Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2406.14948

Identifying impurities in a silicon substrate by using a superconducting flux qubit

Hiraku Toida, Kosuke Kakuyanagi, Leonid Victorovich Abdurakhimov, Masahiro Hori, Ono Yukinori, Shiro Saito

Published Jun 21, 2024• 0 citations
arXivHTMLPDF

Abstract

A bismuth-doped silicon substrate was analyzed by using a magnetometer based on a superconducting flux qubit. The temperature dependence of the magnetization indicates that the silicon substrate contains at least two signal sources, intentionally doped bismuth spins and a spin 1/2 system with a ratio of 0.873 to 0.127. In combination with a conventional electron spin resonance spectrometer, a candidate origin of the spin 1/2 system was identified as a dangling bond on the silicon surface. In addition, the spin sensitivity of the magnetometer was also estimated to be 12 spins/$\sqrt{\mathrm{Hz}}$ by using optimized dispersive readout.

DOI
10.48550/arxiv.2406.14948

Related papers

Strong coupling of a superconducting flux qubit to single bismuth donors

Tikai Chang, Itamar Holzman, Shao Qi Lim +4 more

The realization of a quantum computer represents a tremendous scientific and technological challenge due to the extreme fragility of quantum information. The physical support of information, namely the quantum bit or qubit, must at the same time be strongly coupled to other qubits by gates to compute information, and well decoupled from its environment to keep its quantum behavior. An interesting physical system for realizing such qubits are magnetic impurities in semiconductors, such as bismuth donors in silicon. Indeed, spins associated to bismuth donors can reach an extremely long coherence time - of the order of seconds. Yet it is extremely difficult to establish and control efficient gates between these spins. Here we demonstrate a protocol where single bismuth donors can coherently transfer their quantum information to a superconducting flux qubit, which acts as a mediator or quantum bus. This superconducting device allows to connect distant spins on-demand with little impact on their coherent behavior. Donor spin impurities in silicon are promising qubit candidates, but efficient control and coupling of distant spins remains a key challenge. In this work, the authors experimentally demonstrate coherent coupling between a superconducting flux qubit and individual bismuth donor spins in silicon.

arXiv:2411.02852•Nature Communications•Nov 7, 2025•5 citations

Electron Spin Resonance Spectroscopy Using a Superconducting Flux Qubit

Hiraku Toida, Kosuke Kakuyanagi, William J. Munro +2 more

We use a superconducting flux qubit for the sensing application of electron spin resonance (ESR) spectroscopy.The superconducting flux qubit is a highly sensitive magnetometer with micrometer-scale spatial resolution.The sensitivity of our spectrometer is 400 spins/√Hz, and the sensing volume is 0.05 pL.This high sensitivity and high spatial resolution enable us to investigate a small number of electron spins in a microscale area.The spectrometer also obtains a wider ESR spectrum range with twoparameter (frequency and magnetic field) scanning.This enables us to refine the material parameters.

NTT technical review•Aug 1, 2019•1 citation

Field-Dependent Qubit Flux Noise Simulated from Materials-Specific Disordered Exchange Interactions Between Paramagnetic Adsorbates

Keith G. Ray, Yaniv Rosen, Jonathan L Dubois +1 more

Superconducting quantum devices, from qubits and magnetometers to dark matter detectors, are influenced by magnetic flux noise originating from paramagnetic surface defects and impurities. These spin systems can feature complex dynamics, including a Berezinskii-Kosterlitz-Thouless transition, that depend on the lattice, interactions, external fields, and disorder. However, the disorder included in typical models is not materials-specific, diminishing the ability to accurately capture measured flux noise phenomena. We present a first principles-based simulation of a spin lattice consisting of paramagnetic O$_2$ molecules on an Al$_2$O$_3$ surface, a likely flux noise source in superconducting qubits, to elucidate opportunities to mitigate flux noise. We simulate an ensemble of surface adsorbates with disordered orientations and calculate the orientation-dependent exchange couplings using density functional theory. Thus, our spin simulation has no free parameters or assumed functional form of the disorder, and captures correlation in the defect landscape that would appear in real systems. We calculate a range of exchange interactions between electron pairs, with the smallest values, 0.016 meV and -0.023 meV, being in the range required to act as a two-level system and couple to GHz resonators. We calculate the flux noise frequency, temperature, and applied external magnetic field dependence, as well as the susceptibility-flux noise cross-correlation. Calculated trends agree with experiment, demonstrating that a surface harboring paramagnetic adsorbates arranged with materials-specific disorder and interactions captures the various properties of magnetic flux noise observed in superconducting circuits. In addition, we find that an external electric field can tune the spin-spin interaction strength and reduce magnetic flux noise.

