Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2408.06575 · Physical Review A

Optimal strategies for low-noise detection of atoms using resonant frequency modulation spectroscopy in cold-atom interferometers

Ryan Thomas, Samuel Legge, Simon A. Haine, J. D. Close

Published Dec 10, 2024• 0 citations
arXivHTMLPDF

Abstract

Resonant frequency modulation spectroscopy has been previously used as a highly sensitive method for measuring the output of cold atom interferometers. Using a detailed model that accounts for optical saturation, laser intensities and atomic densities that vary spatially, and radiation pressure on the atoms, we theoretically investigate under what parameter regimes the optimum signal-to-noise ratio is found under experimentally realistic conditions. We compare this technique to the standard method of fluorescence imaging and find that it outperforms fluorescence imaging for compact interferometers using condensed atomic sources or where the photon collection efficiency is limited. However, we find that fluorescence imaging is likely to be the preferred method when using squeezed atomic sources due to limited atom number.

DOI
10.1103/physreva.110.063706

Related papers

Fluorescence detection at the atom shot noise limit for atom interferometry

E Rocco, R N Palmer, T. Valenzuela +3 more

Atom interferometers (AIs) are promising tools for precision measurement with applications ranging from geophysical exploration and tests of the equivalence principle of general relativity to the detection of gravitational waves. Their optimal sensitivity is ultimately limited by their detection noise. We review resonant and near-resonant methods to detect the atom number of the interferometer outputs, and we theoretically analyze the relative influence of various scheme dependent noise sources and the technical challenges affecting the detection. We show that for the typical conditions under which an AI operates, simultaneous fluorescence detection with a charge-coupled device sensor is the optimal imaging scheme. We extract the laser beam parameters such as detuning, intensity, and duration required for reaching the atom shot noise limit.

arXiv:1404.7117•New Journal of Physics•Sep 25, 2014•36 citations

Highly sensitive detection of Rydberg atoms with fluorescence loss spectrum in cold atoms*

Xuerong Shi, Hao Zhang, Mingyong Jing +3 more

Fluorescence loss spectrum for detecting cold Rydberg atoms with high sensitivity has been obtained based on lock-in detection of fluorescence of 6P3/2 state when cooling lasers of the magneto-optical trap are modulated. The experiment results show that the signal to noise ratio has been improved by 32.64 dB when the modulation depth (converted to laser frequency) and frequency are optimized to 4 MHz and 6 kHz, respectively. This technique enables us to perform a highly sensitive non-destructive detection of Rydberg atoms.

Chinese Physics B•Nov 20, 2019•1 citation

Fluorescence imaging efficiency of cold atoms in free fall

Isabelle Serre, Laurence Pruvost, H. T. Duong

A fluorescence detection scheme coupled to a highly sensitive nitrogen-cooled CCD camera is used to image the spatial distribution of a low-density falling rubidium atomic cloud released from an optical trap. The falling cloud passes through a thin probe laser beam tuned to resonance. The performance of the scheme is illustrated in the analysis of cold atomic clouds collimated by pinholes during their free fall under the influence of gravity. Clouds of approximately 10(4) atoms and with typically 10(6) at./cm(3) density are analyzed spatially with 24-mum resolution. This method is compared with different atomic cloud imaging techniques.

Applied Optics•Feb 20, 1998•7 citations

Real-time local density probe for cold atoms utilizing Raman driven spin noise spectroscopy

Sayari Majumder, Bhagyashri Bidwai, Bernadette Varsha +1 more

We demonstrate a minimally perturbative detection method—Raman driven spin noise spectroscopy (RDSNS)—to directly probe the local density of a cloud of cold 39K atoms in real time. The technique relies on detecting the polarization fluctuations of a far-off resonant focused probe light passing through the atoms, driven by two coherent Raman lasers connecting adjacent Zeeman spin states. This is an easily implementable scheme with a wide-ranging applicability in detecting cold atoms. Unlike traditional fluorescence and absorption imaging techniques, this approach does not require stochastic photon scattering from trapped atoms, thereby leaving the cold cloud unperturbed. The data can be collected in MHz refresh rate, allowing for near real-time detection. We validated this technique by monitoring the strength of the RDSNS signal by varying the key parameters of the three-dimensional magneto-optical trap (MOT) and the cold atom source (two-dimensional MOT). We performed experiments to probe local densities across the cold atom cloud using our technique and compared it with the inverse Abel-transformed density profiles extracted from the fluorescence of a spherically symmetric atomic cloud and found excellent agreement. This detection protocol is particularly advantageous for probing systems that lack inherent symmetry, where the Abel transformation is inapplicable. Moreover, RDSNS imaging is suitable for extracting the dynamical properties of systems in real time.

Applied Physics Letters•Jul 28, 2025•0 citations

Comparison of two absorption imaging methods to detect cold atoms in magnetic trap

Yan Wang, Zhaohui Hu, Lu Qi

Two methods of absorption imaging to detect cold atoms in a magnetic trap are implemented for a high-precision cold atom interferometer. In the first method, a probe laser which is in resonance with a cycle transition frequency is used to evaluate the quantity and distribution of the atom sample. In the second method, the probe laser is tuned to an open transition frequency, which stimulates a few and constant number of photons per atom. This method has a shorter interaction time and results in absorption images which are not affected by the magnetic field and the light field. We make a comparison of performance between these two imaging methods in the sense of parameters such as pulse duration, light intensity, and magnetic field strength. The experimental results show that the second method is more reliable when detecting the quantity and density profiles of the atoms. These results fit well to the theoretical analysis.

