Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Acta Physica Sinica

Bright metastable noble gas atomic beam and atom trap using laser cooling

Cheng Cun-Feng, Yang Guo-Min, Wei Jiang, Pan Hu, Sun Yu, A.W. Liu, Cheng Guo-Sheng, Shui-Ming Hu

Published Jan 1, 2011• 3 citations
Publisher

Abstract

Metastable noble gas atomic beam is widely used in atomic and molecular physics studies.Using radio-frequency discharge and transverse laser cooling, we produced a well-collimated intense meta-stable Krypton beam.Numerical simulation is also used to analyze the trajectories of atoms in an optic field produced by transverse cooling laser beams.The charactersisticl of the atomic beam are determined by measuring the laser induced fluorescence.The atomic beam flux measured at 230 cm downstream is 1.61016 atoms/(s*sr), which is enhanced by two orders of magnitude.The Kr atoms are finally trapped in a magneto-optic trap.A total of 1.31010 meta-stable 84Kr atoms can be simultaneously trapped with a loading rate of 3.01011 atoms/s.The same setup is also successfully used to obtain a bright metastable atomic argon beam and trap.

DOI
10.7498/aps.60.103701

Related papers

Bright metastable helium atomic beam for lithography and atom optics

K. G. H. Baldwin, Wei-Jian Lu, Dragana Milic +3 more

Intense, highly collimated sources of atoms have many potential applications. Bright beams will be important for competitive high flux and high resolution direct-write techniques in lithography, with the added advantage of parallel writing through laser manipulation. Intense sources will also be useful in other atom optic devices e.g. for loading atoms into hollow fiber waveguides. In atomic physics, many collision processes can only be measured with the sensitivity offered by such high flux sources. We report progress on the development of an intense, collimated beam of metastable helium atoms which improves the brightness generated by conventional nozzle discharge sources by several orders of magnitude. The system uses diode lasers to transversely collimate and then to longitudinally slow the atoms, using Zeeman tuning to compensate for the changing Doppler shift. The slowed, collimated beam is then compressed in a 2D magneto-optic trap before a final collimation stage, to achieve the required increase in intensity. Initial experiments using the helium source for some of the applications above are described.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 1, 1997•4 citations

An atomic beam fluorescence locked magneto-optical trap for krypton atoms

Sunita Singh, Vibhuti Bhushan Tiwari, Satya Ram Mishra +1 more

We report here an atomic beam loaded magneto-optical trap (MOT) for metastable krypton atoms in which the fluorescence signal from the atomic beam is used to lock the cooling laser frequency. The fluorescence signal is generated by exciting the metastable krypton atomic beam using a probe laser beam (i.e. part of the cooling laser beam) intersecting the atomic beam at an angle. A spectral shift in the fluorescence signal can be achieved by varying the angle between the probe laser beam and the atomic beam to obtain the desired frequency detuning to lock the cooling laser frequency. This has been used to optimize the number of cold atoms in the MOT. The dependence of the peak height and slope of the atomic beam fluorescence (ABF) locking signal on the RF power in the discharge tube and pressure in the observation chamber of the setup has been studied to correlate its effect on the number of atoms in the MOT.

Laser Physics•Jan 17, 2014•3 citations

A bright metastable helium atomic beam for lithography and atom optics

Baldwin, KGH, Lu, W, Dragana Milic +3 more

Intense, highly collimated sources of atoms have many potential applications. Bright beams will be important for competitive high flux and high resolution direct-write techniques in lithography, with the added advantage of parallel writing through laser manipulation. Intense sources will also be useful in other atom optic devices e.g. for loading atoms into hollow fiber waveguides. In atomic physics, many collision processes can only be measured with the sensitivity offered by such high flux sources. We report progress on the development of an intense, collimated beam of metastable helium atoms which improves the brightness generated by conventional nozzle discharge sources by several orders of magnitude. The system uses diode lasers to transversely collimate and then to longitudinally slow the atoms, using Zeeman tuning to compensate for the changing Doppler shift. The slowed, collimated beam is then compressed in a 2D magneto-optic trap before a final collimation stage, to achieve the required increase in intensity. Initial experiments using the helium source for some of the applications above are described.

