High-quality quantum oscillators are preferred for precision sensing of external physical parameters because if the noise level due to interactions with the environment is too high, metrological information can be lost due to quantum decoherence. On the other hand, stronger interactions with a thermal environment could be seen as a resource for new types of metrological schemes. We present a general amplification strategy that enables the detection of zero-point fluctuations using low-quality quantum oscillators at finite temperature. We show that by injecting a controllable level of multiplicative frequency noise in a Brownian oscillator, quantum deviations from the virial theorem can be amplified by a parameter proportional to the strength of the frequency noise at constant temperature. As an application, we suggest a scheme in which the virial ratio is used as a witness of the quantum fluctuations of an unknown thermal bath, either by measuring the oscillator energy or the heat current flowing into an ancilla bath. Our work expands the metrological capacity of low-quality oscillators and can enable new measurements of the quantum properties of thermal environments by sensing their zero-point contributions to system variables.
High-quality quantum oscillators are preferred for precision sensing of external physical parameters because if the noise level due to interactions with the environment is too high, metrological information can be lost due to quantum decoherence. On the other hand, stronger interactions with a thermal environment could be seen as a resource for new types of metrological schemes. We present a general amplification strategy that enables the detection of zero-point fluctuations using low-quality quantum oscillators at finite temperature. We show that by injecting a controllable level of multiplicative frequency noise in a Brownian oscillator, quantum deviations from the virial theorem can be amplified by a parameter proportional to the strength of the frequency noise at constant temperature. As an application, we suggest a scheme in which the virial ratio is used as a witness of the quantum fluctuations of an unknown thermal bath, either by measuring the oscillator energy or the heat current flowing into an ancilla bath. Our work expands the metrological capacity of low-quality oscillators and can enable new measurements of the quantum properties of thermal environments by sensing their zero-point contributions to system variables.
It is often the case that the environment of a quantum system may be described as a bath of oscillators with an ohmic density of states. In turn, the precise characterization of these classes of environments is a crucial tool to engineer decoherence or to tailor quantum information protocols. Recently, the use of quantum probes in characterizing ohmic environments at zero-temperature has been discussed, showing that a single qubit provides precise estimation of the cutoff frequency. On the other hand, thermal noise often spoil quantum probing schemes, and for this reason we here extend the analysis to a complex system at thermal equilibrium. In particular, we discuss the interplay between thermal fluctuations and time evolution in determining the precision attainable by quantum probes. Our results show that the presence of thermal fluctuations degrades the precision for low values of the cutoff frequency, i.e., values of the order ω c ≲ T (in natural units). For larger values of ω c , decoherence is mostly due to the structure of environment, rather than thermal fluctuations, such that quantum probing by a single qubit is still an effective estimation procedure.
Why are classical theories often sufficient to describe the physics of our world even though everything around us is entirely composed of microscopic quantum systems? The boundary between these two fundamentally dissimilar theories remains an unsolved problem in modern physics. Position measurements of small objects allow us to probe the area where the classical approximation breaks down. In quantum mechanics, Heisenbergâ s uncertainty principle dictates that any measurement of the position must be accompanied by measurement induced back-action---in this case manifested as an uncertainty in the momentum. In recent years, cavity optomechanics has become a powerful tool to perform precise position measurements and investigate their fundamental limitations. The utilization of optical micro-cavities greatly enhances the interaction between light and state-of-the-art nanomechanical oscillators. Therefore, quantum mechanical phenomena have been successfully observed in systems far beyond the microscopic world. In such a cavity optomechanical system, the fluctuations in the position of the oscillator are transduced onto the phase of the light, while fluctuations in the amplitude of the light disturb the momentum of the oscillator during the measurement. As a consequence, correlations are established between the amplitude and phase quadrature of the probe light. However, so far, observation of quantum effects has been limited exclusively to cryogenic experiments, and access to the quantum regime at room temperature has remained an elusive goal because the overwhelming amount of thermal motion masks the weak quantum effects. This thesis describes the engineering of a high-performance cavity optomechanical device and presents experimental results showing, for the first time, the broadband effects of quantum back-action at room temperature. The device strongly couples mechanical and optical modes of exceptionally high quality factors to provide a measurement sensitivity ∼104 times below the requirement to resolve the zero-point fluctuations of the mechanical oscillator. The quantum back-action is then observed through the correlations created between the probe light and the motion of the nanomechanical oscillator. A so-called â variational measurementâ , which detects the transmitted light in a homodyne detector tuned close to the amplitude quadrature, resolves the quantum noise due to these correlations at the level of 10\% of the thermal noise over more than an octave of Fourier frequencies around mechanical resonance. Moreover, building on this result, an additional experiment demonstrates the ability to achieve quantum enhanced metrology. In this case, the generated quantum correlations are used to cancel quantum noise in the measurement record, which then leads to an improved relative signal-to-noise ratio in measurements of an external force. In conclusion, the successful observation of broadband quantum behavior on a macroscopic object at room temperature is an important milestone in the field of cavity optomechanics. Specifically, this result heralds the rise of optomechanical systems as a platform for quantum physics at room temperature and shows promise for generation of ponderomotive squeezing in room-temperature interferometers.
