Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Towards linear optical detection with single photon sensitivity at telecommunication wavelengths

S. Jahanmirinejad, Andrea Fiore

Published Jan 1, 2011• 0 citations
OpenAlex

Abstract

The conventional optical detectors operate in a linear mode, but their sensitivity is limited due to the noise in the readout electronics. Single photon detectors, on the other hand, have the highest sensitivity, but are strongly nonlinear. Photon number resolving detectors, which can precisely determine the number of photons in weak optical pulses, are potential candidates to fill the gap between these two detection modes. We present the design of photon number resolving detectors with large dynamic range, based on spatial multiplexing of superconducting single photon detectors, with excellent timing resolution and very high sensitivity at the telecommunication wavelength range.

Related papers

Towards linear optical detection with single photon sensitivity at telecom wavelengths

Saeedeh Jahanmirinejad, Andrea Fiore

Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 21, 2012•2 citations

A scalable photon number resolving detector

F. Mattioli, Alessandro Gaggero, Roberto Leoni +5 more

A novel photon-number-resolving detector (PNRD) structure, based on an array of nanowire superconducting single photon detectors (SSPDs) connected in series, have recently been proposed. With this configuration, it is possible to scale to large photon numbers. In this framework, PNRDs capable of resolving up to four, eight and twelve photons at telecommunication wavelengths have been fabricated and tested. The photon-induced voltage signals from all the series elements are summed up into a single readout pulse with a height proportional to the detected photon number. Analysis of the linearity shows the potential of scaling to an even larger dynamic range.

Italian National Conference on Photonic Technologies (Fotonica)•May 1, 2014•0 citations

Experimental demonstration of a novel superconducting photon-number resolving detector at telecom wavelengths

Saeedeh Jahanmirinejad, G. Frucci, F. Mattioli +4 more

We present a novel configuration for a photon number resolving detector based on a series array of shunted superconducting nanowires, which has the potential to provide a high dynamic range. The first prototype of the detector consisting of four series elements is demonstrated with the ability to resolve up to four photons in an incident optical pulse at the telecommunication wavelength window.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 1, 2012•0 citations

Superconducting series nanowire detector counting up to twelve photons

Zili Zhou, Saeedeh Jahanmirinejad, F. Mattioli +5 more

We demonstrate a superconducting photon-number-resolving detector capable of resolving up to twelve photons at telecommunication wavelengths. It is based on a series array of twelve superconducting NbN nanowire elements, each connected in parallel with an integrated resistor. The photon-induced voltage signals from the twelve elements are summed up into a single readout pulse with a height proportional to the detected photon number. Thirteen distinct output levels corresponding to the detection of n = 0-12 photons are observed experimentally. A detailed analysis of the linearity and of the excess noise shows the potential of scaling to an even larger dynamic range.

arXiv:1311.6458•Optics Express•Feb 6, 2014•43 citations

High-efficiency multi-element superconducting single-photon detector

Maria Moshkova, Pavel Morozov, A.V. Antipov +2 more

We present the result of the creation and investigation of the multi-element superconducting single photon detectors, which can recognize the number of photons (up to six) in a short pulse of the radiation at telecommunication wavelengths range. The best receivers coupled with single-mode fiber have the system quantum efficiency of ⁓85%. The receivers have a 100 ps time resolution and a few nanoseconds dead time that allows them to operate at megahertz counting rate. Implementation of the multi-element architecture for creation of the superconducting single photon detectors with increased sensitive area allows to create the high efficiency receivers coupled with multi-mode fibers and with preserving of the all advantages of superconducting photon counters.

Quantum Optics and Photon Counting•Apr 14, 2021•1 citation

Counting Photons Using a Nanonetwork of Superconducting Wires

Andrea Fiore, Francesco Marsili, David Bitauld +9 more

We show how the parallel connection of photo-sensitive supercon-ducting nanowires can be used to count the number of photons in an optical pulse, down to the single-photon level. Using this principle we demonstrate photon-number resolving detectors with unprecedented sensitivity and speed at telecommunication wavelengths.

•May 9, 2012•0 citations
The conventional optical detectors operate in a linear mode, but their sensitivity is limited due to the noise in the readout electronics. Single photon detectors, on the other hand, have the highest sensitivity, but are strongly nonlinear. Photon number resolving detectors, which can precisely determine the number of photons in weak optical pulses, are potential candidates to fill the gap between these two detection modes. We present the design of photon number resolving detectors with large dynamic range, based on spatial multiplexing of superconducting single photon detectors, with excellent timing resolution and very high sensitivity at the telecommunication wavelength range.
Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.
A novel photon-number-resolving detector (PNRD) structure, based on an array of nanowire superconducting single photon detectors (SSPDs) connected in series, have recently been proposed. With this configuration, it is possible to scale to large photon numbers. In this framework, PNRDs capable of resolving up to four, eight and twelve photons at telecommunication wavelengths have been fabricated and tested. The photon-induced voltage signals from all the series elements are summed up into a single readout pulse with a height proportional to the detected photon number. Analysis of the linearity shows the potential of scaling to an even larger dynamic range.
We demonstrate a superconducting photon-number-resolving detector capable of resolving up to twelve photons at telecommunication wavelengths. It is based on a series array of twelve superconducting NbN nanowire elements, each connected in parallel with an integrated resistor. The photon-induced voltage signals from the twelve elements are summed up into a single readout pulse with a height proportional to the detected photon number. Thirteen distinct output levels corresponding to the detection of n = 0-12 photons are observed experimentally. A detailed analysis of the linearity and of the excess noise shows the potential of scaling to an even larger dynamic range.
We present the result of the creation and investigation of the multi-element superconducting single photon detectors, which can recognize the number of photons (up to six) in a short pulse of the radiation at telecommunication wavelengths range. The best receivers coupled with single-mode fiber have the system quantum efficiency of ⁓85%. The receivers have a 100 ps time resolution and a few nanoseconds dead time that allows them to operate at megahertz counting rate. Implementation of the multi-element architecture for creation of the superconducting single photon detectors with increased sensitive area allows to create the high efficiency receivers coupled with multi-mode fibers and with preserving of the all advantages of superconducting photon counters.