Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2407.07579

Suppressing photon detection errors in nondeterministic state preparation

Csaba Czabán, Zoltán Kolarovszki, Márton Karácsony, Zoltán Zimborás

Published Jun 19, 2024• 1 citation
arXivHTMLPDF

Abstract

Photonic quantum computing has recently emerged as a promising candidate for fault-tolerant quantum computing by photonic qubits. These protocols make use of nondeterministic gates, enabling universal quantum computation. However, the suggested solutions heavily use particle number resolving detectors (PNRDs), which are experimentally hard to realize and are usually biased in practice. We investigate the possibility of suppressing such errors caused by such photodetector imperfections by adjusting the optimal beamsplitter and phaseshifter angles in the interferometer corresponding to nondeterministic gates. Moreover, we devise an optimization method for determining the adjusted angles, which may achieve higher output state fidelities while controlling the success probabilities of the nondeterministic gates.

DOI
10.1145/3665870.3665873

Related papers

ALTERNATE SCHEME FOR OPTICAL CLUSTER-STATE GENERATION WITHOUT NUMBER-RESOLVING PHOTON DETECTORS

Mark M. Wilde, Federico M. Spedalieri, Jonathan P. Dowling +1 more

We design a controlled-phase gate for linear optical quantum computing by using photodetectors that cannot resolve photon number. An intrinsic error-correction circuit corrects errors introduced by the detectors. Our controlled-phase gate has a 1/4 success probability. Recent development in cluster-state quantum computing has shown that a two-qubit gate with non-zero success probability can build an arbitrarily large cluster state only with polynomial overhead. Hence, it is possible to generate optical cluster states without number-resolving detectors and with polynomial overhead.

arXiv:quant-ph/0610115•International Journal of Quantum Information•Aug 1, 2007•1 citation

Nondeterministic Logic Gates in Optical Quantum Computing

Federico M. Spedalieri, Jonathan P. Dowling, Hwang Lee

Federico M. Spedalieri, Jonathan P. Dowling, and Hwang Lee Abstract We present a detailed description of nondeterministic quantum logic gates: the crucial component of linear optical quantum computing. We use the qubits that are encoded in the polarization degrees of freedom, as opposed to the original dual-rail encoding. Employing the polarization-encoding scheme, we can avoid the undetected errors due to the inefficiency of the photodetectors and, therefore, achieve high gate fidelity, independent of the quantum efficiency of the detectors. Furthermore, we show that such a high-fidelity gate operation can be performed with no need of number-resolving detectors.

Chapman & Hall/CRC eBooks•Sep 19, 2007•0 citations

Improving photon detector efficiency using a high-fidelity optical controlled-not gate

Katherine L. Brown, R. Singh, Joshua H. Mendez +2 more

A significant problem for optical quantum computing is inefficient or inaccurate photodetectors. It is possible to use controlled-not (cnot) gates to improve a detector by making a large cat state, then measuring every qubit in that state. In this paper we develop a code that compares five different schemes for making multiple measurements, some of which are capable of detecting loss and some of which are not. We explore how each of these schemes performs in the presence of different errors, and derive a formula to find at what probability of qubit loss it is worth detecting loss, and at what probability does this just lead to further errors than the loss introduces.

arXiv:1308.2645•Physical Review A•Feb 20, 2015•0 citations

Modeling of linear optical controlled-z quantum gate with dimensional errors of passive components

Fedor Dmitrievich Kiselev, E.Y. Samsonov, Artur V. Gleim

Linear optical quantum computing can be realized using photonic integrate circuits (PICs).It is advantageous in comparison to other physical implementations of quantum computing due to simplicity of qubit encoding using photons and low decoherence times.Passive components like beamsplitters and phaseshifters are key elements for such PICs.In this article, we present modeling of linear optical controlled-Z gate with imperfections of beamsplitters and phaseshifters taken into account.Results showed that errors occur which cannot be detected by projection measurements and post-selection proposed by Knill, Laflamme and Milburn.We studied how these errors and success probability changes with the increase of dimensional errors using Monte-Carlo simulation.The obtained results can be used for design and calibration stages of chip manufacturing.

