Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Full Solid Angle Ion-Light Interface

Martin Fischer, Robert Maiwald, Andrea Golla, Marianne Bader, Markus Sondermann, Gerd Leuchs

Published Jan 1, 2013• 0 citations
Publisher

Abstract

We present an optical system covering 81 % of the solid angle into which an ion emits light. With this configuration we focus light close to the diffraction limit, while also approaching optimal light matter coupling.
DOI
10.1364/cleo_qels.2013.jth2a.80

Related papers

A Single Ion Headlight

Robert Maiwald, Andrea Golla, Martin Fischer +7 more

We report on progress towards achieving a full 4pi solid angle strong coupling between a single trapped ion and a light field using a deep parabolic mirror enabling both efficient photon collection and ion excitation.

•Jan 1, 2011•0 citations

Focusing characteristics of a 4 πparabolic mirror light-matter interface

Lucas Alber, Martin Fischer, Marianne Bader +3 more

Focusing with a 4 π parabolic mirror allows for concentrating light from nearly the complete solid angle, whereas focusing with a single microscope objective limits the angle cone used for focusing to half solid angle at maximum. Increasing the solid angle by using deep parabolic mirrors comes at the cost of adding more complexity to the mirror’s fabrication process and might introduce errors that reduce the focusing quality. To determine these errors, we experimentally examine the focusing properties of a 4 π parabolic mirror that was produced by single-point diamond turning. The properties are characterized with a single 174 Yb + ion as a mobile point scatterer. The ion is trapped in a vacuum environment with a movable high optical access Paul trap. We demonstrate an effective focal spot size of 209 nm in lateral and 551 nm in axial direction. Such tight focusing allows us to build an efficient light-matter interface. Our findings agree with numerical simulations incorporating a finite ion temperature and interferometrically measured wavefront aberrations induced by the parabolic mirror. We point at further technological improvements and discuss the general scope of applications of a 4 π parabolic mirror.

arXiv:1609.06884•Journal of the European Optical Society Rapid Publications•May 1, 2017•21 citations

Integrated Diffractive Optics for Surface Ion Traps

Erik W. Streed, Moji Ghadimi, Valdis Blūms +6 more

Bulletin of the American Physical Society•May 26, 2016•0 citations

Generation of a light mode optimized for efficient free-space photon-atom coupling

Andrea Golla, Bénoît Chalopin, Robert Maiwald +4 more

Today the interaction of light and matter on the single quantum level is a wide research field. Strong coupling between a single photon and a single atom has already been achieved with optical cavities. Here, we treat strong interaction in free space, i.e. strong interaction whilst maintaining the free space density of states of the electromagnetic field. We pursue the coupling of a properly designed single photon wave packet to a single ion aiming at an excitation probability close to unity. For this purpose a linear dipole transition of an ion localized in the focal point of a deep parabolic mirror is addressed by a collimated laser beam focused onto the ion from nearly the full solid angle. In order to reach the highest possible coupling strength, the incident vectorial light field must be matched to the radiation pattern of the corresponding atomic transition both in the spatial and in the temporal domain. Here the generation of such an incident light mode is presented.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2011•0 citations

Efficient ion-photon coupling with phase Fresnel lenses

Erik W. Streed, Benjamin Norton, Till J. Weinhold +1 more

Bulletin of the American Physical Society•May 27, 2010•0 citations

Efficient Coupling of Tapered Optical Fibers to Silicon Nanophotonic Waveguides on Rare-Earth Doped Crystals

Yan Qi Huan

Quantum networks are a rapidly developing field of quantum information processing that have the potential to enable long-range entanglement between future quantum computers as well as the implementation of secure communication through quantum key distribution. Two key components of such networks are quantum memories to store entangled photon pairs for use in the quantum repeater protocol and quantum light-matter interfaces to efficiently interconvert between stationary qubits and flying qubits in the form of photons. Rare-earth ion-doped crystals are a promising solid-state platform that show promise for both of these applications due to their long optical and spin coherence times. Due to their relatively weak optical transitions, rare-earth ions have been coupled with nanophotonic resonators to enhance their transition strengths, with past work in the Faraon group utilizing focused ion beam milled photonic crystal resonators with 45-degree angled couplers to couple light in and out. Such resonators have the disadvantage of requiring manual alignment to fabricate, and the couplers are also relatively inefficient which limits the performance of such devices. It is therefore desirable to move towards silicon photonics, where mature techniques such as electron-beam lithography can allow for scalable fabrication of nanophotonic cavities together with high coupling efficiencies. In this thesis, we demonstrate significant progress towards the usage of acid-etched tapered optical fibers as an efficient interface for coupling light into tapered silicon nanophotonic waveguides. We show comprehensive simulations of the taper geometries required to achieve adiabatic coupling with theoretical efficiencies of more than 99%, and design a silicon photonic crystal mirror to be used in the measurement of the fiber-waveguide coupling efficiency. We then optimize the hydrofluoric acid fiber etching process and demonstrate the ability to make tapered fibers which are 200 microns long with a taper half-angle of 2 degrees and a tip diameter of 50 nm. Using these tapered fibers to couple light into tapered silicon waveguides fabricated using electron-beam lithography shows a moderately high coupling efficiency of 11.4% with the potential for improvement. This method of tapered fiber coupling shows promise to be integrated into silicon nanophotonic resonators on rare-earth ion doped crystals and allow for highly efficient quantum memories and quantum light-matter interfaces in the solid-state.

