Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Optics Express

Unimpaired phase-sensitive amplification by vector four-wave mixing near the zero-dispersion frequency

Colin J. McKinstrie, Stojan Radic, Michael G. Raymer, Luca Schenato

Published Jan 1, 2007• 17 citations
Publisher

Abstract

Phase-sensitive amplification (PSA), which is produced by degenerate four-wave mixing (FWM) in a randomly-birefringent fiber, has the potential to improve the performance of optical communication systems. Scalar FWM, which is driven by parallel pumps, is impaired by the generation of pump-pump and pump-signal harmonics, which limit the level, and modify the phase sensitivity, of the signal gain. In contrast, vector FWM, which is driven by perpendicular pumps, is not impaired by the generation of harmonics. Vector FWM produces PSA with the classical properties of a one-mode squeezing transformation.

DOI
10.1364/oe.15.002178

Related papers

Experimental analysis of degenerate vector phase-sensitive amplification

Abel Lorences-Riesgo, Fabrizio Chiarello, Carl Lundström +2 more

We comprehensively investigate a degenerate vector phase-sensitive amplifier (PSA). We determine the gain dependence on the relative phase and polarization angle between the pumps and the degenerate signal wave. The vector PSA is experimentally shown to be sensitive to the pump states of polarization (SOP) due to polarization mode dispersion in the fiber. However, the scheme performance agrees well with theory under specific pump SOPs and we achieve an on-off gain over 10 dB with a small deviation from the theoretically expected results. In comparison to the scalar scheme, the proposed vector scheme has larger tolerance for pump depletion due to four-wave mixing between pumps and generation of higher-order idlers.

Optics Express•Sep 2, 2014•19 citations

Characterization and Applications of Vector Phase-Sensitive Amplifiers

Abel Lorences-Riesgo

This work is devoted to the characterization of vector phase-sensitive amplifiers and processors. A detailed analysis of degenerate vector phase-sensitive amplifier (PSA) is performed.The gain and phase-sensitive extinction ratio are theoretically analyzed using three-wave theory. Experiments and simulation results confirm the validity of this three-wave theory. The influence of polarization-mode dispersion is also evaluated, showing that aligning the pump polarizations at the fiber input is essential in order to achieve the theoretically predicted results. The scheme is also compared to the degenerate scalar PSA scheme. At the same pump power, the vector PSA has lower gain but also less influence from higher-order idlers and lower pump depletion due to FWM between the pumps. Using the degenerate vector PSA, phase-sensitive (PS) amplification of dual-polarization (DP) binary phase-shift keying (BPSK) signals was demonstrated. To the best of our knowledge, this was the first demonstration of a DP-modulated signal with large net phase-sensitive gain. Furthermore, we also demonstrated that this scheme can phase regenerate the signal. The same scheme was also used for a different purpose: quadrature decomposition into two cross-polarized waves. We demonstrated demultiplexing of quadrature phase-shift keying (QPSK) signal into two cross-polarized BPSK signals by the operating the amplifier in phase-insensitive mode. The design of a novel phase-locked loop scheme enabled stable operation and negligible penalty in the decomposition.

•Jan 1, 2015•0 citations

Phase and Amplitude Regeneration of Differential Phase-Shift Keyed Signals Using Phase-Sensitive Amplification

Kevin Croussore, Guifang Li

Phase-sensitive amplifiers (PSAs) offer numerous advantages over phase-insensitive amplifiers in optical communications. Squeezing of optical phase through PSA can remove accumulated phase jitter, which is a critical functionality for an all- optical, phase-shift keyed network. In recent experiments, reviewed in this report, different implementations of PSA were used for phase regeneration of both return-to-zero differential phase-shift keying and nonreturn-to-zero differential phase-shift keying data. The first demonstration explored the properties and performance of PSA that occurs in nonlinear interferometers. Experiments confirmed that a PSA operating in the depleted pump regime provides simultaneous reduction of amplitude and phase noise (PN). Phase regeneration performance limit was reached as a consequence of pump-wave imperfections, which can be significantly reduced through proper design. PSA that occurs directly in fiber in a traveling-wave configuration through partially degenerate four-wave mixing was also studied. The latter implementation offers stronger phase-matched gain and suppression of amplitude-to-phase noise conversion. Technical issues that remain to be addressed are identified for each implementation. Results characterized using coherent detection offer direct measurements of the phase-regenerative behavior.