We discuss the detection of quantum fluctuations in the light of the relationship between time-dependent correlators and measurable properties [L. Van Hove, Phys. Rev 95, 249 (1954)]. Considering the interaction between the fluctuating electron system and a resonant circuit or a photon mode, we prove that zero-point fluctuations (ZPF) are not observable by a passive detector, corroborating the results of Lesovik and Loosen (Pis'ma Zh. \'Eksp. Teor. Fiz. [JETP Lett. 65, 269 (1997)]). By a passive detector we mean one which is itself effectively in the ground state, and cannot transfer energy to the ZPF whose detection is attempted. We find that the ZPF can, on the other hand, be observed from deexcitation of an active detector. We also make the connection between these statements and the recent discussion of whether decoherence can be caused by the ZPF. The distinction is made between decoherence via making a real excitation in the environment and effects due to its polarization by virtual excitations.
The nonzero ground-state energy of the quantum mechanical harmonic oscillator implies quantum fluctuations around the minimum of the potential with the mean-square value proportional to Planck's constant. On the other hand, thermal fluctuations occur when the oscillator is coupled to a heat bath. Using quantum statistical mechanics, this paper describes the transition from pure quantum fluctuations at zero temperature to classical thermal fluctuations in the high-temperature limit. It was early pointed out by Peierls that the classical mean-square thermal fluctuations in a harmonic chain—a linear chain of coupled harmonic oscillators—increase linearly with the distance of the masses from the fixed end of the chain, destroying long-range crystalline order. As shown here, the corresponding quantum fluctuations lead to a much slower logarithmic increase with the distance from the end. It is also shown that this behavior implies, for example, the absence of sharp Bragg peaks in x-ray scattering in an infinite chain at zero temperature, which instead shows power-law behavior typical for one-dimensional quantum liquids (called Luttinger liquids).
Conventional criticality-based quantum metrological schemes work only at zero or very low temperature because the quantum uncertainty around the quantum phase-transition point is generally erased by thermal fluctuations with the increase of temperature. Such an ultralow-temperature requirement severely restricts the development of quantum critical metrology. In this paper, we propose a thermodynamic-criticality-enhanced quantum sensing scenario at finite temperature. In our scheme, a qubit is employed as a quantum sensor to estimate parameters of interest in the Dicke model which experiences a thermodynamic phase transition. It is revealed that the thermodynamic criticality of the Dicke model can significantly improve the sensing precision. Enriching the scope of quantum critical metrology, our finding provides a possibility to realize highly sensitive quantum sensing without cooling.
Accurately characterizing the properties of structured reservoirs is a key challenge in quantum systems and is of great importance for advances in quantum metrology and sensing. In this work, we employ a two-level system (qubit) as a probe, which is coupled to a structured reservoir consisting of an ancilla qubit and a Markovian environment modeled as a thermal bath. By exploiting non-Markovian dynamics, we systematically investigate the effectiveness of different interaction types between the probe and ancilla for estimating critical parameters, including temperature, ancilla frequency, and system-bath coupling strength. We quantify the precision of parameter estimation using quantum Fisher information (QFI) and analyze the system dynamics in both transient and steady-state regimes. Our findings demonstrate that non-Markovianity substantially enhances parameter estimation in the transient regime, with specific interactions facilitating sustained information backflow and yielding higher QFI values. However, the performance of these interactions is contingent on the parameter under estimation and the operational regime. For instance, certain interactions become prominent in the transient regime but exhibit diminished utility in the steady state, whereas others maintain their effectiveness even at equilibrium. These results stress the importance of judiciously selecting interactions adapted to specific estimation objectives and operational regimes.