Scalability is a challenging yet key aspect required for large scale quantum computing and simulation using ions trapped in radio-frequency (rf) Paul traps. In this thesis 171Yb+ ions are used to demonstrate a magnetic field insensitive qubit which has a measured coherence time of 1.5 s, making it an ideal candidate to use for storing quantum information. A magnetic field sensitive qubit is also characterised which can be used for the implementation of multi-qubit gates using a potentially very scalable scheme based on microwaves in conjunction with a static magnetic field gradient instead of using lasers. However, the measured coherence time is limited by magnetic field fluctuations and will prohibit high fidelity gate operations from being performed. To address this issue, the preparation of a dressed-state qubit using a microwave based stimulated rapid adiabatic passage (STIRAP) pulse sequence will be presented. This qubit is protected against the noisy environment making it less sensitive to magnetic field fluctuations. The lifetime of this qubit is measured to demonstrate its suitability for storing quantum information. A powerful method for manipulating the dressed-state qubit will be presented and is used to measure a coherence time of the qubit of 500 ms which is two orders of magnitude longer compared to the magnetic field sensitive qubit. It will also be shown that our method allows for the implementation of arbitrary rotations of the dressed-state qubit on the Bloch sphere using only a single rf field. This substantially simplifies the experimental setup for single and multi-qubit gates. Furthermore, this thesis will present a experimental setup capable of successfully operating microfabricated surface ion traps. This setup is then used to operate and characterise the first two-dimensional (2D) lattice of ion traps on a microchip. A unique feature of the microfabrication technique used for this device is the extremely large voltage that can be applied which allows long ion lifetimes along with large secular frequencies to be measured, demonstrating the robustness of this device. Rudimentary shuttling between neighbouring lattice sites will be shown which could be used as part of a efficient scheme to load a large lattice of ions. One of the many applications of a 2D lattice of ions lies in the field of quantum simulations where many-body systems such as quantum magnetism, high temperature superconductivity, the fractional quantum hall effect and synthetic gauge fields can be simulated. It will be shown how making only minor modifications to the microchip the ion-ion separation can be reduced sufficiently to offer an exciting platform for the successful implementation of 2D quantum simulations. A theoretical investigation on the optimal 2D ion trap lattice geometry will also be presented with the aim to maximise the ratio of ion-ion coupling strength to decoherence from motional heating of the ions and to laser induced off-resonant coupling.
Scalability is a challenging yet key aspect required for large scale quantum computing and simulation using ions trapped in radio-frequency (rf) Paul traps. In this thesis 171Yb+ ions are used to demonstrate a magnetic field insensitive qubit which has a measured coherence time of 1.5 s, making it an ideal candidate to use for storing quantum information. A magnetic field sensitive qubit is also characterised which can be used for the implementation of multi-qubit gates using a potentially very scalable scheme based on microwaves in conjunction with a static magnetic field gradient instead of using lasers. However, the measured coherence time is limited by magnetic field fluctuations and will prohibit high fidelity gate operations from being performed. To address this issue, the preparation of a dressed-state qubit using a microwave based stimulated rapid adiabatic passage (STIRAP) pulse sequence will be presented. This qubit is protected against the noisy environment making it less sensitive to magnetic field fluctuations. The lifetime of this qubit is measured to demonstrate its suitability for storing quantum information. A powerful method for manipulating the dressed-state qubit will be presented and is used to measure a coherence time of the qubit of 500 ms which is two orders of magnitude longer compared to the magnetic field sensitive qubit. It will also be shown that our method allows for the implementation of arbitrary rotations of the dressed-state qubit on the Bloch sphere using only a single rf field. This substantially simplifies the experimental setup for single and multi-qubit gates. Furthermore, this thesis will present a experimental setup capable of successfully operating microfabricated surface ion traps. This setup is then used to operate and characterise the first two-dimensional (2D) lattice of ion traps on a microchip. A unique feature of the microfabrication technique used for this device is the extremely large voltage that can be applied which allows long ion lifetimes along with large secular frequencies to be measured, demonstrating the robustness of this device. Rudimentary shuttling between neighbouring lattice sites will be shown which could be used as part of a efficient scheme to load a large lattice of ions. One of the many applications of a 2D lattice of ions lies in the field of quantum simulations where many-body systems such as quantum magnetism, high temperature superconductivity, the fractional quantum hall effect and synthetic gauge fields can be simulated. It will be shown how making only minor modifications to the microchip the ion-ion separation can be reduced sufficiently to offer an exciting platform for the successful implementation of 2D quantum simulations. A theoretical investigation on the optimal 2D ion trap lattice geometry will also be presented with the aim to maximise the ratio of ion-ion coupling strength to decoherence from motional heating of the ions and to laser induced off-resonant coupling.
