Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Demonstration of a low-noise near-infrared photon counter with multiphoton discrimination

Aaron Miller, Sae Woo Nam, John M. Martinis, Alexander V. Sergienko

Published Jul 24, 2003• 285 citations
Publisher

Abstract

We have demonstrated a system capable of directly measuring the photon-number state of a single pulse of light using a superconducting transition-edge sensor microcalorimeter. We verify the photon-number distribution of a weak pulsed-laser source at 1550 nm. Such single-photon metrology at telecommunication wavelengths provides the foundation for ensuring the security of photon sources used in implementations of quantum cryptography. Additionally, this system has the lowest noise equivalent power of any single-photon detector and combines high efficiency near-infrared photon counting with the ability to resolve multiphoton absorption events.

DOI
10.1063/1.1596723

Related papers

Counting near-infrared single-photons with 95% efficiency

Adriana E. Lita, Aaron Miller, Sae Woo Nam

Single-photon detectors operating at visible and near-infrared wavelengths with high detection efficiency and low noise are a requirement for many quantum-information applications. Superconducting transition-edge sensors (TESs) are capable of detecting visible and near-infrared light at the single-photon level and are capable of discriminating between one- and two-photon absorption events; however these capabilities place stringent design requirements on the TES heat capacity, thermometry, and optical detection efficiency. We describe the fabrication and evaluation of a fiber-coupled, photon-number-resolving TES detector optimized for absorption at 1550 and 1310 nm wavelengths. The measured system detection efficiency at 1556 nm is 95 % +/- 2 %, which to our knowledge is the highest system detection efficiency reported for a near-infrared single-photon detector.

Optics Express•Jan 1, 2008•733 citations

Noise-free high-efficiency photon-number-resolving detectors

Danna Rosenberg, Adriana E. Lita, Aaron Miller +1 more

High-efficiency optical detectors that can determine the number of photons in a pulse of monochromatic light have applications in a variety of physics studies, including post-selection-based entanglement protocols for linear optics quantum computing and experiments that simultaneously close the detection and communication loopholes of Bell's inequalities. Here we report on our demonstration of fiber-coupled, noise-free, photon-number-resolving transition-edge sensors with 88% efficiency at 1550 nm. The efficiency of these sensors could be made even higher at any wavelength in the visible and near-infrared spectrum without resulting in a higher dark-count rate or degraded photon-number resolution.

arXiv:quant-ph/0506175•Physical Review A•Jun 17, 2005•242 citations

Extending single-photon optimized superconducting transition edge sensors beyond the single-photon counting regime

Thomas Gerrits, Brice Calkins, Nathan A. Tomlin +4 more

Typically, transition edge sensors resolve photon number of up to 10 or 20 photons, depending on the wavelength and TES design. We extend that dynamic range up to 1000 photons, while maintaining sub-shot noise detection process uncertainty of the number of detected photons and beyond that show a monotonic response up to ≈ 6 · 10(6) photons in a single light pulse. This mode of operation, which heats the sensor far beyond its transition edge into the normal conductive regime, offers a technique for connecting single-photon-counting measurements to radiant-power measurements at picowatt levels. Connecting these two usually incompatible operating regimes in a single detector offers significant potential for directly tying photon counting measurements to conventional cryogenic radiometric standards. In addition, our measurements highlight the advantages of a photon-number state source over a coherent pulse source as a tool for characterizing such a detector.

Optics Express•Oct 2, 2012•55 citations

Superconducting transition-edge sensors optimized for high-efficiency photon-number resolving detectors

Adriana E. Lita, Brice Calkins, Lenson A. Pellouchoud +2 more

Superconducting photon detectors have emerged as a powerful new option for detecting single photons. System detection efficiency that incorporates the quantum efficiency of the device and system losses is one of the most important single-photon detector performance metrics for quantum information applications. Superconducting transition-edge sensors (TESs) are microcalorimeters that have the ability of distinguishing single photons with negligible dark counts. In addition, TESs are capable of directly measuring the photon number in a pulse of light. We have achieved near-unity system detection efficiency with TESs at particular wavelengths in the near-infrared by using multilayer structures that enhance the absorption of light into the active device material. We describe the design of the multilayer structure enabling high detection efficiency TESs including issues and requirements for obtaining detection efficiency values higher than 99 %. We describe the device fabrication and finally, show recent results of devices optimized for high detection efficiency using the multilayer structure.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 20, 2010•51 citations

