© 2026 Aqora Quantum S.A.S.

Terms Privacy Legal Notice

arXiv:2504.18915 · Physical Review Applied

Rapid qubit readout dependent on the transmission of a single fluxon

Waltraut Wustmann, Kevin D. Osborn

Published Jan 20, 2026• 1 citation

Abstract

The readout speed of qubits is a major limitation for error correction in quantum information science. We show simulations of a proposed device that gives readout of a fluxonium qubit using a ballistic fluxon with an estimated readout time of less than 1 nanosecond, without the need for an input microwave tone. This contrasts the prevalent readout based on circuit quantum electrodynamics, but is related to previous studies where a fluxon moving in a single long Josephson junction (LJJ) can exhibit a time delay depending on the state of a coupled qubit. Our readout circuit contains two LJJs and a qubit coupled at their interface. We find that the device can exhibit single-shot readout of a qubit -- one qubit state leads to a single dynamical bounce at the interface and fluxon reflection, and the other qubit state leads to a couple of bounces at the interface and fluxon transmission. Dynamics are initially computed with a separate degree of freedom for all Josephson junctions of the circuit. However, a collective coordinate model reduces the dynamics to three degrees of freedom: one for the fluxonium Josephson junction and one for each LJJ. The large mass imbalance in this model allows us to simulate the mixed quantum-classical dynamics, as an approximation for the full quantum dynamics. Calculations give backaction on the qubit at $\leq 0.1\%$.

DOI: 10.1103/lq5c-3j66

Related papers

Design of a ballistic fluxon qubit readout

Anna Herr, Arkady Fedorov, Alexander Shnirman +2 more

A detailed design is given for a flux qubit readout using ballistic fluxons. In this scheme, fluxons propagate through an underdamped Josephson transmission line (JTL) coupled to the qubit, whose state affects the fluxon propagation time. For strong qubit–JTL coupling, and far from the symmetry point, a qubit can be measured with fidelity greater than 99% and measurement time of 4 ns. The readout circuit requires additional rapid single flux quantum (RSFQ) interface circuitry to launch and receive the delayed flux solitons. The parameters of this driver and receiver have been optimized to produce low fluxon speed at launch and impedance matching at the receiver. The delayed solitons are compared to a reference line using a detector with time resolution of better than 16 ps. Both the JTL and RSFQ interface were designed for the Nb 30 A cm −2 process developed at VTT, Finland, with postdeposition of the Al qubit at IPHT, Germany.

Superconductor Science and Technology•Oct 18, 2007•38 citations

Fluxon Time-Delay Readout of a Superconducting Qubit Protected by a Spectral Gap in a Josephson Transmission Line

Shunsuke Kamimura, Aree Taguchi, Masamitsu Tanaka +1 more

We theoretically investigate a readout scheme of the quantum state of a superconducting qubit based on time delay of a single flux quantum (SFQ), also known as a fluxon, propagating in a Josephson transmission line (JTL). We concretely study the time-delay readout based on capacitive coupling between a transmon qubit and a JTL, and we evaluate the time delay depending on the qubit state. We also reveal a feature of the absence of fluxon pinning and exponential suppression of nonadiabatic transitions caused by the propagating fluxon, which is advantageous for the time-delay readout. We extend the analysis to a multi-level transmon as well. Owing to the spectral gap in the JTL, the radiative decay of the qubit mediated by the JTL is exponentially suppressed, and thus the transmission line itself also serves as a filter protecting the qubit. The readout scheme requires neither complicated wiring to low-temperature stages nor bulky microwave components, which are bottlenecks for integration of a large-scale superconducting quantum computer.

quant-pharXiv:2603.13175•Mar 16, 2026•0 citations

Rapid ballistic readout for flux qubits

D. V. Averin, Kristian Rabenstein, Vasili K. Semenov

We suggest a magnetic flux detector that can be optimized with respect to the measurement back action, e.g., for the situation of quantum measurements. The detector is based on manipulation of ballistic motion of individual fluxons in a Josephson transmission line (JTL), with the output information contained in either probabilities of fluxon transmission and reflection, or time delay associated with the fluxon propagation through the JTL. We calculate the detector characteristics of the JTL and derive equations for conditional evolution of the measured system both in the transmission and reflection and the time-delay regimes. Combination of the quantum-limited detection with control over individual fluxons should make the JTL detector suitable for implementation of nontrivial quantum measurement strategies, including conditional measurements and feedback control schemes.

