This paper presents a scheme to amplify dispersion signal of Rydberg atomic microwave detection system, using a quantum weak measurement technique together with improved dimensionless pointer. The scheme effectively mitigates the impact of technical noise and can be used to achieve a measurement precision close to the limit set by atomic shot noise in theory. Compared with the superheterodyne method based on transmission detection, our scheme has been experimentally proved to have a sensitivity increase of 5 ~ 6 dB. In this work, the Rydberg dispersion signal amplification mechanism offers an approach to enhance microwave detection sensitivity, which also facilitates deeper investigations into its dynamic processes and further applications of this mechanism in quantum communication and quantum control. The authors propose a weak value measurement scheme to amplify the dispersion signal of Rydberg atom-based microwave electric field sensors using a superheterodyne technique. Experimentally, they demonstrate that this scheme improves the sensitivity of the microwave receiver by ~ 5-6dB compared to traditional amplitude-based superheterodyne detection.
This paper presents a scheme to amplify dispersion signal of Rydberg atomic microwave detection system, using a quantum weak measurement technique together with improved dimensionless pointer. The scheme effectively mitigates the impact of technical noise and can be used to achieve a measurement precision close to the limit set by atomic shot noise in theory. Compared with the superheterodyne method based on transmission detection, our scheme has been experimentally proved to have a sensitivity increase of 5 ~ 6 dB. In this work, the Rydberg dispersion signal amplification mechanism offers an approach to enhance microwave detection sensitivity, which also facilitates deeper investigations into its dynamic processes and further applications of this mechanism in quantum communication and quantum control. The authors propose a weak value measurement scheme to amplify the dispersion signal of Rydberg atom-based microwave electric field sensors using a superheterodyne technique. Experimentally, they demonstrate that this scheme improves the sensitivity of the microwave receiver by ~ 5-6dB compared to traditional amplitude-based superheterodyne detection.
Measurement sensitivity is crucial for the practical application of Rydberg atomic microwave superheterodyne receiver systems in communication, radar, and navigation. Based on laser-atom-microwave interaction mechanisms, the influence of laser powers and local-oscillator (LO) microwave field intensity on measurement sensitivity is systematically studied in this paper. Measurement sensitivity is analyzed through electromagnetically induced transparency (EIT) spectral characteristics, specifically EIT amplitude and full-width-half-maximum (FWHM),larger amplitudes and narrower FWHM indicate improved signal-to-noise ratios. For a 60D-state Rydberg atomic system with fixed probe and coupling laser beam waists (800 µm and 875 µm), optimal parameters are determined: probe laser power of 60 µW(Rabi frequency: 2π×7.02 MHz), coupling laser power of 40 mW (Rabi frequency: 2π×0.66 MHz), and LO microwave Rabi frequency of 2π×8.34 MHz. Experimental results demonstrate a 4.6 dB sensitivity enhancement, advancing from −137.5dBm/Hz to −142.1 dBm/Hz at 3.21 GHz microwave field. This improvement is attributed to precise alignment of laser-atom and microwave-atom interactions, bridging the gap toward quantum sensitivity limits.
In recent years, electric field measurement techniques based on Rydberg atoms have shown unique advantages in high sensitivity and wideband applications and miniaturization. The Rydberg atom receiver senses the electromagnetic signal using the quantum coherence effect, which overcomes the inherent defects of traditional electronic receivers in terms of thermal noise, insertion loss of microwave devices, and the use of wavelength-dependent antennas, thus providing the Rydberg atomic receivers the potential to become the next generation of microwave receivers. For some particular application scenarios such as radar and communication, superheterodyne reception is a critical technical approach, and the linear dynamic range is an essential factor in evaluating the performance of the superheterodyne receivers. It is challenging to promote the Rydberg atomic receiver without figuring out the influence of system parameters on the linear dynamic range. This paper starts with the response mechanism of the Rydberg atomic superheterodyne receiver, and a theoretical model is established to simulate the atom-microwave responses. Then the harmonics' generation mechanism is discussed, and the atomic linear dynamic range under different probe light Rabi frequencies is studied further. Furthermore, a method to evaluate the antiblocking performance of the system is proposed. This work is expected to provide theoretical guidance for the design and performance optimization of the Rydberg atomic superheterodyne receiver.