Quantum Key Distribution Using Polarized Single Infrared Photons

Roman Sobolewski

Experimental research has been conducted in order to establish the new quantum key distribution system for secure and undecipherable quantum communications. The system has been based on optical single-photon transmitters and superconducting single-photon detector receivers. The photon transmitters were based on heavily attenuated femtosecond optical pulses, generated by a high-repetition-rate laser. Novel superconducting devices were designed and developed for efficient and ultrafast counting of visible-light and near-infrared (telecommunication wavelength) photons. The devices were fabricated as nanostructured superconducting NbN serpentine lines with the active area of 100 micrometers squared and operated at 4.2 K inside a cryostat. The detector experimental quantum efficiency reached above 10% for visible-light and up to 8% for near-infrared photons. The dark counts were 0.1 per second. The real-time photon counting rate was above 2 GHz and jitter was 18 ps. In terms of the photon-counting performance, our detectors are significantly better than any competing avalanche photodiodes and photomultipliers.

•Dec 1, 2004•0 citations

Ultrafast superconducting single-photon optical detectors

Roman Sobolewski, J. Zhang, Wojciech Słysz +12 more

We present a new class of single-photon devices for counting of both visible and infrared photons. Our superconducting single-photon detectors (SSPDs) are characterized by the intrinsic quantum efficiency (QE) reaching up to 100%, above 10 GHz counting rate, and negligible dark counts. The detection mechanism is based on the photon-induced hotspot formation and subsequent appearance of a transient resistive barrier across an ultrathin and submicron-wide superconducting stripe. The devices are fabricated from 3.5-nm-thick NbN films and operate at 4.2 K, well below the NbN superconducting transition temperature. Various continuous and pulsed laser sources in the wavelength range from 0.4 μm up to >3 μm were implemented in our experiments, enabling us to determine the detector QE in the photon-counting mode, response time, and jitter. For our best 3.5-nm-thick, 10×10 μm2-area devices, QE was found to reach almost 100% for any wavelength shorter than about 800 nm. For longer-wavelength (infrared) radiation, QE decreased exponentially with the photon wavelength increase. Time-resolved measurements of our SSPDs showed that the system-limited detector response pulse width was below 150 ps. The system jitter was measured to be 35 ps. In terms of the counting rate, jitter, and dark counts, the NbN SSPDs significantly outperform their semiconductor counterparts. Already identifeid and implemented applications of our devices range from noninvasive testing of semiconductor VLSI circuits to free-space quantum communications and quantum cryptography.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 8, 2003•3 citations
We have demonstrated a system capable of directly measuring the photon-number state of a single pulse of light using a superconducting transition-edge sensor microcalorimeter. We verify the photon-number distribution of a weak pulsed-laser source at 1550 nm. Such single-photon metrology at telecommunication wavelengths provides the foundation for ensuring the security of photon sources used in implementations of quantum cryptography. Additionally, this system has the lowest noise equivalent power of any single-photon detector and combines high efficiency near-infrared photon counting with the ability to resolve multiphoton absorption events.
Single-photon detectors operating at visible and near-infrared wavelengths with high detection efficiency and low noise are a requirement for many quantum-information applications. Superconducting transition-edge sensors (TESs) are capable of detecting visible and near-infrared light at the single-photon level and are capable of discriminating between one- and two-photon absorption events; however these capabilities place stringent design requirements on the TES heat capacity, thermometry, and optical detection efficiency. We describe the fabrication and evaluation of a fiber-coupled, photon-number-resolving TES detector optimized for absorption at 1550 and 1310 nm wavelengths. The measured system detection efficiency at 1556 nm is 95 % +/- 2 %, which to our knowledge is the highest system detection efficiency reported for a near-infrared single-photon detector.
High-efficiency optical detectors that can determine the number of photons in a pulse of monochromatic light have applications in a variety of physics studies, including post-selection-based entanglement protocols for linear optics quantum computing and experiments that simultaneously close the detection and communication loopholes of Bell's inequalities. Here we report on our demonstration of fiber-coupled, noise-free, photon-number-resolving transition-edge sensors with 88% efficiency at 1550 nm. The efficiency of these sensors could be made even higher at any wavelength in the visible and near-infrared spectrum without resulting in a higher dark-count rate or degraded photon-number resolution.
