Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Applied Physics Letters

Improvement of fluorescence intensity of nitrogen vacancy centers in self-formed diamond microstructures

Satoko Furuyama, Kosuke Tahara, Takayuki Iwasaki, Maki Shimizu, Junya Yaita, M. Kondo, Tetsuo Kodera, Mutsuko Hatano

Published Oct 19, 2015• 18 citations
Publisher

Abstract

We present umbrella-shaped diamond microstructures with metal mirrors at the bottom in order to improve the amount of collected photons from nitrogen vacancy centers. The metal mirrors at the bottom are self-aligned to the umbrella-shaped diamond microstructures which are selectively grown through holes created on a metal mask. By the finite-difference time-domain simulations, we found that the umbrella-shaped microstructures, which have an effect similar to solid immersion lens, could collect photons more efficiently than bulk or pillar-shaped microstructures. Improvement of the fluorescence intensity by factors of from 3 to 5 is shown experimentally.

DOI
10.1063/1.4933103

Related papers

Diamond-optic enhanced photon collection efficiency for sensing with nitrogen-vacancy centers

Muhib Omar, Andreas Conta, Andreas Westerhoff +4 more

We present a design to increase the amount of collected fluorescence emitted by nitrogen-vacancy color centers in diamond used for quantum-sensing. An improvement was measured in collected fluorescence when comparing oppositely faced emitting surfaces by a factor of 3.8(1). This matches ray-tracing simulation results. This design therefore improves on the shot noise limited sensitivity in optical readout-based measurements of, for instance, magnetic and electric fields, pressure, temperature, and rotations.

arXiv:2301.06583•Optics Letters•Apr 5, 2023•8 citations

Strongly enhanced photon collection from diamond defect centers under microfabricated integrated solid immersion lenses

John Patrick Hadden, J. P. Harrison, A. C. Stanley‐Clarke +5 more

The efficiency of photon collection from optically active defect centers in bulk diamond is greatly reduced by refraction at the diamond-air interface. We report on the fabrication and measurement of a geometrical solution to the problem; integrated solid immersion lenses (SILs) etched directly into the surface of diamond. An increase of a factor of 10 was observed in the saturated count-rate from a single negatively charged nitrogen-vacancy (NV−) within a 5 μm diameter SIL compared with NV−’s under a planar surface in the same crystal. Such a system is potentially scalable and easily adaptable to other defect centers in bulk diamond.

arXiv:1006.2093•Applied Physics Letters•Dec 13, 2010•292 citations

Laser written nitrogen vacancy centers in diamond integrated with transfer print GaN solid immersion lenses

Xingrui Cheng, Nils Kolja Wessling, Saptarsi Ghosh +9 more

Laser-written Nitrogen Vacancy (NV−) centers are combined with transfer-printed GaN micro-lenses to increase fluorescent light collection by reducing total internal reflection at the planar diamond interface. We find a 2x improvement of fluorescent light collection using a 0.95 NA air objective at room temperature, in agreement with FDTD simulations. The nature of the transfer print micro-lenses leads to better performance with lower Numerical Aperture (NA) collection, as confirmed by results with a 0.5NA air objective which show improvement greater than 5x. The approach is attractive for scalable integrated quantum technologies.

Nanoscale and Quantum Materials: From Synthesis and Laser Processing to Applications•Mar 12, 2024•0 citations

Invited Article: Precision nanoimplantation of nitrogen vacancy centers into diamond photonic crystal cavities and waveguides

Marco Schukraft, Jiabao Zheng, Tim Schröder +5 more

We demonstrate a self-aligned lithographic technique for precision generation of nitrogen vacancy (NV) centers within photonic nanostructures on bulk diamond substrates. The process relies on a lithographic mask with nanoscale implantation apertures for NV creation, together with larger features for producing waveguides and photonic nanocavities. This mask allows targeted nitrogen ion implantation, and precision dry etching of nanostructures on bulk diamond. We demonstrate high-yield generation of single NVs at pre-determined nanoscale target regions on suspended diamond waveguides. We report implantation into the mode maximum of diamond photonic crystal nanocavities with a single-NV per cavity yield of ∼26% and Purcell induced intensity enhancement of the zero-phonon line. The generation of NV centers aligned with diamond photonic structures marks an important tool for scalable production of optically coupled spin memories.

APL Photonics•May 1, 2016•38 citations

Integrated Optics for Efficient Fluorescence Collection from Deep Single NV centers

Robert Bruss, Lucas Kirchbach, Andreas Stute

Efficient collection of fluorescence light is essential for all optically adressable qubit platforms. For the nitrogen-vacancy (NV) center in diamond, the high refractive index of the host medium poses a major challenge as it limits the solid angle under which fluorescence light can leave the crystal. To enhance collection efficiency from single NV centers, we design and simulate micro-optical elements that shall be directly fabricated on the diamond surface using two-photon polymerization. Several optical designs and photoresists are evaluated for their expected coupling efficiency into single-mode fibers and their tolerance to fabrication errors. Additionally, an analytical solution for single lens collimation of the emission of a point source in diamond at a specific wavelength is presented, as well as considerations regarding the degradation of wavefront quality in multi-wavelength Fresnel designs.

