Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

International Conference on Transparent Optical Networks

Ultrafast all-optical memory operation using a polarization bistable VCSEL

Hitoshi Kawaguchi

Published Jun 1, 2010• 1 citation
Publisher

Abstract

The fastest operation of all-optical flip-flop memory was experimentally demonstrated using a 980-nm polarization bistable vertical-cavity surface-emitting laser (VCSEL). Operating conditions of the input signal power and the frequency detuning to achieve the fast optical memory operation were characterized experimentally. At the optimum condition, 1-bit data signals were arbitrarily sampled and memorized from a 26-1 pseudorandom bit sequence return-to-zero signal at 20 Gb/s by using AND gate and memory functionalities obtained from the polarization bistability. In addition, 1-bit memory operation was achieved for a 6-bit non-return-to-zero signal at 40 Gb/s. Both memory operations had optical gain.

DOI
10.1109/icton.2010.5548994

Related papers

All-optical memory operation of 980-nm polarization bistable VCSEL for 20-Gb/s PRBS RZ and 40-Gb/s NRZ data signals

Jun Sakaguchi, Takeo Katayama, Hitoshi Kawaguchi

The fastest known operation of all-optical flip-flop memory was experimentally demonstrated using a 980-nm polarization bistable vertical-cavity surface-emitting laser (VCSEL). Operating conditions of the input signal power and the frequency detuning to achieve the fast optical memory operation were characterized experimentally. At the optimum condition, 1-bit data signals were arbitrarily sampled and memorized from a 2(6)-1 pseudorandom bit sequence return-to-zero signal at 20 Gb/s by using AND gate and memory functionalities obtained from the polarization bistability. In addition, 1-bit memory operation was achieved for a 6-bit non-return-to-zero signal at 40 Gb/s. Both memory operations required 250-microW data signal power and had optical gain. The high potential of all-optical flip-flop memories based on polarization bistable VCSELs for use in ultrafast all-optical future networks was demonstrated.

Optics Express•May 26, 2010•52 citations

High Switching-Speed Operation of Optical Memory Based on Polarization Bistable Vertical-Cavity Surface-Emitting Laser

Jun Sakaguchi, Takeo Katayama, Hitoshi Kawaguchi

Operation conditions of all-optical buffer memories based on polarization bistable vertical-cavity surface-emitting lasers (VCSELs) were investigated. The switching power dependence on the frequency detuning of the input optical signal was measured for a 980-nm polarization bistable VCSEL. The proper operating conditions for 10-Gb/s memory operation were also measured and found to be on the negative detuning side. Calculations based on a two-mode rate-equation model successfully explained the measured characteristics of the switching power dependence on the frequency detuning and the operating conditions. Maximum data rates for the memory operation strongly depended on theQfactor (i.e., photon lifetime) of the VCSELs. A possibility of 40-Gb/s memory operation using a polarization bistable VCSEL with aQfactor as low as 500 was shown.

IEEE Journal of Quantum Electronics•Sep 8, 2010•58 citations

10 Gb/s optical buffer memory using a polarization bistable VCSEL

Takashi Mori, Yousuke Sato, Hitoshi Kawaguchi

Optical buffer memory for 10-Gb/s data signal is demonstrated experimentally using a polarization bistable vertical-cavity surface-emitting laser (VCSEL). The optical buffer memory is based on an optical AND gate function and the polarization bistability of the VCSEL. Fast AND gate operation responsive to 50-ps-width optical pulses is achieved experimentally by increasing the detuning frequency between an injection light into the VCSEL and a lasing light from the VCSEL. A specified bit is extracted from the 10-Gb/s data signal by the fast AND gate operation and is stored as the polarization state of the VCSEL by the polarization bistability. The corresponding numerical simulations are also performed using two-mode rate equations taking into account the detuning frequency. The simulation results confirm the fast AND gate operation by increasing the detuning frequency as well as the experimental results.

European Conference on Optical Communication•Jan 1, 2007•4 citations

Experimental Demonstration of Multi-Bit Optical Buffer Memory Using 1.55-$\mu{\hbox {m}}$ Polarization Bistable Vertical-Cavity Surface-Emitting Lasers

Takeo Katayama, Tomohiro Ooi, Hitoshi Kawaguchi

We demonstrate a novel all-optical buffer memory using 1.55-μm polarization bistable vertical-cavity surface-emitting lasers (VCSELs). A one-bit data is stored as one of two orthogonal polarization states of a VCSEL in this memory. The polarization state is transferred from the VCSEL to another VCSEL which is optically connected in cascade as a shift register. A 4-bit optical buffer memory is constructed using two sets of the shift-register memory connected in parallel. These results show the technical feasibility of multi-bit optical buffer memory.