This thesis describes experimental work on implementing single and two qubit gates in ¹7¹Yb+ ions using methods suitable for a large scale quantum computer. By combining a magnetic field gradient with microwave and radiofrequency radiation, the spin and motional states of the ions are coupled which allows multi-qubit operations to be performed, as well as providing individual addressing of ions in frequency space. A dressed state qubit is used which exhibits an increase of over two orders of magnitude in the coherence time for a qubit that it is sensitive to the magnetic field gradient. Using this system, single qubit gates are characterised using the technique of randomised benchmarking, resulting in a measured average error per gate of 9(3)x10¯4. A new type of two qubit gate is experimentally demonstrated, which in comparison to a standard two qubit gate shows significantly increased resilience to two major sources of gate infidelity: heating of the motional mode of the ions during gate operations, and incorrectly set gate field frequencies. These types of errors are expected to become increasingly important with the move towards quantum processors with large numbers of qubits. Using this same technique, a two qubit gate is also demonstrated at a higher initial temperature with a significantly improved fidelity compared to standard methods. These gate techniques are used to demonstrate work towards implementing positiondependent quantum logic, a method which could remove the correlation between the number of ions and the number of gate fields required in a large scale quantum computing architecture. A method to move the dressed state qubit through a magnetic field gradient while preserving quantum information is demonstrated, as well as a method to optimise the phase of a two qubit gate of unknown phase in order to implement a CNOT logic gate. This provides a path forwards to demonstrating a CNOT gate using position-dependent quantum logic.
This thesis describes the experimental work towards the development of a scalable quantum computer based on microfabricated ion trap using long-wavelength radiation and magnetic field gradient. There are three key elements in implementing such a quantum computer: the junction trap to shuttle ions, the structure to generate high gradient magnetic field and the structure to induce strong microwave coupling to the ions. A new dynamic simulation tool was developed addressing the problems faced by static solvers. This tool was used to aid the design and optimisation of an X junction geometry allowing the ions to be shuttled with minimised motional heating gain. The design and fabrication techniques were reported on the structure to generate a high gradient magnetic field. A discussion was given on the design of producing microwave and maximise the coupling to the cold ions. A review was given on the far-field methods and near-field methods. A novel design was reported where the single-qubit gate is predicted to be 45 times faster than a conventional setup. Two essential topics on the microfabrication of a reliable scalable quantum computer unit were discussed: breakdown and RF loss. Investigation using numerical simulations showed that dielectric can breakdown due to high voltage and local heating which are results of impedance mismatch. Microfabrication processes were improved, high-quality films were reported to have twice as much breakdown voltages. The mechanisms of RF loss were reviewed. Novel structures and smooth electroplating technique were developed to minimise the loss. A low loss ion trap was produced and tested. An experimentally observed anomalous glow discharge phenomenon was reported and investigated.
The major challenges in trapped-ion quantum computation are to scale up few-ion experiments to many qubits and to improve control techniques so that quantum logic gates can be carried out with higher fidelities. This thesis reports experimental progress in both of these areas. In the early part of the thesis we describe the fabrication of a surface-electrode ion trap, the development of the apparatus and techniques required to operate it and the successful trapping of 40Ca+ ions. Notably we developed methods to control the orientation of the principal axes and to minimise ion micromotion. We propose a repumping scheme that simplifies heating rate measurements for ions with low-lying D levels, and use it to characterise the electric field noise in the trap. Surface-electrode traps are important because they offer a route to dense integration of electronic and optical control elements using existing microfabrication technology. We explore this scaling route by testing a series of three traps that were microfabricated at Sandia National Laboratories. Investigations of micromotion and charging of the surface by laser beams were carried out and improvements to future traps are suggested. Using one of these traps we also investigated anomalous electrical noise from the electrode surfaces and discovered that it can be reduced by cleaning with a pulsed laser. A factor of two decrease was observed; this represents the first in situ removal of this noise source, an important step towards higher gate fidelities. In the second half of the thesis we describe the design and construction of an experiment for the purpose of replacing laser-driven multi-qubit quantum logic gates with microwave-driven ones. We investigate magnetic-field-independent hyperfine qubits in 40Ca+ as suitable qubits for this scheme. We make a design study of how best to integrate an ion trap with the microwave conductors required to implement the gate and propose a novel integrated resonant structure. The trap was fabricated and ions were successfully loaded. Single-qubit experiments show that the microwave fields above the trap are in excellent agreement with software simulations. There are good prospects for demonstrating a multi-qubit gate in the near future. We conclude by discussing the possibilities for larger-scale quantum computation by combining microfabricated traps and microwave control.
