, etc., but none can be applied in real world 3-D device because these materials are still in the early stage of development.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 27, 1993•0 citations

Storage Limits of Two-Photon Based Three-Dimensional Memories

Hakan Ürey, Frederick B. McCormick

Two-photon absorption 3-D optical memories have the potential for simple media fabrication, parallel access for high data transfer rates, high volumetric storage density, and low raw bit error rates (BER).1-2 The writing or erasure takes place at the intersection of two orthogonally propagating beams where a unique physical location is allocated to each stored bit. The data can be stored and retrieved in several formats in a single operation. By using either orthogonal-propagating beams or counter-propagating beams, it is possible to control the region of overlap of the two beams to be a single point, a line, or a plane. We will refer to those data formats as bit, vector, and image (or page) storage.

Optics in Computing•Jan 1, 1997•0 citations

Two-photon 3-D optical memories (Invited Paper)

Sadik C. Esener, Peter M. Rentzepis

•Dec 1, 1991•0 citations

Storage of single photon and two photons states in an all-optical quantum memory

Viviane Cotte, Hector Simon, Rosa Tualle-Brouri

SPIE Quantum Technologies•May 6, 2022•0 citations

Data transfer rates and parallelism of two-photon memories

James H. Strickler

Data transfer rates of recently proposed 3D two-photon memories are potentially limited by repetition rates of pulsed lasers. Herein we propose a method of spatially and temporally multiplexing pulse from a multi-Watt, 100 MHz repetition rate, sub-picosecond pulse width mode-locked laser to a linear array of parallel data channels in order to increase the two- photon writing rate. Nearby channels are desynchronized so that pulses incident on adjacent regions of the storage medium do not overlap far from the focal plane. This prevents pairs of photons directed to proximate bits from being simultaneously absorbed in regions of beam overlap which would otherwise degrade the optical sectioning property of the two-photon absorption method. This method may be applied to an earlier proposed architecture that uses 2D arrays of channels for massively parallel memories. Our modified writing method obviates the necessity for intersecting beams and thus reduces the diffraction limit to the storage density of this alternative approach.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Nov 9, 1993•1 citation

Memory and neural networks on the basis of color centers in solids

Albrecht Winnacker, Andres Osvet

Optical data recording is one of the most widely used and efficient systems of memory in the non-living world. The application of color centers in this context offers not only systems of high speed in writing and read-out due to a high degree of parallelism in data handling but also a possibility to set up models of neural networks. In this way, systems with a high potential for image processing, pattern recognition and logical operations can be constructed. A limitation to storage density is given by the diffraction limit of optical data recording. It is shown that this limitation can at least in principle be overcome by the principle of spectral hole burning, which results in systems of storage capacities close to the human brain system.

Biological Chemistry•Sep 13, 2009•1 citation
The speed of modern supercomputers is primarily limited by the relatively slow speed of memory. Research over the past years has focused on developing optical memory systems that, by nature of optics, promise to achieve high speed and high memory capacity. Three- dimensional optical memory systems are well known for their storage capacity and achievable short access time. But the early attempts to exploit 3-dimensional media were limited to photorefractive crystals such as lithium niobate, due to the unavailability of any other suitable medium (alternative media are precluded by their diffraction limited storage densities and non- erasable characteristics). Although volume phase holograms can be recorded in photorefractive crystals, these materials have many obvious flaws such as strong scattering, phase distortion, self diffraction, fast decay, and low refractive index modulation. There have also been continuous efforts to develop new 3-D media (such as photon echo, photorefractive polymers, bacteriorhodusphin, memory access cache, etc., but none can be applied in real world 3-D device because these materials are still in the early stage of development.
Two-photon absorption 3-D optical memories have the potential for simple media fabrication, parallel access for high data transfer rates, high volumetric storage density, and low raw bit error rates (BER).1-2 The writing or erasure takes place at the intersection of two orthogonally propagating beams where a unique physical location is allocated to each stored bit. The data can be stored and retrieved in several formats in a single operation. By using either orthogonal-propagating beams or counter-propagating beams, it is possible to control the region of overlap of the two beams to be a single point, a line, or a plane. We will refer to those data formats as bit, vector, and image (or page) storage.
Data transfer rates of recently proposed 3D two-photon memories are potentially limited by repetition rates of pulsed lasers. Herein we propose a method of spatially and temporally multiplexing pulse from a multi-Watt, 100 MHz repetition rate, sub-picosecond pulse width mode-locked laser to a linear array of parallel data channels in order to increase the two- photon writing rate. Nearby channels are desynchronized so that pulses incident on adjacent regions of the storage medium do not overlap far from the focal plane. This prevents pairs of photons directed to proximate bits from being simultaneously absorbed in regions of beam overlap which would otherwise degrade the optical sectioning property of the two-photon absorption method. This method may be applied to an earlier proposed architecture that uses 2D arrays of channels for massively parallel memories. Our modified writing method obviates the necessity for intersecting beams and thus reduces the diffraction limit to the storage density of this alternative approach.
Optical data recording is one of the most widely used and efficient systems of memory in the non-living world. The application of color centers in this context offers not only systems of high speed in writing and read-out due to a high degree of parallelism in data handling but also a possibility to set up models of neural networks. In this way, systems with a high potential for image processing, pattern recognition and logical operations can be constructed. A limitation to storage density is given by the diffraction limit of optical data recording. It is shown that this limitation can at least in principle be overcome by the principle of spectral hole burning, which results in systems of storage capacities close to the human brain system.