Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Europhysics Letters (EPL)

Room Temperature Persistent Spectral Hole Burning in Sm-Doped SrFCl 1/2 Br 1/2 Mixed Crystals

Raivo Jaaniso, Hans Bill

Published Oct 7, 1991• 173 citations
Publisher

Abstract

Two-photon persistent hole burning is observed at T = 296 K in 5 D 1 – 7 F 0 and 5 D 0 – 7 F 0 transitions of Sm 2+ ions in substitutionally disordered SrFCl 1/2 single crystals, showing the ratio of inhomogeneous to homogeneous linewidth of 20 ÷ 25. The minimum hole widths of 3.5 cm -1 and 2.6 cm -1 , respectively, were determined for these transitions. In fact, the applicability of persistent spectral hole burning, known as a low-temperature high-resolution spectroscopic method and a potential basis for the use of a new–spectral–dimension in optical data storage and processing, is demonstrated for the first time at room temperature in inorganic materials.

DOI
10.1209/0295-5075/16/6/010

Related papers

Spectral Hole-Burning Between 2 K and Room Temperature in Sm2+ Doped Substitutionally Disordered Microcrystals

Keith Holliday, Changjiang Wei, Mauro Croci +1 more

Photon gated spectral hole-burning was first observed in a samarium doped crystal, BaFCl:Sm2+ [1]. This material was of interest to the developement of optical memories as the holes were found to be stable to room temperature thermal cycling. Holes could be burnt at liquid helium temperatures but as the temperature was raised the line quickly became homogeneously broadened. The addition of bromine to the melt succeeded in broadening the inhomogeneous linewidths to about 2 nm through substitutional disorder [2] and persistent holes were observed at 77 K [3]. Subsequently, a study of the parameters for spectral hole-burning in a BaFCl0.5Br0.5:Sm2+ crystalline powder was performed [4] and the highest temperature for which persistent hole-burning had been observed was raised to 133 K. Here we report spectral hole-burning at room temperature (figure 1) in a related compound, Sr0.5Mg0.5FCl0.5Br0.5:Sm2+.

Spectral Hole-Burning and Related Spectroscopies: Science and Applications•Jan 1, 1991•0 citations

Room temperature spectral hole burning observed in Sm-doped mixed crystals

Zhiqiang Jin, B.Y. Yu, Hyun Sook Bae +4 more

For next generation high density optical storage, extensive studies on persistent spectral hole burning (PSHB) have been performed, because they have a large potential for a high density frequency-domain optical data storage. PSHB has been observed at room temperature in Sm-doped crystals and glasses. Among them, glasses are considered to be more favorable than single crystals, due to their wide inhomogeneous line width and easy process for mass production. In the study, we developed a new glass mixture which shows room temperature PSHB with a inhomogeneous line width broadened up to 70 cm/sup -1/. The PSHB was characterized by investigating the time decay pattern of fluorescence and the excitation spectra.

Conference on Lasers and Electro-Optics Pacific Rim (CLEO-PR)•Jan 20, 2003•0 citations

One-photon persistent spectral hole burning in Sm+2-doped Mg 0.5 Sr 0.5 FCl 0.5 Br 0.5 at room temperature

Hyun‐Sook Bae, Byung Yong Yu, Jung Il Lee +5 more

A mixed crystal Sm2+-doped Mg0.5Sr0.5FCl0.5Br0.5 has a high potential in the application for a 3D optical memory. We have observed one-photon persistent spectral hole burning in this material at room temperature. The powder sample of (formula available in paper) was synthesized by firing at 1000 degrees C for 2 hours in a reducing stream of hydrogen. The product was examined with an X-ray diffractometer for the crystalline structure. Fluorescence excitation and emission spectra were recorded with a spectrofluorometer.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 13, 2000•0 citations

Room-temperature persistent spectral hole burning of Sm/sup 2+/ in silicate-based fiber

Kentarou Nouchi, Tsuneo Mitsuyu, Kimihiko Hirao +2 more

Summary form only given. Persistent spectral hole burning (PSHB) of rare-earth-doped inorganic materials has attracted much attention in view of application to high-density optical memories. In particular, it seems that the glass materials are advantageous for application in wavelength-selective optical devices, as well as the memory devices, because of their large inhomogeneous linewidth. The wavelength-selective devices are key components in the wavelength-division multiplexing system, which is important for the next-generation optical communication technology. The problem for practical application lies in the fact that PSHB of rare-earth ions in glasses is usually observed only at temperature below 20 K. However, room-temperature PSHB has been observed recently for Sm/sup 2+/-doped crystals and glasses.

Conference on Lasers and Electro-Optics•Jan 20, 2003•0 citations

Room-temperature persistent spectral hole burning in Sm-doped KLaF4 crystals

Nobuhiro Kodama, Tomoko Takahashi, Kazuyuki Hirao

Persistent spectral hole burning is observed at room temperature in the excitation spectrum for the F07→D05 transition of Sm2+ in KLaF4 single crystals. The hole width and depth are about 10 cm−1 and 18% of the total intensity, respectively. It is concluded that the dominant burning mechanism in this crystal is a photoionization of electron trapping at a site other than Sm3+ ions because of the absence of an antihole around the burned hole.