Nanosystems Physics Chemistry Mathematics•Dec 28, 2019•2 citations

Quantum Gate and Quantum State Preparation through Neighboring Optimal Control

Yuchen Peng

Successful implementation of fault-tolerant quantum computation on a system of qubits places severe demands on the hardware used to control the many-qubit state. It is known that an accuracy threshold Pa exists for any quantum gate that is to be used for such a computation to be able to continue for an unlimited number of steps. Specifically, the error probability Pe for such a gate must fall below the accuracy threshold: Pe < Pa. Estimates of Pa vary widely, though Pa ∼ 10−4 has emerged as a challenging target for hardware designers. I present a theoretical framework based on neighboring optimal control that takes as input a good quantum gate and returns a new gate with better performance. I illustrate this approach by applying it to a universal set of quantum gates produced using non-adiabatic rapid passage. Performance improvements are substantial comparing to the original (unimproved) gates, both for ideal and non-ideal controls. Under suitable conditions detailed below, all gate error probabilities fall by 1 to 4 orders of magnitude below the target threshold of 10−4. After applying the neighboring optimal control theory to improve the performance of quantum gates in a universal set, I further apply the general control theory in a two-step procedure for fault-tolerant logical state preparation, and I illustrate this procedure by preparing a logical Bell state fault-tolerantly. The two-step preparation procedure is as follow: Step 1 provides a one-shot procedure using neighboring optimal control theory to prepare a physical qubit state which is a high-fidelity approximation to the Bell state |β01⟩ = 1/√2(|01⟩ + |10⟩). I show that for ideal (non-ideal) control, an approximate |β01⟩ state could be prepared with error probability ϵ ∼ 10−6 (10−5) with one-shot local operations. Step 2 then takes a block of p pairs of physical qubits, each prepared in |β01⟩ state using Step 1, and fault-tolerantly prepares the logical Bell state for the C4 quantum error detection code.

•Jan 1, 2016•0 citations

Quantum receivers with squeezing and photon-number-resolving detectors for M -ary coherent state discrimination

Shuro Izumi, Masahiro Takeoka, Kazuhiro Ema +1 more

We propose quantum receivers with optical squeezing and photon-number-resolving detectors (PNRDs) for the near-optimal discrimination of quaternary phase-shift-keyed coherent state signals. The basic scheme is similar to the previous proposals [e.g., Izumi et al., Phys. Rev. A 86, 042328 (2012)] in which displacement operations, on-off detectors, and electrical feedforward operations were used. Here we study two types of receivers, one of which installs optical squeezings and the other uses PNRDs instead of on-off detectors. We show that both receivers can attain lower error rates than that in the previous scheme. In particular, we show the PNRD-based receiver has a significant gain when the ratio between the mean photon number of the signal and the number of the feedforward steps is relatively high, in other words, when the probability of detecting two or more photons at each detector is not negligible. Moreover, we show that the PNRD-based receiver can suppress the errors due to dark counts, which the receiver with the on-off detector cannot do with a small number of feedforwards.

