Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Le Journal de Physique Colloques

NONLINEAR REFRACTION AND INCREASING ABSORPTION IN HgCdTe OPTICAL BISTABILITY AT ROOM TEMPERATURE : AN EXPERIMENTAL STUDY

S. CECCHI, Peter Coppo, P. Salieri, F. T. Arecchi

Published Jun 1, 1988• 1 citation
Publisher

Abstract

In room temperature Hg0.815Cd0.185Te samples, nonlinear absorption is observed to induce in trasmission, upon increasing in put intensity, a transition from anticlockwise to clockwise hysteresis loops.
DOI
10.1051/jphyscol:1988231

Related papers

Nonlinear Refraction and Increasing Absorption in HgCdTe Optical Bistability at Room Temperature: an Experimental Study

Peter Coppo, S. Cecchi, P. Salieri +1 more

Many authors have experimentally examined the nonlinearities of HgCdTe at resonance with the CO2 laser wavelength [1]. At room temperature non1inearities of electronic origin, arising from band filling, are weak because of Auger recombination and are masked by thermal effects. In this communication we extend the analysis of ref. 1 on thermally induced optical bistability at low power: we show, for the first time in HgCdTe, the appearance of clockwise hysteresis cycles in transmission as input power Pi is increased, due to nonlinear absorption. We can account for both absorptive and refractive nonlinear contributions by simultaneous monitoring of transmission and reflection. The Hg0.815Cd0.185Te plates (280 um in thickness, with doping pa =1*1016 cm-3, prepared and polished by Elettronica SpA) were placed without heatsinking in a thermally controlled environment. In Fig. 1 the transmitted (Pt) and reflected (Pr) power is shown as a function of Pi: the three data sets differ in cavity mistuning. The thermooptic effect was measured directly, by a close focus optical pyrometer, and indirectly by taking data at different thermal bath temperature T. The values of Pi at the hysteresis associated to a given cavity interference order (indicated with the symbols of Fig. 1c) drift with T (Fig. 2): the maximum induced temperature increase is inferred to be 30-35°C, with steps of 2.5-3.5°C at the switching points, and a value of dn/dT = -2.8*10-3 K-1 is deduced. Fig. 3 presents numerical results (to be compared with Fig. 1b) obtained parametrically solving the nonlinear Fabry Perot equations using the absorption measured after AR coating one sample face. This nonlinear absorption will be discussed in terms of a free carrier origin.

Topical Meeting on Optical Bistability (OB)•Jan 1, 1988•0 citations

Nonlinear refraction and increasing absorption in HgCdTe optical bistability at room temperature: an experimental study

S. Cecchi, Peter Coppo, P. Salieri +1 more

Optics Communications•Jul 1, 1988•1 citation

An experimental study of nonlinear effects in room temperature HgCdTe thermal optical bistability: Increasing absorption and self-defocusing

Peter Coppo, S. Cecchi, P. Salieri

Optics Communications•Mar 1, 1990•2 citations

Observation of optical bistabillty in ZnS waveguides

B. C. Svensson, G. Assanto, D. Kuchibhatla +3 more

Utilizing prism coupling of an argon laser beam into a nonlinear ZnS waveguide we have observed power-dependent optical bistability. We detuned the incidence angle by several linewidths from the optimal low power efficiency case. At this position we observed switching and hysteresis and verified the hysteresis loop to be bistable. The origin of the bistability we tentatively identified as a combination of intensity-dependent absorption and dispersion. Our conditions for bistability were different from those of W. Lukosz et al. in OPTICAL BISTABILITY III (Springer-Verlag, New York, 1986), p. 109.

Annual Meeting Optical Society of America•Jan 1, 1986•0 citations

MODELING OF INCREASING ABSORPTION OPTICAL BISTABILITY IN BULK ZNSE AT DIFFERENT THICKNESSES

Y Esnaashari, A A Kouhian, Saeid Jelvani +1 more

•Jan 1, 2006•0 citations

INCREASING ABSORPTION OPTICAL BISTABILITY FOR ZnSe THIN FILM

Zhang Xiqing, Fan Xi-wu, Yimin Chen +6 more

Cailiao yanjiu xuebao•Aug 25, 1998•0 citations
Many authors have experimentally examined the nonlinearities of HgCdTe at resonance with the CO2 laser wavelength [1]. At room temperature non1inearities of electronic origin, arising from band filling, are weak because of Auger recombination and are masked by thermal effects. In this communication we extend the analysis of ref. 1 on thermally induced optical bistability at low power: we show, for the first time in HgCdTe, the appearance of clockwise hysteresis cycles in transmission as input power Pi is increased, due to nonlinear absorption. We can account for both absorptive and refractive nonlinear contributions by simultaneous monitoring of transmission and reflection. The Hg0.815Cd0.185Te plates (280 um in thickness, with doping pa =1*1016 cm-3, prepared and polished by Elettronica SpA) were placed without heatsinking in a thermally controlled environment. In Fig. 1 the transmitted (Pt) and reflected (Pr) power is shown as a function of Pi: the three data sets differ in cavity mistuning. The thermooptic effect was measured directly, by a close focus optical pyrometer, and indirectly by taking data at different thermal bath temperature T. The values of Pi at the hysteresis associated to a given cavity interference order (indicated with the symbols of Fig. 1c) drift with T (Fig. 2): the maximum induced temperature increase is inferred to be 30-35°C, with steps of 2.5-3.5°C at the switching points, and a value of dn/dT = -2.8*10-3 K-1 is deduced. Fig. 3 presents numerical results (to be compared with Fig. 1b) obtained parametrically solving the nonlinear Fabry Perot equations using the absorption measured after AR coating one sample face. This nonlinear absorption will be discussed in terms of a free carrier origin.
Utilizing prism coupling of an argon laser beam into a nonlinear ZnS waveguide we have observed power-dependent optical bistability. We detuned the incidence angle by several linewidths from the optimal low power efficiency case. At this position we observed switching and hysteresis and verified the hysteresis loop to be bistable. The origin of the bistability we tentatively identified as a combination of intensity-dependent absorption and dispersion. Our conditions for bistability were different from those of W. Lukosz et al. in OPTICAL BISTABILITY III (Springer-Verlag, New York, 1986), p. 109.