With great interest from the quantum computing community, an immense amount of R&D effort has been invested into improving superconducting qubits. The technologies developed for the design and fabrication of these qubits can be directly applied to applications for ultralow-threshold particle detectors, e.g., low-mass dark matter and far-infrared photon sensing. We propose a novel energy-resolving sensor based on the transmon qubit architecture combined with a signal-enhancing superconducting quasiparticle amplification stage. We refer to these sensors as SQUATs: superconducting quasiparticle-amplifying transmons. We detail the operating principle and design of this new sensor and predict that, with minimal R&D effort, solid-state-based detectors patterned with these sensors can achieve sensitivity to single terahertz photons, and sensitivity to 1 meV phonons in the detector absorber substrate on the microsecond timescale. Published by the American Physical Society 2024
With great interest from the quantum computing community, an immense amount of R&D effort has been invested into improving superconducting qubits. The technologies developed for the design and fabrication of these qubits can be directly applied to applications for ultralow-threshold particle detectors, e.g., low-mass dark matter and far-infrared photon sensing. We propose a novel energy-resolving sensor based on the transmon qubit architecture combined with a signal-enhancing superconducting quasiparticle amplification stage. We refer to these sensors as SQUATs: superconducting quasiparticle-amplifying transmons. We detail the operating principle and design of this new sensor and predict that, with minimal R&D effort, solid-state-based detectors patterned with these sensors can achieve sensitivity to single terahertz photons, and sensitivity to 1 meV phonons in the detector absorber substrate on the microsecond timescale. Published by the American Physical Society 2024
The Superconducting Quasiparticle-Amplifying Transmon (SQUAT) is a new sensor architecture for THz (meV) detection based on a weakly charge-sensitive transmon directly coupled to a transmission line. In such devices, energy depositions break Cooper pairs in the qubit capacitor islands, generating quasiparticles. Quasiparticles that tunnel across the Josephson junction change the transmon qubit parity, generating a measurable signal. In this paper, we present the design of first-generation SQUATs and demonstrate an architecture validation. We summarize initial characterization measurements made with prototype devices, comment on background sources that influence the observed parity-switching rate, and present experimental results showing simultaneous detection of charge and quasiparticle signals using aluminum-based SQUATs.
The next generation of rare-event searches, such as those aimed at determining the nature of particle dark matter or measuring fundamental neutrino properties, will benefit from particle detectors with thresholds at the meV scale, 100 – 1000 × lower than currently available. Quantum parity detectors (QPDs) are a class of proposed quantum devices, extending recent work on superconducting qubit sensors, that exploit the fingerprints of single quasiparticle tunneling across a coherent weak link as their detection concept. As envisioned, phonons generated by particle interactions within a crystalline substrate cause an eventual quasiparticle cascade within a surface-patterned superconducting qubit element. This process alters the fundamental charge parity of the device in a binary manner, which can be used to deduce the initial properties of the energy deposition. This work lays out multiple resonator-coupled readout schemes depending on qubit architecture, provides an analytic formulation for reconstructing sensor energies, and details strategies for multiplexing large arrays of sensors. We further compute the sensitivity of QPDs and detail an R&D pathway to demonstrating sub-eV energy deposit thresholds.
The tunnelling of quasiparticles across Josephson junctions in superconducting quantum circuits is an intrinsic decoherence mechanism for qubit degrees of freedom. Understanding the limits imposed by quasiparticle tunnelling on qubit relaxation and dephasing is of theoretical and experimental interest, particularly as improved understanding of extrinsic mechanisms has allowed crossing the 100 microsecond mark in transmon-type charge qubits. Here, by integrating recent developments in high-fidelity qubit readout and feedback control in circuit quantum electrodynamics, we transform a state-of-the-art transmon into its own real-time charge-parity detector. We directly measure the tunnelling of quasiparticles across the single junction and isolate the contribution of this tunnelling to qubit relaxation and dephasing, without reliance on theory. The millisecond timescales measured demonstrate that quasiparticle tunnelling does not presently bottleneck transmon qubit coherence, leaving room for yet another order of magnitude increase. Superconducting circuits are promising for quantum computing, but quasiparticle tunnelling across Josephson junctions introduces qubit decoherence. Ristè et al. convert a transmon qubit into its own real-time quasiparticle tunnelling detector and accurately measure induced decoherence in the millisecond range.
