Single atoms trapped in tightly focused optical dipole traps provide an excellent experimental platform for quantum computing, precision measurement, and fundamental physics research. In this work, we propose and demonstrate a novel approach to enhancing the loading of single atoms by introducing a weak ancillary dipole beam. The loading rate of single atoms in a dipole trap can be significantly improved by only a few tens of microwatts of counter-propagating beam. It was also demonstrated that multiple atoms could be loaded with the assistance of a counter-propagating beam. By reducing the power requirements for trapping single atoms and enabling the trapping of multiple atoms, our method facilitates the extension of single-atom arrays and the investigation of collective light-atom interactions.
Single atoms trapped in tightly focused optical dipole traps provide an excellent experimental platform for quantum computing, precision measurement, and fundamental physics research. In this work, we propose and demonstrate a novel approach to enhancing the loading of single atoms by introducing a weak ancillary dipole beam. The loading rate of single atoms in a dipole trap can be significantly improved by only a few tens of microwatts of counter-propagating beam. It was also demonstrated that multiple atoms could be loaded with the assistance of a counter-propagating beam. By reducing the power requirements for trapping single atoms and enabling the trapping of multiple atoms, our method facilitates the extension of single-atom arrays and the investigation of collective light-atom interactions.
Single atoms trapped in tightly focused optical dipole traps provide an excellent experimental platform for quantum computing, precision measurement, and fundamental physics research. In this work, we propose and demonstrate an approach to enhancing the loading of single atoms by introducing a weak ancillary dipole beam. The loading rate of single atoms in a dipole trap can be significantly improved by only a few tens of microwatts of a counterpropagating beam. It was also demonstrated that multiple atoms could be loaded with the assistance of a counterpropagating beam. By reducing the power requirements for trapping single atoms and enabling the trapping of multiple atoms, our method facilitates the extension of single-atom arrays and the investigation of collective light-atom interactions.
Reconfigurable arrays of trapped single atoms are an excellent platform for the simulation of many-body physics and the realisation of high-fidelity quantum gates. The confinement of atoms is often achieved with focussed laser beams acting as optical dipole-force traps that allow for both static and dynamic positioning of atoms. In these traps, light-assisted collisions -- enhancing the two-atom loss rate -- ensure that single atom occupation of traps can be realised. However, the time-averaged probability of trapping a single atom is limited to 0.5 when loading directly from a surrounding cloud of laser-cooled atoms, preventing deterministic filling of large arrays. In this work, we demonstrate that increasing the depth of a static, optical dipole trap enables the transition from fast loading on a timescale of 2.1s to an extended trap lifetime of 7.9s. This method demonstrates an achievable filling ratio of (79±2)% without the need of rearranging atoms to fill vacant traps.
Single atoms are interesting candidates for studying quantum optics and quantum information processing. Recently, trapping and manipulation of single atoms using tight optical dipole traps has generated considerable interest. Here we report an experimental investigation of the dynamics of atoms in a modified optical dipole trap with a backward propagating dipole trap beam, where a change in the two-atom collision rate by six times has been achieved. The theoretical model presented gives a prediction of high probabilities of few-atom loading rates under proper experimental conditions. This work provides an alternative approach to the control of the few-atom dynamics in a dipole trap and the study of the collective quantum optical effects of a few atoms.
