Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

IEEE Journal of Quantum Electronics

A simplified analysis of the optical bistability of multiple quantum well etalons

H. Yokoyama

Published Jun 1, 1989• 13 citations
Publisher

Abstract

An analysis of static room-temperature-operation characteristics of a reflection-mode semiconductor multiple-quantum well etalon by a simplified two-level system formula of optical nonlinear properties and a computer simulation is presented. In the calculation for a GaAs/AlGaAs multiple-quantum-well etalon using the parameters reported in experimental measurement, it is shown that the very large excitonic optical nonlinearity is not effectively utilized for the optical bistable operation. This occurs because the effective positive-feedback mechanism which increases the etalon internal light intensity is suppressed when a hardly saturable background interband absorption tail is larger than a few thousand cm/sup -1/ at a wavelength where the large excitonic dispersive nonlinearity is observed.>

DOI
10.1109/3.29246

Related papers

Origin of the nonlinear index saturation in the band tail absorption region of GaAs/AlGaAs multiple quantum wells

Bruno G. Sfez, J. L. Oudar, Robert Kuszelewicz +1 more

The saturation behavior of the nonlinear index δnNL in the band tail of GaAs/AlGaAs multiple quantum wells is experimentally studied in quasi-steady state and in a low absorption region (below 300 cm−1), where dispersive optical bistability is observed. Measurements at different detunings from the exciton resonance allow us to study the absorption dependence of the saturation parameters. The saturation intensity IS is found inversely proportional to the linear absorption coefficient, while the saturating nonlinear index δnS is approximately constant. This evidences that the nonlinear index saturation is due to a saturation of the carrier density versus light intensity, due to the saturation of the band tail absorption itself.

Applied Physics Letters•Mar 9, 1992•10 citations

Multiple quantum well optical nonlinearities: bistability from increasing absorption and the self electro-optic device

David A. B. Miller

Abstract This paper briefly reviews the nonlinear optical and electro-optical properties and applications of GaAs—AlGaAs multiple quantum wells, all of which are compatible with laser diodes or semiconductor electronics or both. They show large nonlinear absorption and refraction (associated with their strong room-temperature exciton resonances) applicable to all-optical devices. They also show large electroabsorptive effects, some of which are unique to the quantum wells at any temperature, which are so strong that optical modulators can be made with micrometre dimensions. A new class of optical bistability (due to increasing absorption) is also reviewed; combination of this with the electroabsorptive effects enables a new mirrorless optical switch called a Self Electro-optic Effect Device (SEED), which sets a new standard for optical switching energies, with energy densities reduced by a factor of six by comparison to even the best resonant cavity devices.

Philosophical Transactions of the Royal Society of London Series A Mathematical and Physical Sciences•Dec 18, 1984•6 citations

Optical nonlinearity, bistability, and signal processing in semiconductors

Nasser N. Peyghambarian, H. M. Gibbs

Semiconductors exhibit large optical nonlinearities near the band edge because of resonance enhancement. Optical bistability occurs when the optical nonlinearities are coupled with feedback. In bulk GaAs and GaAs–AlGaAs multiple-quantum-well superlattices, the nonlinearity arising from the presence of the free-exciton resonance has produced room-temperature optical bistability with a few milliwatts of power. The formation of biexcitons in CuCl, the saturation of the bound exciton on CdS, and band-filling effects in InSb, InAs, and HgCdTe lead to observation of bistability in these materials. A bistable etalon can be operated in an optical-gate mode to generate optical analogs of electronic gates such as and, or, and nor. It has been demonstrated that a GaAs optical NOR gate responds in ∼1 psec, using only ≲3 pJ of energy. However, because of the carrier lifetime of a few nanoseconds, the repetition rate of the NOR gate is now limited to a few hundred megahertz.

Journal of the Optical Society of America B•Jul 1, 1985•69 citations

Room-temperature excitonic optical bistability in bulk GaAs

Jack L. Jewell, Seth Ovadia, Nasser N. Peyghambarian +4 more

Optical bistable devices containing GaAs/AlGaAs multiple quantum well (MQW) structures have shown great potential for performing fast low-power optical switching at room temperature.1 The presence of a much stronger exciton absorption feature in the MQW structures compared to bulk GaAs suggests far superior performance in the former. We report the observation of room-temperature bistability in bulk GaAs with input power <10 mW and intensities of a few kW/cm2. The intensities are consistent with the data of Miller et al.2 which show a saturation intensity of nearly 4 kW/cm2 in a MQW sample with a detuning of less than a halfwidth from the peak of the exciton resonance. Our detunings are always several halfwidths.