In the current landscape of quantum technologies, great efforts are being made to overcome the technical challenges of realising robust and scalable devices for use in a wide variety of potentially impactful applications. This thesis therefore describes the design considerations and assembly of a purpose-built vacuum system for the realisation of high-fidelity quantum logic operations on a microfabricated surface ion trap device. The device consists of an X-junction structure with embedded current-carrying wires, which will allow for the demonstration of scalable, laser-free, magnetic field gradient-based quantum logic. Initial characterisation experiments and observations pertaining to this novel microchip design are presented, as well as demonstrations of coherent quantum operations using the 171Yb+ qubit both with and without the current-carrying wire generated magnetic field gradient. In addition, this work also shows how this static magnetic field gradient design for scalable quantum computing may be leveraged for use in metrology. By utilising the inherent gradient-induced coupling of the trapped ion qubit’s transition frequency to it’s position in this architecture, the ion becomes extremely sensitive to electric field perturbations, enabling the implementation of many well-established quantum electric and magnetic field sensing techniques. Furthermore, the nature of this novel sensing scheme permits high sensitivities within the unique DC − kHz bandwidth, which many current quantum electrometers are unable to reach. Measurements of DC and AC electric fields yield unprecedented sensitivities for the sensing of phase coherent electric fields in a linear Paul trap. In addition, an implementation of a common magnetometry technique to measure electric field noise is also exhibited. Finally, it is shown that a purpose built system for the implementation of this scheme has the potential to improve sensitivities by up to six orders of magnitude, enabling the possibility of utilising this scheme for a wide variety of applications'
Microfabricated ion traps are an important tool in the development of scalable quantum systems. Tremendous advancements towards an ion quantum computer were made in the past decade and most requirements for a quantum computer have been fulfilled in individual experiments. Incorporating all essential capabilities in a fully scalable system will require the further advancement of established quantum information technologies and development of new trap fabrication techniques. In my thesis I will discuss the theoretical background and experimental setup required for the operation of ion traps. Measurement of the important ion trap heating rate was performed in the setup and I will discuss the results in more detail. I will give a review of microfabrication processes used for the fabrication of traps, outlining advantages, disadvantages and issues inherent to the processes. Following the review I will present my work on a concept for a scalable ion trap quantum system based on microwave quantum gates and shuttling through X-junctions. Many of the required building blocks, including ion trap structures with current-carrying wires intended to create strong magnetic field gradients for microwave gates were investigated further. A novel fabrication process was developed to combine current-carrying wires with advanced multilayered ion trap structures. Several trap designs intended for proof of principle experiments of high fidelity microwave gates, advanced detection techniques and shuttling between electrically disconnected ion traps will be presented. Also the electrode geometry of an optimized X-junction design with strongly suppressed rf barrier height will be presented. Further, I developed several modifications for the experimental setup to extend the existing capabilities. A plasma source capable of performing in-situ cleans of the trap electrode surfaces, which has been demonstrated to dramatically reduce the heating rate in ion traps, was incorporated. I will also present a vacuum system modification designed to cool ion traps with current-carrying wires and transport the generated heat out of the vacuum system. In addition a novel low-noise, high-speed, multichannel voltage control system was developed by me. The device can be used in future experiments to precisely shuttle ions from one trapping zone to another and also to shuttle ions through ion trap junctions. Lastly I will outline the process optimization and microfabrication of my ion trap designs. A novel fabrication process which makes use of the extremely high thermal conductivity of diamond substrates and combines it with thick copper tracks embedded in the substrate was developed. Large currents will be passed through the wires creating a strong and controllable magnetic field gradient. Ion trap designs with isolated electrodes connected via buried wires can be placed on top of the current-carrying wires, allowing the most advanced electrode designs to be fabricated with current-carrying wires.
This thesis describes an ion trap magnetometer, in which experimental hardware and theory for trapped ion magnetometry has been developed and demonstrated. Quantum magnetometry has been a fast expanding field in recent years due to the plethora of military, medical and security applications. The current quantum magnetometer literature has shown great improvements on the standard magnetometer success metrics such as sensitivity, spacial resolution, frequency tuneability, noise shielding and vector field resolution. Ion trap magnetometry could potentially boast several advantages over some of the better established methods such as, nano-meter spatial resolution, broadband tuneability over radio-frequency (RF) and microwave frequencies, and magnetic field noise shielding and sensitivity improvements through dynamic decoupling methods; all in room temperature environments. The experimental setup discussed uses a micro-fabricated Paul trap for ion confinement due to the scalability of this technology. The method for sensing that was demonstrated utilises long-wavelength radiation dressed states to extend the coherence time of a single 171Yb+ ion beyond the bare states and to allow for a high level of frequency tuneability. The coherence times measured were T2 = 0:645 s for RF field sensing at 15.616 MHz and T2 = 1.153 s for microwave field sensing at 12.658466 GHz. Sensitivities of SB = 125.857 ± 26.155 pT/ vHz for RF magnetic fields and SB = 102.054 ± 11.046 pT/ vHz for microwave magnetic fields were achieved experimentally. A novel micro-fabricated Paul trap for trapping multiple ion clusters was developed to improve sensitivity values by increasing the total number of trapped ions. The design confines ions over a two-dimensional surface spanning 0.65 x 1.00 mm which would also allow for magnetic field gradient measurements. Efforts have been made to miniaturise certain experimental hardware to further the development of portable trapped ion experiments. For this, a miniaturised RF resonator that could be used for radial confinement of ions within Paul traps has been developed. At the current stage of development it is capable of applying a peak RF voltage of 114.9 V with a Q value of 70 at a resonant frequency of O/2p = 12.65 MHz.