Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2504.20201

Comparison of Different Rydberg Atom-Based Microwave Electrometry Techniques

Eliel Leandro Alves Junior, Manuel Alejandro Lefrán Torres, Jorge Douglas Massayuki Kondo, Luís Gustavo Marcassa

Published Apr 28, 2025• 0 citations
arXivHTMLPDF

Abstract

In this study, we have compared different Rydberg atom-based microwave electrometry techniques under the same experimental conditions and using the same Rydberg states ($68S_{1/2}$, $68P_{3/2}$ and $67P_{3/2}$). The comparison was carried out for the following techniques: i) Auxiliary microwave field, ii) Microwave amplitude modulation, and iii) Polarization spectroscopy. Our results indicate that all three techniques have a similar minimum measurable microwave electric field. A slightly better result can be obtained by performing polarization spectroscopy using a Laguerre-Gauss coupling laser beam.

DOI
10.48550/arxiv.2504.20201

Related papers

Comparison of Different Rydberg Atom-Based Microwave Electrometry Techniques

Eliel Leandro Alves Junior, Manuel Alejandro Lefrán Torres, Jorge Douglas Massayuki Kondo +1 more

In this study, we have compared different Rydberg atom-based microwave electrometry techniques under the same experimental conditions and using the same Rydberg states (68S1/2, 68P3/2, and 67P3/2). The comparison was carried out for the following techniques: (i) auxiliary microwave field, (ii) microwave amplitude modulation, and (iii) polarization spectroscopy. Our results indicate that all three techniques have a similar minimum measurable microwave electric field. A slightly better result can be obtained by performing polarization spectroscopy using a Laguerre–Gauss coupling laser beam.

Atoms•Jun 20, 2025•0 citations

Rydberg atom-based microwave electrometry using polarization spectroscopy

Naomy Duarte Gomes, Vinícius M. Pepino, Ben‐Hur V. Borges +5 more

Abstract In this study, we investigated Rydberg atom-based microwave (MW) electrometry using polarization spectroscopy in a room-temperature vapor cell. By measuring Autler-Townes splitting in the electromagnetically induced transparency (EIT) spectrum, we determined that the minimum measurable MW electric field is approximately five times lower than conventional EIT techniques. The results are well reproduced by a full optical Bloch equation model, which takes into account all the hyperfine levels involved. Subsequently, the EIT setup was used to characterize a custom MW cylindrical lens, which increases the field at the focus by a factor of three, decreasing the minimum measurable MW electric field by the same amount. Our results indicate that the combination of polarization spectroscopy and a MW lens may enhance MW electrometry, and may allow its use as a secondary standard.

arXiv:2407.20433•Journal of Physics B Atomic Molecular and Optical Physics•Oct 22, 2024•3 citations

Rydberg-atom-based electrometry

Huang Wei, Liang Zhen-Tao, Du Yan-Xiong +2 more

Atom in Rydberg state has large polarizability, large electric dipole and low ionization threshold field. It is very sensitive to electric field, therefore it can be used to measure the amplitude of electric field, especially the microwave electric field. The new developed scheme is based on quantum interference effects (electromagnetically induced transparency and Autler-Townes splitting) in Rydberg atoms. Instead of the direct amplitude measurement, this method tests the Rabi frequency value of the transmission spectrum which is determined by the microwave electric field strength and the corresponding atom nature. The minimum measured strengths of microwave electric fields are far below the standard values obtained by traditional antenna methods. Compared with the traditional methods, this new scheme has several advantages, such as self-calibration, non-perturbation to the measured field and independence of the probe length. Besides, this scheme can also be used to measure the polarization direction of microwave electric field and realize sub-wavelength imaging. Through adjusting the wavelength of coupling laser, a broadband 1-500 GHz microwave electric field measurement can be achieved. This new scheme is benefitial to conducting the continue electric field measurement and the miniaturization of the test equipment. In this paper, the researches about using Rydberg atom to measure electric field with high precision are reviewed. The basic theory and experimental techniques are introduced. Finally, we discuss a promising method of using Rydberg atom interferometer to detect the accumulated phase in the process of interaction between electric field and Rydberg atoms. This method converts amplitude measurement into phase test, which may improve the precision and sensitivity.

