Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Reduced and negative phase-amplitude-coupling coefficient in a modulated semiconductor optical amplifier submitted to four-wave mixing

Horacio Soto, Didier Erasme, Guy Debarge, Pierre Doussiere

Published Jun 2, 1996• 0 citations
OpenAlex

Abstract

Summary form only given. We present a four-wave mixing (FWM) experiment using a semiconductor optical amplifier (SOA). The FWM process is analyzed via the nonlinear susceptibilities for carrier density pulsation (CDP), the spectral hole burning (SHB) and the carrier heating (CH).

Related papers

An experimental method for identifying nonlinear phenomena intervening in a FWM process developed in a semiconductor optical amplifier

Horacio Soto, Didier Erasme

The new experimental research on the four-wave mixing (FWM) phenomena described here consists in launching three optical waves (pump, probe, and test) into a semiconductor optical amplifier and measuring the test beam transmission and the conversion efficiency of the new wave generated to one side of the test beam. It allows for an excellent identification of the nonlinear phenomena involved in the FWM process. The analysis principle is based on the modulation of the gain curve for each of the three effects considered: spectral hole burning, carrier heating, and carrier density pulsation. Experimental and theoretical results are presented.

IEEE Journal of Quantum Electronics•Jan 1, 1998•8 citations

Four-wave mixing in quantum dot semiconductor optical amplifiers

Ahmed H. Flayyih, Amin Habbeb AL-Khursan

The theory of four-wave mixing (FWM) in the quantum dot (QD) semiconductor optical amplifiers (SOAs) is discussed by combining the QD rate equations system, the quantum-mechanical density-matrix theory, and the pulse propagation in QD SOAs including the three region of QD structure ground state (GS), excited state (ES), and wetting layer. Also, relations for differential gain, gain integral, and nonlinear susceptibility of both pump, probe, and signal pulses were discussed. Gain and differential gain have been calculated for QD structure. FWM efficiency and its components [spectral hole burning (SHB), carrier heating, and carrier density pulsation] are calculated. It is found that inclusion of ES in the formulas and in the calculations is essential since it works as a carrier reservoir for GS. It is found that QD SOA with enough capture time from ES to GS will reduce the SHB component, and so it is suitable for telecommunication applications that require symmetric conversion and independent detuning.

Applied Optics•May 6, 2013•14 citations

Frequency-domain model of multiwave mixing in bulk semiconductor optical amplifiers

M.A. Summerfield, R.S. Tucker

We present a new steady-state frequency-domain model of highly nondegenerate four-wave mixing in bulk semiconductor optical amplifiers (SOA's). The model can handle a large number of interacting optical fields and situations in which the nonlinear interactions are complex. It accounts for the longitudinal dependence of the population inversion in the SOA and the spectral dependence of the gain. Carrier population pulsations, spectral-hole burning, and carrier heating, which dominate the nonlinear response over bandwidths into the terahertz range, are included. The model also includes output amplified spontaneous emission noise and allows important system parameters such as signal-to-noise ratio and noise figure to be estimated. A number of applications of the model are presented in which good agreement between theoretical and experimental results is demonstrated.

IEEE Journal of Selected Topics in Quantum Electronics•Jan 1, 1999•43 citations

Demonstration of slow light in semiconductor optical amplifier

Anoop C. Patil, Deepa Venkitesh, Karl J. Dexter +2 more

Slow light generation through four wave mixing is experimentally investigated in a non-linear semiconductor optical amplifier (SOA). The mechanism of slow-light generation is analyzed through gain saturation behavior of the SOA. The delay of the probe beam is controlled optically by pump-probe detuning. A delay of 260 ps is achieved for sinusoidal modulation at 0.5 GHz corresponding to a RF phase change of 0.26π.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Dec 29, 2010•0 citations

Experimental investigation on slow light via four-wave mixing in semiconductor optical amplifiers

Yin Zhang⋆, Xinliang Zhang, Xi Huang

Optical buffer is a key component in all-optical information processing systems. Slow light at room temperature via four-wave mixing in semiconductor an optical amplifier (SOA) is experimentally investigated. Time delay of 0.4 ns is achieved for a sinusoidal modulation signal at 0.1GHz, corresponding to a delay-bandwidth product (DBP) of 0.04. Factors that affect the experimental results are discussed. It is found out that the variable optical delay via four-wave mixing in SOA can be controlled either electrically by changing the SOA bias, or optically by varying the pump power or pump-probe detuning.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Dec 11, 2008•0 citations