•Jan 1, 1997•0 citations

Thermal beam of metastable krypton atoms produced by optical excitation

Yue Ding, Shui-Ming Hu, K. Bailey +5 more

A room-temperature beam of krypton atoms in the metastable 5s[3/2]2 level is demonstrated via an optical excitation method. A Kr-discharge lamp is used to produce vacuum ultraviolet photons at 124 nm for the first-step excitation from the ground level 4p6 1S0 to the 5s[3/2]1 level. An 819 nm Ti:sapphire laser is used for the second-step excitation from 5s[3/2]1 to 5s[3/2]2 followed by a spontaneous decay to the 5s[3/2]2 metastable level. A metastable atomic beam with an angular flux density of 3 x 10(14) s(-1) sr(-1) is achieved at the total gas flow rate of 0.01 cm3/s at STP (or 3 x 10(17) at./s). The dependences of the flux on the gas flow rate, laser power, and lamp parameters are investigated.

arXiv:physics/0612046•Review of Scientific Instruments•Feb 1, 2007•25 citations

Trapping ultracold argon atoms

P. D. Edmunds

This thesis describes the dipole trapping of both metastable and ground state argon atoms. Metastable argon atoms are first Doppler-cooled down to ∼80 μK in a magneto- optical trap (MOT) on the 4s[3/2]2 to 4p[5/2]3 transitions. These were loaded into dipole traps formed both within the focus of a high-power CO2 laser beam and within an optical build-up cavity. The optical cavity’s well depth could be rapidly modulated: allowing efficient loading of the trap, characterisation of trapped atom temperature, and reduction of intensity noise. Collisional properties of the trapped metastable atoms were studied within the cavity and the Penning and associative losses from the trap calculated. Ground state noble gas atoms were also trapped for the first time. This was achieved by optically quenching metastable atoms to the ground state and then trapping the atoms in the cavity field. Although the ground state atoms could not be directly probed, we detected them by observing the additional collisional loss from co-trapped metastable argon atoms. This trap loss was used to determine an ultra-cold elastic cross section between the ground and metastable states. Using a type of parametric loss spectroscopy we also determined the polarisability of metastable argon at the trapping wavelength of 1064 nm.

•Mar 28, 2015•1 citation

An atomic beam of titanium for ultracold atom experiments

Jackson Schrott, Diego Novoa, Scott Eustice +1 more

We generate an atomic beam of titanium (Ti) using a "Ti-ball" Ti-sublimation pump, which is a common getter pump used in ultrahigh vacuum systems. We show that the sublimated atomic beam can be optically pumped into the metastable 3d3(4F)4s a5F5 state, which is the lower energy level in a cycling optical transition that can be used for laser cooling. We measure the atomic density and transverse and longitudinal velocity distributions of the beam through laser fluorescence spectroscopy. We find a metastable atomic flux density of 4.3(2) × 109 s-1 cm-2 with a mean forward velocity of 773(8) m/s at 2.55 cm directly downstream of the center of the Ti-ball. Owing to the details of optical pumping, the beam is highly collimated along the transverse axis parallel to the optical pumping beam and the flux density falls off as 1/r. We discuss how this source can be used to load atoms into a magneto-optical trap.

