Recently, Rydberg atom has emerged as an attractive choice to realize quantum sensing of low-frequency electric field. The progress so far has mostly utilized the intensity and phase changes in probe laser and the corresponding detection mechanism still remains classical. Nevertheless, external field acting on the Rydberg state can induce the polarization variation of probe laser in the Rydberg electromagnetically induced transparency (EIT) system embedded in realistic multi-state atoms. We experimentally observe this phenomenon and realize signal extraction by appropriately utilizing the polarization degrees of freedom. Based on such a mechanism, we further design and implement a quantum weak measurement scheme, which clearly suppresses the technical noise and leads to considerable improvement of performance. Evaluation of the sensitivities across different post-selection angles demonstrates that the weak measurement results agree well with the theoretical model predictions. The advantages of our method are analyzed from multiple aspects, including characterizing the responses over different frequencies and comparing the responses of the weak measurement scheme and the traditional transmission-based method. After accounting for the screening effect of a measured ratio 17\% where the $^\text{87}$Rb atoms experience a substantially reduced field inside the glass cell, the performance reaches 33 $μ\text{V}~\text{cm}^\text{-1}~\text{Hz}^\text{-1/2}$ in sensitivity and 1.0 $μ\text{V/cm}$ in minimal detectable field for an integration time of 1000 s, as perceived by the atoms.
Recently, Rydberg atom has emerged as an attractive choice to realize quantum sensing of low-frequency electric field. The progress so far has mostly utilized the intensity and phase changes in probe laser and the corresponding detection mechanism still remains classical. Nevertheless, external field acting on the Rydberg state can induce the polarization variation of probe laser in the Rydberg electromagnetically induced transparency (EIT) system embedded in realistic multi-state atoms. We experimentally observe this phenomenon and realize signal extraction by appropriately utilizing the polarization degrees of freedom. Based on such a mechanism, we further design and implement a quantum weak measurement scheme, which clearly suppresses the technical noise and leads to considerable improvement of performance. Evaluation of the sensitivities across different post-selection angles demonstrates that the weak measurement results agree well with the theoretical model predictions. The advantages of our method are analyzed from multiple aspects, including characterizing the responses over different frequencies and comparing the responses of the weak measurement scheme and the traditional transmission-based method. After accounting for the screening effect of a measured ratio 17% where the 87Rb atoms experience a substantially reduced field inside the glass cell, the performance reaches 33 μVcm-1Hz-1/2 in sensitivity and 1.0 μV/cm in minimal detectable field for an integration time of 1000 s, as perceived by the atoms.
Detection of long-wavelength signal is of importance for diverse sensing and communication applications. Conventional metal antennas are limited in this regime, particularly when compactness and high sensitivity are both required. Despite intrinsic advantages for electric-field sensing across an ultra-broad range from DC to terahertz, Rydberg atoms still face challenges in practical long-wavelength signal detection, motivating the development of more sensitive and scalable approaches. In this work, we experimentally show that such a signal acting on the Rydberg state can be converted into a polarization variation of the probe laser, and realize signal extraction by appropriately utilizing the polarization degrees of freedom. Based on such a mechanism, we further design and implement a quantum weak measurement scheme, which clearly suppresses the technical noise and leads to considerable improvement of performance. Evaluation of the sensitivities across different post-selection angles demonstrates that the weak measurement results agree well with the theoretical model predictions. The advantages of our method are analyzed from multiple aspects, including characterizing the responses over different frequencies and comparing the responses of the weak measurement scheme and the traditional transmission-based method. After accounting for the screening effect of a measured ratio of 17% where the Rb 87 atoms experience a substantially reduced field inside the glass cell, the performance reaches 33 μV cm −1 Hz −1/2 in sensitivity and 1.0 μV cm −1 in minimal detectable field for an integration time of 1000 s, as perceived by the atoms.
Rydberg atoms have emerged as a versatile and efficient platform for high-sensitivity quantum sensing of free-space electric fields, with remarkable progress in detecting low-frequency signals. To date, low-frequency Rydberg receivers have relied on a constant bias field, typically realized via intra-cell electrodes or Rydberg plasmas generated by photoelectric effects or inter-atomic interactions. While these approaches improve sensitivity, they suffer from inherent challenges in calibration, long-term stability, and robustness, hindering practical deployment. Here, we propose, design, and experimentally demonstrate a quantum sensing scheme for low-frequency electric signals using modulated auxiliary fields in Rydberg atoms. Unlike conventional methods that employ external DC electric fields that are often fully shielded by adsorbed atom layers on the cell walls, we introduce an AC-field modulation strategy. The incoming low-frequency signal mixes with the auxiliary field, and together they induce Stark shifts of the Rydberg level. These shifts are mapped onto the probe laser via electromagnetically induced transparency (EIT), in a manner analogous to heterodyne detection. We demonstrate a sensitivity of 7.5±2.6μV/(cm⋅Hz1/2) at 5 kHz and a minimal detectable field of 0.26±0.04μV/cm with an integration time of 1000 s. Furthermore, we extend this approach to systematically analyze the performance of generalized auxiliary fields containing multiple frequency components. By virtue of modulated auxiliary field and quantum frequency mixing, our results establish a robust and systematic framework for quantum sensing of low-frequency electric fields with Rydberg atoms, offering improved sensitivity, stability, and immunity to environmental drifts.