IEEE Journal of Selected Topics in Quantum Electronics•Jan 1, 2008•103 citations

Phase-sensitive amplification produced by degenerate four-wave mixing in a fiber

Colin J. McKinstrie, Stojan Radic, Michael G. Raymer +1 more

Degenerate scalar and vector four-wave mixing produce phase-sensitive amplification in a fiber. The quantum-mechanical properties of these schemes are described, and formulas for the field-quadrature and photon-number variances are derived.

Conference on Lasers and Electro-Optics•Jan 1, 2005•2 citations

Four-wave mixing-based phase sensitive amplification with pulsed signal input

Xiaosheng Xiao, Perry Ping Shum

The four-wave mixing (FWM)-based phase sensitive amplification (PSA) with pulsed signal input is investigated. A set of exact analytical solutions for the output amplitude and phase of PSA is derived, taking into account the pump depletion and the self- and cross-phase modulation (SPM and XPM) from pumps, signal and idler. Simplified analytical expression of output idler power is obtained, which shows that, the amplified signal/idler pulse will be compressed firstly due to the phase distortion of input signal, then will be broadened due to pump-depletion.

IEEE International Conference on Advanced Infocomm Technology•Jan 1, 2008•0 citations

Phase matching condition of dual-pump phase-sensitive amplification in optical fiber

Kyo Inoue

Phase-sensitive amplification (PSA) is a unique optical amplification scheme, featuring a low-noise property (i.e., quantum limited noise figure of 0 dB) and a phase clamping effect available for phase noise suppression [1]. It is based on optical parametric interaction between signal and pump lights. It is known that the interaction efficiency and then the signal gain depend on the phase matching between those interacting lights. There are typically two frequency arrangements for PSA in an optical fiber: (i) one pump (frequency: fp) with signal (frequency: fs) and conjugated idler (frequency: fi) satisfying fs+ fi= 2fp[Fig. 1(a)], and (ii) two pumps (frequencies: fp1, fp2) with signal (frequency: fs) satisfying fp1+ fp2= 2fs[Fig. 1(b)]. The phase matching condition for the former is well known, which is equivalent to that of phase-insensitive amplification where the signal light is amplified without an idler incident, such that the phase matching is satisfied when the center wavelength of interacting lights is in the normal dispersion region, i.e., a wavelength longer than the zero-dispersion wavelength of a fiber, as indicated in Fig. 1(a) [2]. On the other hand, the phase-matching condition for the latter has not been explicitly investigated, to the author's knowledge. Although several experimental demonstrations of dual-pump fiber PSA have been reported, many of them employed the wavelength allocation of the center wavelength being in the normal dispersion region, without detailed considerations on the phase matching [3-6]. Thereupon, this paper studies the phase matching condition of dual-pump PSA in an optical fiber.