Acta Physica Sinica•Jan 1, 2015•15 citations

Polarization-insensitive microwave electrometry using Rydberg atoms

Matthew Cloutman, Matthew Chilcott, Alexander Elliott +3 more

We investigate the Autler-Townes splitting for Rydberg atoms dressed with linearly polarized microwave radiation, resonant with generic ${S}_{1/2}\ensuremath{\leftrightarrow}{P}_{1/2}$ and ${S}_{1/2}\ensuremath{\leftrightarrow}{P}_{3/2}$ transitions. The splitting is probed using laser light via electromagnetically induced transparency measurements, where the transmission of probe laser light reveals a two-peak pattern. In particular, this pattern is invariant under rotation of the microwave field polarization. In consequence, we establish $S\ensuremath{\leftrightarrow}P$ Rydberg transitions as ideally suited for polarization-insensitive electrometry, contrary to recent findings [A. Chopinaud and J. D. Pritchard, Phys. Rev. Appl. 16, 024008 (2021)].

arXiv:2312.01974•Physical Review Applied•Apr 12, 2024•25 citations

Microwave electric field sensing with Rydberg atoms

Daniel T. Stack, Paul D. Kunz, David H. Meyer +1 more

Atoms form the basis of precise measurement for many quantities (time, acceleration, rotation, magnetic field, etc.). Measurements of microwave frequency electric fields by traditional methods (i.e. engineered antennas) have limited sensitivity and can be difficult to calibrate properly. Highly-excited (Rydberg) neutral atoms have very large electric-dipole moments and many dipole allowed transitions in the range of 1 - 500 GHz. It is possible to sensitively probe the electric field in this range using the combination of two quantum interference phenomena: electromagnetically induced transparency and the Autler-Townes effect. This technique allows for very sensitive field amplitude, polarization, and sub-wavelength imaging measurements. These quantities can be extracted by measuring properties of a probe laser beam as it passes through a warm rubidium vapor cell. Thus far, Rydberg microwave electrometry has relied upon the absorption of the probe laser. We report on our use of polarization rotation, which corresponds to the real part of the susceptibility, for measuring the properties of microwave frequency electric fields. Our simulations show that when a magnetic field is present and directed along the optical propagation direction a polarization rotation signal exists and can be used for microwave electrometry. One central advantage in using the polarization rotation signal rather than the absorption signal is that common mode laser noise is naturally eliminated leading to a potentially dramatic increase in signal-to-noise ratio.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 19, 2016•3 citations

Precise measurement of microwave polarization using a Rydberg atom-based mixer

Yuhan Wang, Feng-Dong Jia, Jianhai Hao +9 more

A Rydberg atom-based mixer has opened up a new method to characterize microwave electric fields such as the precise measurement of their phase and strength. This study further demonstrates, theoretically and experimentally, a method to accurately measure the polarization of a microwave electric field based on a Rydberg atom-based mixer. The results show that the amplitude of the beat note changes with the polarization of the microwave electric field in a period of 180 degrees, and in the linear region a polarization resolution better than 0.5 degree can be easily obtained which reaches the best level by a Rydberg atomic sensor. More interestingly, the mixer-based measurements are immune to the polarization of the light field that forms the Rydberg EIT. This method considerably simplifies theoretical analysis and the experimental system required for measuring microwave polarization using Rydberg atoms and is of interest in microwave sensing.

