In this article, a low noise amplifier is quantum mechanically analyzed to study the behavior of the noise figure. The analysis view is changed from the classic to quantum, because using quantum theory produces some degrees of freedom, which may be ignored when a circuit is analyzed using a classical theory. For this reason, the associated Lagrangian is initially derived for the circuit and then using Legendre transformation and canonical quantization procedure the classical and quantum Hamiltonian are derived, respectively. Consequently, the dynamic equation of motion of the circuit is introduced by which all of the circuit measurable observations such as voltage and current fluctuations are calculated. As an interesting point of this study, the low noise amplifier is deliberately supposed as two oscillators connecting to each other sharing the mutual specifications and accordingly the voltage and current are expressed in terms of the oscillators photon number. As a result, one can analyze the critical quantity such as the noise figure in terms of the oscillators photon number and also the photons coupling between oscillators. The latter mentioning term is considered as a factor to engineering the amplifier critical quantities. Additionally, the considered circuit is designed and classically simulated to testify the derived results using the quantum theory.
In this article, a low noise amplifier is quantum mechanically analyzed to study the behavior of the noise figure. The analysis view is changed from the classic to quantum, because using quantum theory produces some degrees of freedom, which may be ignored when a circuit is analyzed using a classical theory. For this reason, the associated Lagrangian is initially derived for the circuit and then using Legendre transformation and canonical quantization procedure the classical and quantum Hamiltonian are derived, respectively. Consequently, the dynamic equation of motion of the circuit is introduced by which all of the circuit measurable observations such as voltage and current fluctuations are calculated. As an interesting point of this study, the low noise amplifier is deliberately supposed as two oscillators connecting to each other sharing the mutual specifications and accordingly the voltage and current are expressed in terms of the oscillators photon number. As a result, one can analyze the critical quantity such as the noise figure in terms of the oscillators photon number and also the photons coupling between oscillators. The latter mentioning term is considered as a factor to engineering the amplifier critical quantities. Additionally, the considered circuit is designed and classically simulated to testify the derived results using the quantum theory.
Abstract The present article primarily focuses on the design of an ultra-low-noise amplifier specifically tailored for quantum applications. The circuit design places a significant emphasis on improving the noise figure, as quantum-associated applications require the circuit's noise temperature to be around 0.4 K. This requirement aims to achieve performance comparable to the Josephson Junction amplifier. Although this task presents considerable challenges, the work concentrates on engineering the circuit to minimize mismatch and reflection coefficients, while simultaneously enhancing circuit transconductance. These efforts aim to improve the noise figure as efficiently as possible. The results of this study indicate the possibility of achieving a noise figure of approximately 0.009 dB for a unique circuit design operating at 10 K. In a departure from traditional approaches, this study employs quantum mechanical theory to analyze the circuit comprehensively. By employing quantum theory, the researchers derive relationships that highlight the crucial quantities upon which the circuit design should focus to optimize the noise figure. For example, the circuit's gain power, which depends on the circuit's photonic modes, is theoretically derived and found to affect the noise figure directly. Ultimately, by merging quantum theory with engineering approaches, this study successfully designs a highly efficient circuit that significantly minimizes the noise figure in a quantum application setting.
The nature of phase noise in quantum optics is analyzed. In an experiment involving the measurement of the electromagnetic field the two quantities of interest are the energy and phase of the field. However, measurements of the quantities produce quantum fluctuations. The quantum fluctuations are regarded as noise in the treatment presented here. The quantum system is represented by a probability distribution, the Wigner function, and the quantum fluctuations are treated as stochastic noise associated with the quantity being measured. The difficulties of associating a quantum operator with the phase of the system are reviewed and the related energy-phase uncertainty relation is discussed. The alternate interpretation of the phase noise of a quantum system as being the classical phase noise of the Wigner function is presented. In particular the energy and phase noise of the vacuum state, the coherent state, the squeezed state and the squeezed vacuum are discussed in this way. The squeezed states of light are minimum uncertainty states with respect to the quadrature operators and exhibit noise of one quadrature below the noise level associated with the vacuum. The reduced noise level in one quadrature of the field underlies the importance of squeezed states in many practical applications where there is a need to reduce the quantum noise of one quadrature of coherent light. The periodic phase operator eliminates the difficulties associated with the multivalued nature of phase. The analysis of the vacuum and intense coherent state of Carruthers and Nieto by employing periodic phase operators is reviewed, particularly with respect to the energy-phase uncertainty relations and we generalize the approach to develop a phase operator analysis of the squeezed state in the intense field and vacuum limits. We demonstrate here for the first time that the phase operator is simply related to the phase of the squeezed state in the intense field limit and that the squeezed state is approximately an energy-phase minimum uncertainty state in the low-squeezing limit. Also we enlarge on previous work to demonstrate that the phase operator corresponds simply and unambiguously to the phase of the squeeze parameter for the strongly squeezed vacuum and the intensely squeezed vacuum is an energy-phase minimum uncertainty state for some values of phase. The occurrence of squeezing for the case of two coupled quantum oscillators is presented. The system consisting of one mode of the electromagnetic field coupled to a spinless nonrelativistic electron subjected to an harmonic potential is represented by two coupled harmonic oscillators. The dynamics are compared for the case that the rotating wave approximation is employed and for the case that the counter-rotating terms are included. These calculations have not been performed before. The parametric amplifier Hamiltonian with a nonresonant coupling is also studied in order to provide insight into the effects of the counter-rotating terms. Squeezing of the field produced by the electron is a consequence of the inclusion of the counter-rotating terms. The case of a spinless nonrelativistic electron subject to an harmonic potential and coupled to a continuum of electromagnetic field modes is also considered. The case of two coupled oscillators discussed above is generalized by replacing the oscillator which represents the single-mode field by a bath of oscillators. The effects of including counter-rotating terms and of ignoring the counter - rotating terms in the Hamiltonian are compared. The interaction is assumed to produce a frequency shift and an exponential damping term for the oscillating electron. The frequency shift is assumed to be small in either case and so the Wigner-Weisskopff approximation is employed to solve the equations of motion. We demonstrate the new results that dissipation-induced phase-dependent noise is a consequence of including the counter-rotating terms and that the noise is phase-independent for the case that the counterrotating terms are excluded. The relation between these results and recent work on quantum tunnelling in superconducting quantum interference devices is discussed. We conclude by suggesting further research related to the work in this thesis.