This thesis reports on the design, setup, and operation of a new atom trap apparatus, which is developed to confine few rubidium atoms in ultrahigh vacuum by means of taylored and dynamically variable light potentials (dipole traps), thus making the atoms available for spectroscopy and controlled manipulations. To maintain low background pressure, atoms of a vapour cell are transferred into a cold atomic beam by laser cooling techniques, and accumulated by a magneto-optic trap (MOT) in a separate part of the vacuum system. The laser cooled atoms are then transferred into dipole traps made of focused far-off-resonant laser fields in single or crossed-beam geometry, which are superimposed with the center of the MOT. Gaussian as well as hollow Laguerre-Gaussian (LG01) beam profiles are used with red-detuned and blue-detuned light. Microfabricated dielectric phase objects allow the efficient and robust mode conversion of Gaussian into Laguerre-Gaussian laser beams. Trap geometries can easily be changed due to the highly flexible experimental setup. The dipole trap laser beams have powers up to several hundred milliwatts and are focused to around 10 m. At a detuning of several tens of nanometers from the atomic resonance, the resulting traps are a few millikelvin deep, and the trapped atoms exhibit motional frequencies near 30 kHz, trap light scattering rates of a few hundred photons per second per atom, and storage times of several seconds. The number of dipole-trapped atoms ranges from more than ten thousand to below ten. The dipole-trapped atoms are detected either by a photon counting system with efficient straylight discrimination, or by recapture into the MOT, which is imaged onto a sensitive photodiode and a CCD-camera. Due to the strong AC-Stark shift imposed by the high-intensity trapping light, energy-selective resonant excitation and detection of the stored atoms is possible. The measured energy distribution is consistent with a harmonic potential shape and allows for the determination of temperatures and heating rates. From initial measurements, the thermal energy is found to be about 10 % of the trap depth. Using a crossed-beam geometry with red-detuned laser light, efficient transfer of atoms between the beams is observed. Optimum transfer occurs when the two beams cross at a radial offset, which can qualitatively be understood when the particle energy and geometrical properties of the two-beam trapping potential are considered. Numerical simulations reproduce the general features of the measured transfer efficiency vs. radial beam offset. This experiment is a first step towards dynamically variable potentials. Atoms have been radially confined in a blue-detuned hollow beam, and their decay time has been determined. This configuration is currently extended to a three-dimensionally confining blue-detuned dipole trap. For advanced laser cooling, state manipulation and spectroscopy of trapped atoms, a system of two diode lasers has been set up which are phase-coherently locked with a difference frequency near 6.834 GHz, to drive Raman transitions between the hyperfine-split ground states of 87Rb atoms. Resonances of such a transition have been recorded in a buffer gas loaded rubidium vapour cell with linewidths below 100 Hz.
We report on the experimental realization of a standing-wave atom tweezer (SWAT) by aligning tightly focused dipole laser beams from a commercial objective lens and a metalens on a chip. By independently tuning the laser intensities of the two beams, we demonstrate the controlled loading of multiple atoms into the SWAT. We systematically investigate the influence of the standing-wave potential modulation depth on single-atom loading dynamics and quantitatively estimate the number of atoms in the SWAT by calculating the fluorescence of trapped atoms. Our results show that the SWAT can trap a chain of more than 20 atoms with significantly suppressed atom collisions, exhibiting a lifetime exceeding 1 second. Our work presents a versatile platform for investigating atom dynamics in 1D optical lattices, enabling the study of collective atom-photon interactions and many-body physics in a highly controllable system.
Single atoms are promising candidates for physically implementing quantum bits, the fundamental unit of quantum information. We have built an apparatus for cooling, trapping and imaging single rubidium atoms in microscopic optical tweezers. The traps are formed from a tightly focused off-resonant laser beam, which traps atoms using the optical dipole force. The traps have a diameter of ~1 μm and a depth of ~1 mK. The novelty of our approach is the use a digital mirror device (DMD) to generate multiple independently movable tweezers from a single laser beam. The DMD consists of an array of micro-mirrors that can be switched on and off, thus acting as a binary amplitude modulator. We use the DMD to imprint a computer-generated hologram on the laser beam, which is converted in to the desired arrangement of traps in the focal plane of a lens. We have developed fast algorithms for calculating binary holograms suitable for the DMD. In addition, we use this method to measure and correct for errors in the phase of the wavefront caused by optical aberrations, which is necessary for producing diffraction-limited focal spots. Using this apparatus, we have trapped arrays of up to 20 atoms with arbitrary geometrical arrangements. We exploit light-assisted collisions between atoms to ensure there is at most one atom per trapping site. We measure the temperature of the atoms in the traps to be 12 μK, and their lifetime to be 1.4 s. Finally, we demonstrate the ability to select individual atoms from an array and transport them over a distance of 14μm with laser cooling, and 5 μm without.