arXiv:cond-mat/0510771•Physical Review B•Mar 8, 2006•68 citations

Fluxon Readout of a Superconducting Qubit

Kirill G. Fedorov, Anastasia V. Shcherbakova, Michael Johannes Wolf +2 more

An experiment demonstrating a link between classical single-flux quantum digital logic and a superconducting quantum circuit is reported. We implement coupling between a moving Josephson vortex (fluxon) and a flux qubit by reading out of a state of the flux qubit through a frequency shift of the fluxon oscillations in an annular Josephson junction. The energy spectrum of the flux qubit is measured using this technique. The implemented hybrid scheme opens an opportunity to readout quantum states of superconducting qubits with the classical fluxon logic circuits.

arXiv:1304.0645•Physical Review Letters•Apr 25, 2014•63 citations

Josephson vortex coupled to a flux qubit

Kirill G. Fedorov, Anastasia V. Shcherbakova, R. Schäfer +1 more

Experiments towards realizing a readout of superconducting qubits by using ballistic Josephson vortices are reported. We measured the microwave radiation induced by a fluxon moving in an annular Josephson junction. By coupling a flux qubit as a current dipole to the annular junction, we detect periodic variations of the fluxon's oscillation frequency versus magnetic flux through the qubit. We found that the scattering of a fluxon on a current dipole can lead to the acceleration of a fluxon regardless of a dipole polarity. We use the perturbation theory and numerical simulations of the perturbed sine-Gordon equation to analyze our results.

arXiv:1301.5164•Applied Physics Letters•Apr 1, 2013•17 citations

Flux-pulse-assisted readout of a fluxonium qubit

Taryn V. Stefanski, Christian Kraglund Andersen

Much attention has focused on the transmon architecture for large-scale superconducting quantum devices; however, the fluxonium qubit has emerged as a possible successor. With a shunting inductor in parallel to a Josephson junction, the fluxonium offers larger anharmonicity and stronger protection against dielectric loss, leading to higher coherence times as compared to conventional transmon qubits. The interplay between the inductive and Josephson energy potentials of the fluxonium qubit leads to a rich dispersive-shift landscape when tuning the external flux. Here, we propose to exploit the features in the dispersive shift to improve qubit readout. Specifically, we report on theoretical simulations showing improved readout times and error rates by performing the readout at a flux-bias point with large dispersive shift. We expand the scheme to include different error channels and show that with an integration time of 155 ns, flux-pulse-assisted readout offers about a 5 -times improvement in the signal-to-noise ratio. Moreover, we show that the performance improvement persists in the presence of finite measurement efficiency combined with quasistatic flux noise and also when considering the increased Purcell rate at the flux-pulse-assisted readout point. We suggest a set of reasonable energy parameters for the fluxonium architecture that will allow for the implementation of our proposed flux-pulse-assisted readout scheme.

arXiv:2309.17286•Physical Review Applied•Jul 30, 2024•8 citations

The readout speed of qubits is a major limitation for error correction in quantum information science. We show simulations of a proposed device that gives readout of a fluxonium qubit using a ballistic fluxon with an estimated readout time of less than 1 nanosecond, without the need for an input microwave tone. This contrasts the prevalent readout based on circuit quantum electrodynamics, but is related to previous studies where a fluxon moving in a single long Josephson junction (LJJ) can exhibit a time delay depending on the state of a coupled qubit. Our readout circuit contains two LJJs and a qubit coupled at their interface. We find that the device can exhibit single-shot readout of a qubit -- one qubit state leads to a single dynamical bounce at the interface and fluxon reflection, and the other qubit state leads to a couple of bounces at the interface and fluxon transmission. Dynamics are initially computed with a separate degree of freedom for all Josephson junctions of the circuit. However, a collective coordinate model reduces the dynamics to three degrees of freedom: one for the fluxonium Josephson junction and one for each LJJ. The large mass imbalance in this model allows us to simulate the mixed quantum-classical dynamics, as an approximation for the full quantum dynamics. Calculations give backaction on the qubit at

\leq 0.1\%

.