We demonstrate the measurement of super low-frequency electric field using Rydberg atoms in an atomic vapor cell with inside parallel electrodes, thus overcoming the low-frequency electric-field-screening effect at frequencies below a few kHz. Rydberg electromagnetically induced transparency (EIT) spectra involving 52 D 5/2 state is employed to measure the signal electric field. An auxiliary DC field is applied to improve the sensitivity. A DC Stark map is demonstrated, where the utilized 52 D 5/2 exhibits m j = 1/2, 3/2, 5/2 Stark shifts and splittings. The m j = 1/2 state is employed to detect the signal field because of its larger polarizability than that of m j = 3/2, 5/2. Also, we show that the strength of the spectrum is dependent on the angle between the laser polarizations and the electric field. With optimization of the applied DC field to shift the m j = 1/2 Rydberg energy level to a high sensitivity region and the laser polarizations to obtain the maximum m j = 1/2 signal, we achieve the detection of the signal electric field with a frequency of 100 Hz down to 214.8 µ V/cm with a sensitivity of 67.9 µ V cm −1 Hz −1/2 , and the linear dynamic range is over 37 dB. Our work extends the measurement frequency of Rydberg sensors to super low frequency with high sensitivity, which has the advantages of high sensitivity and miniaturization for receiving super low frequency.
Recently, the rapid progress of quantum sensing research reveals that the Rydberg atoms have great potentials in becoming high-precision centimeter-scale antenna of low-frequency fields. In order to facilitate efficient and reliable detection of low-frequency fields via Rydberg atoms, we design, implement and analyze a special but low-cost and scalable method based on heterodyning processes under the condition of electromagnetically induced transparency (EIT) embedded in typical two-photon ground-Rydberg transition. Instead of relying on observing changes in absorption of light by Rydberg atoms, our method focuses on the phase modulation effect on the probe laser induced by the low-frequency fields via the Rydberg EIT mechanism and utilizes a demodulation process to accurately retrieve the signal. The general principles of our method apply to both electric and magnetic fields and it is even possible to realize the combination of both functionalities in the same apparatus. In particular, we experimentally demonstrate the full cycle of operations with respect to both cases. In the measurement of low-frequency electric fields, we discover that the Rydberg dipole-dipole interaction among atoms induce linear superposition of Rydberg states with different angular momentum that generates a first-order response corresponding to the signature of linear Stark effect. As the Rydberg atoms have excellent coupling strengths with electric fields, our results indicate that our method can hopefully reach high-precision performance for practical tasks in the future.
Abstract Recently, the rapid progress of quantum sensing research reveals that Rydberg atoms have great potential in becoming high-precision centimeter-scale antennas for low-frequency fields. In order to facilitate efficient and reliable detection of low-frequency fields via Rydberg atoms, we designed and implemented a heterodyne method based on the linear response to external signals under the condition of Rydberg electromagnetically induced transparency (EIT). Instead of relying on observing changes in the absorption of light by Rydberg atoms, our method focuses on the phase modulation effect on the probe laser induced by low-frequency fields via the Rydberg EIT mechanism and utilizes a special demodulation process to accurately retrieve signals including both amplitude and phase. The general principles of our method apply to both electric and magnetic fields, and it is even possible to realize a combination of both functionalities in the same apparatus. In particular, we experimentally demonstrate the full cycle of operations with respect to both cases. In measuring low-frequency electric fields, we discover that the Rydberg dipole–dipole interaction among atoms induces a linear superposition of Rydberg states with different angular momentum, generating a first-order response corresponding to the signature of the linear Stark effect. As Rydberg atoms have excellent coupling strengths with electric fields, our results indicate that our method can hopefully achieve high-precision performance for practical tasks in the future.
Rydberg atoms are highly excited atoms with large principal quantum number n, big sizes (~n2) and long lifetimes (~n3). Rydberg atoms are very sensitive to an external field due to the large polarizabilities of Rydberg atoms (~n7). Electromagnetically induced transparency (EIT) of Rydberg atom provides an ideal method to detect Rydberg atoms without destroying atoms, and can be used to measure the external direct current and radio frequency (RF) field. In this paper, we study the EIT effect of a cesium ladder-type three-level atom involving Rydberg state exposed to a weak RF field. The ground state (6S1/2), the excited state (6P3/2) and Rydberg state (48D5/2) constitute the Rydberg three-level system, in which the probe laser couples 6S1/2(F=4)6P3/2(F'=5) transition, whereas the coupling laser scans across the 6P3/248D5/2 Rydberg transition. The coupling laser (510 nm laser, propagating in the z-axis direction and linear polarization in the y-axis direction) and the probe laser (852 nm laser, linear polarization in the y-axis direction) counter-propagate through a 50-mm-long cesium vapor cell at room temperature, yielding Rydberg EIT spectra. Rydberg EIT signal is detected as a function of the detuning of the coupling laser. When a weak RF (80 MHz) electric field polarized in the x-axis direction is applied to a pair of electrode plates located on both sides of the cesium cell, the EIT spectrum of Rydberg 48D5/2 shows the Stark splitting and the even order harmonic sidebands. The experimental results are analyzed by using the Floquet theory. The simulation results accord well with the experimentally measured results. Furthermore, we also investigate the influence of the self-ionization effect of Rydberg atom on the Stark spectrum by changing the RF frequency. We put forward a proposal to avoid the effect of ionization by placing electrode plates in the cesium cell. In the weak RF-field domain, mj=5/2 Stark line crosses mj=1/2, 3/2 sidebands, these cross points provide an antenna-free method of accurately calibrating the RF electric field based on Rydberg atoms.