Four-wave mixing and rabi oscillations in quantum-dot semiconductor optical amplifiers

Benjamin Lingnau, Marina Zajnulina, Kathy Lüdge

Using a self-consistent delay-differential-equation model for the description of the nonlinear light propagation in InAs/InGaAs quantum-dot-in-a-well semiconductor optical amplifiers, we analyze the amplifier in a four-wave-mixing setup in terms of the conversion efficiency. Our model allows us to extract the hierarchy of nonlinear effects that constitute the four-wave-mixing process. We show that spectral hole burning in the quantum-dot medium facilitates wavelength conversion over a spectral detuning of several THz, whereas the effect of carrier heating and global carrier-density pulsations is found to be negligible. Furthermore we show that for high optical field amplitudes the emergence of Rabi oscillations leads to a flattening of the conversion efficiency, potentially allowing for ultra-broadband wavelength conversion and frequency comb generation.

International Conference on Numerical Simulation of Optoelectronic Devices (NUSOD)•Jul 1, 2017•1 citation
The new experimental research on the four-wave mixing (FWM) phenomena described here consists in launching three optical waves (pump, probe, and test) into a semiconductor optical amplifier and measuring the test beam transmission and the conversion efficiency of the new wave generated to one side of the test beam. It allows for an excellent identification of the nonlinear phenomena involved in the FWM process. The analysis principle is based on the modulation of the gain curve for each of the three effects considered: spectral hole burning, carrier heating, and carrier density pulsation. Experimental and theoretical results are presented.
The theory of four-wave mixing (FWM) in the quantum dot (QD) semiconductor optical amplifiers (SOAs) is discussed by combining the QD rate equations system, the quantum-mechanical density-matrix theory, and the pulse propagation in QD SOAs including the three region of QD structure ground state (GS), excited state (ES), and wetting layer. Also, relations for differential gain, gain integral, and nonlinear susceptibility of both pump, probe, and signal pulses were discussed. Gain and differential gain have been calculated for QD structure. FWM efficiency and its components [spectral hole burning (SHB), carrier heating, and carrier density pulsation] are calculated. It is found that inclusion of ES in the formulas and in the calculations is essential since it works as a carrier reservoir for GS. It is found that QD SOA with enough capture time from ES to GS will reduce the SHB component, and so it is suitable for telecommunication applications that require symmetric conversion and independent detuning.
We present a new steady-state frequency-domain model of highly nondegenerate four-wave mixing in bulk semiconductor optical amplifiers (SOA's). The model can handle a large number of interacting optical fields and situations in which the nonlinear interactions are complex. It accounts for the longitudinal dependence of the population inversion in the SOA and the spectral dependence of the gain. Carrier population pulsations, spectral-hole burning, and carrier heating, which dominate the nonlinear response over bandwidths into the terahertz range, are included. The model also includes output amplified spontaneous emission noise and allows important system parameters such as signal-to-noise ratio and noise figure to be estimated. A number of applications of the model are presented in which good agreement between theoretical and experimental results is demonstrated.
Optical buffer is a key component in all-optical information processing systems. Slow light at room temperature via four-wave mixing in semiconductor an optical amplifier (SOA) is experimentally investigated. Time delay of 0.4 ns is achieved for a sinusoidal modulation signal at 0.1GHz, corresponding to a delay-bandwidth product (DBP) of 0.04. Factors that affect the experimental results are discussed. It is found out that the variable optical delay via four-wave mixing in SOA can be controlled either electrically by changing the SOA bias, or optically by varying the pump power or pump-probe detuning.
Using a self-consistent delay-differential-equation model for the description of the nonlinear light propagation in InAs/InGaAs quantum-dot-in-a-well semiconductor optical amplifiers, we analyze the amplifier in a four-wave-mixing setup in terms of the conversion efficiency. Our model allows us to extract the hierarchy of nonlinear effects that constitute the four-wave-mixing process. We show that spectral hole burning in the quantum-dot medium facilitates wavelength conversion over a spectral detuning of several THz, whereas the effect of carrier heating and global carrier-density pulsations is found to be negligible. Furthermore we show that for high optical field amplitudes the emergence of Rabi oscillations leads to a flattening of the conversion efficiency, potentially allowing for ultra-broadband wavelength conversion and frequency comb generation.