arXiv:2406.07779•Review of Scientific Instruments•Nov 1, 2024•5 citations
Metastable noble gas atomic beam is widely used in atomic and molecular physics studies.Using radio-frequency discharge and transverse laser cooling, we produced a well-collimated intense meta-stable Krypton beam.Numerical simulation is also used to analyze the trajectories of atoms in an optic field produced by transverse cooling laser beams.The charactersisticl of the atomic beam are determined by measuring the laser induced fluorescence.The atomic beam flux measured at 230 cm downstream is 1.61016 atoms/(s*sr), which is enhanced by two orders of magnitude.The Kr atoms are finally trapped in a magneto-optic trap.A total of 1.31010 meta-stable 84Kr atoms can be simultaneously trapped with a loading rate of 3.01011 atoms/s.The same setup is also successfully used to obtain a bright metastable atomic argon beam and trap.
Intense, highly collimated sources of atoms have many potential applications. Bright beams will be important for competitive high flux and high resolution direct-write techniques in lithography, with the added advantage of parallel writing through laser manipulation. Intense sources will also be useful in other atom optic devices e.g. for loading atoms into hollow fiber waveguides. In atomic physics, many collision processes can only be measured with the sensitivity offered by such high flux sources. We report progress on the development of an intense, collimated beam of metastable helium atoms which improves the brightness generated by conventional nozzle discharge sources by several orders of magnitude. The system uses diode lasers to transversely collimate and then to longitudinally slow the atoms, using Zeeman tuning to compensate for the changing Doppler shift. The slowed, collimated beam is then compressed in a 2D magneto-optic trap before a final collimation stage, to achieve the required increase in intensity. Initial experiments using the helium source for some of the applications above are described.
We report here an atomic beam loaded magneto-optical trap (MOT) for metastable krypton atoms in which the fluorescence signal from the atomic beam is used to lock the cooling laser frequency. The fluorescence signal is generated by exciting the metastable krypton atomic beam using a probe laser beam (i.e. part of the cooling laser beam) intersecting the atomic beam at an angle. A spectral shift in the fluorescence signal can be achieved by varying the angle between the probe laser beam and the atomic beam to obtain the desired frequency detuning to lock the cooling laser frequency. This has been used to optimize the number of cold atoms in the MOT. The dependence of the peak height and slope of the atomic beam fluorescence (ABF) locking signal on the RF power in the discharge tube and pressure in the observation chamber of the setup has been studied to correlate its effect on the number of atoms in the MOT.
Intense, highly collimated sources of atoms have many potential applications. Bright beams will be important for competitive high flux and high resolution direct-write techniques in lithography, with the added advantage of parallel writing through laser manipulation. Intense sources will also be useful in other atom optic devices e.g. for loading atoms into hollow fiber waveguides. In atomic physics, many collision processes can only be measured with the sensitivity offered by such high flux sources. We report progress on the development of an intense, collimated beam of metastable helium atoms which improves the brightness generated by conventional nozzle discharge sources by several orders of magnitude. The system uses diode lasers to transversely collimate and then to longitudinally slow the atoms, using Zeeman tuning to compensate for the changing Doppler shift. The slowed, collimated beam is then compressed in a 2D magneto-optic trap before a final collimation stage, to achieve the required increase in intensity. Initial experiments using the helium source for some of the applications above are described.
A room-temperature beam of krypton atoms in the metastable 5s[3/2]2 level is demonstrated via an optical excitation method. A Kr-discharge lamp is used to produce vacuum ultraviolet photons at 124 nm for the first-step excitation from the ground level 4p6 1S0 to the 5s[3/2]1 level. An 819 nm Ti:sapphire laser is used for the second-step excitation from 5s[3/2]1 to 5s[3/2]2 followed by a spontaneous decay to the 5s[3/2]2 metastable level. A metastable atomic beam with an angular flux density of 3 x 10(14) s(-1) sr(-1) is achieved at the total gas flow rate of 0.01 cm3/s at STP (or 3 x 10(17) at./s). The dependences of the flux on the gas flow rate, laser power, and lamp parameters are investigated.
This thesis describes the dipole trapping of both metastable and ground state argon atoms. Metastable argon atoms are first Doppler-cooled down to ∼80 μK in a magneto- optical trap (MOT) on the 4s[3/2]2 to 4p[5/2]3 transitions. These were loaded into dipole traps formed both within the focus of a high-power CO2 laser beam and within an optical build-up cavity. The optical cavity’s well depth could be rapidly modulated: allowing efficient loading of the trap, characterisation of trapped atom temperature, and reduction of intensity noise. Collisional properties of the trapped metastable atoms were studied within the cavity and the Penning and associative losses from the trap calculated. Ground state noble gas atoms were also trapped for the first time. This was achieved by optically quenching metastable atoms to the ground state and then trapping the atoms in the cavity field. Although the ground state atoms could not be directly probed, we detected them by observing the additional collisional loss from co-trapped metastable argon atoms. This trap loss was used to determine an ultra-cold elastic cross section between the ground and metastable states. Using a type of parametric loss spectroscopy we also determined the polarisability of metastable argon at the trapping wavelength of 1064 nm.
We generate an atomic beam of titanium (Ti) using a "Ti-ball" Ti-sublimation pump, which is a common getter pump used in ultrahigh vacuum systems. We show that the sublimated atomic beam can be optically pumped into the metastable 3d3(4F)4s a5F5 state, which is the lower energy level in a cycling optical transition that can be used for laser cooling. We measure the atomic density and transverse and longitudinal velocity distributions of the beam through laser fluorescence spectroscopy. We find a metastable atomic flux density of 4.3(2) × 109 s-1 cm-2 with a mean forward velocity of 773(8) m/s at 2.55 cm directly downstream of the center of the Ti-ball. Owing to the details of optical pumping, the beam is highly collimated along the transverse axis parallel to the optical pumping beam and the flux density falls off as 1/r. We discuss how this source can be used to load atoms into a magneto-optical trap.