Chinese Physics B•Feb 1, 2015•1 citation

High-precision cavity spectroscopy using high-frequency squeezed light

J. Junker, D. M. Wilken, Elanor H. Huntington +1 more

In this article, we present a novel spectroscopy technique that improves the signal-to-shot-noise ratio without the need to increase the laser power. Detrimental effects by technical noise sources are avoided by frequency-modulation techniques (frequency up-shifting). Superimposing the signal on non-classical states of light leads to a reduced quantum noise floor. Our method reveals in a proof-of-concept experiment small signals at Hz to kHz frequencies even below the shot noise limit. Our theoretical calculations fully support our experimental findings. The proposed technique is interesting for applications such as high-precision cavity spectroscopy, e.g., for explosive trace gas detection where the specific gas might set an upper limit for the laser power employed.

Optics Express•Jan 15, 2021•12 citations
Resonant frequency modulation spectroscopy has been previously used as a highly sensitive method for measuring the output of cold atom interferometers. Using a detailed model that accounts for optical saturation, laser intensities and atomic densities that vary spatially, and radiation pressure on the atoms, we theoretically investigate under what parameter regimes the optimum signal-to-noise ratio is found under experimentally realistic conditions. We compare this technique to the standard method of fluorescence imaging and find that it outperforms fluorescence imaging for compact interferometers using condensed atomic sources or where the photon collection efficiency is limited. However, we find that fluorescence imaging is likely to be the preferred method when using squeezed atomic sources due to limited atom number.
Atom interferometers (AIs) are promising tools for precision measurement with applications ranging from geophysical exploration and tests of the equivalence principle of general relativity to the detection of gravitational waves. Their optimal sensitivity is ultimately limited by their detection noise. We review resonant and near-resonant methods to detect the atom number of the interferometer outputs, and we theoretically analyze the relative influence of various scheme dependent noise sources and the technical challenges affecting the detection. We show that for the typical conditions under which an AI operates, simultaneous fluorescence detection with a charge-coupled device sensor is the optimal imaging scheme. We extract the laser beam parameters such as detuning, intensity, and duration required for reaching the atom shot noise limit.
Fluorescence loss spectrum for detecting cold Rydberg atoms with high sensitivity has been obtained based on lock-in detection of fluorescence of 6P3/2 state when cooling lasers of the magneto-optical trap are modulated. The experiment results show that the signal to noise ratio has been improved by 32.64 dB when the modulation depth (converted to laser frequency) and frequency are optimized to 4 MHz and 6 kHz, respectively. This technique enables us to perform a highly sensitive non-destructive detection of Rydberg atoms.
A fluorescence detection scheme coupled to a highly sensitive nitrogen-cooled CCD camera is used to image the spatial distribution of a low-density falling rubidium atomic cloud released from an optical trap. The falling cloud passes through a thin probe laser beam tuned to resonance. The performance of the scheme is illustrated in the analysis of cold atomic clouds collimated by pinholes during their free fall under the influence of gravity. Clouds of approximately 10(4) atoms and with typically 10(6) at./cm(3) density are analyzed spatially with 24-mum resolution. This method is compared with different atomic cloud imaging techniques.
We demonstrate a minimally perturbative detection method—Raman driven spin noise spectroscopy (RDSNS)—to directly probe the local density of a cloud of cold 39K atoms in real time. The technique relies on detecting the polarization fluctuations of a far-off resonant focused probe light passing through the atoms, driven by two coherent Raman lasers connecting adjacent Zeeman spin states. This is an easily implementable scheme with a wide-ranging applicability in detecting cold atoms. Unlike traditional fluorescence and absorption imaging techniques, this approach does not require stochastic photon scattering from trapped atoms, thereby leaving the cold cloud unperturbed. The data can be collected in MHz refresh rate, allowing for near real-time detection. We validated this technique by monitoring the strength of the RDSNS signal by varying the key parameters of the three-dimensional magneto-optical trap (MOT) and the cold atom source (two-dimensional MOT). We performed experiments to probe local densities across the cold atom cloud using our technique and compared it with the inverse Abel-transformed density profiles extracted from the fluorescence of a spherically symmetric atomic cloud and found excellent agreement. This detection protocol is particularly advantageous for probing systems that lack inherent symmetry, where the Abel transformation is inapplicable. Moreover, RDSNS imaging is suitable for extracting the dynamical properties of systems in real time.
Two methods of absorption imaging to detect cold atoms in a magnetic trap are implemented for a high-precision cold atom interferometer. In the first method, a probe laser which is in resonance with a cycle transition frequency is used to evaluate the quantity and distribution of the atom sample. In the second method, the probe laser is tuned to an open transition frequency, which stimulates a few and constant number of photons per atom. This method has a shorter interaction time and results in absorption images which are not affected by the magnetic field and the light field. We make a comparison of performance between these two imaging methods in the sense of parameters such as pulse duration, light intensity, and magnetic field strength. The experimental results show that the second method is more reliable when detecting the quantity and density profiles of the atoms. These results fit well to the theoretical analysis.
In this article, we present a novel spectroscopy technique that improves the signal-to-shot-noise ratio without the need to increase the laser power. Detrimental effects by technical noise sources are avoided by frequency-modulation techniques (frequency up-shifting). Superimposing the signal on non-classical states of light leads to a reduced quantum noise floor. Our method reveals in a proof-of-concept experiment small signals at Hz to kHz frequencies even below the shot noise limit. Our theoretical calculations fully support our experimental findings. The proposed technique is interesting for applications such as high-precision cavity spectroscopy, e.g., for explosive trace gas detection where the specific gas might set an upper limit for the laser power employed.