cond-mat.mes-hallCross-listedarXiv:2602.09471•Feb 11, 2026•0 citations

Electron Spin Resonance Detected by Superconducting Circuits

Rangga P. Budoyo, Hiraku Toida, Shiro Saito

Superconducting circuits are promising components for future quantum information technologies such as quantum computing, quantum simulation, and quantum sensing. Superconducting quantum interference devices (SQUIDs) and superconducting flux qubits can be used as a sensitive magnetic field sensor to detect local electron spin resonance (ESR). These types of sensor are characterized by good sensitivity and high spatial resolution for electron spins. In fact, we have achieved a sensitivity of 20 spins/\(\sqrt{\text {Hz}}\) with a sensing volume of 6 fl combining a flux qubit and qubit readout using a Josephson bifurcation amplifier. As a demonstration, we measured the ESR spectrum of erbium electron spins in a Y\(_{2}\)SiO\(_{5}\) crystal and nitrogen vacancy centers in diamond. In both cases, we obtained reasonable electron spin parameters by fitting a simulation to the spectrum. In this way, we proved superconducting circuits to be promising magnetic field sensors for evaluating the properties of solid materials.

Quantum science and technology•Jan 1, 2021•1 citation

Magnetometry of neurons using a superconducting qubit

Hiraku Toida, Koji Sakai, Tetsuhiko Teshima +5 more

Abstract Iron plays important physiological and pathological roles in the human body. However, microscopic analysis including redox status by a conventional electron spin resonance (ESR) spectrometer is difficult due to limited spatial resolution and sensitivity. Here we demonstrate magnetometry of cultured neurons on a polymeric film using a superconducting flux qubit that works as a sensitive magnetometer in a microscale area towards realizing ESR spectroscopy. By changing temperature (12.5–200 mK) and a magnetic field (2.5–12.5 mT), we observe a clear magnetization signal from the neurons that is well above the control magnetometry of the polymeric film itself. From ESR spectrum measured at 10 K, the magnetization signal is identified to originate from electron spins of iron ions in neurons. This technique to detect a bio-spin system can be extended to achieve ESR spectroscopy at the single-cell level, which will give the spectroscopic fingerprint of cells.

arXiv:2206.15164•Communications Physics•Feb 6, 2023•9 citations

Magnetic fluctuation from oxygen deficiency centers on the SiO$_2$ surface

Nicole Adelstein, Donghwa Lee, Jonathan L. DuBois +1 more

The magnetic stability of oxygen deficiency centers on the surface of α-quartz is investigated with first- principles calculations to understand their role in contributing to magnetic flux noise in superconducting qubits (SQs) and superconducting quantum interference devices (SQUIDs) fabricated on amorphous silica substrates. Magnetic defects on the substrate are likely responsible for some of the 1/f noise that plagues these systems. Dangling-bonds associated with three-coordinated Si atoms allow electron density transfer between spin up and down channels, resulting in low energy magnetic states. Such under-coordinated Si defects are common in both stoichiometric and oxygen deficient silica and quartz and are a probable source of magnetic flux fluctuations in SQs and SQUIDs.

