Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Communications

Feedback method of the noise suppression in wave-mixing amplifiers based on non-linear materials with photorefractive response in a reflection grating configuration

M.K. Maurya, R.A. Yadav

Published Feb 24, 2010• 10 citations
Publisher
DOI
10.1016/j.optcom.2010.02.026

Related papers

Effect of partial coherence on four-wave mixing in photorefractive materials via reflection grating approximation

Jianhua Zhao, Xianmin Yi, X. Shen +2 more

Applied Physics B•Feb 1, 2001•0 citations

Transient response of the two-wave-mixing process in photorefractive materials (A)

Gilmore J. Dunning, Juan Francisco Lam

Journal of the Optical Society of America A•Jan 1, 1983•0 citations

Frequency detuning dependence of oscillation condition for a semilinear photorefractive optical resonator in a photorefractive material with reflection gratings

M.K. Maurya, R.A. Yadav

Optik•Oct 17, 2011•3 citations

Stabilization of the phase conjugate reflectivity in photorefractive four-wave mixing

Tsutomu Shimura, Atsushi Nakamura, Kazuo Kuroda +2 more

Phase conjugate reflectivity of the photorefractive four-wave mixing system is usually quite unstable and it is serious issue for practical use of these systems. The cause of this instability is mainly combination of the fluctuation of the phases of input signal and pump beams and the slow response time of the photorefractive crystal. When all input beams in the four-wave mixing system are mutually coherent and the phases of the input beams are not stable, four kinds of gratings are compete each other and the phase conjugate output becomes quite unstable. To avoid this problem, we can make one of the pump incoherent to the signal and another pump1. The phase conjugate output is, however, still unstable due to the rewriting of the grating caused by the fluctuation of the phase of the input beams. In this paper, we report our feedback system to stabilize the power of the phase conjugate output from the four-wave mixing system by controlling the phase of the signal beam. In this system, we detect the phase difference between signal and forward pump beam with lock-in amplifier and control the phase of the signal with a piezoelectric mirror to stabilize the phase difference.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•Jan 1, 1996•0 citations

Spatial subharmonics and noise reduction in photorefractive amplifiers

Jean‐Pierre Huignard

•May 21, 1990•0 citations

Noise reduction in photorefractive image amplifiers and applications

J.-P. Huignard, Henri J. Rajbenbach

We propose and experimentally demonstrate two original methods for suppressing the beam fanning noise of photorefractive amplifiers. The first one involves two wave mixing in a slowly rotating crystal, while the second requires to tilt the crystal with respect to the recording beams. This method applies to materials which exhibit a sharp resonance of the gain versus the pump-probe beam angle. With both methods a large improvement of the S/N ratio is achieved and virtually noise free image amplifiers are demonstrated. In Bi12SiO20, subpicowatt optical signals are detected and amplified. By using combinations of LiNbO3/Bi12SiO20, as storage and amplification crystals respectively a long term readout (more than 20 hours) of a photorefractive memory is achieved.

Journal de Physique III•Jul 1, 1993•0 citations
Phase conjugate reflectivity of the photorefractive four-wave mixing system is usually quite unstable and it is serious issue for practical use of these systems. The cause of this instability is mainly combination of the fluctuation of the phases of input signal and pump beams and the slow response time of the photorefractive crystal. When all input beams in the four-wave mixing system are mutually coherent and the phases of the input beams are not stable, four kinds of gratings are compete each other and the phase conjugate output becomes quite unstable. To avoid this problem, we can make one of the pump incoherent to the signal and another pump1. The phase conjugate output is, however, still unstable due to the rewriting of the grating caused by the fluctuation of the phase of the input beams. In this paper, we report our feedback system to stabilize the power of the phase conjugate output from the four-wave mixing system by controlling the phase of the signal beam. In this system, we detect the phase difference between signal and forward pump beam with lock-in amplifier and control the phase of the signal with a piezoelectric mirror to stabilize the phase difference.
We propose and experimentally demonstrate two original methods for suppressing the beam fanning noise of photorefractive amplifiers. The first one involves two wave mixing in a slowly rotating crystal, while the second requires to tilt the crystal with respect to the recording beams. This method applies to materials which exhibit a sharp resonance of the gain versus the pump-probe beam angle. With both methods a large improvement of the S/N ratio is achieved and virtually noise free image amplifiers are demonstrated. In Bi12SiO20, subpicowatt optical signals are detected and amplified. By using combinations of LiNbO3/Bi12SiO20, as storage and amplification crystals respectively a long term readout (more than 20 hours) of a photorefractive memory is achieved.