The Chinese remainder theorem is used in metrology for extending the range of quantum clocks/radar/interferometry, where the phase of a signal is known relative to a set of oscillators with different periods. This paper investigates the performance of a quantum-mechanical Chinese remainder clock, consisting of atoms/oscillators with pairwise coprime periods. We provide the optimal initial state and the optimal Heisenberg-limited quantum measurements for measuring time up to the product of the periods. We introduce a novel fault-tolerant post-processing protocol that allows reconstruction of the correct time even in the presence of errors in the remainders.
The Chinese remainder theorem is used in metrology for extending the range of quantum clocks/radar/interferometry, where the phase of a signal is known relative to a set of oscillators with different periods. This paper investigates the performance of a quantum-mechanical Chinese remainder clock, consisting of atoms/oscillators with pairwise coprime periods. We provide the optimal initial state and the optimal Heisenberg-limited quantum measurements for measuring time up to the product of the periods. We introduce a novel fault-tolerant post-processing protocol that allows reconstruction of the correct time even in the presence of errors in the remainders.
Quantum sensors have been shown to enable more precise measurements than classical sensors. By using entanglement and coherent evolution, the estimation error can be made to scale better in interrogation time, photon count, and other resources, achieving Heisenberg-limited scaling. However, environmental noise and hardware errors typically destroy the coherence of the sensitive quantum states. This motivates the use of fault-tolerant techniques to create more robust quantum sensing protocols. Such fault-tolerant quantum sensing approaches have been shown to enhance sensitivity for qubit systems, but many practical sensors require bosonic probes. In this paper, we propose a fault-tolerant protocol using bosons to estimate displacements in the presence of dephasing noise. We construct an optimal error-correcting code under a mean photon-number constraint. Controlled displacements couple the probe to a repetition-encoded qubit register, while repeated boson-parity measurements and resets remove probe noise without erasing the stored logical phase. Under circuit-level bit-flip noise, a distance-d code suppresses logical failures to order p(d+1)/2. We show that, for a decay rate γA, a total sensing time T and a mean photon number budget N, and for sufficiently small residual signals, the Fisher information scales as NT2 over interrogation times of order γA−(d+1)/2. This is a significant improvement over the non-fault-tolerant approach that achieves Heisenberg scaling only for a total time O(γA−1).
Quantum effect enables enhanced estimation precision in metrology, with the Heisenberg limit (HL) representing the ultimate limit allowed by quantum mechanics. Although the HL is generally unattainable in the presence of noise, quantum error correction (QEC) can recover the HL in various scenarios. A notable example is estimating a Pauli-Z signal under bit-flip noise using the repetition code, which is both optimal for metrology and robust against noise. However, previous protocols often assume noise affects only the signal accumulation step, while the QEC operations -- including state preparation and measurement -- are noiseless. To overcome this limitation, we study fault-tolerant quantum metrology where all qubit operations are subject to noise. We focus on estimating a Pauli-Z signal under bit-flip noise, together with state preparation and measurement errors in all QEC operations. We propose a fault-tolerant metrological protocol where a repetition code is prepared via repeated syndrome measurements, followed by a fault-tolerant logical measurement. We demonstrate the existence of an error threshold, below which errors are effectively suppressed and the HL is attained.
Quantum mechanical applications range from quantum computers to quantum key distribution to teleportation. In these applications, quantum error correction is extremely important for protecting quantum states against decoherence. Here I present two main results regarding quantum error correction protocols.
The first main topic I address is the development of continuous-time quantum error correction protocols via combination with techniques from quantum control. These protocols rely on weak measurement and Hamiltonian feedback instead of the projective measurements and unitary gates usually assumed by canonical quantum error correction. I show that a subclass of these protocols can be understood as a quantum feedback protocol, and analytically analyze the general case using the stabilizer formalism; I show that in this case perfect feedback can perfectly protect a stabilizer subspace. I also show through numerical simulations that another subclass of these protocols does better than canonical quantum error correction when the time between corrections is limited.
The second main topic is development of improved overhead results for fault-tolerant computation. In particular, through analysis of topological quantum error correcting codes, it will be shown that the required blowup in depth of a noisy circuit performing a fault-tolerant computation can be reduced to a factor of O(log log L), an improvement over previous results. Showing this requires investigation into a local method of performing fault-tolerant correction on a topological code of arbitrary dimension.
Quantum sensors hold great promise for achieving better sensitivity in the measurement of physical quantities compared to their classical counterparts. However, the conditions under which quantum advantage in sensing can be achieved are rather restrictive, and most quantum enhancements in sensing are lost in the presence of noise, errors, or a poorly calibrated system. To overcome these limitations, we are motivated to import ideas from fault-tolerant quantum computing to quantum sensing. Specifically, we consider a qubit noise model where the probability of phase-flip errors is exponentially smaller (in qubit number) compared to the probability of bit-flip errors that occur with probability p. For this noise structure, we demonstrate that, given a total sensing time T, Heisenberg scaling can be attained for times up to T∝1/p(N+1)/2 for a N-qubit repetition code, in contrast with T∝1/p without using a fault-tolerant sensing protocol.
The ultimate stability of atomic clocks is limited by the quantum noise of the atoms. To reduce this noise it has been suggested to use entangled atomic ensembles with reduced atomic noise. Potentially this can push the stability all the way to the limit allowed by the Heisenberg uncertainty relation, which is denoted the Heisenberg limit. In practice, however, entangled states are often more prone to decoherence, which may prevent reaching this performance. Here we present an adaptive measurement protocol that in the presence of a realistic source of decoherence enables us to get near-Heisenberg-limited stability of atomic clocks using entangled atoms. The protocol may thus realize the full potential of entanglement for quantum metrology despite the detrimental influence of decoherence.
High-precision measurement of oscillating signal is a ubiquitous issue in fundamental science and a critical task in practical technologies. In quantum metrology, quantum lock-in detection provide an efficient method for measuring such signal. In general, when the initial phase of the oscillating signal is unknown,quantum double lock-in detection can effectively extract complete information about the signal's amplitude, frequency, and initial phase. Conventional quantum double lock-in detection requires two individual quantum interferometry, each of which must undergo state preparation and readout. However, the time for state preparation and readout need not be negligible in practical experiments. In particular, the time for state preparation is longer than the time for sensing. To save experimental resources, it is challenging to achieve quantum double lock-in detection just via a single quantum interferometry while still extracting complete information about the signal's amplitude, frequency, and initial phase. Here, we present a general protocol for achieving a quantum double lock-in detection just via a single quantum interferometry under a sequential orthogonal periodic multipulse sequences. In particular, if the input state is a Greenberger-Horne-Zeilinger state and two interaction-based operations are applied during interferometry, the measurement precisions for frequency, amplitude, and initial phase can both approach the Heisenberg limit. Our study paves a new way for measuring oscillating signals with a single quantum interferometry, and provides a feasible method for achieving Heisenberg-limited detection of alternating signals.