Typically, transition edge sensors resolve photon number of up to 10 or 20 photons, depending on the wavelength and TES design. We extend that dynamic range up to 1000 photons, while maintaining sub-shot noise detection process uncertainty of the number of detected photons and beyond that show a monotonic response up to ≈ 6 · 10(6) photons in a single light pulse. This mode of operation, which heats the sensor far beyond its transition edge into the normal conductive regime, offers a technique for connecting single-photon-counting measurements to radiant-power measurements at picowatt levels. Connecting these two usually incompatible operating regimes in a single detector offers significant potential for directly tying photon counting measurements to conventional cryogenic radiometric standards. In addition, our measurements highlight the advantages of a photon-number state source over a coherent pulse source as a tool for characterizing such a detector.
Superconducting photon detectors have emerged as a powerful new option for detecting single photons. System detection efficiency that incorporates the quantum efficiency of the device and system losses is one of the most important single-photon detector performance metrics for quantum information applications. Superconducting transition-edge sensors (TESs) are microcalorimeters that have the ability of distinguishing single photons with negligible dark counts. In addition, TESs are capable of directly measuring the photon number in a pulse of light. We have achieved near-unity system detection efficiency with TESs at particular wavelengths in the near-infrared by using multilayer structures that enhance the absorption of light into the active device material. We describe the design of the multilayer structure enabling high detection efficiency TESs including issues and requirements for obtaining detection efficiency values higher than 99 %. We describe the device fabrication and finally, show recent results of devices optimized for high detection efficiency using the multilayer structure.
Experimental research has been conducted in order to establish the new quantum key distribution system for secure and undecipherable quantum communications. The system has been based on optical single-photon transmitters and superconducting single-photon detector receivers. The photon transmitters were based on heavily attenuated femtosecond optical pulses, generated by a high-repetition-rate laser. Novel superconducting devices were designed and developed for efficient and ultrafast counting of visible-light and near-infrared (telecommunication wavelength) photons. The devices were fabricated as nanostructured superconducting NbN serpentine lines with the active area of 100 micrometers squared and operated at 4.2 K inside a cryostat. The detector experimental quantum efficiency reached above 10% for visible-light and up to 8% for near-infrared photons. The dark counts were 0.1 per second. The real-time photon counting rate was above 2 GHz and jitter was 18 ps. In terms of the photon-counting performance, our detectors are significantly better than any competing avalanche photodiodes and photomultipliers.
We present a new class of single-photon devices for counting of both visible and infrared photons. Our superconducting single-photon detectors (SSPDs) are characterized by the intrinsic quantum efficiency (QE) reaching up to 100%, above 10 GHz counting rate, and negligible dark counts. The detection mechanism is based on the photon-induced hotspot formation and subsequent appearance of a transient resistive barrier across an ultrathin and submicron-wide superconducting stripe. The devices are fabricated from 3.5-nm-thick NbN films and operate at 4.2 K, well below the NbN superconducting transition temperature. Various continuous and pulsed laser sources in the wavelength range from 0.4 μm up to >3 μm were implemented in our experiments, enabling us to determine the detector QE in the photon-counting mode, response time, and jitter. For our best 3.5-nm-thick, 10×10 μm2-area devices, QE was found to reach almost 100% for any wavelength shorter than about 800 nm. For longer-wavelength (infrared) radiation, QE decreased exponentially with the photon wavelength increase. Time-resolved measurements of our SSPDs showed that the system-limited detector response pulse width was below 150 ps. The system jitter was measured to be 35 ps. In terms of the counting rate, jitter, and dark counts, the NbN SSPDs significantly outperform their semiconductor counterparts. Already identifeid and implemented applications of our devices range from noninvasive testing of semiconductor VLSI circuits to free-space quantum communications and quantum cryptography.