A detailed design is given for a flux qubit readout using ballistic fluxons. In this scheme, fluxons propagate through an underdamped Josephson transmission line (JTL) coupled to the qubit, whose state affects the fluxon propagation time. For strong qubit–JTL coupling, and far from the symmetry point, a qubit can be measured with fidelity greater than 99% and measurement time of 4 ns. The readout circuit requires additional rapid single flux quantum (RSFQ) interface circuitry to launch and receive the delayed flux solitons. The parameters of this driver and receiver have been optimized to produce low fluxon speed at launch and impedance matching at the receiver. The delayed solitons are compared to a reference line using a detector with time resolution of better than 16 ps. Both the JTL and RSFQ interface were designed for the Nb 30 A cm −2 process developed at VTT, Finland, with postdeposition of the Al qubit at IPHT, Germany.

We theoretically investigate a readout scheme of the quantum state of a superconducting qubit based on time delay of a single flux quantum (SFQ), also known as a fluxon, propagating in a Josephson transmission line (JTL). We concretely study the time-delay readout based on capacitive coupling between a transmon qubit and a JTL, and we evaluate the time delay depending on the qubit state. We also reveal a feature of the absence of fluxon pinning and exponential suppression of nonadiabatic transitions caused by the propagating fluxon, which is advantageous for the time-delay readout. We extend the analysis to a multi-level transmon as well. Owing to the spectral gap in the JTL, the radiative decay of the qubit mediated by the JTL is exponentially suppressed, and thus the transmission line itself also serves as a filter protecting the qubit. The readout scheme requires neither complicated wiring to low-temperature stages nor bulky microwave components, which are bottlenecks for integration of a large-scale superconducting quantum computer.

We suggest a magnetic flux detector that can be optimized with respect to the measurement back action, e.g., for the situation of quantum measurements. The detector is based on manipulation of ballistic motion of individual fluxons in a Josephson transmission line (JTL), with the output information contained in either probabilities of fluxon transmission and reflection, or time delay associated with the fluxon propagation through the JTL. We calculate the detector characteristics of the JTL and derive equations for conditional evolution of the measured system both in the transmission and reflection and the time-delay regimes. Combination of the quantum-limited detection with control over individual fluxons should make the JTL detector suitable for implementation of nontrivial quantum measurement strategies, including conditional measurements and feedback control schemes.

An experiment demonstrating a link between classical single-flux quantum digital logic and a superconducting quantum circuit is reported. We implement coupling between a moving Josephson vortex (fluxon) and a flux qubit by reading out of a state of the flux qubit through a frequency shift of the fluxon oscillations in an annular Josephson junction. The energy spectrum of the flux qubit is measured using this technique. The implemented hybrid scheme opens an opportunity to readout quantum states of superconducting qubits with the classical fluxon logic circuits.

Experiments towards realizing a readout of superconducting qubits by using ballistic Josephson vortices are reported. We measured the microwave radiation induced by a fluxon moving in an annular Josephson junction. By coupling a flux qubit as a current dipole to the annular junction, we detect periodic variations of the fluxon's oscillation frequency versus magnetic flux through the qubit. We found that the scattering of a fluxon on a current dipole can lead to the acceleration of a fluxon regardless of a dipole polarity. We use the perturbation theory and numerical simulations of the perturbed sine-Gordon equation to analyze our results.

Much attention has focused on the transmon architecture for large-scale superconducting quantum devices; however, the fluxonium qubit has emerged as a possible successor. With a shunting inductor in parallel to a Josephson junction, the fluxonium offers larger anharmonicity and stronger protection against dielectric loss, leading to higher coherence times as compared to conventional transmon qubits. The interplay between the inductive and Josephson energy potentials of the fluxonium qubit leads to a rich dispersive-shift landscape when tuning the external flux. Here, we propose to exploit the features in the dispersive shift to improve qubit readout. Specifically, we report on theoretical simulations showing improved readout times and error rates by performing the readout at a flux-bias point with large dispersive shift. We expand the scheme to include different error channels and show that with an integration time of 155 ns, flux-pulse-assisted readout offers about a 5 -times improvement in the signal-to-noise ratio. Moreover, we show that the performance improvement persists in the presence of finite measurement efficiency combined with quasistatic flux noise and also when considering the increased Purcell rate at the flux-pulse-assisted readout point. We suggest a set of reasonable energy parameters for the fluxonium architecture that will allow for the implementation of our proposed flux-pulse-assisted readout scheme.