A field noise spectral density matrix for the noise from a linear optical device, modeled as an optical multiport, is derived semi-classically. The noise is formulated in the scattering parameters, population inversion factor, and internal efficiency of the device. From this noise expression, a new equation for the amplified spontaneous emission spectral density from an optical amplifier is derived. This equation is more general than those previously published. The derivations are accomplished with the aid of methods from ordinary (classical) electrical network theory and only one quantum mechanical result regarding the noise from a conductance. As a result, the first-mentioned noise expression also includes the so-called vacuum field fluctuations. Further, the current noise spectrum of a square-law detector is derived with classical methods. The optical input to the detector includes the vacuum field fluctuations, which are shown to be the cause of the detector shot noise. Here, a second quantum mechanical result has to be employed, viz., that the vacuum field fluctuations cannot be detected alone. The results in this paper agree with the special cases found in the literature. The noise expressions are well suited for examination of the optical noise performance of arbitrary linear optical networks including, e.g., amplifiers, attenuators, isolators, reflections, filters, and couplers.>
Introduction In previous chapters we studied wave propagation in fiber OPAs from a classical standpoint, i.e. starting from Maxwell's equations. That approach provides only a partial view of the rich nature of the electromagnetic field, namely its wave nature. However, a complete description of the electromagnetic field requires quantum mechanics. This quantum description of the electromagnetic field (called quantum electrodynamics, or QED) predicts fluctuations in measurable quantities due to the Heisenberg uncertainty principle and sets ultimate limits on the performance of devices such as optical amplifiers. A remarkable result of this theory is that the statistics and thus the noise performance of a system are affected by the quantum statistics of the source and by the physical measurement that is made. Thus a different analysis is needed depending on whether homodyne, heterodyne, or direct detection (where the field simply impinges on a photodiode) is used. Direct detection reveals the particle nature of the electromagnetic field. More specifically, energy arrives in discrete units, called photons, each of which may create an electron–hole pair in a semiconductor photodetector. In particular, the number of photons in an optical pulse can be thought of as a random variable having a mean and a variance. By deriving the mean and variance of the photocurrent that would be present if one performed direct detection of ideal laser light at the input of an optical amplifier and then a similar measurement at its exit, one can quantify the degradation of the signal-to-noise ratio (SNR) caused by the amplifier.
The classical definition of noise figure, based on signal-to-noise ratio, is adapted to the case when quantum noise is predominant. The noise figure is normalized to "uncertainty noise." General quantum mechanical equations for linear amplifiers are set up using the condition of linearity and the requirement that the commutator brackets of the pertinent operators are conserved in the amplification. These equations include as special cases the maser, the parametric amplifier, and the parametric up-converter. Using these equations the noise figure of a general amplifier is derived. The minimum value of this noise figure is equal to 2. The significance of the result with regard to a simultaneous phase and amplitude measurement is explored.
Abstract This article mainly focuses on important quantum phenomenon called entanglement arising the nonlinearity property. This study uses a unique approach in which transistor nonlinearity effect (third-order nonlinearity) entangled microwave photons are created in a cryogenic low-noise amplifier (LNA). For entanglement analysis, the Hamiltonian of the designed cryogenic LNA (containing two coupled oscillators) is derived, and then, using the dynamic equation of motion, the oscillator’s number of photons and the phase-sensitive cross-correlation factor are calculated in the Fourier domain to calculate the entanglement metric. The oscillators are coupled to each other through the gate–drain capacitor, and nonlinear transconductance is as an important factor strongly manipulating the entanglement. As a main conclusion, the study shows that the designed circuit using transistor third-order nonlinearity has the ability to generate the entangled microwave photons at very low intrinsic transconductance and more importantly when the noise figure (NF) is strongly minimized. As a complementary task, the printed circuit board of the cryogenic LNA is designed and simulated to verify the ability of the circuit to achieve an ultralow NF, by which the probability of the generation of entangled microwave photons is increased.