Applied Physics Letters•Mar 30, 1998•7 citations

Inhomogeneous Broadening and Persistent Spectral Hole-Burning of Divalent Samarium Ions In Alkaline Earth Metal Halides

Jiahua Zhang, Xiangjun Wang, Shihua Huang +1 more

Persistent spectral hole burning (PSHB) was discovered in organic molecular system in 1974[1]. Five years later, PSHB in inorganic materials was discovered in NaF by R. M. Macfarlane et al [2]. In 1985, A. Winnacker et al [3] first observed photon gated spectral hole burning in BaFCl: Sm2+ at 2K. Hole burning(HB) is useful in high resolution spectroscopy. It is also of crucial importance for the application to frequency domain optical storage. The storage density is proportional to the ratio of inhomogeneous linewidth(Γi) to the homogeneous linewidth(Γh), N(= Γi/Γh). The inhomogeneous linewidth of 5D0-TF0 transition of Sm2+ is 16GHz and the hole width is 25MHz in BaFCl at 2K[3]. For this material, the inhomogeneous linewidth changes only moderately with the temperature; On the other hand, the homogeneous linewidth increases rapidly as the temperature rises. Then, a small value of N(~2) can be estimated when HB temperature is raised to 77K. That means, it is difficult to burn a hloe in the inhomogeneous line in BaFCl:Sm2+ at 77K. To maintain a reasonable storage capacity or to study HB at a quite high temperature, a large inhomogeneous linewidth is in great request.

Spectral Hole-Burning and Related Spectroscopies: Science and Applications•Jan 1, 1991•0 citations
Two-photon persistent hole burning is observed at T = 296 K in 5 D 1 – 7 F 0 and 5 D 0 – 7 F 0 transitions of Sm 2+ ions in substitutionally disordered SrFCl 1/2 single crystals, showing the ratio of inhomogeneous to homogeneous linewidth of 20 ÷ 25. The minimum hole widths of 3.5 cm -1 and 2.6 cm -1 , respectively, were determined for these transitions. In fact, the applicability of persistent spectral hole burning, known as a low-temperature high-resolution spectroscopic method and a potential basis for the use of a new–spectral–dimension in optical data storage and processing, is demonstrated for the first time at room temperature in inorganic materials.
Photon gated spectral hole-burning was first observed in a samarium doped crystal, BaFCl:Sm2+ [1]. This material was of interest to the developement of optical memories as the holes were found to be stable to room temperature thermal cycling. Holes could be burnt at liquid helium temperatures but as the temperature was raised the line quickly became homogeneously broadened. The addition of bromine to the melt succeeded in broadening the inhomogeneous linewidths to about 2 nm through substitutional disorder [2] and persistent holes were observed at 77 K [3]. Subsequently, a study of the parameters for spectral hole-burning in a BaFCl0.5Br0.5:Sm2+ crystalline powder was performed [4] and the highest temperature for which persistent hole-burning had been observed was raised to 133 K. Here we report spectral hole-burning at room temperature (figure 1) in a related compound, Sr0.5Mg0.5FCl0.5Br0.5:Sm2+.
For next generation high density optical storage, extensive studies on persistent spectral hole burning (PSHB) have been performed, because they have a large potential for a high density frequency-domain optical data storage. PSHB has been observed at room temperature in Sm-doped crystals and glasses. Among them, glasses are considered to be more favorable than single crystals, due to their wide inhomogeneous line width and easy process for mass production. In the study, we developed a new glass mixture which shows room temperature PSHB with a inhomogeneous line width broadened up to 70 cm/sup -1/. The PSHB was characterized by investigating the time decay pattern of fluorescence and the excitation spectra.
A mixed crystal Sm2+-doped Mg0.5Sr0.5FCl0.5Br0.5 has a high potential in the application for a 3D optical memory. We have observed one-photon persistent spectral hole burning in this material at room temperature. The powder sample of (formula available in paper) was synthesized by firing at 1000 degrees C for 2 hours in a reducing stream of hydrogen. The product was examined with an X-ray diffractometer for the crystalline structure. Fluorescence excitation and emission spectra were recorded with a spectrofluorometer.
Summary form only given. Persistent spectral hole burning (PSHB) of rare-earth-doped inorganic materials has attracted much attention in view of application to high-density optical memories. In particular, it seems that the glass materials are advantageous for application in wavelength-selective optical devices, as well as the memory devices, because of their large inhomogeneous linewidth. The wavelength-selective devices are key components in the wavelength-division multiplexing system, which is important for the next-generation optical communication technology. The problem for practical application lies in the fact that PSHB of rare-earth ions in glasses is usually observed only at temperature below 20 K. However, room-temperature PSHB has been observed recently for Sm/sup 2+/-doped crystals and glasses.
Persistent spectral hole burning (PSHB) was discovered in organic molecular system in 1974[1]. Five years later, PSHB in inorganic materials was discovered in NaF by R. M. Macfarlane et al [2]. In 1985, A. Winnacker et al [3] first observed photon gated spectral hole burning in BaFCl: Sm2+ at 2K. Hole burning(HB) is useful in high resolution spectroscopy. It is also of crucial importance for the application to frequency domain optical storage. The storage density is proportional to the ratio of inhomogeneous linewidth(Γi) to the homogeneous linewidth(Γh), N(= Γi/Γh). The inhomogeneous linewidth of 5D0-TF0 transition of Sm2+ is 16GHz and the hole width is 25MHz in BaFCl at 2K[3]. For this material, the inhomogeneous linewidth changes only moderately with the temperature; On the other hand, the homogeneous linewidth increases rapidly as the temperature rises. Then, a small value of N(~2) can be estimated when HB temperature is raised to 77K. That means, it is difficult to burn a hloe in the inhomogeneous line in BaFCl:Sm2+ at 77K. To maintain a reasonable storage capacity or to study HB at a quite high temperature, a large inhomogeneous linewidth is in great request.