IEEE Journal of Quantum Electronics•Nov 1, 2009•74 citations

All-optical flip-flop operation of VCSOA

Aaron M. Kaplan, Govind Prasad Agrawal, Drew N. Maywar

An all-optical flip-flop, the memory of which is based on dispersive bistability in a single vertical cavity semiconductor optical amplifier, is demonstrated experimentally. Flip-flop control is achieved using two mechanisms: cross-phase modulation to set the flip-flop and cross-gain modulation of the holding beam within a remote SOA to reset it. Optical control signals are sub-milliwatt in power and derived from a single 5 ns, 1539 nm initial pulse. Flip-flop operation at 1542 nm is polarisation insensitive to control signals and achieved with an on-off contrast greater than 3 dB.

Electronics Letters•Jan 13, 2009•25 citations

Optical memory using a vertical-cavity surface emitting laser

Diana L. Huffaker, W.D. Lee, DENNIS GLENN DEPPE +4 more

Data are presented demonstrating optical switching and memory in a bistable vertical-cavity surface-emitting laser (VCSEL). Optical switching from lasing to nonlasing or from nonlasing to lasing in the vertical-cavity laser was demonstrated using an AlGaAs probe laser at approximately 0.78 mu m.>

IEEE Photonics Technology Letters•Dec 1, 1991•10 citations
The fastest operation of all-optical flip-flop memory was experimentally demonstrated using a 980-nm polarization bistable vertical-cavity surface-emitting laser (VCSEL). Operating conditions of the input signal power and the frequency detuning to achieve the fast optical memory operation were characterized experimentally. At the optimum condition, 1-bit data signals were arbitrarily sampled and memorized from a 26-1 pseudorandom bit sequence return-to-zero signal at 20 Gb/s by using AND gate and memory functionalities obtained from the polarization bistability. In addition, 1-bit memory operation was achieved for a 6-bit non-return-to-zero signal at 40 Gb/s. Both memory operations had optical gain.
The fastest known operation of all-optical flip-flop memory was experimentally demonstrated using a 980-nm polarization bistable vertical-cavity surface-emitting laser (VCSEL). Operating conditions of the input signal power and the frequency detuning to achieve the fast optical memory operation were characterized experimentally. At the optimum condition, 1-bit data signals were arbitrarily sampled and memorized from a 2(6)-1 pseudorandom bit sequence return-to-zero signal at 20 Gb/s by using AND gate and memory functionalities obtained from the polarization bistability. In addition, 1-bit memory operation was achieved for a 6-bit non-return-to-zero signal at 40 Gb/s. Both memory operations required 250-microW data signal power and had optical gain. The high potential of all-optical flip-flop memories based on polarization bistable VCSELs for use in ultrafast all-optical future networks was demonstrated.
Operation conditions of all-optical buffer memories based on polarization bistable vertical-cavity surface-emitting lasers (VCSELs) were investigated. The switching power dependence on the frequency detuning of the input optical signal was measured for a 980-nm polarization bistable VCSEL. The proper operating conditions for 10-Gb/s memory operation were also measured and found to be on the negative detuning side. Calculations based on a two-mode rate-equation model successfully explained the measured characteristics of the switching power dependence on the frequency detuning and the operating conditions. Maximum data rates for the memory operation strongly depended on theQfactor (i.e., photon lifetime) of the VCSELs. A possibility of 40-Gb/s memory operation using a polarization bistable VCSEL with aQfactor as low as 500 was shown.
Optical buffer memory for 10-Gb/s data signal is demonstrated experimentally using a polarization bistable vertical-cavity surface-emitting laser (VCSEL). The optical buffer memory is based on an optical AND gate function and the polarization bistability of the VCSEL. Fast AND gate operation responsive to 50-ps-width optical pulses is achieved experimentally by increasing the detuning frequency between an injection light into the VCSEL and a lasing light from the VCSEL. A specified bit is extracted from the 10-Gb/s data signal by the fast AND gate operation and is stored as the polarization state of the VCSEL by the polarization bistability. The corresponding numerical simulations are also performed using two-mode rate equations taking into account the detuning frequency. The simulation results confirm the fast AND gate operation by increasing the detuning frequency as well as the experimental results.
Experimental Demonstration of Multi-Bit Optical Buffer Memory Using 1.55-μm\mu{\hbox {m}}μm Polarization Bistable Vertical-Cavity Surface-Emitting Lasers
We demonstrate a novel all-optical buffer memory using 1.55-μm polarization bistable vertical-cavity surface-emitting lasers (VCSELs). A one-bit data is stored as one of two orthogonal polarization states of a VCSEL in this memory. The polarization state is transferred from the VCSEL to another VCSEL which is optically connected in cascade as a shift register. A 4-bit optical buffer memory is constructed using two sets of the shift-register memory connected in parallel. These results show the technical feasibility of multi-bit optical buffer memory.
An all-optical flip-flop, the memory of which is based on dispersive bistability in a single vertical cavity semiconductor optical amplifier, is demonstrated experimentally. Flip-flop control is achieved using two mechanisms: cross-phase modulation to set the flip-flop and cross-gain modulation of the holding beam within a remote SOA to reset it. Optical control signals are sub-milliwatt in power and derived from a single 5 ns, 1539 nm initial pulse. Flip-flop operation at 1542 nm is polarisation insensitive to control signals and achieved with an on-off contrast greater than 3 dB.