arXiv:1403.0685•Mar 4, 2014•0 citations
A bismuth-doped silicon substrate was analyzed by using a magnetometer based on a superconducting flux qubit. The temperature dependence of the magnetization indicates that the silicon substrate contains at least two signal sources, intentionally doped bismuth spins and a spin 1/2 system with a ratio of 0.873 to 0.127. In combination with a conventional electron spin resonance spectrometer, a candidate origin of the spin 1/2 system was identified as a dangling bond on the silicon surface. In addition, the spin sensitivity of the magnetometer was also estimated to be 12 spins/Hz\sqrt{\mathrm{Hz}}Hz​ by using optimized dispersive readout.
The realization of a quantum computer represents a tremendous scientific and technological challenge due to the extreme fragility of quantum information. The physical support of information, namely the quantum bit or qubit, must at the same time be strongly coupled to other qubits by gates to compute information, and well decoupled from its environment to keep its quantum behavior. An interesting physical system for realizing such qubits are magnetic impurities in semiconductors, such as bismuth donors in silicon. Indeed, spins associated to bismuth donors can reach an extremely long coherence time - of the order of seconds. Yet it is extremely difficult to establish and control efficient gates between these spins. Here we demonstrate a protocol where single bismuth donors can coherently transfer their quantum information to a superconducting flux qubit, which acts as a mediator or quantum bus. This superconducting device allows to connect distant spins on-demand with little impact on their coherent behavior. Donor spin impurities in silicon are promising qubit candidates, but efficient control and coupling of distant spins remains a key challenge. In this work, the authors experimentally demonstrate coherent coupling between a superconducting flux qubit and individual bismuth donor spins in silicon.
We use a superconducting flux qubit for the sensing application of electron spin resonance (ESR) spectroscopy.The superconducting flux qubit is a highly sensitive magnetometer with micrometer-scale spatial resolution.The sensitivity of our spectrometer is 400 spins/√Hz, and the sensing volume is 0.05 pL.This high sensitivity and high spatial resolution enable us to investigate a small number of electron spins in a microscale area.The spectrometer also obtains a wider ESR spectrum range with twoparameter (frequency and magnetic field) scanning.This enables us to refine the material parameters.
Superconducting quantum devices, from qubits and magnetometers to dark matter detectors, are influenced by magnetic flux noise originating from paramagnetic surface defects and impurities. These spin systems can feature complex dynamics, including a Berezinskii-Kosterlitz-Thouless transition, that depend on the lattice, interactions, external fields, and disorder. However, the disorder included in typical models is not materials-specific, diminishing the ability to accurately capture measured flux noise phenomena. We present a first principles-based simulation of a spin lattice consisting of paramagnetic O2_22​ molecules on an Al2_22​O3_33​ surface, a likely flux noise source in superconducting qubits, to elucidate opportunities to mitigate flux noise. We simulate an ensemble of surface adsorbates with disordered orientations and calculate the orientation-dependent exchange couplings using density functional theory. Thus, our spin simulation has no free parameters or assumed functional form of the disorder, and captures correlation in the defect landscape that would appear in real systems. We calculate a range of exchange interactions between electron pairs, with the smallest values, 0.016 meV and -0.023 meV, being in the range required to act as a two-level system and couple to GHz resonators. We calculate the flux noise frequency, temperature, and applied external magnetic field dependence, as well as the susceptibility-flux noise cross-correlation. Calculated trends agree with experiment, demonstrating that a surface harboring paramagnetic adsorbates arranged with materials-specific disorder and interactions captures the various properties of magnetic flux noise observed in superconducting circuits. In addition, we find that an external electric field can tune the spin-spin interaction strength and reduce magnetic flux noise.
Superconducting circuits are promising components for future quantum information technologies such as quantum computing, quantum simulation, and quantum sensing. Superconducting quantum interference devices (SQUIDs) and superconducting flux qubits can be used as a sensitive magnetic field sensor to detect local electron spin resonance (ESR). These types of sensor are characterized by good sensitivity and high spatial resolution for electron spins. In fact, we have achieved a sensitivity of 20 spins/Hz\sqrt{\text {Hz}}Hz​ with a sensing volume of 6 fl combining a flux qubit and qubit readout using a Josephson bifurcation amplifier. As a demonstration, we measured the ESR spectrum of erbium electron spins in a Y2_{2}2​SiO5_{5}5​ crystal and nitrogen vacancy centers in diamond. In both cases, we obtained reasonable electron spin parameters by fitting a simulation to the spectrum. In this way, we proved superconducting circuits to be promising magnetic field sensors for evaluating the properties of solid materials.
Abstract Iron plays important physiological and pathological roles in the human body. However, microscopic analysis including redox status by a conventional electron spin resonance (ESR) spectrometer is difficult due to limited spatial resolution and sensitivity. Here we demonstrate magnetometry of cultured neurons on a polymeric film using a superconducting flux qubit that works as a sensitive magnetometer in a microscale area towards realizing ESR spectroscopy. By changing temperature (12.5–200 mK) and a magnetic field (2.5–12.5 mT), we observe a clear magnetization signal from the neurons that is well above the control magnetometry of the polymeric film itself. From ESR spectrum measured at 10 K, the magnetization signal is identified to originate from electron spins of iron ions in neurons. This technique to detect a bio-spin system can be extended to achieve ESR spectroscopy at the single-cell level, which will give the spectroscopic fingerprint of cells.
Magnetic fluctuation from oxygen deficiency centers on the SiO2_22​ surface
The magnetic stability of oxygen deficiency centers on the surface of α-quartz is investigated with first- principles calculations to understand their role in contributing to magnetic flux noise in superconducting qubits (SQs) and superconducting quantum interference devices (SQUIDs) fabricated on amorphous silica substrates. Magnetic defects on the substrate are likely responsible for some of the 1/f noise that plagues these systems. Dangling-bonds associated with three-coordinated Si atoms allow electron density transfer between spin up and down channels, resulting in low energy magnetic states. Such under-coordinated Si defects are common in both stoichiometric and oxygen deficient silica and quartz and are a probable source of magnetic flux fluctuations in SQs and SQUIDs.