Optics Express•Feb 23, 2023•39 citations
In this study, we have compared different Rydberg atom-based microwave electrometry techniques under the same experimental conditions and using the same Rydberg states (68S1/268S_{1/2}68S1/2​, 68P3/268P_{3/2}68P3/2​ and 67P3/267P_{3/2}67P3/2​). The comparison was carried out for the following techniques: i) Auxiliary microwave field, ii) Microwave amplitude modulation, and iii) Polarization spectroscopy. Our results indicate that all three techniques have a similar minimum measurable microwave electric field. A slightly better result can be obtained by performing polarization spectroscopy using a Laguerre-Gauss coupling laser beam.
In this study, we have compared different Rydberg atom-based microwave electrometry techniques under the same experimental conditions and using the same Rydberg states (68S1/2, 68P3/2, and 67P3/2). The comparison was carried out for the following techniques: (i) auxiliary microwave field, (ii) microwave amplitude modulation, and (iii) polarization spectroscopy. Our results indicate that all three techniques have a similar minimum measurable microwave electric field. A slightly better result can be obtained by performing polarization spectroscopy using a Laguerre–Gauss coupling laser beam.
Abstract In this study, we investigated Rydberg atom-based microwave (MW) electrometry using polarization spectroscopy in a room-temperature vapor cell. By measuring Autler-Townes splitting in the electromagnetically induced transparency (EIT) spectrum, we determined that the minimum measurable MW electric field is approximately five times lower than conventional EIT techniques. The results are well reproduced by a full optical Bloch equation model, which takes into account all the hyperfine levels involved. Subsequently, the EIT setup was used to characterize a custom MW cylindrical lens, which increases the field at the focus by a factor of three, decreasing the minimum measurable MW electric field by the same amount. Our results indicate that the combination of polarization spectroscopy and a MW lens may enhance MW electrometry, and may allow its use as a secondary standard.
Atom in Rydberg state has large polarizability, large electric dipole and low ionization threshold field. It is very sensitive to electric field, therefore it can be used to measure the amplitude of electric field, especially the microwave electric field. The new developed scheme is based on quantum interference effects (electromagnetically induced transparency and Autler-Townes splitting) in Rydberg atoms. Instead of the direct amplitude measurement, this method tests the Rabi frequency value of the transmission spectrum which is determined by the microwave electric field strength and the corresponding atom nature. The minimum measured strengths of microwave electric fields are far below the standard values obtained by traditional antenna methods. Compared with the traditional methods, this new scheme has several advantages, such as self-calibration, non-perturbation to the measured field and independence of the probe length. Besides, this scheme can also be used to measure the polarization direction of microwave electric field and realize sub-wavelength imaging. Through adjusting the wavelength of coupling laser, a broadband 1-500 GHz microwave electric field measurement can be achieved. This new scheme is benefitial to conducting the continue electric field measurement and the miniaturization of the test equipment. In this paper, the researches about using Rydberg atom to measure electric field with high precision are reviewed. The basic theory and experimental techniques are introduced. Finally, we discuss a promising method of using Rydberg atom interferometer to detect the accumulated phase in the process of interaction between electric field and Rydberg atoms. This method converts amplitude measurement into phase test, which may improve the precision and sensitivity.
We investigate the Autler-Townes splitting for Rydberg atoms dressed with linearly polarized microwave radiation, resonant with generic ${S}_{1/2}\ensuremath{\leftrightarrow}{P}_{1/2}$ and ${S}_{1/2}\ensuremath{\leftrightarrow}{P}_{3/2}$ transitions. The splitting is probed using laser light via electromagnetically induced transparency measurements, where the transmission of probe laser light reveals a two-peak pattern. In particular, this pattern is invariant under rotation of the microwave field polarization. In consequence, we establish $S\ensuremath{\leftrightarrow}P$ Rydberg transitions as ideally suited for polarization-insensitive electrometry, contrary to recent findings [A. Chopinaud and J. D. Pritchard, Phys. Rev. Appl. 16, 024008 (2021)].
Atoms form the basis of precise measurement for many quantities (time, acceleration, rotation, magnetic field, etc.). Measurements of microwave frequency electric fields by traditional methods (i.e. engineered antennas) have limited sensitivity and can be difficult to calibrate properly. Highly-excited (Rydberg) neutral atoms have very large electric-dipole moments and many dipole allowed transitions in the range of 1 - 500 GHz. It is possible to sensitively probe the electric field in this range using the combination of two quantum interference phenomena: electromagnetically induced transparency and the Autler-Townes effect. This technique allows for very sensitive field amplitude, polarization, and sub-wavelength imaging measurements. These quantities can be extracted by measuring properties of a probe laser beam as it passes through a warm rubidium vapor cell. Thus far, Rydberg microwave electrometry has relied upon the absorption of the probe laser. We report on our use of polarization rotation, which corresponds to the real part of the susceptibility, for measuring the properties of microwave frequency electric fields. Our simulations show that when a magnetic field is present and directed along the optical propagation direction a polarization rotation signal exists and can be used for microwave electrometry. One central advantage in using the polarization rotation signal rather than the absorption signal is that common mode laser noise is naturally eliminated leading to a potentially dramatic increase in signal-to-noise ratio.
A Rydberg atom-based mixer has opened up a new method to characterize microwave electric fields such as the precise measurement of their phase and strength. This study further demonstrates, theoretically and experimentally, a method to accurately measure the polarization of a microwave electric field based on a Rydberg atom-based mixer. The results show that the amplitude of the beat note changes with the polarization of the microwave electric field in a period of 180 degrees, and in the linear region a polarization resolution better than 0.5 degree can be easily obtained which reaches the best level by a Rydberg atomic sensor. More interestingly, the mixer-based measurements are immune to the polarization of the light field that forms the Rydberg EIT. This method considerably simplifies theoretical analysis and the experimental system required for measuring microwave polarization using Rydberg atoms and is of interest in microwave sensing.