This thesis mainly summarizes two experiments that relate to building a quantum computer out of superconducting transmon qubits. Transmon qubits have emerged as one of the foremost solid state qubits, realizing processors with more than ten qubits and demonstrating small scale quantum algorithms as well as quantum error correction schemes. Right now, there is a race between different academic and industry research groups to scale up transmon qubit processors. The first experiment was a demonstration of qubit control by selective broadcasting in order to reduce the scaling of expensive electronics with the number of qubits for individual single-qubit control. We demonstrated that we can bring two transmon qubits to the same frequency (combining fabrication accuracy and in-situ fine tuning) and use the same hardware to control both, routing the pulses with a nanosecond-timescale vector switch matrix. Despite the compromises required by this technique, we show a scalable path to single qubit control beyond the threshold required for quantum error correction. In benchmarking, we take into account gate leakage due to the fact that transmons are fundamentally multi-level systems. In the second experiment we establish entanglement between two transmon qubits on different chips. We use an entanglement by measurement scheme and demonstrate that we can overcome minor fabrication imperfections by shaping our measurement pulses. Ultimately, performance is mainly limited by photon loss between the chips and up to the amplification chain. This entanglement mediated by traveling photons could be used to make a distributed transmon processor where computations are spread across several chip modules. This modularity could enable connectivities that cannot be realized on chip and ease fabrication requirements, as modules could be individually fabricated and selected. Thus, both of these experiments fit into the larger effort to converge on the hardware, control equipment and architecture of a future large-scale transmon quantum computer. Other experiments I contributed to are summarized in the conclusion chapter to show the diverse physics that can be studied in cQED experiments.
Current state-of-the-art superconducting microwave qubits are cooled to extremely low temperatures to avoid sources of decoherence. Higher qubit operating temperatures would significantly increase the cooling power available, which is desirable for scaling up the number of qubits in quantum computing architectures and integrating qubits in experiments requiring increased heat dissipation. To operate superconducting qubits at higher temperatures, it is necessary to address both quasiparticle decoherence (which becomes significant for aluminum junctions above 160 mK) and dephasing from thermal microwave photons (which are problematic above 50 mK). Using low-loss niobium-trilayer junctions, which have reduced sensitivity to quasiparticles due to the higher superconducting transition temperature of niobium, we fabricate transmons with higher frequencies than previously studied, up to 24 GHz. We measure decoherence and dephasing times of about 1 μ s , corresponding to average qubit quality factors of approximately 10 5 , and find that decoherence is unaffected by quasiparticles up to 1 K . Without relaxation from quasiparticles, we are able to explore dephasing from purely thermal sources, finding that our qubits can operate up to approximately 250 mK while maintaining similar performance. The thermal resilience of these qubits creates new options for scaling up quantum processors, enables hybrid quantum experiments with high heat-dissipation budgets, and introduces a material platform for even-higher-frequency qubits. Published by the American Physical Society 2024
One of the areas of research of the Superconducting Quantum Systems and Materials (SQMS) center is the application of quantum sensing to fundamental physics searches, demonstrating that quantum sensors can greatly improve the sensitivity of experiments searching for Beyond the Standard Model (BSM) physics, or performing high-precision measurements. Theorists have developed many ideas for BSM physics that would result in interactions that can in principle be detected, but with signals small enough that they haven t been observed yet. In this field, the capability to lower the detector s thermal noise to few or dozens of mK, and to use QIS technologies such as Josephson Parametric Amplifiers and photon counters (in-situ or itinerant) enable us to reach unprecedented sensitivities and faster scan rates. Here is presented an overview of the quantum sensing efforts at SQMS [1], focusing on theoretical advancements and experimental searches for Dark Sector particles (as dark matter candidates and not), gravitational waves, and precision measurements. The experiments conducted, or under preparation, include axion dark matter (DM) [2, 3], dark photon DM searches [4,5], light-shining-through-wall experiments [6], cavity-based searches for high frequency gravitational waves [7], and measurements of the electron magnetic moment [8]. [1] Berlin, A., et al. "Searches for new particles, dark matter, and gravitational waves with SRF cavities." arXiv preprint arXiv:2203.12714 (2022). [2] Giaccone, B., et al. "Design of axion and axion dark matter searches based on ultra high Q SRF cavities." arXiv preprint arXiv:2207.11346 (2022). [3] Braggio, C., et al. "Quantum-enhanced sensing of axion dark matter with a transmon-based single microwave photon counter." arXiv preprint arXiv:2403.02321 (2024). [4] Fan, X., et al. "One-electron quantum cyclotron as a milli-eV dark-photon detector." Physical review letters 129.26 (2022): 261801. [5] Cervantes, R., et al. "Deepest sensitivity to wavelike dark photon dark matter with superconducting radio frequency cavities." Physical Review D 110.4 (2024): 043022. [6] Romanenko, A., et al. "Search for dark photons with superconducting radio frequency cavities." Physical review letters 130.26 (2023): 261801. [7] Berlin, A., et al. "Electromagnetic cavities as mechanical bars for gravitational waves." Physical Review D 108.8 (2023): 084058. [8] Fan, X., et al. "Measurement of the electron magnetic moment." Physical review letters 130.7 (2023): 071801.