Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Counting Photons Using a Nanonetwork of Superconducting Wires

Andrea Fiore, Francesco Marsili, David Bitauld, Alessandro Gaggero, Roberto Leoni, F. Mattioli, Alexander V. Divochiy, Alexander A. Korneev, Vitaliy Seleznev, N. Kaurova, Olga V. Minaeva, Gregory N Gol'tsman

Published May 9, 2012• 0 citations
OpenAlex

Abstract

We show how the parallel connection of photo-sensitive supercon-ducting nanowires can be used to count the number of photons in an optical pulse, down to the single-photon level. Using this principle we demonstrate photon-number resolving detectors with unprecedented sensitivity and speed at telecommunication wavelengths.

Related papers

Superconducting nanowire photon number resolving detector at telecom wavelength

Francesco Marsili, David Bitauld, Alexander V. Divochiy +12 more

We demonstrate a photon-number-resolving (PNR) detector, based on parallel superconducting nanowires, capable of resolving up to 5 photons in the telecommunication wavelength range, with sensitivity and speed far exceeding existing approaches. © 2008 Optical Society of America.

•May 4, 2008•5 citations

Superconducting series nanowire detector counting up to twelve photons

Zili Zhou, Saeedeh Jahanmirinejad, F. Mattioli +5 more

We demonstrate a superconducting photon-number-resolving detector capable of resolving up to twelve photons at telecommunication wavelengths. It is based on a series array of twelve superconducting NbN nanowire elements, each connected in parallel with an integrated resistor. The photon-induced voltage signals from the twelve elements are summed up into a single readout pulse with a height proportional to the detected photon number. Thirteen distinct output levels corresponding to the detection of n = 0-12 photons are observed experimentally. A detailed analysis of the linearity and of the excess noise shows the potential of scaling to an even larger dynamic range.

arXiv:1311.6458•Optics Express•Feb 6, 2014•43 citations

Towards linear optical detection with single photon sensitivity at telecom wavelengths

Saeedeh Jahanmirinejad, Andrea Fiore

Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 21, 2012•2 citations

Photon-number resolving detector based on a series array of superconducting nanowires

S. Jahanmirinejad, G. Frucci, F. Mattioli +4 more

We present the experimental demonstration of a superconducting photon number resolving detector. It is based on the series connection of N superconducting nanowires, each connected in parallel to an integrated resistor. The device provides a single voltage readout, proportional to the number of photons absorbed in distinct nanowires. Clearly separated output levels corresponding to the detection of n=1-4 photons are observed in a 4-element detector fabricated from an NbN film on GaAs substrate, with a single-photon system quantum efficiency of 2.6% at the wavelength of 1300nm. The series-nanowire structure is promising in view of its scalability to large photon numbers and high efficiencies.

arXiv:1203.5477•Applied Physics Letters•Aug 13, 2012•88 citations

Superconducting nanowires connected in series for photon number resolving functionality

F. Mattioli, S. Jahanmirinejad, Zili Zhou +5 more

The experimental demonstration of a superconducting photon-number-resolving detector, based on the series connection of N superconducting nanowires, is presented. An integrated resistor is connected in parallel to each section of the device that provides in this way a single voltage-readout, proportional to the number of photons detected in distinct nanowires. As a proof of principle a four element detector has been fabricated from an NbN film on a GaAs substrate and fully characterized. Clearly separated output levels corresponding to the detection of n = 1 – 4 photons are observed achieving a single-photon system quantum efficiency of 2.6% at λ=1.3 μm. In order to demonstrate the potential scalability of the series-nanowire detector to a larger number of photons, we report our preliminary results in the characterization of detectors fabricated with 8 and 12 pixels. Clear evidence of n= 1-8 photon absorption in the 8-pixel detector has been achieved.

Journal of Physics Conference Series•May 12, 2014•5 citations

Experimental demonstration of a novel superconducting photon-number resolving detector at telecom wavelengths

Saeedeh Jahanmirinejad, G. Frucci, F. Mattioli +4 more

We present a novel configuration for a photon number resolving detector based on a series array of shunted superconducting nanowires, which has the potential to provide a high dynamic range. The first prototype of the detector consisting of four series elements is demonstrated with the ability to resolve up to four photons in an incident optical pulse at the telecommunication wavelength window.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 1, 2012•0 citations
We demonstrate a superconducting photon-number-resolving detector capable of resolving up to twelve photons at telecommunication wavelengths. It is based on a series array of twelve superconducting NbN nanowire elements, each connected in parallel with an integrated resistor. The photon-induced voltage signals from the twelve elements are summed up into a single readout pulse with a height proportional to the detected photon number. Thirteen distinct output levels corresponding to the detection of n = 0-12 photons are observed experimentally. A detailed analysis of the linearity and of the excess noise shows the potential of scaling to an even larger dynamic range.
Standard linear optical detectors have a maximum sensitivity in the few hundreds of photons range, limited by amplifier noise. On the other hand, single photon detectors, which are the most sensitive detectors, are strongly nonlinear: One or more photons result in the same output signal. Photon number resolving (PNR) detectors, which have the ability to discriminate the number of photons in a weak optical pulse, are of great importance in the field of quantum information processing and quantum cryptography. Moreover, a PNR detector with large dynamic range can cover the gap between these two detection modes. Such detectors are greatly desirable not only in quantum information science and technology, but also in any application dealing with low light levels. In this work, we propose a novel approach to photon number resolving detectors based on spatial multiplexing of nanowire superconducting single-photon detectors. In the proposed approach, N superconducting nanowires, each connected in parallel to an integrated resistor, are connected in series. Photon absorption in a nanowire switches its bias current to the parallel resistor, forming a voltage pulse across it. The sum of these voltages, proportional to the number of absorbed photons, is measured at the output. The use of a cryogenic preamplifier with high input impedance for the read-out increases the linearity, the signal to noise ratio, and the speed. With this combination, we expect to be able to count up to few tens of photons with high fidelity, excellent timing resolution, and very high sensitivity in the telecommunication wavelength range.
We present the experimental demonstration of a superconducting photon number resolving detector. It is based on the series connection of N superconducting nanowires, each connected in parallel to an integrated resistor. The device provides a single voltage readout, proportional to the number of photons absorbed in distinct nanowires. Clearly separated output levels corresponding to the detection of n=1-4 photons are observed in a 4-element detector fabricated from an NbN film on GaAs substrate, with a single-photon system quantum efficiency of 2.6% at the wavelength of 1300nm. The series-nanowire structure is promising in view of its scalability to large photon numbers and high efficiencies.
The experimental demonstration of a superconducting photon-number-resolving detector, based on the series connection of N superconducting nanowires, is presented. An integrated resistor is connected in parallel to each section of the device that provides in this way a single voltage-readout, proportional to the number of photons detected in distinct nanowires. As a proof of principle a four element detector has been fabricated from an NbN film on a GaAs substrate and fully characterized. Clearly separated output levels corresponding to the detection of n = 1 – 4 photons are observed achieving a single-photon system quantum efficiency of 2.6% at λ=1.3 μm. In order to demonstrate the potential scalability of the series-nanowire detector to a larger number of photons, we report our preliminary results in the characterization of detectors fabricated with 8 and 12 pixels. Clear evidence of n= 1-8 photon absorption in the 8-pixel detector has been achieved.