The broadcast nature of wireless communications makes the propagation medium vulnerable to security attacks such as eavesdropping and jamming from adversarial or unauthorized users. Applying physical layer secrecy approaches will enable the exchange of confidential messages over a wireless medium in the presence of unauthorized eavesdroppers, without using any secret keys. However, physical layer security approaches are typically feasible only when the source-eavesdropper channel is weaker than the source-destination channel. Cooperative jamming can be used to overcome this challenge and increase the secrecy rate. In this paper, the security of two-phase relaying system with multiple intermediate nodes and in the presence of an eavesdropper is investigated. To enhance the system secrecy rate, a joint cooperative beamforming and jamming combined with relay and jammer selections is proposed. In phase I, the source node broadcasts a signal to relays while three intermediate nodes (which act as jammers) help the source node by transmitting random jamming signals to confuse the eavesdropper. Since the friendly (cooperative) jammers create interference for both the intended relays and the eavesdropper, optimal beamforming is applied such that no interference is caused at two preselected desired relays (that are going to receive the confidential massage in phase I). In phase II, two preselected relays transmit the source message with beamforming coefficients such that the received signal at the eavesdropper is completely nulled out. Our goal in this paper is to minimize the received SNR at the eavesdropper while increasing it at the destination as much as possible by applying different methods such as cooperative beamforming, cooperative jamming and relay selection. To avoid operational complexity, we consider the minimum number of intermediate nodes that are necessary without losing the performance. Numerical results demonstrate the advantage of our proposed scheme compared with the scheme with no cooperative jamming.
The broadcast nature of wireless communications makes the propagation medium vulnerable to security attacks such as eavesdropping and jamming from adversarial or unauthorized users. Applying physical layer secrecy approaches will enable the exchange of confidential messages over a wireless medium in the presence of unauthorized eavesdroppers, without using any secret keys. However, physical layer security approaches are typically feasible only when the source-eavesdropper channel is weaker than the source-destination channel. Cooperative jamming can be used to overcome this challenge and increase the secrecy rate. In this paper, the security of two-phase relaying system with multiple intermediate nodes and in the presence of an eavesdropper is investigated. To enhance the system secrecy rate, a joint cooperative beamforming and jamming combined with relay and jammer selections is proposed. In phase I, the source node broadcasts a signal to relays while three intermediate nodes (which act as jammers) help the source node by transmitting random jamming signals to confuse the eavesdropper. Since the friendly (cooperative) jammers create interference for both the intended relays and the eavesdropper, optimal beamforming is applied such that no interference is caused at two preselected desired relays (that are going to receive the confidential massage in phase I). In phase II, two preselected relays transmit the source message with beamforming coefficients such that the received signal at the eavesdropper is completely nulled out. Our goal in this paper is to minimize the received SNR at the eavesdropper while increasing it at the destination as much as possible by applying different methods such as cooperative beamforming, cooperative jamming and relay selection. To avoid operational complexity, we consider the minimum number of intermediate nodes that are necessary without losing the performance. Numerical results demonstrate the advantage of our proposed scheme compared with the scheme with no cooperative jamming.
In this paper, the security of two-phase relaying system with multiple intermediate nodes in the presence of a malicious eavesdropper is investigated. To enhance the secrecy, a joint cooperative beamforming and jamming combined with relay and jammer selection is proposed. First, the source broadcasts its signal to the relays that are located close to source in a cluster, i.e., the source node uses a small amount of power to broadcast its message locally to other nodes of the cluster, while destination and the eavesdropper are located outside this cluster. In the second phase, two relays transmit re-encoded signal with optimal beamforming such that the secrecy rate is maximized. Simultaneously, two other intermediate nodes (which act as friendly jammers) transmit random jamming signals to degrade the eavesdropper’s channel. Our goal in this paper is to maximize the secrecy rate by applying different methods such as cooperative beamforming, cooperative jamming and relay and jammer selection. To avoid operational complexity, we consider the minimum number of intermediate nodes needed for relaying and jamming without losing the performance, i.e., achieving a non-zero secrecy rate. Cooperative beamforming with multiple relays demands high amount of information exchange and therefore increases the operational complexity. Thus, we aim to reduce the number of relays which take part in cooperative beamforming. Limiting the number of relays may have a bad effect on the coding gain which we compensate it with a proposed selection gain scheme. Numerical results demonstrate the advantage of our proposed scheme compared to the scheme with no cooperative jamming. The main contribution of this work is combining cooperative beamforming and jamming with relay and jammer selection to enhance the physical layer security.