arXiv:1302.2691•Physical Review A•Apr 23, 2013•60 citations
Photonic quantum computing has recently emerged as a promising candidate for fault-tolerant quantum computing by photonic qubits. These protocols make use of nondeterministic gates, enabling universal quantum computation. However, the suggested solutions heavily use particle number resolving detectors (PNRDs), which are experimentally hard to realize and are usually biased in practice. We investigate the possibility of suppressing such errors caused by such photodetector imperfections by adjusting the optimal beamsplitter and phaseshifter angles in the interferometer corresponding to nondeterministic gates. Moreover, we devise an optimization method for determining the adjusted angles, which may achieve higher output state fidelities while controlling the success probabilities of the nondeterministic gates.
We design a controlled-phase gate for linear optical quantum computing by using photodetectors that cannot resolve photon number. An intrinsic error-correction circuit corrects errors introduced by the detectors. Our controlled-phase gate has a 1/4 success probability. Recent development in cluster-state quantum computing has shown that a two-qubit gate with non-zero success probability can build an arbitrarily large cluster state only with polynomial overhead. Hence, it is possible to generate optical cluster states without number-resolving detectors and with polynomial overhead.
Federico M. Spedalieri, Jonathan P. Dowling, and Hwang Lee Abstract We present a detailed description of nondeterministic quantum logic gates: the crucial component of linear optical quantum computing. We use the qubits that are encoded in the polarization degrees of freedom, as opposed to the original dual-rail encoding. Employing the polarization-encoding scheme, we can avoid the undetected errors due to the inefficiency of the photodetectors and, therefore, achieve high gate fidelity, independent of the quantum efficiency of the detectors. Furthermore, we show that such a high-fidelity gate operation can be performed with no need of number-resolving detectors.
A significant problem for optical quantum computing is inefficient or inaccurate photodetectors. It is possible to use controlled-not (cnot) gates to improve a detector by making a large cat state, then measuring every qubit in that state. In this paper we develop a code that compares five different schemes for making multiple measurements, some of which are capable of detecting loss and some of which are not. We explore how each of these schemes performs in the presence of different errors, and derive a formula to find at what probability of qubit loss it is worth detecting loss, and at what probability does this just lead to further errors than the loss introduces.
Linear optical quantum computing can be realized using photonic integrate circuits (PICs).It is advantageous in comparison to other physical implementations of quantum computing due to simplicity of qubit encoding using photons and low decoherence times.Passive components like beamsplitters and phaseshifters are key elements for such PICs.In this article, we present modeling of linear optical controlled-Z gate with imperfections of beamsplitters and phaseshifters taken into account.Results showed that errors occur which cannot be detected by projection measurements and post-selection proposed by Knill, Laflamme and Milburn.We studied how these errors and success probability changes with the increase of dimensional errors using Monte-Carlo simulation.The obtained results can be used for design and calibration stages of chip manufacturing.
Successful implementation of fault-tolerant quantum computation on a system of qubits places severe demands on the hardware used to control the many-qubit state. It is known that an accuracy threshold Pa exists for any quantum gate that is to be used for such a computation to be able to continue for an unlimited number of steps. Specifically, the error probability Pe for such a gate must fall below the accuracy threshold: Pe < Pa. Estimates of Pa vary widely, though Pa ∼ 10−4 has emerged as a challenging target for hardware designers. I present a theoretical framework based on neighboring optimal control that takes as input a good quantum gate and returns a new gate with better performance. I illustrate this approach by applying it to a universal set of quantum gates produced using non-adiabatic rapid passage. Performance improvements are substantial comparing to the original (unimproved) gates, both for ideal and non-ideal controls. Under suitable conditions detailed below, all gate error probabilities fall by 1 to 4 orders of magnitude below the target threshold of 10−4. After applying the neighboring optimal control theory to improve the performance of quantum gates in a universal set, I further apply the general control theory in a two-step procedure for fault-tolerant logical state preparation, and I illustrate this procedure by preparing a logical Bell state fault-tolerantly. The two-step preparation procedure is as follow: Step 1 provides a one-shot procedure using neighboring optimal control theory to prepare a physical qubit state which is a high-fidelity approximation to the Bell state |β01⟩ = 1/√2(|01⟩ + |10⟩). I show that for ideal (non-ideal) control, an approximate |β01⟩ state could be prepared with error probability ϵ ∼ 10−6 (10−5) with one-shot local operations. Step 2 then takes a block of p pairs of physical qubits, each prepared in |β01⟩ state using Step 1, and fault-tolerantly prepares the logical Bell state for the C4 quantum error detection code.
We propose quantum receivers with optical squeezing and photon-number-resolving detectors (PNRDs) for the near-optimal discrimination of quaternary phase-shift-keyed coherent state signals. The basic scheme is similar to the previous proposals [e.g., Izumi et al., Phys. Rev. A 86, 042328 (2012)] in which displacement operations, on-off detectors, and electrical feedforward operations were used. Here we study two types of receivers, one of which installs optical squeezings and the other uses PNRDs instead of on-off detectors. We show that both receivers can attain lower error rates than that in the previous scheme. In particular, we show the PNRD-based receiver has a significant gain when the ratio between the mean photon number of the signal and the number of the feedforward steps is relatively high, in other words, when the probability of detecting two or more photons at each detector is not negligible. Moreover, we show that the PNRD-based receiver can suppress the errors due to dark counts, which the receiver with the on-off detector cannot do with a small number of feedforwards.