•Jul 2, 2019•0 citations
Focusing with a 4 π parabolic mirror allows for concentrating light from nearly the complete solid angle, whereas focusing with a single microscope objective limits the angle cone used for focusing to half solid angle at maximum. Increasing the solid angle by using deep parabolic mirrors comes at the cost of adding more complexity to the mirror’s fabrication process and might introduce errors that reduce the focusing quality. To determine these errors, we experimentally examine the focusing properties of a 4 π parabolic mirror that was produced by single-point diamond turning. The properties are characterized with a single 174 Yb + ion as a mobile point scatterer. The ion is trapped in a vacuum environment with a movable high optical access Paul trap. We demonstrate an effective focal spot size of 209 nm in lateral and 551 nm in axial direction. Such tight focusing allows us to build an efficient light-matter interface. Our findings agree with numerical simulations incorporating a finite ion temperature and interferometrically measured wavefront aberrations induced by the parabolic mirror. We point at further technological improvements and discuss the general scope of applications of a 4 π parabolic mirror.
Today the interaction of light and matter on the single quantum level is a wide research field. Strong coupling between a single photon and a single atom has already been achieved with optical cavities. Here, we treat strong interaction in free space, i.e. strong interaction whilst maintaining the free space density of states of the electromagnetic field. We pursue the coupling of a properly designed single photon wave packet to a single ion aiming at an excitation probability close to unity. For this purpose a linear dipole transition of an ion localized in the focal point of a deep parabolic mirror is addressed by a collimated laser beam focused onto the ion from nearly the full solid angle. In order to reach the highest possible coupling strength, the incident vectorial light field must be matched to the radiation pattern of the corresponding atomic transition both in the spatial and in the temporal domain. Here the generation of such an incident light mode is presented.
Quantum networks are a rapidly developing field of quantum information processing that have the potential to enable long-range entanglement between future quantum computers as well as the implementation of secure communication through quantum key distribution. Two key components of such networks are quantum memories to store entangled photon pairs for use in the quantum repeater protocol and quantum light-matter interfaces to efficiently interconvert between stationary qubits and flying qubits in the form of photons. Rare-earth ion-doped crystals are a promising solid-state platform that show promise for both of these applications due to their long optical and spin coherence times. Due to their relatively weak optical transitions, rare-earth ions have been coupled with nanophotonic resonators to enhance their transition strengths, with past work in the Faraon group utilizing focused ion beam milled photonic crystal resonators with 45-degree angled couplers to couple light in and out. Such resonators have the disadvantage of requiring manual alignment to fabricate, and the couplers are also relatively inefficient which limits the performance of such devices. It is therefore desirable to move towards silicon photonics, where mature techniques such as electron-beam lithography can allow for scalable fabrication of nanophotonic cavities together with high coupling efficiencies. In this thesis, we demonstrate significant progress towards the usage of acid-etched tapered optical fibers as an efficient interface for coupling light into tapered silicon nanophotonic waveguides. We show comprehensive simulations of the taper geometries required to achieve adiabatic coupling with theoretical efficiencies of more than 99%, and design a silicon photonic crystal mirror to be used in the measurement of the fiber-waveguide coupling efficiency. We then optimize the hydrofluoric acid fiber etching process and demonstrate the ability to make tapered fibers which are 200 microns long with a taper half-angle of 2 degrees and a tip diameter of 50 nm. Using these tapered fibers to couple light into tapered silicon waveguides fabricated using electron-beam lithography shows a moderately high coupling efficiency of 11.4% with the potential for improvement. This method of tapered fiber coupling shows promise to be integrated into silicon nanophotonic resonators on rare-earth ion doped crystals and allow for highly efficient quantum memories and quantum light-matter interfaces in the solid-state.