Rydberg atom-based microwave electric field sensing has attracted growing interest owing to its inherent advantages, such as absolute calibration, wideband operability, and compatibility with room-temperature devices. A critical bottleneck that limits sensitivity is the inefficient coupling between the Rydberg atoms and the incident microwave field, particularly when detecting weak signals propagating in free space. Here we propose and experimentally validate a scheme that integrates a horn antenna with a resonant microwave cavity to significantly improve this coupling for free-space signal reception in the S-band. Using a two-photon excitation scheme in a cesium vapor cell, we systematically characterize the sensing performance under three configurations: a bare cell, direct cavity injection, and a cavity coupled to a horn antenna that captures free-space microwave signals over a 1 m distance. In the antenna-coupled cavity configuration, we achieve an optimal sensitivity of 2.33 nV/cm/Hz at the receiving antenna, which corresponds to an enhancement of approximately 17.9 dB compared to the optimized bare vapor cell configuration. Our findings offer a practical and effective route to boost the sensitivity of Rydberg atomic sensors, facilitating their adoption in real-world microwave metrology and wireless communication applications where weak free-space electric fields must be reliably measured.
High-sensitivity measurements of the microwave electric field are important in applications of communication and metrology. The sensitivity of traditional Rydberg superheterodyne receivers in free space is effectively determined by the signal-to-noise ratio (SNR), which is often considered equivalent to sensitivity in practical sensing applications. In this work, we demonstrate a cavity-enhanced receiver, where an optical cavity significantly amplifies the interaction between the probe light and cesium atoms, which substantially improves the signal-to-noise ratio via enhancing the expansion coefficient κ . Here, κ is the edge slope of the single peak obtained by fitting the double-peak EIT-AT spectrum, characterizing the response of the probe light to the frequency detuning of the coupling laser. The sensitivity is thus boosted by a factor of approximately 19 dB. This study highlights the pivotal role of optical cavities in advancing Rydberg-based detection systems, offering a promising approach for high-sensitivity microwave electric field measurements.
Atom in Rydberg state has large polarizability, large electric dipole and low ionization threshold field. It is very sensitive to electric field, therefore it can be used to measure the amplitude of electric field, especially the microwave electric field. The new developed scheme is based on quantum interference effects (electromagnetically induced transparency and Autler-Townes splitting) in Rydberg atoms. Instead of the direct amplitude measurement, this method tests the Rabi frequency value of the transmission spectrum which is determined by the microwave electric field strength and the corresponding atom nature. The minimum measured strengths of microwave electric fields are far below the standard values obtained by traditional antenna methods. Compared with the traditional methods, this new scheme has several advantages, such as self-calibration, non-perturbation to the measured field and independence of the probe length. Besides, this scheme can also be used to measure the polarization direction of microwave electric field and realize sub-wavelength imaging. Through adjusting the wavelength of coupling laser, a broadband 1-500 GHz microwave electric field measurement can be achieved. This new scheme is benefitial to conducting the continue electric field measurement and the miniaturization of the test equipment. In this paper, the researches about using Rydberg atom to measure electric field with high precision are reviewed. The basic theory and experimental techniques are introduced. Finally, we discuss a promising method of using Rydberg atom interferometer to detect the accumulated phase in the process of interaction between electric field and Rydberg atoms. This method converts amplitude measurement into phase test, which may improve the precision and sensitivity.
Recently, Rydberg atom has emerged as an attractive choice to realize quantum sensing of low-frequency electric field. The progress so far has mostly utilized the intensity and phase changes in probe laser and the corresponding detection mechanism still remains classical. Nevertheless, external field acting on the Rydberg state can induce the polarization variation of probe laser in the Rydberg electromagnetically induced transparency (EIT) system embedded in realistic multi-state atoms. We experimentally observe this phenomenon and realize signal extraction by appropriately utilizing the polarization degrees of freedom. Based on such a mechanism, we further design and implement a quantum weak measurement scheme, which clearly suppresses the technical noise and leads to considerable improvement of performance. Evaluation of the sensitivities across different post-selection angles demonstrates that the weak measurement results agree well with the theoretical model predictions. The advantages of our method are analyzed from multiple aspects, including characterizing the responses over different frequencies and comparing the responses of the weak measurement scheme and the traditional transmission-based method. After accounting for the screening effect of a measured ratio 17\% where the 87Rb atoms experience a substantially reduced field inside the glass cell, the performance reaches 33 μVcm-1Hz-1/2 in sensitivity and 1.0 μV/cm in minimal detectable field for an integration time of 1000 s, as perceived by the atoms.