This paper proposes a joint cooperative relaying and jamming scheme based on distributed beamforming to enhance the secrecy rate of a wireless channel in the presence of an eavesdropper. Specifically, we consider the scenario that a source node transmits messages to a destination with the help of multiple cooperative relays, where a relay might be compromised to become an eavesdropper as an inside attacker. Our joint relaying and jamming approach is to assign some relay nodes to act as jammers to interfere the eavesdropper, while the remaining ones continue relaying information to the destination. We propose a protocol to implement the joint cooperative relaying and jamming. Our protocol further considers the particular challenge brought by the inside attacker: it may know the jamming signal and can use it to remove the interference from the jammers. The issue of phase and frequency synchronization in the distributed beamforming is also taken into account. A mixed integer programming problem is formulated to maximize the secrecy rate with the proposed joint relaying and jamming, by which the optimal role assignment to a relay and the associated optimal power assignment can be solved. Numerical results are presented to demonstrate the efficiency of the proposed joint relaying and jamming in improving the secrecy rate, with comparison to existing approaches.
To improve physical (PHY) layer security of a wireless relay system in the presence of an eavesdropper, a two-phase cooperative relaying scheme is investigated in this paper. In phase I, the source transmits confidential message, simultaneously, it cooperates with the friendly jammers and destination to create jamming signal at the eavesdropper without affecting the forwarding relay which is preselected. In phase II, the forwarding relay retransmits the decoded signal, meanwhile, the particular relay cooperates with the friendly jammers to create jamming signal at the eavesdropper without affecting the destination. We focus on the investigation of optimal power allocation for maximizing achievable secrecy rate subject to a total power constraint. Optimal relay selection and suboptimal relay selection schemes are also proposed. It is shown that as the number of relays increases, both secrecy rate and the performance of suboptimal relay selection scheme improve significantly. Numerical results are presented to validate the derived analytical results and compare them to existing work.
This paper proposes a new joint cooperative beamforming and jamming (JCBJ) scheme for improving the physical layer security of decode-and-forward wireless networks where a source node transmits to its destination with the aid of multiple intermediate nodes in the presence of an eavesdropper. In the proposed JCBJ scheme, we select the intermediate nodes succeeding in source decoding as the relays to forward the source transmission simultaneously by employing a beamforming weight vector, and meanwhile, use the remaining ones as the friendly jammers to disturb the eavesdropper by sending artificial noise. In order to achieve the secrecy rate maximum, we further study on the power allocation among the source, relays, and jammers under two assumptions of the wiretap link's channel state information. We derive the closed-form optimal solutions by first allocating the transmit power at the source within different ranges to consider all the possible relay selection schemes in which different numbers of relays are employed, and then transforming the multivariable power allocation problem to a set of single-variable optimization subproblems. Our numerical results show the superiority of the proposed JCBJ scheme and the proposed power allocation strategies.
To improve the information-theoretic security of two-way wireless cooperative communication systems, we propose in this study a hybrid relaying and jamming mechanism based on multi-node cooperative beamforming to enhance the security of the physical layer transmission of information. The basic concept is that in the cooperative transmission phase, some intermediate nodes adopt distributed beamforming to help the transmitter send messages to legitimate users and simultaneously others jam the eavesdropper, which can significantly improve the security performance of the system in the broadcast phase. Two different cooperative beamforming schemes are proposed with and without the instantaneous channel state information (CSI) of the eavesdropper. We show that optimizing both the schemes requires the mathematical solving of one or a series of second-order convex cone programming (SOCP) problems, which can be executed by efficiently using the interior point method. Simulation and comparisons show that our proposed hybrid relaying, jamming mechanism and beamforming approaches significantly increase the security sum rate of the two source terminals and outperform both the relays-only and jammers-only mechanisms when the number of intermediate nodes is relatively large.
Physical (PHY) layer security approaches for wireless communications can prevent eavesdropping without upper layer data encryption. However, they are hampered by wireless channel conditions: absent feedback, they are typically feasible only when the source-destination channel is better than the source-eavesdropper channel. Node cooperation is a means to overcome this challenge and improve the performance of secure wireless communications. This paper addresses secure communications of one source-destination pair with the help of multiple cooperating relays in the presence of one or more eavesdroppers. Three cooperative schemes are considered: decode-and-forward (DF), amplify-and-forward (AF), and cooperative jamming (CJ). For these schemes, the relays transmit a weighted version of a reencoded noise-free message signal (for DF), a received noisy source signal (for AF), or a common jamming signal (for CJ). Novel system designs are proposed, consisting of the determination of relay weights and the allocation of transmit power, that maximize the achievable secrecy rate subject to a transmit power constraint, or, minimize the transmit power subject to a secrecy rate constraint. For DF in the presence of one eavesdropper, closed-form optimal solutions are derived for the relay weights. For other problems, since the optimal relay weights are difficult to obtain, several criteria are considered leading to suboptimal but simple solutions, i.e., the complete nulling of the message signals at all eavesdroppers (for DF and AF), or the complete nulling of jamming signal at the destination (for CJ). Based on the designed relay weights, for DF in the presence of multiple eavesdroppers, and for CJ in the presence of one eavesdropper, the optimal power allocation is obtained in closed-form; in all other cases the optimal power allocation is obtained via iterative algorithms. Numerical evaluation of the obtained secrecy rate and transmit power results show that the proposed design can significantly improve the performance of secure wireless communications.