Opto-Electronics and Communications Conference (OECC)•Jul 1, 2017•1 citation
Phase-sensitive amplification (PSA), which is produced by degenerate four-wave mixing (FWM) in a randomly-birefringent fiber, has the potential to improve the performance of optical communication systems. Scalar FWM, which is driven by parallel pumps, is impaired by the generation of pump-pump and pump-signal harmonics, which limit the level, and modify the phase sensitivity, of the signal gain. In contrast, vector FWM, which is driven by perpendicular pumps, is not impaired by the generation of harmonics. Vector FWM produces PSA with the classical properties of a one-mode squeezing transformation.
We comprehensively investigate a degenerate vector phase-sensitive amplifier (PSA). We determine the gain dependence on the relative phase and polarization angle between the pumps and the degenerate signal wave. The vector PSA is experimentally shown to be sensitive to the pump states of polarization (SOP) due to polarization mode dispersion in the fiber. However, the scheme performance agrees well with theory under specific pump SOPs and we achieve an on-off gain over 10 dB with a small deviation from the theoretically expected results. In comparison to the scalar scheme, the proposed vector scheme has larger tolerance for pump depletion due to four-wave mixing between pumps and generation of higher-order idlers.
This work is devoted to the characterization of vector phase-sensitive amplifiers and processors. A detailed analysis of degenerate vector phase-sensitive amplifier (PSA) is performed.The gain and phase-sensitive extinction ratio are theoretically analyzed using three-wave theory. Experiments and simulation results confirm the validity of this three-wave theory. The influence of polarization-mode dispersion is also evaluated, showing that aligning the pump polarizations at the fiber input is essential in order to achieve the theoretically predicted results. The scheme is also compared to the degenerate scalar PSA scheme. At the same pump power, the vector PSA has lower gain but also less influence from higher-order idlers and lower pump depletion due to FWM between the pumps. Using the degenerate vector PSA, phase-sensitive (PS) amplification of dual-polarization (DP) binary phase-shift keying (BPSK) signals was demonstrated. To the best of our knowledge, this was the first demonstration of a DP-modulated signal with large net phase-sensitive gain. Furthermore, we also demonstrated that this scheme can phase regenerate the signal. The same scheme was also used for a different purpose: quadrature decomposition into two cross-polarized waves. We demonstrated demultiplexing of quadrature phase-shift keying (QPSK) signal into two cross-polarized BPSK signals by the operating the amplifier in phase-insensitive mode. The design of a novel phase-locked loop scheme enabled stable operation and negligible penalty in the decomposition.
Phase-sensitive amplifiers (PSAs) offer numerous advantages over phase-insensitive amplifiers in optical communications. Squeezing of optical phase through PSA can remove accumulated phase jitter, which is a critical functionality for an all- optical, phase-shift keyed network. In recent experiments, reviewed in this report, different implementations of PSA were used for phase regeneration of both return-to-zero differential phase-shift keying and nonreturn-to-zero differential phase-shift keying data. The first demonstration explored the properties and performance of PSA that occurs in nonlinear interferometers. Experiments confirmed that a PSA operating in the depleted pump regime provides simultaneous reduction of amplitude and phase noise (PN). Phase regeneration performance limit was reached as a consequence of pump-wave imperfections, which can be significantly reduced through proper design. PSA that occurs directly in fiber in a traveling-wave configuration through partially degenerate four-wave mixing was also studied. The latter implementation offers stronger phase-matched gain and suppression of amplitude-to-phase noise conversion. Technical issues that remain to be addressed are identified for each implementation. Results characterized using coherent detection offer direct measurements of the phase-regenerative behavior.
The four-wave mixing (FWM)-based phase sensitive amplification (PSA) with pulsed signal input is investigated. A set of exact analytical solutions for the output amplitude and phase of PSA is derived, taking into account the pump depletion and the self- and cross-phase modulation (SPM and XPM) from pumps, signal and idler. Simplified analytical expression of output idler power is obtained, which shows that, the amplified signal/idler pulse will be compressed firstly due to the phase distortion of input signal, then will be broadened due to pump-depletion.
Phase-sensitive amplification (PSA) is a unique optical amplification scheme, featuring a low-noise property (i.e., quantum limited noise figure of 0 dB) and a phase clamping effect available for phase noise suppression [1]. It is based on optical parametric interaction between signal and pump lights. It is known that the interaction efficiency and then the signal gain depend on the phase matching between those interacting lights. There are typically two frequency arrangements for PSA in an optical fiber: (i) one pump (frequency: fp) with signal (frequency: fs) and conjugated idler (frequency: fi) satisfying fs+ fi= 2fp[Fig. 1(a)], and (ii) two pumps (frequencies: fp1, fp2) with signal (frequency: fs) satisfying fp1+ fp2= 2fs[Fig. 1(b)]. The phase matching condition for the former is well known, which is equivalent to that of phase-insensitive amplification where the signal light is amplified without an idler incident, such that the phase matching is satisfied when the center wavelength of interacting lights is in the normal dispersion region, i.e., a wavelength longer than the zero-dispersion wavelength of a fiber, as indicated in Fig. 1(a) [2]. On the other hand, the phase-matching condition for the latter has not been explicitly investigated, to the author's knowledge. Although several experimental demonstrations of dual-pump fiber PSA have been reported, many of them employed the wavelength allocation of the center wavelength being in the normal dispersion region, without detailed considerations on the phase matching [3-6]. Thereupon, this paper studies the phase matching condition of dual-pump PSA in an optical fiber.