•Feb 5, 2026•0 citations

Enhancing the sensitivity of nitrogen-vacancy color-center ensemble sensors using one-dimensional photonic crystals

Yunpeng Yang, Sen Zhang, Kang Liu +4 more

The nitrogen-vacancy (NV) color center in diamond is a promising solid-state quantum system at room temperature. However, its sensitivity is limited by its low fluorescence collection efficiency, and its coherence time is limited by spin interference of impurity electrons around the NV color center. Here, we innovatively fabricated a one-dimensional photonic crystal on the surface of diamond, which greatly improved the fluorescence intensity of the NV color centers and increased the sensitivity of NV ensembles by a factor of 2.92. In addition, the laser reflected by the photonic crystal excites impurity electrons around the NV color centers, improving the electric field environment around the NV color centers, which exponentially prolongs the dephasing time (from 209 to 841 ns), opening avenues for NV color-center ensemble sensors.

Photonics Research•Apr 3, 2025•4 citations
We present umbrella-shaped diamond microstructures with metal mirrors at the bottom in order to improve the amount of collected photons from nitrogen vacancy centers. The metal mirrors at the bottom are self-aligned to the umbrella-shaped diamond microstructures which are selectively grown through holes created on a metal mask. By the finite-difference time-domain simulations, we found that the umbrella-shaped microstructures, which have an effect similar to solid immersion lens, could collect photons more efficiently than bulk or pillar-shaped microstructures. Improvement of the fluorescence intensity by factors of from 3 to 5 is shown experimentally.
We present a design to increase the amount of collected fluorescence emitted by nitrogen-vacancy color centers in diamond used for quantum-sensing. An improvement was measured in collected fluorescence when comparing oppositely faced emitting surfaces by a factor of 3.8(1). This matches ray-tracing simulation results. This design therefore improves on the shot noise limited sensitivity in optical readout-based measurements of, for instance, magnetic and electric fields, pressure, temperature, and rotations.
The efficiency of photon collection from optically active defect centers in bulk diamond is greatly reduced by refraction at the diamond-air interface. We report on the fabrication and measurement of a geometrical solution to the problem; integrated solid immersion lenses (SILs) etched directly into the surface of diamond. An increase of a factor of 10 was observed in the saturated count-rate from a single negatively charged nitrogen-vacancy (NV−) within a 5 μm diameter SIL compared with NV−’s under a planar surface in the same crystal. Such a system is potentially scalable and easily adaptable to other defect centers in bulk diamond.
Laser-written Nitrogen Vacancy (NV−) centers are combined with transfer-printed GaN micro-lenses to increase fluorescent light collection by reducing total internal reflection at the planar diamond interface. We find a 2x improvement of fluorescent light collection using a 0.95 NA air objective at room temperature, in agreement with FDTD simulations. The nature of the transfer print micro-lenses leads to better performance with lower Numerical Aperture (NA) collection, as confirmed by results with a 0.5NA air objective which show improvement greater than 5x. The approach is attractive for scalable integrated quantum technologies.
We demonstrate a self-aligned lithographic technique for precision generation of nitrogen vacancy (NV) centers within photonic nanostructures on bulk diamond substrates. The process relies on a lithographic mask with nanoscale implantation apertures for NV creation, together with larger features for producing waveguides and photonic nanocavities. This mask allows targeted nitrogen ion implantation, and precision dry etching of nanostructures on bulk diamond. We demonstrate high-yield generation of single NVs at pre-determined nanoscale target regions on suspended diamond waveguides. We report implantation into the mode maximum of diamond photonic crystal nanocavities with a single-NV per cavity yield of ∼26% and Purcell induced intensity enhancement of the zero-phonon line. The generation of NV centers aligned with diamond photonic structures marks an important tool for scalable production of optically coupled spin memories.
Efficient collection of fluorescence light is essential for all optically adressable qubit platforms. For the nitrogen-vacancy (NV) center in diamond, the high refractive index of the host medium poses a major challenge as it limits the solid angle under which fluorescence light can leave the crystal. To enhance collection efficiency from single NV centers, we design and simulate micro-optical elements that shall be directly fabricated on the diamond surface using two-photon polymerization. Several optical designs and photoresists are evaluated for their expected coupling efficiency into single-mode fibers and their tolerance to fabrication errors. Additionally, an analytical solution for single lens collimation of the emission of a point source in diamond at a specific wavelength is presented, as well as considerations regarding the degradation of wavefront quality in multi-wavelength Fresnel designs.
The nitrogen-vacancy (NV) color center in diamond is a promising solid-state quantum system at room temperature. However, its sensitivity is limited by its low fluorescence collection efficiency, and its coherence time is limited by spin interference of impurity electrons around the NV color center. Here, we innovatively fabricated a one-dimensional photonic crystal on the surface of diamond, which greatly improved the fluorescence intensity of the NV color centers and increased the sensitivity of NV ensembles by a factor of 2.92. In addition, the laser reflected by the photonic crystal excites impurity electrons around the NV color centers, improving the electric field environment around the NV color centers, which exponentially prolongs the dephasing time (from 209 to 841 ns), opening avenues for NV color-center ensemble sensors.