Conference on Lasers and Electro-Optics•Jan 1, 1984•1 citation

Bistable optical switching in GaAs multiple-quantum-well epitaxial etalons

J Oudar, Bruno G. Sfez, Robert Kuszelewicz

Epitaxial methods allow the fabrication of nonlinear interferomethc structures which include the mirrors and the GaAs Multiple Quantum Wells (MQW) nonlinear medium in a single crystal. This results in very compact nonlinear microcavities with typically 5im overall thickness. Optical bistability is observed in these structures at mW optical power. We review our latest experimental results on these structures including the observation of high contrast switching in the reflection mode the direct measurement of dispersive optical nonlinearities in MQWs evidencing their saturation behavior at high intensities. Finally we report external-beam switching experiments which allow to assess the potential of these structures as all-optical gates.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Mar 1, 1991•0 citations

Evidence That Room Temperature Optical Bistability Is Excitonic In Both Bulk And Multiple-Quantum-Well Gallium Arsenide

Seth Ovadia, H. M. Gibbs, Jack L. Jewell +2 more

The minimum power (=5 mW) for room-temperature optical bistability is very similar in bulk and multiple-quantum-well (MQW) etalons. No exciton resonance is obvious in the absorption spectrum of bulk GaAs at 300 K because it blends into the band edge, but it is present, and its area is two-thirds that of the MOW heavy-hole exciton. It is shown that the excitonic nonlinear index change is consistent with the observed bistability.

Optical Engineering•Aug 1, 1985•17 citations
An analysis of static room-temperature-operation characteristics of a reflection-mode semiconductor multiple-quantum well etalon by a simplified two-level system formula of optical nonlinear properties and a computer simulation is presented. In the calculation for a GaAs/AlGaAs multiple-quantum-well etalon using the parameters reported in experimental measurement, it is shown that the very large excitonic optical nonlinearity is not effectively utilized for the optical bistable operation. This occurs because the effective positive-feedback mechanism which increases the etalon internal light intensity is suppressed when a hardly saturable background interband absorption tail is larger than a few thousand cm/sup -1/ at a wavelength where the large excitonic dispersive nonlinearity is observed.>
The saturation behavior of the nonlinear index δnNL in the band tail of GaAs/AlGaAs multiple quantum wells is experimentally studied in quasi-steady state and in a low absorption region (below 300 cm−1), where dispersive optical bistability is observed. Measurements at different detunings from the exciton resonance allow us to study the absorption dependence of the saturation parameters. The saturation intensity IS is found inversely proportional to the linear absorption coefficient, while the saturating nonlinear index δnS is approximately constant. This evidences that the nonlinear index saturation is due to a saturation of the carrier density versus light intensity, due to the saturation of the band tail absorption itself.
Abstract This paper briefly reviews the nonlinear optical and electro-optical properties and applications of GaAs—AlGaAs multiple quantum wells, all of which are compatible with laser diodes or semiconductor electronics or both. They show large nonlinear absorption and refraction (associated with their strong room-temperature exciton resonances) applicable to all-optical devices. They also show large electroabsorptive effects, some of which are unique to the quantum wells at any temperature, which are so strong that optical modulators can be made with micrometre dimensions. A new class of optical bistability (due to increasing absorption) is also reviewed; combination of this with the electroabsorptive effects enables a new mirrorless optical switch called a Self Electro-optic Effect Device (SEED), which sets a new standard for optical switching energies, with energy densities reduced by a factor of six by comparison to even the best resonant cavity devices.
Semiconductors exhibit large optical nonlinearities near the band edge because of resonance enhancement. Optical bistability occurs when the optical nonlinearities are coupled with feedback. In bulk GaAs and GaAs–AlGaAs multiple-quantum-well superlattices, the nonlinearity arising from the presence of the free-exciton resonance has produced room-temperature optical bistability with a few milliwatts of power. The formation of biexcitons in CuCl, the saturation of the bound exciton on CdS, and band-filling effects in InSb, InAs, and HgCdTe lead to observation of bistability in these materials. A bistable etalon can be operated in an optical-gate mode to generate optical analogs of electronic gates such as and, or, and nor. It has been demonstrated that a GaAs optical NOR gate responds in ∼1 psec, using only ≲3 pJ of energy. However, because of the carrier lifetime of a few nanoseconds, the repetition rate of the NOR gate is now limited to a few hundred megahertz.
Optical bistable devices containing GaAs/AlGaAs multiple quantum well (MQW) structures have shown great potential for performing fast low-power optical switching at room temperature.1 The presence of a much stronger exciton absorption feature in the MQW structures compared to bulk GaAs suggests far superior performance in the former. We report the observation of room-temperature bistability in bulk GaAs with input power <10 mW and intensities of a few kW/cm2. The intensities are consistent with the data of Miller et al.2 which show a saturation intensity of nearly 4 kW/cm2 in a MQW sample with a detuning of less than a halfwidth from the peak of the exciton resonance. Our detunings are always several halfwidths.
Epitaxial methods allow the fabrication of nonlinear interferomethc structures which include the mirrors and the GaAs Multiple Quantum Wells (MQW) nonlinear medium in a single crystal. This results in very compact nonlinear microcavities with typically 5im overall thickness. Optical bistability is observed in these structures at mW optical power. We review our latest experimental results on these structures including the observation of high contrast switching in the reflection mode the direct measurement of dispersive optical nonlinearities in MQWs evidencing their saturation behavior at high intensities. Finally we report external-beam switching experiments which allow to assess the potential of these structures as all-optical gates.